Philips VCM7A79/00T Operation & User’s Manual

Text of Philips VCM7A79/00T User Guide:

• 4 Page Introduction.............................................................................................................. 4 Connection and operation facilities ...................................................................... 5 Installation .............................................................................................................. 5 Camera position Focus

• Philips VCM7A79/00T, 5 1 Focus adjustment ring 2 Back-focus adjustment ring 3 Camera sound on/off 4 Auto-iris socket 5 Cable length compensation selector 6 System cable socket 7 External supply socket This chapter describes the installation of the camera. For more detailed information about the installation and operation of the system monitor you should consult the monitor manuals. Remarks: * When the system configuration is altered, the system monitor needs to check and memorise the cameras and accessories connected to its inputs. This is done automatically when the power is switched on (rear switch). * This system

• Philips VCM7A79/00T, 6 Installation 1. Take the camera, system cable and monitor to the area you want to observe (with the monitor on site, you can check whether the camera covers the required area). Remark: For outdoor use protective camera housing has to be used to protect the camera from rain and snow. 2. Connect the camera to the system monitor (1). 3. Connect the system monitor to the mains (2). 4. Switch on the mains power switch (3). The monitor will check the system. After a short time the camera image will appear on the monitor screen. 5. If necessary adjust contrast /brightness and/or colour (controls at the f

• Philips VCM7A79/00T, 7 7. Check on the monitor whether the camera covers the required area (The best results are obtained when the camera is pointed slightly downwards and is not looking into a bright light source). Adjust focus if necessary. 8. Fasten the wall bracket (1) to the wall, or another even and firm surface. 9. Tighten the knob (2). 10. Fasten the camera to the bracket (3). 11. Loosen knob (4) and screw (5) slightly (figure below). 12. Direct the camera at the object or area you want to observe (8). Check the camera image on the monitor. Adjust focus if necessary. 13. Tigh

• Philips VCM7A79/00T, 8 Focus adjustment • Adjust the focus ring of the camera lens to obtain optimal image sharpness. Remark: If still no sharp object image is obtained, you should adjust the back-focus of the camera. Back-focus adjustment Caution: Back-focus adjustment is only necessary when no sharp object image is obtained with the focus adjustment ring. • Set focus adjustment ring to Far or Infinity (1). • Aim the camera at an object at least 15 metres/45 feet away. Remark: When bright light sources are positioned within thecamera view field; dim the light source. • Loosen the back-focus locking ring (2). • Rotate the lens, including the CS-mount ring, until the video image

• Philips VCM7A79/00T, 9 The CS-mount of the camera allows you to use other lenses. The field of view (= covered area) of an 8mm lens is half of the field of view of the 4mm lens (see figure below). The auto-iris lenses are recommended when the camera is used in environments with variable light conditions (eg. outdoors). By means of the auto-iris the amount of light going through the lens is regulated. The auto-iris is DC-controlled through a 4-pole connector at the back of the camera (3). Perform the following steps to change a lens: • Point the camera downwards. This to minimize possible deposit of dust on the inside of the camera when the lens is removed

• 10 For the interconnections between the system monitor and camera 25m/75ft system cable is supplied. For an optimum picture and sound quality you should always use 4-wire dual twisted- pair cable when extending the connection. The max. allowed cable length is 300m/900ft. The cable and plugs are available in the hobby and professional trade. Pay attention that the connectors are fixed to the ca

• Philips VCM7A79/00T, 88 Pick-up element 1/3" solid state CCD Pixel elements 5 12 (H) x 582 (V), PAL interlaced, or 512(H) x 492 (V), NTSC interlaced Resolution 330 TVL Gain control automatic Lens See: Using a different lens Iris Electronic iris When connected, an auto-iris lens overrides the electronic iris. Light sensitivity • 0.3 lux minimally acceptable picture with standard lens (F1.2) at 3200K, transmission 86%, scene reflection 100% • 0.5 lux, 50ire (-6dB) with standard lens (F1.2) at 3200K, transmission

Related Products and Documents (Security Camera):

Comparable Devices:

Similar Resources:

• Channel Plus 7410 (2 pages) 7410-74207430PRINTERS INSTRUCTIONSINSTR,INSTL,74XX CAMERAS,CP - P/N: 223012 B - INK: BLACK - MATERIAL: 20 LB. MEAD BOND - SIZE: 8.500” X 11.000” - FOLDING: 1 FOLD VERTICAL, 2 FOLDS HORIZONTAL, FINISH WITH LOGO SHOWING - SCALE: 1-1 - SIDE 1 of 2Linear LLC2055 Corte Del Nogal, Carlsbad, CA 92009, USA760-438-7000800-999-5225fax: 760-931-1340www.channelplus. …

• Sanyo VCC-WB4000P (78 pages) INSTRUCTION MANUALNetwork CameraVCC-WB4000PAbout this manualBefore installing and using this unit, please read this manual carefully. Be sure to keep ithandy for later reference.L5AM2/XE (VCC-WB4000P) GB 2004, 2, 20 …

• Uniden GNC 701 (12 pages) 1Quick-Start GuideGNC 701/710IP CameraUse this Quick-Start Guide to connect the camera to the network and for basic installation and setup procedure. For more detailed instructions refer to the online Owner’s Manual on the Uniden website www.uniden.com.au. This quick start guide is for reference only. Slight difference may be found in user interface.In the …

• Uniden UDW10055 (26 pages) Sistema de vídeo vigilancia UDW10055Manual del usuario¿Qué viene en la caja?Receptor portátil con pantalla LCD a color de 3-1/2 pulgadasCámara (2) inalámbrica UDWC25 resistente a las inclemencias del tiempoAntena (2)Soporte para la cámara (2) Adaptador CA para el receptor (1) Adaptadores para lacámara (2)CD del softwareCables AVCable USBCables …

• Zjuxin WIFI Smart Camera (28 pages)  1/28Quick Manual for our WIFI Smart Camera Form (1)Remark before using our camera. Please confirm whether the voltage meets the requirements before using the products, or improper voltage will damage and bring security risk. Please install the device correctly and make sure whether to disconnect the power supply at the time of installation T …

• AVer PTZ310 (2 pages) ©2018 AVer Information Inc. All rights reserved. PTZ310/330 Quick Start Guide Package Contents BLCMenu/ HDMI cable PTZ 310/330 Power adapter & Power cord Cable ties(x5) Remote controller/ Batteries(x2) RS232 In/Out cable Quick Guide Cable Fixing plates(x 2) Din8 to D-Sub9 cable Screw for mount Overview (4) (5) (6) (7)(8)(9)(10)( …

Comments, Questions and Opinions: