Manualios.com

Addlogix IV-2020 Operation & User’s Manual

Addlogix IV-2020 Manual Online:

3.35, 2669 votes
Addlogix IV-2020 User Manual
Addlogix IV-2020 User Guide
Addlogix IV-2020 Online Manual

Text of Addlogix IV-2020 User Guide:

  • Addlogix IV-2020, 3.04.58 NOV0507 28 If the video pauses at the beginning of the sequence for less than 2 seconds and restarts • This is normal behavior. The system is optimizing settings to optimize video compression and display performance. If the DVD or video playback is jerky or does not display on the TV screen • Check your video playback software documentation, and try disabling “Overlay” • In the event that your PC has more than one display enabled, make sure video is being played back on your PC’s primary display • We recommend PowerDVD player for optimal viewing experience If the video appears excessively blocky �

  • Addlogix IV-2020, 3.04.58 NOV0507 3 Introduction Congratulations, and thank you for your InternetVue™ purchase. InternetVue™ will allow you to display your PC’s screen contents on any TV or projector wirelessly. You will be able to view videos, digital photos, websites, and just about anything on your PC, will be shown on your TV. Moreover, your PC’s audio will also be heard from your TV or audio system. InternetVue™ is a two-part solution – a software component and a hardware receiver/decoder module. The software running on

  • Addlogix IV-2020, 3.04.58 NOV0507 26 Advanced More advanced options can be set here. Password Setup Optional password setting. See p.13 for more info. Upgrade This screen allows you to perform a manual firmware upgrade. It is recommended not perform any manual firmware upgrades unless instructed by Addlogix support. Video Settings The Quality Settings are similar to the VIDEO and PHOTO buttons at the top of the application window. Pan and Scan This setting allows your PC to maintain a higher resolution, while the image displayed on the TV is a cropped portio

  • 3.04.58 NOV0507 17 Configuration B Select “Connect to external networks using wired ethernet” Configuration C Select “None” Configuration D Select “None” In configurations B and D, only your PC and the InternetVue™ communicate wirelessly; the internet connection to the gateway/router is wired. Wireless security can be enabled between the PC

  • Addlogix IV-2020, 3.04.58 NOV0507 7 Configuration B: Wireless / Wired In this Configuration, your PC communicates to InternetVue™ via wireless networking. The InternetVue™ is directly connected to your router/gateway via the wired network connection. Internet access is relayed through the InternetVue™ to your PC via wireless networking. Configuration C: Wired / Wired In this Configuration, your PC communicates to both the InternetVue™ and your router/gateway through wired network connections. Configuration D: Wired / Wireless In this last Configuration, yo

  • Addlogix IV-2020, 3.04.58 NOV0507 9  The InternetVue™ will auto- detect which output is being used to connect to the TV. In about 30-60 seconds, it will be fully initialized, and the following “Welcome Screen” will come up on your TV or projector: This confirms the connection between the InternetVue™ receiver and the TV or projector. Now, you can begin installation of the PC2TV software on your computer by inserting the CD into your PC’s CD- ROM drive. Follow all ons

  • Addlogix IV-2020, 3.04.58 NOV0507 10 In the event that there is more than one InternetVue™, the Select Output Display window will appear. Here, you can select the InternetVue™ receiver by its “Wireless ID” as shown in the image of step 3 above. Depending on your InternetVue™ receiver’s internal firmware, the PC2TV software may prompt you to upgrade its firmware to the latest version for optimal performance. Simply follow the instructions as this is done automatically.  When the PC2TV software connects to the InternetVue™ for the very first time after initial insta

  • 3.04.58 NOV0507 14 Device Name (SSID) This allows you to change the “Wireless ID” broadcasted by the InternetVue™. This is useful when multiple receivers are present. You can assign any four-character alphanumeric suffix to each InternetVue™ box. The InternetVue™ receiver will then have an SSID of “PC2TV-xxxx” where the “xxxx” is the four-character alphanu

  • Addlogix IV-2020, 3.04.58 NOV0507 19 Factory Reset Sometimes a factory reset is necessary to clear all settings in the InternetVue™ receiver. It will be brought back to the factory default state. The SSID may change, and starting the PC2TV software will invoke the Configuration Wizard once again. To perform a factory reset, make sure the InternetVue™ receiver is powered on and running for a few minutes. This is to ensure that it is not initializing. Press the Factory Reset Button for 10 seconds continuously, then release. After

  • Addlogix IV-2020, 3.04.58 NOV0507 27 Troubleshooting Tips If InternetVue does not appear on the list of available wireless networks • InternetVue™ is powered off, its wireless signal is too weak, or the antenna has come loose. Check for these conditions, or try moving the PC closer to it. • If you are using Microsoft wireless utility: 1. Exit the PC2TV application. 2. Open the utility and view available wireless networks. Press the Refresh button to update the list of available APs. If the InternetVue™ still does not appear in the available list, perform the following: 3. Exit the PC2TV application. See p.1

  • Addlogix IV-2020, 3.04.58 NOV0507 23 About the Security Access Number feature When enabled, this forces the user to enter a four-digit code displayed on the TV before the InternetVue™ will allow the PC to connect to it. This code changes each time the InternetVue™ receiver is power-cycled. The Security Access Number provides additional security by not allowing users to display video or change PC2TV settings without seeing the TV image. When starting the PC2TV software, enter the four digit Security Access Number as shown on the Welcome Screen on the

  • 3.04.58 NOV0507 2 Table of Contents Introduction .................................................................................................................................... 3 Product Specifications ........................................................................................................................3 Retail Box Contents .......................

  • Addlogix IV-2020, 3.04.58 NOV0507 29 FCC Notice (USA) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the manufacturer’s instructions, may cause interference to radio communications. Operation of the equipment in a residential area i

  • Addlogix IV-2020, 3.04.58 NOV0507 6 Configuration Options There are four possible ways to interface the InternetVue™, your PC, and your internet connection. However, keep in mind that the internet connection is not necessary. Select which Configuration works best for you from the table below. Configuration A B C D PC Network Connection Type Wireless Wireless Wired Wired Internet Router Type Wireless Wired Wired Wireless Configuration A: Wireless / Wireless In this Configuration, your PC communicates to InternetVue™ via wireless networking. The Inter

  • Addlogix IV-2020, 3.04.58 NOV0507 4 Power Audio CVBS Pr Y Pb RJ45 Factory Reset Button Antenna Retail Box Contents Ensure that your InternetVue™ kit has all the following items. Otherwise, contact Tech Support for more information. InternetVue™ Receiver Application CD Quick Start Guide AC Power Adapter Audio Cable Video Cable Ethernet Cable Ports and Connectors InternetVue™ has two sets of output video connectors, and one audio output connector. For video, there are the

  • Addlogix IV-2020, 3.04.58 NOV0507 22 Device Settings Clicking on “Device Settings” on the left side shows the next screen: Click here to star t the Configuration Wizard Click here to enable the Security Access Number

  • Addlogix IV-2020, 3.04.58 NOV0507 8 Installation Procedure  Make sure that the TV or projector and the InternetVue™ is unpowered. Connect the InternetVue™ receiver box to your TV or projector’s appropriate AV inputs. TV with Component Video Inputs (Best Quality): TV with Composite Video Input:  Connect the power adapter to the InternetVue™ DC power jack input first (a), then plug in the power adapter into an AC outlet (b). Turn on your TV or projector and select the appropriate AV input. If your configuration involves a wired connecti

  • Addlogix IV-2020, 3.04.58 NOV0507 21 PC2TV Advanced Settings The Advanced Settings are the same as those in the Configuration Wizard, aside from a few additional options. Summary The first screen shows the overall connection summary:

Related Products and Documents (TV Receiver):

Comparable Devices:

# Manufacturer Model Document Type File Updated Pages Size
1 ADT Safewatch Pro 3000 Installaton manual adt/safewatch-pro-3000-559.pdf 01 Aug 2023 88
2 DeLonghi EDG400 B Melody II Operation & user’s manual delonghi/edg400-b-melody-ii-FZJ.pdf 19 Mar 2024 32
3 Panasonic PVDM2794 - TV/DVD/VCR COMBO Operating instructions manual panasonic/pvdm2794-tv-dvd-vcr-combo-841.pdf 22 Mar 2023 84 7.27 Mb
4 Blue Hawk 0300812 Operation & user’s manual blue-hawk/0300812-432.pdf 23 Feb 2023 36
5 Acer Aspire E1-422 Manual  acer/aspire-e1-422-XE8.pdf 02 Oct 2023 9
6 NordicTrack Gx 3.0 Gw Bike Manual  nordictrack/gx-3-0-gw-bike-RE2.pdf 28 Mar 2023 28

Similar Resources:

  • Axis

    S10

    (130 pages)
    AXISCameraStationS10RecorderSeriesAXISCameraStationS1016MkIIRecorderAXISCameraStationS9002DesktopTerminalAXISCameraStationS9101DesktopTerminalAXISCameraStationS9201DesktopTerminalInstallationGuide …
  • AT&T

    U-verse TV

    (2 pages)
    Having trouble?Many issues can be resolved in three simple steps: 1. Check your connections.Verify that cables, cords, and filters on all devices are connected as specified in steps 1A–1E. Make sure:• The dual-port filter (optional) is plugged into the wall jack (and not the Wireless Gateway).• The data cable is plugged into the DSL port on the …
  • Samsung

    CW29M064VPXXEC

    (75 pages)
    COLOR TELEVISION RECEIVERChassis : S56A(P) Rev.1Model: CW29M064VPXXECCW29M064NPXXECCS21S8MH3C/ABSCS21A11MH4SGARCS21A11MH3CABSCOLOR TELEVISION RECEIVER CONTENTSPrecautionsReference Information Specifications Alignment and AdjustmentsTroubleshootingExploded Views and Parts ListElectrical Parts ListBlock Diagrams Wiring DiagramSchematic Diagrams1.2.3.4.5.6.7.8 …
  • DirecTV

    D12

    (79 pages)
    DIRECTV® RECEIVERUSER GUIDEDIRECTV® RECEIVER USER GUIDE To place batteries in your remote control:1. Remove cover from the battery compartment by sliding it downward.2. Insert 2 AA batteries (supplied), matching the positive (+) and negative (–) at each end.3. Slide the cover back on to complete installation.To program your remote control:1. See “Progr …
  • Humax

    BXR-HD2

    (2 pages)
    www.macab.com...a step into a digital worldwww.macab.com120711 • 02119www.humaxdigital.co.ukRecording via external USB HDD Play Media Contents in external USB HDD or USB memory (MP3, JPG, Xvid)See Digital TV in HD quality Support Full HD resolution : 1080p/24, 1080i, 720p and 576pFully compliant to DVB-T2 prole as well as DVB-TUser friendly receiver wit …
  • Vizio

    VO320E

    (67 pages)
    VIZIO VO320E User Manual Version 1/22/2009 1 www.VIZIO.com TM® Dear VIZIO Customer, Congratulations on your new VIZIO VO320E television purchase. Thank you for your support. For maximum benefit of your set, please read these instructions before making any adjustments, and retain them for future reference. We hope you will experi …

Comments, Questions and Opinions: