adt-audio SRC 51 Installation Manual

Text of adt-audio SRC 51 User Guide:

• adt-audio SRC 51, Installation Manual Part II: Connectors Pinning Diagrams Description of Connectors for Consoles without Patchbay analoge + digitale Tonstudiotechnik Karl Jüngling • Inh. Dipl.-Ing. Gerd Jüngling 4-6, Scholtwiese • Gladbeck • 45966 • NRW • Germany • Phone: 0049 2043 51061 • Fax: 0049 2043 56844 E-Mail: info@adt-au di o.com • Internet: www.adt-audio.com www.broadcast-console.com Version 1.6/14 • English adt-audio 51 SRC

• adt-audio SRC 51, 2 adt-audio 51 SRC Summary Preface.................................................................. 3 3. Connectors...................................................... 4 3.1 Technical data of Inputs and Outputs .................. 4 3.2 Connector Types...................................................... 5 3.3 Connector Panels ................................................... 7 Input Channel Connector Panels................... 7 Master Section Connector Panel...................... 8 Connectors on the Master Panel in brief........ 8 Pinnings of the Master Connectors.....

• adt-audio SRC 51, 3 adt-audio 51 SRC Preface This manual contains all information that is necessary to prepare and plan the installation of the mixing console and accessory components. Please, read this manual carefully. We point out common mistakes and problems that are connected with the installation and provide suggestions to avoid such problems. You will save a lot of time and unnecessary start up problems by investing a couple of hours in the reading of this manual. The rst part of the manual contains everything about the power supply units and crossover devices that a

• adt-audio SRC 51, 4 adt-audio 51 SRC 3. Connectors 3.1 Technical data of Inputs and Outputs The characteristic data of all audio inputs and outputs of the modules are identical. Here is a listing of the basic data of the different types. Level The nominal level of the SRC51 system is determined by the customer. It is only xed by the adjustment of the system meters that can be set to any level between 0 dBu and +15 dBu. If no nominal level is specied by the customer, it will be set to + 6 dBu = 1.55 V RMS Headroom The maximum level of a particular signal chain always refers to an overall gain of 0 dB. Wit

• adt-audio SRC 51, 5 adt-audio 51 SRC mixing busses as well, maximum dynamic range is achieved, also as far as the mix noise is concerned. The mix noise in particular suffers from a level diagram, that uses lower internal levels to achieve a nominal higher output level. 3.2 Connector Types Four versions of the connector panel The connections for each module type of the SRC51 consoles are standardized. There are two types of connector panels. Please note that this manual concerns the SRC51 version without internal patchbay. Patchbay versions use different connector panels. Version 1 is used for all types of input modules for consoles without inter

• adt-audio SRC 51, 6 adt-audio 51 SRC chapter about the audio installation about our recommendations what principles of wiring should be used. As mentioned in this chapter, all screen pins are separted from ground. If the console has to be installed in a very ‘dirty’ electric environment, it is possible to oat the entire connector ground network and connect to audio ground via a low ohm resistor of approximately 1 to 5 ohms. This will avoid any ground loop current. However, call us for advice before you do so. The exception from this principle are the microphone input screens.

• adt-audio SRC 51, 7 adt-audio 51 SRC 3.3 Connector Panels The connector panels for input channels combines 4 module slots. The connector panel of the master section is 4 slots wide. Each connector panel is located behind the belonging modules. Input Channel Connector Panels The input connector panel can be used with all sorts of input channels. The 3-pin XLR connectors are used for the microphone input, the line/keyboard input, the mon- (daw-return) input, and the channel output (daw-send) with the IM5 mono inp

• adt-audio SRC 51, 8 adt-audio 51 SRC The Master Section Connector Panel This connector panel is located right behind the master section of the con- sole. It holds 17 D-Sub connectors, the power connector and a ground connector. Even though the pinning of all connectors is the same with all versions of the console. There are 15 25-pin female audio connectors and 2 25-pin male control connectors. The Connectors on the Master Panel in Brief TB-Audio Audio inputs and outputs of the talkback-, listen-, and oscillator section. This connector is only functional, is the TBO talkback module is installed. TB-Control Control in

• 9 adt-audio 51 SRC module. This connector is only functional, is the TBO talkback mo- dule is installed. 2-TR/9-12, 2-TR/13-16, 2TR/17-20, and 2-TR/21-24 The inputs of the additional monitor source selectors, installed in the optional TBO talkback module and the optional STU playback module. 6-TR/2-TR-A, 6-TR/2-TR-B The inputs of the monitor source selectors in the mandatory CT5

• adt-audio SRC 51, 10 adt-audio 51 SRC MIX OUT L SubD-25 Connector Female in Console Frame MIX OUTPUTS MIX OUT R MIX OUT SL MIX OUT SR MIX OUT C MIX OUT LFE MIX OUT STEREO DOWNMIX L MIX OUT STEREO DOWNMIX R 51 SRC 8 7 1 2 3 4 5 6 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 + - Screen + - Screen + - Screen + - Screen + - Screen + - Screen + - Screen + - Screen nc CUE MASTER OUT R SubD-25 Connector Female in Console Frame THIS CONNECTOR IS INSTALLED IN CONSOLES WITH AND WITHOUT PATCH-BAY. WITH PATCH-BAY IT IS CONNECTED DIRECTLY TO THE INSERT OUTPUT OF

• adt-audio SRC 51, 11 adt-audio 51 SRC CTR-Insert Out / Aux 3 & 4 Out The CTR-Insert can be used to add special func- tions, like bass-management or x-curve lters to the control room monitor chain, using exter- nal gear. The insert is located between the out- put of the control room source selector and the input of the regulator section. The insert point is fully balanced and operates on nominal level with a headroom of + 30 dBu. The outputs are always available, independent of the position of the in- sert switch in the CT5 control room module. In addition, this connector contains the outputs of the auxiliary masters A

• adt-audio SRC 51, 12 adt-audio 51 SRC CTR Stereo Speaker Out These are the outputs of the stereo control room speakers ‚Alternate‘ and ‚Mini‘. If the console is in surround operation mode, these outputs are fed by the stereo downmix matrix in the CT5 control room module. Both, alternate and mini outputs are electronically balanced. In addition, this connector holds the direct ouput of the console‘s stereo PFL system. These out- puts can be used for an external PFL-Speaker sy- stem. 6-Track/2-Track A Repro This connector holds the control room selector

• adt-audio SRC 51, 13 adt-audio 51 SRC 2-Track 9-12 Repro The optional STU playback module contains a source selector with 8 balanced stereo inputs. If this module is installed, the connector 2-Track 9-12 repro feeds the rst 4 stereo inputs of this selector block. The output of this selector feeds the 2-TR-A input of the main control room selector in the CT5 sur- round master module. 2-Track 13-16 Repro The optional STU playback module contains a source selector with 8 balanced stereo inputs. If this module is installed, the connector 2-Track 13-16 repro fe

• 14 adt-audio 51 SRC 2-Track 21-24 Repro The optional TBO talkback module contains a source selector with 8 balanced stereo inputs. If this module is installed, the connector 2-Track 21- 24 repro feeds the second 4 stereo inputs of this selector block. The output of this selector feeds the 2-TR-B input of the main control room selector in the CT5 sur- round mast

• 15 adt-audio 51 SRC Talkback Control This connector is used for the control inputs and outputs of the optional TBO talkbak module. If this module is not installed, these outputs are not active. The control inputs are isolated by optocouplers. Di- ode bridges and resistor in the input circuit make possible to use any voltage between approx. 9 volts and 30 volts of an

• adt-audio SRC 51, 16 adt-audio 51 SRC User Switch There are 4 additional switches in the optional TBO talkback modu- le that can be used for additional functions. Of course, this con- nector is only in use if the TBO module is in- stalled. In the standard versi- on, switch 1 and 2 are non-latching versions, and switch 3 and 4 are latching version. Feel free to tell us with the order any other con- guration; however, later changes from latching to non-latching or vice versa are not possible. Each switch has a ‚normally open‘ and a ‚norma

More Instructions:

	adt-audio SRC 51 Installation manual 02-08-2022 19	DOWNLOAD
	adt-audio SRC 51 Installation manual 02-10-2022 12	DOWNLOAD

Related Products and Documents (Stereo System):

Comparable Devices:

Similar Resources:

• Samsung MM-N6 (19 pages) MICRO COMPONENTSYSTEM WITHREMOTE CONTROLMM-N6On/StandbyPowerSurroundOpen/CloseTimerOn/OffCD RepeatShuffleMono/STTimer/ClockProgram/SetTuner/BandAI Off/SleepClassic Rock Pop AuxCDCDCDVOL.VOL.TuningModeInstruction Manual …

• Yamaha DSP-AX1600 (151 pages) SERVICE MANUAL100981IMPORTANT NOTICEThis manual has been provided for the use of authorized YAMAHA Retailers and their service personnel.It has been assumed that basic service procedures inherent to the industry, and more specifically YAMAHA Products, are alreadyknown and understood by the users, and have therefore not been restated.WARNING: Failure to foll …

• Philips MC-10 (21 pages) 13140 115 27761MC-10Micro HiFi SystemToll Free Help LineLigne d'assistance en service libreLinea de ayuda telefónica sin cargo800-531-0039pg 001-021/MC10/37-Eng 12/8/00, 9:10 AM1 …

• LSS SB17 (24 pages) PROFESSIONAL AUDIO SYSTEM SB17 OPERATING MANUAL Ver. SB17-EN-1.0 LSS Advanced Speaker Systems Via On. Longo 53-89024 Polistena (RC) ITALY Tel (39) 966 9321299 – Fax (39) 966 933007 Email: [email protected] - Internet: www.lss.it …

• Yamaha MCR-E410 (365 pages) YAMAHA ELECTRONICS CORPORATION, USA 6660 ORANGETHORPE AVE., BUENA PARK, CALIF. 90620, U.S.A.YAMAHA CANADA MUSIC LTD. 135 MILNER AVE., SCARBOROUGH, ONTARIO M1S 3R1, CANADAYAMAHA ELECTRONIK EUROPA G.m.b.H. SIEMENSSTR. 22-34, 25462 RELLINGEN BEI HAMBURG, GERMANYYAMAHA ELECTRONIQUE FRANCE S.A. RUE AMBROISE CROIZAT BP70 CROISSY-BEAUBOURG 77312 MARNE-LA-VALLEE CED …

• Sony ICF-C11iP (2 pages) Personal Audio System©2013 Sony Corporation Printed in China4-450-037-21(1)ICF-C11iPOperating InstructionsStartup GuideBefore operating the system, please read this guide thoroughly and retain it for future reference.WARNINGTo reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture.To reduce the …

Comments, Questions and Opinions: