Manualios.com

Comcater FC54-E Instruction Manual

Comcater FC54-E Manual Online:

3.35, 1366 votes
Comcater FC54-E User Manual
Comcater FC54-E User Guide
Comcater FC54-E Online Manual

Text of Comcater FC54-E User Guide:

  • Comcater FC54-E, 18 FOREWORD 1. Read the instructions contained in the enclosed booklet carefully, because it contains important information on installation, operation and maintenance safety. Store this booklet carefully for any further consultation by other operators. 2. Having removed the packing material, check that all the equipment is present. If there is any doubt, do not use it and contact qualified personnel. The packing elements (plastic bags, foam polystyrene, nails, etc.) should be kept away from children

  • Comcater FC54-E, INSTRUCTIONS FOR THE USER 20 OPERATION AND USE 1)Before washing make sure that: • the wall-mounted on/off switch is switched on; • the water tap is open; • water is present in the distribution network; • the pump protection filters are installed in their respective positions; • the overflow in inserted; • all rotating parts are free; • the rinse aid dispenser is full; • water temperatures maintain their regulated values:wash 55/60°C, rinse 85°C (lamp "H1

  • Comcater FC54-E, INSTRUCTIONS FOR THE USER 21 5)START With closed door, select the wash cycle according to conditions of the dishware: • with normally dirty dishes press "S3" button (rapid flashing of the lamp "H3") (short cycle started); • with particularly dirty dishes or deep dishes, press "S3" button for 3 sec. (slow flashing of the lamp “H3”) (long cycle started). The end of which will be indicated by the swi

  • Comcater FC54-E, INSTRUCTIONS FOR THE USER 22 8)SELF-CLEANING AND DRAIN When the wash operation has been completed (machine off) pull out the overflow pipe, close the front door and press the "S5" button for the self- cleanig and drain cycle. The machine will carry out the cycle (lamp "H5" flashes) for 2 minutes and 20 seconds. The end of which will be indicated by the switching off of the "H5" lamp. At this point, the tank filter can be taken out, in order to be washed, then replace it with the overflow in its place. For further use , switch on the ma

  • INSTRUCTIONS FOR THE USER 24 USEFUL SUGGESTIONS 1) MAINTENANCE IMPORTANT: Before carrying out the cleaning and maintenance operations, disconnect the equipment from the electric supply. Frequently check and clean the nozzles. The frequency of this operation will depend on the quantity of residue

  • INSTRUCTIONS FOR THE USER 25 3) TEMPORARY MACHINE NON-USE In case the machine is stopped for some weeks, it is recommended before closing it to fill the tank and run the machine with clean water, then empty it out, in order to avoid the forming of bad odour and that any residue remains i

  • Comcater FC54-E, INSTRUCTIONS FOR THE USER 25 6) RESINS REGENERATION OF THE WATER SOFTENER (only for machines with built-in water softener) The regeneration of the water softener resins is completely automatic. The flashing of the regeneration lamp “H4” indicates the need to regenerate the resins, in any case the presence of some opaque spots on the glasses will show that it is necessary to start the regeneration. This operation has to be carried out with full tank. First of all, make sure that in the designated tank container “S” there is some regeneration salt (1kg is enough for a

  • Comcater FC54-E, INSTRUCTIONS FOR THE USER 27 CONTROL PANELS Q1 Main switch S3 Push button “CYCLE SELECTION / START CYCLE” S4 Push button “REGENERATION” (mod. FC54-EA) S5 Push button “SELF-CLEANING / DRAIN CYCLE” (machine OFF) Push button “DRAIN CYCLE” (machine ON / door frontal opened) H1-H2 Pilot lamp “MACHINE ON" (flashing) H1-H2 Pilot lamp “MACHINE READY" (fixed) H3 Pilot lamp “MACHINE WORKING" H4 Pilot lamp “REGENERATION” (mod. FC54-EA) H5 Pilot lamp “SELF-CLEANING / DRAIN CYCLE S Salt container (mod. FC54-EA) I Regulating screw for rinse aid

  • 28 INSTALLATION AND MAINTENANCE INSTRUCTIONS The following instructions are addressed to a qualified personnel the only one authorised to carry out checks and repairs, if any. The manufacturer declines any responsibility in the case of interventions made by a non qualified personnel or the use of spare parts other than those supplied by the Manufacture.

  • INSTRUCTIONS FOR TECHNICAL PERSONNEL 29 INSTALLATION 1)During installation, carry out proper machine levelling, which is a prerequisite for a correct operation thereof (max. tolerance 2°). In order to prevent any damage caused by steam going out of the machine, make sure that the surrounding materials do not deteriorate in its presence. After machin

  • Comcater FC54-E, INSTRUCTIONS FOR TECHNICAL PERSONNEL 30 3)WATER CONNECTION Install a 55°C water tap and for machines with cold rinse a 12°C water tip in a well accessible place, terminating in a 3/4" fitting, which the pipe strainer and inlet hose shall be connected to. Carefully comply with any national or regional regulations in force. The operating pressure should be neither less than 2 bars or greater that 4 bars (200/400 kPa). If water pressure is inferior then 2 bar, a pressure increase pump is necessary. If water pressure exceeds 4 bar, a pre

  • Comcater FC54-E, INSTRUCTIONS FOR TECHNICAL PERSONNEL 31 6)DETERGENT DOSAGE (for machines with built-in detergent dispenser) With the screw on the side of the detergent pump, close completely the product intake, then slowly open the screw until the desired intake quantity has been reached. The correct quantity is indicated by the detergent supplier. Check that the intake of the pipe during the rinse cycle is as preset. (1cm = 1g approximately). Maximum intake or delivery distance: 2 meters. To

  • Comcater FC54-E, INSTRUCTIONS FOR TECHNICAL PERSONNEL 32 7) WASH CYCLE SETTING Using the "S5" button it is possible to select different wash cycles according to the type of requirement. Set the cycles time, as follow: A. Turn on the machine by switching on the wall switch and keep pressed "S5" button (lamps "H1-H2, H3 and H5" flash). B. Release the "S5" button. The lamps will show the Short cycle settings (see the table). C.

  • Comcater FC54-E, INSTRUCTIONS FOR TECHNICAL PERSONNEL 33 ENERGY CONSUMPTION Mod. Tank capacity (l) Water consumption per cycle (l) Tank heater (W) booster heater (W) Pump (W) Total power (W) Max hourly production racks with inlet water at 55°C Max hourly production racks with inlet water at 12°C FC54-E 15 3.5 2000 3000 450 3450 30/20 10 FC54-EA 15 3.5 2000 3000 450 3450 30/20 10 In the event of low water supply temperature, the will be a subsequent machine output drop.

  • Comcater FC54-E, INSTRUCTIONS FOR INSTRUCTIONS FOR TECHNICAL PERSONNELTECHNICAL PERSONNEL 33 WIRING DIAGRAM Q1 Main switch S3 Start switch S4 Regeneration switch S5 Self-cleaning / drain switch H1-H2 Pilot lamp power on / machine ready H3 Pilot lamp machine working H4 Pilot lamp regeneration H5 Pilot lamp Self-cleaning/drain cycle A1 Control electronic panel A2 Power electronic panel S1 Door microswitch Y1 Rinse solenoid valve Y4 Regeneration solenoid valve C3 Condensator

Related Products and Documents (Dishwasher):

Comparable Devices:

# Manufacturer Model Document Type File Updated Pages Size
1 Brother PT-2460 Operation & user’s manual brother/pt-2460-PBQ.pdf 19 Jun 2023 116 2.16 Mb
2 Azden 1200BT Specifications azden/1200bt-58E.pdf 06 Mar 2023 2 0.22 Mb
3 DigiTech BP8 Operation & user’s manual digitech/bp8-WX7.pdf 14 Feb 2023 30 1.39 Mb
4 Philips AJB3552 Operation & user’s manual philips/ajb3552-U4L.pdf 11 Dec 2023 33 0.41 Mb
5 American Standard Cascada 30" Vanity 9437.200 Assembly and installation instructions american-standard/cascada-30-vanity-9437-200-526.pdf 19 Jan 2024 3 0.38 Mb
6 InFocus IN42+ Brochure infocus/in42-AIO.pdf 26 Dec 2023 4

Similar Resources:

  • Hobart

    FT1000 Series

    (78 pages)
    701 S. RIDGE AVENUETROY, OHIO 45374-0001937 332-3000www.hobartcorp.comF47504 (October 2014)FT1000-SERIES DISHWASHERSLAVE-VAISSELLE DE LA GAMME FT1000LAVAVAJILLAS SERIE FT1000MODEL ML-130250 COVERS ALL OF THE FOLLOWING MODELSMODÈLE MODELO FT1000FT1000-ERFT1000-ER-BDFT1000SFT1000S-ERFT1000S-ER-BD …
  • Fisher & Paykel

    double drawer DD6051

    (32 pages)
    DishDrawerIntegrated panel preparationUS CADS605I and DD605I modelsDishDrawerPréparation du panneau intégréModèles DS605I et DD605I DishDrawerPreparación del panel integradoModelos DS605I y DD605I …
  • Parmco

    PD6-PSDF-1

    (24 pages)
    Installationand OperatingInstructionsAs part of Parmco Appliances commitment to improving and upda ng product ranges,we reserve the right to alter, change and update technical speci ca ons and appearancea ributes of all Parmco Appliances products. E&OE.Models: PD6-PSDF-1 PD6-PWDF-1727626062014 …
  • Guzzanti

    GZ-8705A

    (187 pages)
    1GZ-8705AMYČKA NÁDOBÍUMÝVAČKA RIADUZMYWARKA DO NACZYŃMOSOGATÓGÉPPOMIVALNI STROJGESCHIRRSPÜLERDISHWASHERSISKHPLCZENDENávod k obsluzeNávod na obsluhuInstrukcja obsługiHasználati útmutatóNavodila za uporaboGebrauchsanleitung Instruction manual …
  • Asko

    D5233XXL

    (32 pages)
    ASKO D5233Operating InstructionsDishwasherSave these instructions for future referenceDear ASKO customer!Thank you for choosing this quality product from Scandinavia, which was made in Sweden.We want you to feel assured that the inside of your new machine is just as good as the outside and that the ethics and standards that went into the production of this …
  • GE

    GLD4209

    (16 pages)
    Owner’s ManualDishwashers165D4700P347 49-55028 09-06 JRSafety Instructions . . . . . . 2, 3Operating InstructionsCare and Cleaning . . . . . . . . . . . . 12Control Panel and Settings . . . 4–7Loading Place Settings . . . . . . . . 11Loading the Racks . . . . . . . . . . . . 10Optional Accessories . . . . . . . . . .11Using the Dishwasher . …

Comments, Questions and Opinions: