ARGtek POWER KING-X ARG-1210 Quick Installation Manual

Text of ARGtek POWER KING-X ARG-1210 User Guide:

• ARGtek POWER KING-X ARG-1210, ARGtek Communication Inc. www.argtek.com E-Mail:[email protected] Tel:+ 886-2-2999-6958 Fax :+ 886-2-2999-7742 ARGtek ARG-1210 WLAN AP Router For 802.11b/g/n POWER KING-X Quick Installation Guide Ver. 08.11

• ARGtek POWER KING-X ARG-1210, ARGtek Communication Inc. www.argtek.com E-Mail:[email protected] Tel:+ 886-2-2999-6958 Fax :+ 886-2-2999-7742 Part I: External Installation Direction Package Content AP Router 1 DC 12V Power Adapter 1 Antenna 2 PoE DC Injector 1 Paper QIG 1 Manual/QIG CD 1 AP Router Connection Before installing the router, please connect your PC to the internet through your internet service provider.

• ARGtek POWER KING-X ARG-1210, ARGtek Communication Inc. www.argtek.com E-Mail:[email protected] Tel:+ 886-2-2999-6958 Fax :+ 886-2-2999-7742 1. Turn off your PC(s), cable/ ADSL modem and the router. 2. Adjust the antenna if needed. Normally, straight up on router is good. 3. Connect the PC(s) and each switch/hub on your local area network to the LAN ports on the router. 4. Connect the ADSL/DSL/cable modem to the router WAN port. 5. Connect the power adapter between the DC-Jack on the router and an electrical outlet. The router will start to work automatically. 6. Turn on your PC(s) and th

• ARGtek POWER KING-X ARG-1210, ARGtek Communication Inc. www.argtek.com E-Mail:[email protected] Tel:+ 886-2-2999-6958 Fax :+ 886-2-2999-7742 AP Router configuration The AP Router is delivered with the following factory default parameters on the Ethernet LAN interfaces. Default IP Address: 192.168.1.254 Default IP subnet mask: 255.255.255.0 Web login User Name: <empty> Web login Password: <empty> The device has three operation modes: 1, Gateway 2, Bridge 3, WISP The default IP addresses for the device are 192.168.1.254, and you need t

• ARGtek POWER KING-X ARG-1210, ARGtek Communication Inc. www.argtek.com E-Mail:[email protected] Tel:+ 886-2-2999-6958 Fax :+ 886-2-2999-7742 PoE DC Injector Configuration PPOE stands for Power over Ethernet, and it is usually used with Wireless Device. You can use it to integrate the power and the Ethernet then connected with the RJ45 cable. With POE, you can bring the power and Ethernet together in one cable for long distance as far as the RJ45 cable can reach. Part II: Internal Web Management

• ARGtek POWER KING-X ARG-1210, ARGtek Communication Inc. www.argtek.com E-Mail:[email protected] Tel:+ 886-2-2999-6958 Fax :+ 886-2-2999-7742 1, Gateway: AP Mode Setup (ADSL) 1-1. Install the antenna & power adapter, and then connect the LAN cable with LAN port of this equipment. Another side of cable line connects with network card of computer. Please wait for reboot around 20 seconds. 1-2. Open the IE (or other browser) and type http://192.168.1.254 on URL to enter the setup frame. If you can’t enter to setup frame, please press Reset button around 10 seconds to restore AP and try to enter again. 1-3. Select the Setup Wizard on the left

• ARGtek Communication Inc. www.argtek.com E-Mail:[email protected] Tel:+ 886-2-2999-6958 Fax :+ 886-2-2999-7742 1-5. In Time Zone Setting, if you don’t need any change, please press Next>> 1-6. In LAN Interface Setup, you may change the setting of IP address, DHCP and etc. Then press Next>> 1-7. In WAN Interface Setup, select PPPoE C

• ARGtek POWER KING-X ARG-1210, ARGtek Communication Inc. www.argtek.com E-Mail:[email protected] Tel:+ 886-2-2999-6958 Fax :+ 886-2-2999-7742 1-8. In Wireless Basic Setting, select AP Mode and change your SSID name, then press Next>> 1-9. In Wireless Security, select your setup of wireless security (WEP, WPA) and press Finished to reboot, and wait for 20 seconds for reboot.

• ARGtek POWER KING-X ARG-1210, ARGtek Communication Inc. www.argtek.com E-Mail:[email protected] Tel:+ 886-2-2999-6958 Fax :+ 886-2-2999-7742 Note: You have to connect ADSL cable with WAN port on Gateway Mode 2. AP Mode Setup (IP Share)

• ARGtek POWER KING-X ARG-1210, ARGtek Communication Inc. www.argtek.com E-Mail:[email protected] Tel:+ 886-2-2999-6958 Fax :+ 886-2-2999-7742 2-1. Install the antenna & power adapter, and then connect the LAN cable with LAN port of this equipment. Another side of cable line connects with network card of computer. Waiting for reboot around 20 seconds. 2-2. Open the IE (or other browser) and type http://192.168.1.254 on URL to enter the setup frame. If you can’t enter to setup frame, please press Reset button around 10 seconds to restore AP and try to enter again. 2-3. Select the Setup Wizard on the left side of setup frame and press Next>> 2-4 . In O

• ARGtek POWER KING-X ARG-1210, ARGtek Communication Inc. www.argtek.com E-Mail:[email protected] Tel:+ 886-2-2999-6958 Fax :+ 886-2-2999-7742 2-5. In Time Zone Setting, if you don’t need any change, please press Next>> 2-6. In LAN Interface Setup, you may change the setting of IP address, DHCP and etc. then press Next>>

• ARGtek Communication Inc. www.argtek.com E-Mail:[email protected] Tel:+ 886-2-2999-6958 Fax :+ 886-2-2999-7742 2-7. In WAN Interface Setup, select DHCP Client for your connection of WAN Access Type and press Next>> 2-8. In Wireless Basic Setting, select AP for your Mode and change your SSID setup, then press Next>>

• ARGtek POWER KING-X ARG-1210, ARGtek Communication Inc. www.argtek.com E-Mail:[email protected] Tel:+ 886-2-2999-6958 Fax :+ 886-2-2999-7742 2-9. In Wireless Security, select your setup of wireless security (WEP, WPA) and press Finished to reboot, and wait for 20 seconds for reboot. 2-10. Select the TCP/IP Settings from left side of setup frame and choice LAN Interface. Then choosing Disable from DHCP and press Apply Changes to reboot around 20 seconds to complete the setup.

• ARGtek Communication Inc. www.argtek.com E-Mail:[email protected] Tel:+ 886-2-2999-6958 Fax :+ 886-2-2999-7742 Note: Please connect cable line with LAN port when you use Bridge Mode to connect IP Share.

• ARGtek Communication Inc. www.argtek.com E-Mail:[email protected] Tel:+ 886-2-2999-6958 Fax :+ 886-2-2999-7742 3. WISP Mode Setup (IP Share) 3-1. Install the antenna & power adapter, and then connect the LAN cable with LAN port of this equipment. Another side of cable line connects with network card of computer. Please wait for reboot around 20 seconds. 3-

• ARGtek POWER KING-X ARG-1210, ARGtek Communication Inc. www.argtek.com E-Mail:[email protected] Tel:+ 886-2-2999-6958 Fax :+ 886-2-2999-7742 3-5. In Time Zone Setting, if you don’t need any change, please press Next>> 3-6. In LAN Interface Setup, you may change the setting of IP address, DHCP and etc. then press Next>>

• ARGtek POWER KING-X ARG-1210, ARGtek Communication Inc. www.argtek.com E-Mail:[email protected] Tel:+ 886-2-2999-6958 Fax :+ 886-2-2999-7742 3-7. In WAN Interface Setup, select PPPoE for your connection of WAN Access Type and enter User Name & Password which presented by your ISOP. And then press Next>> Note: Connecting Telecom Access Point usually is based on PPPoE, but in general, a pure connection is via Static IP or DHCP Client.

• ARGtek POWER KING-X ARG-1210, ARGtek Communication Inc. www.argtek.com E-Mail:[email protected] Tel:+ 886-2-2999-6958 Fax :+ 886-2-2999-7742 3-8. In Wireless Basic Setting, select Client for your Mode and change your SSID setup, then press Next>> 3-9. In Wireless Security, select your setup of wireless security (WPA) and press Finished to reboot around 20 seconds, and wait for 20 seconds for reboot. Note: Please connect cable line with LAN port when you use WISP Mode.

More Instructions:

ARGtek POWER KING-X ARG-1210 Quick installation manual 13-08-2023 18

DOWNLOAD

Related Products and Documents (Network Router):

Comparable Devices:

Similar Resources:

• NETGEAR DG834Gv3 - 54 Mbps Wireless ADSL Firewall Modem (2 pages) DG834G54 Mbps Wireless ADSL Firewall Routerwith 4-port 10/100 Mbps switchWireless or Wired Instant Broadband Access with Internet SharingThis 802.11g wireless router adds considerable power and flexibility to your network. Five products in one, it combines an ADSL modem, router, 10/100 LAN switch, 802.11gaccess point, and SPI Double Firewall. It gives you un …

• Parkside POF 1200 A1 (77 pages) IAN 90981 ROUTER POF 1200 A1 OBERFRÄSE Bedienungs- und Sicherheitshinweise Originalbetriebsanleitung ROUTER Operation and Safety Notes Translation of original operation manual FREZARKA GÓRNOWRZECIONOWA Wskazówki dotyczące obsługi i bezpieczeństwa Tłumaczenie oryginalnej instrukcji obsługi NAMIZNI REZKALNIK Navodila za upravljanje …

• Cisco 2600 Series (142 pages) About This Guide ixAbout This GuideThis preface discusses the objectives, audience, organization, and conventions of thisnetwork module hardware installation guide.ObjectivesThis publication provides hardware installation information for Cisco network modulesused in Cisco 3600 series and Cisco 2600 series modular access routers, referred to asCisco modular …

• NETGEAR FS108PNA (1 pages) 131322 Unpack the Box and Verify the ContentsWhen you open the box, verify that you received everything. The package includes:・ ProSafe 8 Port Fast Ethernet Switch with 4 Port PoE FS108P・ AC power adapter and power cord・ Wall-mounting screws・ FS108P Installation Guide (this document)・ Warranty and support information cardIf you …

• ORiNG IGS-P9164 Series (2 pages) IGS-P9164GC-HVPWRPWR1PWR210/1 00/10 00TG8G6G4G2G7G5G3G1G20G19G16G14G12G10G15G13G11G9G18G17FailClos eFailOpenV-/NV+/LV-/NV+/LRela yPWR2PWR1IGS-P9164GC-LVPWRPWR1PWR210/1 00/10 00TG8G6G4G2G7G5G3G1G16G14G12G10G15G13G11G9V1+V1-PWR1Rela yCOMFail O penFail C loseV2+V2-PWR2G20G19G18G17IGS-P9164GF(X)-HVPWRPWR1PWR210/1 00/10 00TG8G6G4G2G7G5G3G1G20(P20 )G19(P19 )1000 X …

• AudioCodes Mediant 1000B (1281 pages) User's Manual AudioCodes Family of Media Gateways & Session Border Controllers (SBC) Mediant™ 1000B Gateway & Enterprise SBC Version 7.2 …

Comments, Questions and Opinions: