Manualios.com

Alesis ML-9600 Addendum To Owner's Manual

Alesis ML-9600 Manual Online:

4.5, 2237 votes
Alesis ML-9600 User Manual
Alesis ML-9600 User Guide
Alesis ML-9600 Online Manual

Text of Alesis ML-9600 User Guide:

  • Alesis ML-9600, Chapter 2 ALESIS ML-9600 REFERENCE MANUAL 1.00 5 Pressing DOWN/NO while this screen is displayed will cancel the Join operation and return the machine to its previous state. Pressing UP/YES while this screen is displayed will cause Track 2 to be joined to Track 1, removing the inter-Track gap, if one exists. TIP: If you are previewing a Join and notice that the transition from Track to Track seems abrupt, or if you notice a "pop" or a "click" at the transition point, try applying a short (10mS) fade

  • Alesis ML-9600, Chapter 4 ALESIS ML-9600 REFERENCE MANUAL 1.00 17 Figure 4.5.1 Start and End Time Offset Page The cursor defaults under the "St Offset" field; if you press UP/YES while in this field the "En Offset" parameter will be displayed. To the right of the offset field is the "Offset Amount" field. Pressing CURSOR RIGHT will move the cursor to the offset amount field, where pressing the UP/YES or DOWN/NO buttons will adjust the offset amount between 0 and 30 CD frames (0 and 40

  • Alesis ML-9600, Chapter 2 ALESIS ML-9600 REFERENCE MANUAL 1.00 3 NEW PLAYLIST EDIT FEATURES 2.1 SEAMLESS "ADJACENT TRACK" TRANSITIONS In version 1.xx software, two adjacent tracks would always play back with a miniscule amount of silence between them, even if the start time of the second Track was equal to the end time of the first Track. This was due to the way the MasterLink handled Audio Files and Tracks in a playlist. In Version 2.0, adjacent tracks play back with no audible gap; the Tracks will have adjacent

  • Alesis ML-9600, Chapter 3 ALESIS ML-9600 REFERENCE MANUAL 1.00 11 Figure 3.4.1 Render DSP Page Pressing the DOWN/NO button in this page will have no effect. Pressing the UP/YES button will prompt you with an "Are you sure? Y/N" message. Pressing DOWN/NO will cancel the DSP Render operation. Pressing UP/YES in this screen will render all DSP parameters (Track Gain, Compression parameters, EQ parameters, Limiter parameters, Normalizer parameters, and Track Fade parameters) to the destination track. APPLICATION NOTE: It is sometimes necessary to apply DSP to a specific

  • Alesis ML-9600, Chapter 1 2 ALESIS ML-9600 REFERENCE MANUAL 1.00 MasterLink software updates occur via a special "MLOS" (MasterLink Operating System) CD- ROM. If you do not have Version 2.00 software, there are several options available to you: • Call 1-800-5ALESIS and choose "Option 1" to have a free update MLOS disc sent to you. • Contact your nearest Alesis dealer for the update. • If you have a computer with Internet access and a CD-R drive, you can download a CD- ROM "image" and create your own MLOS disc. Simply go to http://www.alesis.com/product

  • Alesis ML-9600, Chapter 2 ALESIS ML-9600 REFERENCE MANUAL 1.00 7 Figure 2.7.1 Audio File In Use Warning In Version 1.xx software, the only way to delete an Audio File that was in use was to find every Track in every playlist that pointed to that Audio File and delete each Track. New to version 2.0 software is the ability to override the warning and automatically delete all of the Tracks associated with the Audio File you wish to delete. After temporarily displaying the "Audio File In Use" screen, the override screen will be displayed, as shown in Figure 2.7.2. F

  • Alesis ML-9600, Chapter 2 4 ALESIS ML-9600 REFERENCE MANUAL 1.00 Track Split Confirmation Screen Pressing DOWN/NO while this screen is displayed will cancel the Split operation and return the machine to its previous state. Pressing UP/YES while this screen is displayed will cause the track to be split at the TRACK START pointer. Because MasterLink defaults to 0.0 seconds of "gap" between Tracks, the audio during the transition from the first track to the second track will play back seamlessly, as if the track had not been split. However, if the original Track had DSP applied

  • Alesis ML-9600, Chapter 3 ALESIS ML-9600 REFERENCE MANUAL 1.00 9 NEW TRACK DSP F EATURES 3.1 COPY DSP SETTINGS New to Version 2.0 software is the ability to copy and paste DSP settings between tracks, even between tracks in different playlists. All of the Track DSP parameters are copied and pasted at once, including Track Gain, Compression parameters, EQ parameters, Limiter parameters, Normalizer parameters, and Track Fade parameters. To copy the DSP settings from a Track, first select the playlist and track from which you wish to copy (your "source" Track), then press the TRACK DSP button repeatedly until DSP Page 5 is displayed, as shown in Figure 3.1.1. Figure 3.1.1 Copy DSP Settings Page P

  • Chapter 4 14 ALESIS ML-9600 REFERENCE MANUAL 1.00 Figure 4.2.1 Playlist Backup Page Pressing the DOWN/NO button in this page will have no effect. Pressing the UP/YES button will prompt you with an "Are you sure? Y/N" message. Pressing DOWN/NO at that point will cancel the Playlist Backup operation. Pressing UP/YES at the prompt will begin the backup process. If there is no blank CD in

  • Alesis ML-9600, Chapter 4 ALESIS ML-9600 REFERENCE MANUAL 1.00 13 NEW UTILITY FEATURES In MasterLink Version 2.0 software, the Utility Pages have been expanded from four pages to nine pages, and have been re-ordered for better ease of use. 4.1 TRACK/PLAYLIST/CD LOOP It is sometimes desirable to loop a Track or a CD when playing back audio. New to Version 2.0 software is the ability to loop Tracks, CD Tracks, Playlists, and entire CDs. To access the various Loop modes, press the UTILITY button repeatedly until Utility Page 2 is displayed, as shown in Figure 4.1.1. Figure 4.1.1 Loop Mode Page The MasterLink defaults to "Loop Off"; pressing UP/YES once will change the

  • Alesis ML-9600, Chapter 4 16 ALESIS ML-9600 REFERENCE MANUAL 1.00 4.4 RENDER PLAYLIST TO DISK There are some instances where you may wish to render a Playlist to the hard drive, but do not want to immediately burn a CD; for instance, you may wish to audition the rendered image before committing to a CD. Version 2.0 software gives you the flexibility to render your playlist without burning a CD. To initiate a Playlist Render, press the UTILITY button repeatedly until Utility Page 5 is displayed, as shown in Figure 4.4.1. Figure 4.4.1 Render Playlist to Image Page Pressing the DOWN/NO button in this page will have no effect. Pressing the UP/YES button will promp

  • Alesis ML-9600, Table Of Contents ALESIS ML-9600 REFERENCE MANUAL 1.00 TABLE OF CONTENTS Introduction.....................................................................................................1 1.1 Version 2.00 Highlights .................................................................................................................1 1.2 How Do I Get Version 2.00 Software? ..........................................................................................1 New Playlist Edit Features .........................................................

  • Chapter 1 ALESIS ML-9600 REFERENCE MANUAL 1.00 1 INTRODUCTION Congratulations on your purchase of an Alesis MasterLink! In a continuing effort to provide our MasterLink customers with the utmost in mastering convenience, we are pleased to announce the debut of MasterLink operating system software version 2.0. Version 2.0 software is packed with over twenty all-new featur

  • Alesis ML-9600, Chapter 3 10 ALESIS ML-9600 REFERENCE MANUAL 1.00 Paste DSP Settings Page Pressing the DOWN/NO button in this page will have no effect. Pressing the UP/YES button will paste all DSP parameters from the temporary RAM buffer into the destination track. This process leaves the RAM buffer intact, so multiple pastes are possible without having to re- copy each time. 3.3 RESET DSP SETTINGS If you just want to "zero" the DSP settings on a Track, returning them to the factory defaults and turning them off, you can use the Reset D

  • Alesis ML-9600, Chapter 4 20 ALESIS ML-9600 REFERENCE MANUAL 1.00 If the destination Playlist already has one or more Tracks in it, the display will prompt "PList not empty. Proceed?" Pressing DOWN/NO will cancel the CD move operation. Pressing UP/YES will begin to copy the entire CD into the destination playlist, with the first CD track placed after the last Track in the playlist. 5.2 PLAYLIST EXCEEDS DISC CAPACITY... MasterLink version 2.0 software now lets you know exactly at which Track a Playlist exceeds the capacity of a Red Book or CD24 disc. In previous versions of software, if a Playlist was too large to fit on a CD, you would be prompted

More Instructions:

DOWNLOAD

Related Products and Documents (CD Player):

Comparable Devices:

# Manufacturer Model Document Type File Updated Pages Size
1 Main Resource Isoetec EZ-1 Manual  main-resource/isoetec-ez-1-797.pdf 18 Feb 2023 7
2 Vinotemp WINE-MATE WM-4500SSLWC Installation, operation & care manual vinotemp/wine-mate-wm-4500sslwc-5DM.pdf 15 Mar 2024 28 0.59 Mb
3 Craftsman 917.254661 Owner's manual craftsman/917-254661-P6Z.pdf 25 Dec 2022 26 3.19 Mb
4 Philips LC5141 Operation & user’s manual philips/lc5141-32C.pdf 20 Mar 2023 24 0.66 Mb
5 Sterling E040500 Installation instructions sterling/e040500-6W5.pdf 05 Sep 2022 2 0.22 Mb
6 COMPX C8754 Manual  compx/c8754-R3U.pdf 15 Jul 2023 1 0.13 Mb

Similar Resources:

  • Sony

    CDP-XE800

    (25 pages)
    — 1 —Model Name Using Similar Mechanism NEWCD Mechanism Type CDM36-14Base Unit Type BU-14Optical Pick-up Type KSS-213B/S-NSPECIFICATIONSMICROFILMCDP-XE800COMPACT DISC PLAYERAEP ModelSERVICE MANUAL …
  • Alpine

    CHM-S665RF - CD Changer

    (40 pages)
    1R• OWNER'S MANUALPlease read this manual to maximize yourenjoyment of the outstanding performance andfeature capabilities of the equipment, then retainthe manual for future reference.• MODE D'EMPLOIVeuillez lire ce mode d'emploi pour tirerpleinement profit des excellentes performances etfonctions de cet appareil, et conservez-le pourtoute …
  • Bose

    Acoustic Wave Music System II

    (204 pages)
    ACOUSTIC WAVE® SOUNDLINK™ ADAPTERFOR THE BOSE® ACOUSTIC WAVE® MUSIC SYSTEM IIOwner’s Guide | Bedienungsanleitung | Guía de usuario | Notice d’utilisation | Manuale di istruzioni Gebruiksaanwijzing | | | | ©2009 Bose Corporation, The Mountain,Framingham, MA 01701-9168 USAAM323699 Rev.00ACOUSTIC WAVE® SOUNDLINK ADAPTERLightwave AWMS Acc cover. …
  • Sony

    DNE330 - Walkman Cd MP3 Atrac Player

    (30 pages)
    SERVICE MANUALPORTABLE CD PLAYERUS ModelUK ModelD-NE330E ModelD-NE330/NE331SPECIFICATIONSD-NE330/NE331Photo: D-NE330Ver. 1.0 2005.12Model Name Using Similar Mechanism D-NE320/NE321CD Mechanism Type CDM-3325ERV2Optical Pick-up Name DAX-25EV9-879-984-012005L05-1© 2005.12Sony CorporationPersonal Audio DivisionPublished by Sony Engineering Corporation– Conti …
  • Sony

    CD-PC50

    (16 pages)
    SON'YoCompact Disc PlayerCDP-C40CDP-C503-769-921-23 (2)DIGITAL AUOtOOperating InstructionsBefore operating the unit, please read this manual thoroughlyand retain it for future reference.CDP-C50Difference between the CDP-C40 and the CDP-C50This manual covers the CDP-C40 and the CDP-C50.Their performance and operation are identical except that for the CDP …
  • Sony

    CFD-V77S

    (76 pages)
    CFD-V77SAEP ModelE ModelSERVICE MANUALCD RADIO CASSETTE-CORDERMICROFILMSPECIFICATIONSCD player sectionSystem Compact disc digital audio systemLaser diode properties Material: GaAlAsWavelength:780 nmEmission duration : ContinuousLaser output : Less than 44.6 µW(This output is the value measured at adistance of about 200 mm from the objectivelens surface on t …

Comments, Questions and Opinions: