AEG 2600D Operating And Installation Manual

Text of AEG 2600D User Guide:

• 3 Contents Safety warnings 4 for the user 4 for the installer 4 Description of the Appliance 6 Extractor version 6 Filter Version 6 Control Panel 7 LED Indicator lights for verifying the saturation of filters 8 Led – Indicator for grease filter C 8 Led - indicator for charcoal filter D 8 Resetting the saturation indicator 8 Maintenance and care 9 Metal grease filter 9 Open the metal grease fi

• AEG 2600D, 4 Safety warnings for the user • Always cover lighted elements, to prevent excess heat from damaging the appliance. In the case of oil, gas and coal fired cookers it is essential to avoid open flames. • Also, when frying, keep the deep frying pan on the cooker top/cooker under careful control. • The hot oil in the frying pan might ignite due to overheating. • The risk of self-ignition increases when the oil being used is dirty. • It is extremely important to note that overheating can cause a fire. • Never carry out any flambé cooking under the

• AEG 2600D, 5 • The air outlet must not be connected to chimney flues or combustion gas ducts. The air outlet must under no circumstances be connected to ventilation ducts for rooms in which fuel-burning appliances are installed. • It is advisable to apply for authorization from the relevant controlling authority when connecting the outlet to an unused chimney flue or combustion gas duct. The air outlet installation must comply with the regulations laid down by the relevant authorities. • When the unit is used in its extractor version, a sufficiently large ventilation hole must be provided, with dimensions that are approximately the same as th

• AEG 2600D, 6 Description of the Appliance Extractor version • The hood is supplied as an extractor unit and can also be used with a filtering function by fitting one charcoal filter (special accessory). • You will need original AEG charcoal filter for this function (see Special Accessories). • The air is discharged to the outside through a pipe, which must be fitted to connection flange A. Fig. 1. • In order to obtain the best performance the hose should have a diameter equal to the outlet hole. Should there already be a pipe of diameter 125 mm that ducts to the outside through the walls or roof, it

• AEG 2600D, 7 Control Panel • Best result are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated. Turn the hood on a few minutes before you start cooking, you will then get an under pressure in the kitchen. The hood should be left on after cooking for about 15 minutes or until all the odours have disappeared. The control switches are located on the unit’s front panel: A - Main switch, hood on/off. B - Start and choice of motor speed 1-2-3-1-2......... C - Indicates speed 1 (LED) and indication of the grease saturation for the filter (flashing indicator). D - Indicates speed 2 (LED) and indicati

• 8 LED Indicator lights for verifying the saturation of filters This hood is supplied without a charcoal filter. If the hood is to be used in the filter version mode with a charcoal filter, the saturation indicator must be activated as follows: Depress and hold the A and B buttons simultaneously for 3 seconds. Initially only the LED indicator signal for the grease filter C is activated, shortly a

• AEG 2600D, 9 Maintenance and care • The hood must always be disconnected from the electricity supply before beginning any maintenance work. Metal grease filter • The purpose of the grease filters is to aspirate grease particles which form during cooking and it must always be used, either in the external evacuation or internal recycling function. Attention: the metal grease filters must be removed and washed, either by hand or in the dishwasher, every four weeks. Open the metal grease filter • First, push the metal grease filter stop backwards, then extract the filter, pulling downwards. Fig. 3. Hand washing Soak grease filters for about one hour in hot water wi

• 10 Charcoal filter • The charcoal filter should only be used if you want to use the hood in its filter version. • To do this you will need an original AEG charcoal filter (see special accessories). • Cleaning/replacing the charcoal filter Unlike other charcoal filters, the LONGLIFE charcoal filter can be cleaned and reactivated. At normal use the filter should be cleaned every second m

• AEG 2600D, 11 Remove the upper glass panel The upper glass panel can be removed for cleaning. • Remove the grease filters. • Pull the handle L down. Fig. 5. • Remove the glass panel. Fig. 5 Warning • Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. You are therefore strongly recommended to follow these instructions. • The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the

• AEG 2600D, 12 Cleaning • Warning: always disconnect the hood from the mains power supply before cleaning it. Never insert pointed objects in the motor’s protective grid. • Wash the outside surfaces using a delicate detergent solution. Never use caustic detergents or abrasive brushes or powders. • Only ever clean the switch panel and filter grille using a damp cloth and delicate detergents. • It is extremely important to clean the unit and change the filters at the recommended intervals. Failure to do so will cause grease deposits to build up that could constitute a fire hazard. Special accessories Charcoal filter KF8 E-Nr.: 942 118 648 Technical

• AEG 2600D, 13 Technical Specifications Models 9600 D Dimensions (in cm): Height 80-122,5 Width 89,8 Depth 52 Maximum absorbed power: 175 W Motor absorption: 1 x 130 W Lighting: 2 x 20W Length of the cable: 150 cm Mounting accessories included 2 hooks 2 metal screws 2,9x13 6 wood-screws 5x45 mm 6 wall plugs Ø 8 mm 4 metal screw 2,9x6,5 1 deflector 1 reduction flange

• AEG 2600D, 14 Electrical connection Safety warnings for the electrician Before connecting the appliance to the power supply, check that the voltage indicated on the rating plate corresponds to the mains power supply available. Appliances fitted with a plug can be connected to any standard power socket within easy access. Should it be necessary to provide a fixed connection, the hood must only be installed by an electrician authorised by the local electricity board. To isolate the cooker hood from the mains, pull the mains plug. If the appliance is permanently connected to the mains, then it must be isolated from the mains using measures provided in the electrical installat

• AEG 2600D, 15 Mounting – Figure 8 • Position the template (1) on the wall and mark the position, and drill the holes (2 x Ø 8 mm).Mount the two rawl plugs with the hooks (3) • Hang the hood on the hooks and level it with the adjustment screws (4) • Remove the grease filters (5) and mark for the two screws (6). Remove the hood and drill the holes (2 x Ø 8 mm). • Insert the rawl plugs (7) and hang the hood on the wall again. Adjust it horizontally with the screws (8) and secure it with the screws (9) • Mount the wall bracket (10) with the wall plugs (9a) and the screws (11). Be careful that it is centered over the hood and horizontally aligned. Fitting f

More Instructions:

AEG 2600D Operating and installation manual 21-12-2022 16

DOWNLOAD

Related Products and Documents (Ventilation Hood):

Comparable Devices:

Similar Resources:

• Lifebreath Clean Air Furnace CAF-02-MB (44 pages) * LEAVE FOR HOMEOWNERNOTE: Due to ongoing research and product development, specifications, ratings and dimensions are subject to change without notice.CAF-02-MB1203Installing ContractorTelephone / ContactSerial NumberInstallation Date ModelTO BE COMPLETED BY CONTRACTOR AFTER INSTALLATIONOPERATION, SIZING AND INSTALLATION MANUALNOTE: ALTHOUGH SOME MODELS …

• Jenn-Air UXI6536BSS (3 pages) 16WHIRLPOOL CORPORATION MAJOR APPLIANCE WARRANTYLIMITED WARRANTYFor one year from the date of purchase, when this major appliance is operated and maintained according to instructions attached to or furnished with the product, Whirlpool Corporation or Whirlpool Canada LP (hereafter “Whirlpool”) will pay for Factory Specified Parts and repair labor to corr …

• Smeg KI52E (12 pages) Libretto istruzioniUser manualManuel d’InstructionsBedienungsanleitungGebruiksaanwijzingManual de instruccionesManual de InstruçõesBrugsvejledningBruksanvisningРуководство по эксплуатацииInstrukcja ObsługiBruksanvisningAsennusohjeetKI52E - KI70E - KIL52E - KIL70E - KSEG5E - KSEG7E - KSEG51E …

• Faber IN-NOVA-PREM-A90 (140 pages) EN COOKER HOODDE DUNSTABZUGSHAUBEFR HOTTE DE CUISINENL AFZUIGKAPES CAMPANAPT EXAUSTORIT CAPPASV SPISFLÄKTNO KJØKKENVIFTEFI LIESITUULETINDA EMHÆTTERU ВЫТЯЖКAET PLIIDIKUMMLV TVAIKUNOSŪCĒJSLT DANGTISUK ВИТЯЖКАHU MOTORHÁZTETÕCZ ODSAVAČPARSK KAPUCŇARO CARTIERPL OKAP KUCHENNYHR NAPASL NAPAGR ΑΠΟΡΡΟΦΗΤΗΡΑ …

• Cooke & Lewis CLVHS50a (30 pages) DO NOT PRINT THIS PAGE - IT IS FOR INFORMATION ONLY.V1.123 4 51This file is the property of Kingfisher Group Plc. No copying, alteration or amendment is permitted withoutwritten authorisation from the Kingfisher Brand Team.V1.1PROCESSBLACKSEPARATIONS JOB INFOVERSION #25/10/18William09/11/18William01/10/18NAME01/10/18NAME01/10/18NAMEPID #: 121265_s1_s5, 121 …

• Greenheck Combination Fire Smoke Dampers SSFSD-211 (7 pages) Model SSFSD-211 meets the requirements for fire dampers, smoke dampers and combination fire smoke dampers established by:National Fire Protection Association NFPA Standards 80, 90A, 92A, 92B, 101, & 105ICBO Uniform Building Codes IBC International Building CodesNew York City (MEA listing #260-91-M) SBCCI Standard Building CodesCalifornia State Fire …

Comments, Questions and Opinions: