Manualios.com

Chrysler Directed Installation Manual

Chrysler Directed Manual Online:

3.85, 2987 votes
Chrysler Directed User Manual
Chrysler Directed User Guide
Chrysler Directed Online Manual

Text of Chrysler Directed User Guide:

  • Chrysler Directed, CHRYSLER13 INSTALLATION GUIDE This product is intended for installation by a professional installer only! Attempts to install this product by a person other than a trained professional may result in severe damage to a vehicle’s electrical system and components. 2016-07-12 © 2016 Directed, Vista CA Directed Digital Solutions Designed by Installers for Installers

  • Chrysler Directed, Contents Warning! Safety first ....................................................................................................................... 3 Introduction .................................................................................................................................... 4 Pre-installation and application warnings ..................................................................................... 4 Vehicle application guide ..........................................................................................

  • Chrysler Directed, 3 Directed Digital Solutions CHRYSLER13 © 2016-07-12 Directed. All rights reserved. Warning! Safety first The following safety warnings must be observed at all times: • Due to the complexity of this system, installation of this product must only be performed by an authorized Directed dealer. • When properly installed, this system can start the vehicle via a command signal from the remote control. Therefore, never operate the system in an area that does not have adequate ventilation. The following precautions are the sole responsibility of the user; however, authorized Directed dealers should: • Never use a test light or logic probe when

  • 4 Directed Digital Solutions CHRYSLER13 © 2016-07-12 Directed. All rights reserved. Introduction The CHRYSLER13 firmware for Directed Digital Solutions is a complete solution for remote start, security (if applicable), bypass interface, and convenience needs compatible with specific Jeep vehicles. Warning! This module can only be programmed via the web tool, whic

  • Chrysler Directed, 5 Directed Digital Solutions CHRYSLER13 © 2016-07-12 Directed. All rights reserved. Vehicle application guide The table below lists the vehicles and features which are compatible with this product. Refer to the following pages for more information on installation wiring, programming and troubleshooting for these vehicles. Vehicles 2016 2015 PK-Immobilizer Bypass-Data No Key Req'd DL-Door Lock Control DL-Door Unlock DL-Trunk / Hatch Release FOB-Control of aftermarket alarm with OEM remote Key2GO RS-SmartStart RS-Tach / RPM Output SS-Entry Mon

  • Chrysler Directed, 6 Directed Digital Solutions CHRYSLER13 © 2016-07-12 Directed. All rights reserved. Wiring connections The wiring connections listed below are specific to this firmware. Main power harness (H1), 12-pin thick gauge connector Conn./Pin Color Description H1/1 White Relay 3 COM – No Connection 1 H1/2 White/Brown Relay 3 N.O. – No Connection 1 H1/3 Brown/Red Relay 2 N.O.– (+) 12 Volt (Battery) H1/4 Yellow/Red Relay 2 COM – (+) Accessory Output H1/5 Orange/Red Relay 2 N.C. – No Connection H1/6 Yellow Relay 1 COM – (-) Lock Input 1 H1/7 White Relay 3

  • Chrysler Directed, 7 Directed Digital Solutions CHRYSLER13 © 2016-07-12 Directed. All rights reserved. Analog harness (H3), 18-pin white connector Conn./Pin Color Description H3/1 Lt. Blue/Red No Connection H3/2 Black/White (-) Parking Brake Input (Manual Transmission) 2 H3/3 Gray (-) Hood Input 2 H3/4 N/A No Connection H3/5 Gray/Black (+) Glow Plug Input 2 H3/6 Violet/White (AC) Tach Input 2 H3/7 Dark Blue (-) Unlock Output 1 H3/8 Brown/Black (-) Horn 1 H3/9 Red/White No Connection 1 H3/10 White/Green (-) Door Input 2 H3/11 Yellow/Green (+) Door Input 2 H3/12 Blue/Red No Connection H3/13 Light Blue (-) Trunk Trigger Input 2 H3/14 Pink/Yellow (-) Activation (S

  • 8 Directed Digital Solutions CHRYSLER13 © 2016-07-12 Directed. All rights reserved. Installation (wiring diagrams & vehicle wiring reference charts) Refer to "Pre-installation and application warnings" on page 4 and "Vehicle wiring reference chart" on page 9 for important information on this installation. 86 85 30 87a 87 12: Brown: (-) Lock Output 3: Br

  • Chrysler Directed, 9 Directed Digital Solutions CHRYSLER13 © 2016-07-12 Directed. All rights reserved. Vehicle wiring reference chart This section provides vehicle wiring information to guide you through the various stages of your installation. Refer to www.directechs.com for additional information. Wire Information Connector Information Function Color Pin Polarity Location Color Pins Ref. Jeep Renegade 2015-2016 HS CAN High Lt. Green 6 Data OBDII diagnostic connector. Black 16 A HS CAN Low Brown 14 Data OBDII diagnostic connector. Black 16 A MS CAN High Blue 3 Data OBDII diagnostic connector. Black 16 A MS CAN Low White 11 Data OBDII diagnostic connector. Black 16 A Parking Lights Whit

  • Chrysler Directed, 10 Directed Digital Solutions CHRYSLER13 © 2016-07-12 Directed. All rights reserved. Key2GO This feature is mandatory to control the immobilizer override in this firmware. Key2GO has been designed and developed to bypass the advanced encryption layers found in modern vehicles. It uses an array of servers to generate a duplicate of the original key, allowing the installation of a remote starter without having to give up a key. The advantage is that this feature allows you to use one original key and the ser

  • Chrysler Directed, 11 Directed Digital Solutions CHRYSLER13 © 2016-07-12 Directed. All rights reserved. Additional connections required for vehicles equipped with a manual transmission (if not supported by firmware) Connection Description (-) E-Brake Status Input (Black/White, pin 2) Must be connected to a working emergency brake in the vehicle. Although most vehicles have simple (-) trigger emergency brake circuits note some vehicles do not and may require unique integration methodologies. (-) Door Trigger Input (White/Green, pin 10) OR (+) Door Input (Yellow/ Green, pin 11) Must be connected to

  • Chrysler Directed, 12 Directed Digital Solutions CHRYSLER13 © 2016-07-12 Directed. All rights reserved. Module programming Refer to "LED diagnostics and troubleshooting" on page 13 for more information and for troubleshooting purposes. To connect the module: 1 Please ensure that the vehicle is in a safe location and cannot move forward during programming. For vehicles equipped with a manual transmission, make sure the gearshift lever is in the neutral position. 2 Connect all the harnesses to the Directed Digital Solutions, EXCEPT the 12-pin main power harness. Connect a

  • Chrysler Directed, 13 Directed Digital Solutions CHRYSLER13 © 2016-07-12 Directed. All rights reserved. LED diagnostics and troubleshooting This section provides LED diagnostics and troubleshooting information to guide you through the various stages of your installation. Module programming LED Description Troubleshooting Off Module has no power. Make sure the D2D harness is connected and that 12 Volt is present between the red and black wires. If 12 Volt is present, the module may be defective. Solid red Waiting to begin the programming sequence. Ensure the correct programming procedure is being followed. Flashes green & red Initializatio

  • Chrysler Directed, 14 Directed Digital Solutions CHRYSLER13 © 2016-07-12 Directed. All rights reserved. External module synchronization LED Description Troubleshooting (Flashes red, red, then orange) x 10 OBDII feature not supported. The diagnostic data bus was not detected, therefore the SmartStart features will be limited. Active Ground When Running (Status) LED Description Troubleshooting Flashes green Ground When Running (Status) command received. The module has initialized the remote start sequence. Flashes red & orange Ignition ON command received. The module

  • 15 Directed Digital Solutions CHRYSLER13 © 2016-07-12 Directed. All rights reserved. Soft reset A module reset will only erase the steps performed in "Module programming" on page 12. The firmware and settings flashed to the module will not be affected. 1 If required for your installation, connect all the harnesses to the Directed Digital Solutions, EXCEPT the 12-pin main power harne

  • Chrysler Directed, 16 Directed Digital Solutions CHRYSLER13 © 2016-07-12 Directed. All rights reserved. Learning the Tach (not needed with Virtual Tach) Tach comes preprogrammed, therefore learning is not required; however, it can be readjusted with the following operations: 1. Start the vehicle using the key. 2. Within 5 seconds, press and hold the Control Center* (antenna) or the main module programming button, until the LED on the Control Center (antenna) or the main module turns ON solid. 3. Release the button. Tachometer value is now stored in memory. If the LED does not turn ON solid, find an alternate tac

  • 17 Directed Digital Solutions CHRYSLER13 © 2016-07-12 Directed. All rights reserved. Limited lifetime consumer warranty Directed Electronics. (“Directed”) promises to the original purchaser to repair or replace (at Directed’s election) with a comparable reconditioned model any Directed unit (hereafter the “unit”), excluding without limitation the

  • Chrysler Directed, Directed Digital Solutions CHRYSLER13 © 2016-07-12 Directed. All rights reserved. Quick Reference Guide SmartStart compatible This system is compatible with Directed SmartStart. For a complete list of supported features, please visit www.mysmartstart.com. What is SmartStart? Now you can remote start, lock and unlock your car just by pushing a button on your smartphone; using the SmartStart App from Directed, the leader in vehicle security and remote start. The simple graphical interface gives you control over the following features of your installed remote start or security with remote start system: • Lock/Arm • Unlock/Disarm • Remote Car Sta

Related Products and Documents (Car Alarm):

Comparable Devices:

# Manufacturer Model Document Type File Updated Pages Size
1 Frigidaire FGFL67DSF Service data sheet frigidaire/fgfl67dsf-8W5.pdf 30 Nov 2022 2 0.82 Mb
2 LEXIBOOK MT1500 Quick start up manual lexibook/mt1500-R4D.pdf 30 Sep 2023 1
3 CLASSÉ AUDIO CDP-102 Owner's manual classe-audio/cdp-102-8SE.pdf 22 Jul 2023 42 1.57 Mb
4 CHIEF RPA4000 Brochure chief/rpa4000-1LM.pdf 29 Nov 2023 4 0.49 Mb
5 Sound Storm E10D Operation & user’s manual sound-storm/e10d-16Z.pdf 19 Dec 2023 3 0.46 Mb
6 Cooper Lighting Interior Wall Luminaire 651 Series Specification sheet cooper-lighting/interior-wall-luminaire-651-series-783.pdf 05 Sep 2023 2 0.33 Mb

Similar Resources:

  • Autostart

    AS-2350vTW-FM

    (1 pages)
    1. (-) Aux 2 output2. (-) AUX 1 output3. (-) Parking lights1. GRAY/LIGHT BLUE ... (-) AUX 2 output2. BLUE/WHITE ... (-) AUX 1 output3. YELLOW..........(-)PARKING LIGHTS12- YELLOW .......................... (+) Glow plug input11- GREY ............................... (-) NEG. Door input 10- WHITE .............................. (-) GROUND when running9- PURPL …
  • Code Alarm

    ca5553sst

    (49 pages)
    CCCJc:~lA~m r:»~OFESSIONAI SE~IES Automatic I Manual Transmission Remote Start with Keyless Entry Installation Guide for models: ca5553sst 2012 Audiovox Electronics Corporation. All rights reserved. 4280478 …
  • Webasto

    Thermo Top C

    (31 pages)
    Water Heater UnitThermo Top C Additional HeaterLegend for Figure 11 Thermo Top C -B heater unit2 Blade-type fuse holder3 Exhaust muffler 4 Combustion-air intake pipe5 Telestart receiver, Thermo Call6 Metering pump7 Gateway control unitWARNING!Hazard warning:Incorrect installation or repair of Webasto heating and cooling systems may cause a fire or result in …
  • MeiTrack

    MVT380

    (7 pages)
    File Name: MVT380 User Guide Creator: Project: MVT380 Creation Date: 2010-08-26 Sub Project: User Guide Page: 1 of 7 Revision: V1.02 Confidential: External Documentation MVT380 USER GUIDE …
  • Ultra Start

    2250 SERIES

    (12 pages)
    -The system must be placed into Service Mode before any service work is started on the vehicle. It isthe sole responsibility of the vehicle owner to ensure that this is done. The manufacturer accepts noliability or responsibility for accidental starting of the vehicle.- CARBON MONOXIDE - Never Start in an Enclosed Building (Garage, Carport etc...)- The Hood …
  • Omega Vehicle Security

    Excalibur RS-11

    (14 pages)
    REMOTE STARTERCOPYRIGHT: OMEGA RESEARCH & DEVELOPMENT 2007FOR AUTOMATIC TRANSMISSION VEHICLES ONLYproduct sold by the Company proves to be defective, the Company will repair or replace it freeof charge within the first year and thereafter all parts to be repaired will be free with only anominal charge for Omega Research and Development, Inc.'s lab …

Comments, Questions and Opinions: