Manualios.com

Panasonic HIT Power 225A General Installation Manual

  • HIT Power 225A Solar panel
  • maK68Lu1FD6Ew
  • General Installation Manual
  • PDF / Adobe Acrobat Reader
  • 10

Panasonic HIT Power 225A Manual Online:

3, 808 votes
Panasonic HIT Power 225A User Manual
Panasonic HIT Power 225A User Guide
Panasonic HIT Power 225A Online Manual

Text of Panasonic HIT Power 225A User Guide:

  • Panasonic HIT Power 225A, General Installation Manual © Feb 2012, SANYO Electric Co., Ltd. All Rights Reserved 1 General Installation Manual for Panasonic HIT ® Photovoltaic Modules, manufactured by SANYO. Please read this manual carefully before installing or using Panasonic modules. This manual applies to the following HIT Power products: HIT Power 225A (VBHN225AA01) HIT Power 220A (VBHN220AA01) HIT Power 215A (VBHN215AA01) HIT Power 210A (VBHN210AA01) INTRODUCTION Thank you for choosing Panasonic HIT photovoltaic (PV) modules. With proper operation and maintenance, Panasonic HIT PV modules will provide you with clean, renewable solar electr

  • Panasonic HIT Power 225A, General Installation Manual © Feb 2012, SANYO Electric Co., Ltd. All Rights Reserved 2 may contribute to fire hazards. Additional devices such as ground fault, fuses, and disconnects may be required. • Do not use modules of different specifications in the same system. • Follow all safety precautions of other system components which are used. UL Listing Information To satisfy UL requirements, when installing the modules, be sure to: 1) Use only stranded or solid copper single–conductor sunlight- resistant cable rated for outdoor use (e.g. type UF or USE) , for all wiring that is exposed to weather. 2) Observe the requirements described in s

  • General Installation Manual © Feb 2012, SANYO Electric Co., Ltd. All Rights Reserved 3 Ground Location (smaller holes for self-tapping screw) Junction Box Label Backside The ground holes are on the backside of the module frame. Figure 3.1 Module Ground Position Ground Location ( lar g er holes for bolt and nut ) time of shipment, Sanyo guarantees the output l

  • General Installation Manual © Feb 2012, SANYO Electric Co., Ltd. All Rights Reserved 4 ¾ All fasteners (nuts, bolts, washers, screws, etc.) must be stainless steel unless otherwise specified. • Length of self-tapping screw or bolt should not be more than 0.78’’ (20 mm) in order to avoid contacting the back-sheet of the module. • Accept

  • Panasonic HIT Power 225A, General Installation Manual © Feb 2012, SANYO Electric Co., Ltd. All Rights Reserved 5 • If using this method, please follow instructions in previous section regarding using bolts and nuts with larger grounding holes. • Use a grounding tin plated solid copper lay-in lug rated for direct burial and outdoor use. Lug must be used ILSCO GBL-4DBT, Burndy CL501TN. • Attach grounding lug to module frame using a stainless steel bolt and lock-nut as shown in figure 3.5. • Tighten stainless steel set screw at the torque specified by lug manufacturer to secure copper wire. • Recommended torque value in tightening bolt and nut is 2.3 N.m (20in-lb). Using

  • Panasonic HIT Power 225A, General Installation Manual © Feb 2012, SANYO Electric Co., Ltd. All Rights Reserved 6 MAINTENANCE • Some maintenance is recommended to maintain optimal output performance of the solar modules. • If the module surface becomes dirty, it may reduce output power. • It is recommended to clean the surface of the module with water and a soft cloth or sponge, twice or more per year. • A mild non-abrasive detergent may be applied for persistent dirt. • It is also recommended to inspect the electrical and mechanical connections annually. • If you need electrical or

  • Panasonic HIT Power 225A, General Installation Manual © Feb 2012, SANYO Electric Co., Ltd. All Rights Reserved 7 Cup washer (Terminal cup) (Stainless steel or *brass) Figure 3.2 (Method 1) Grounding method using self-tapping screw Note: Use the smaller ground holes illustrated in Figure 3.1. Frame (Longer side) Ground wire (#12AWG) (wound around the screw) Flat washer (Stainless steel) Spring washer (Stainless steel) Self-tapping screw (Stainless steel) #10-32 Grounding hole (0.165’‘ diameter (4.2 mm) ) Glass Length (not less than 0.47’‘(12 mm) not

  • Panasonic HIT Power 225A, General Installation Manual © Feb 2012, SANYO Electric Co., Ltd. All Rights Reserved 8 Figure 3.4 Grounding method Using self-tapping screw Note: Use the smaller ground holes illustrated in Figure 3.1. Select a grounding the following lug. ILSCO GBL-4DBT, Burndy CL501TN Figure 3.5 Grounding method Using bolt and nut Note: Use the larger ground holes illustrated in Figure 3.1. Select a grounding the following lug. ILSCO GBL-4DBT, Burndy CL501TN Glass Backsheet Frame (Longer side) Grounding hole (0.205�

  • Panasonic HIT Power 225A, General Installation Manual © Feb 2012, SANYO Electric Co., Ltd. All Rights Reserved 9 Figure 3.6 Grounding method Using Grounding Clip with self-tapping screw Note: Use the smaller ground holes illustrated in Figure 3.1. Grounding Clip Assemblies: Tyco Electronics 1954381-1. Figure 3.7 Grounding method Using Grounding Clip with bolt and nut Note: Use the larger ground holes illustrated in Figure 3.1. Grounding Clip Assemblies: Tyco Electronics 1954381-2 Glass Backsheet Frame (Longer side) Grounding hole (0.205” diameter (5.2mm)) Grounding Clip 8-32 Screw (Stainless steel) Nut (

  • Panasonic HIT Power 225A, General Installation Manual © Feb 2012, SANYO Electric Co., Ltd. All Rights Reserved 10 Model HIT Power 225A HIT Power 220A HIT Power 215A HIT Power 210A (VBHN225AA01) (VBHN220AA01) (VBHN215AA01) (VBHN2 10AA01) Cell Number in Series 72 72 72 72 Rated Power, Watts (Pmax) 225 220 215 210 Maximum Power Voltage (Vpm) 43.4 42.7 42.0 41.3 Maximum Power Current ( Ipm) 5.21 5.17 5.13 5.09 Open Circuit Voltage (Voc) 53.0 52.3 51.6 50.9 Short Cir cuit Cur rent (Isc) 5.66 5.65 5.61 5.57 Cell Type HIT HIT HIT HIT Maximum System Voltage (Voc) 600 600 600 600 Factory Installed Bypass Diodes 3 3 3 3 Maximum series fuse (A) 1515151

Related Products and Documents (Solar panel):

Comparable Devices:

# Manufacturer Model Document Type File Updated Pages Size
1 Kipor Sinemaster IG2600 Operation manual kipor/sinemaster-ig2600-M86.pdf 07 May 2023 22
2 Roadstar CD-900USMP Instruction manual roadstar/cd-900usmp-5G2.pdf 15 Jan 2024 38 0.32 Mb
3 BenQ T904 Operation & user’s manual benq/t904-3P5.pdf 20 Jan 2024 53 6.3 Mb
4 marklin mini-club Elektrolok BR 101 Starlight 88675 Operation & user’s manual marklin/mini-club-elektrolok-br-101-starlight-88675-3OL.pdf 13 Aug 2023 12
5 Siemens Gigaset SL55 Operation & user’s manual siemens/gigaset-sl55-2CE.pdf 09 Aug 2023 144 2.48 Mb
6 Rockford Fosgate RFRZ-PMX0DK Installation and operation manual rockford-fosgate/rfrz-pmx0dk-NL3.pdf 16 Apr 2023 12

Similar Resources:

  • ET Solar

    ET-P654 series

    (10 pages)
    INSTALLATION MANUAL(UL) ET SOLAR SERIES MODULEContact Information Of Manufacturer: You may contact our regional branches for questions and services: Please consult your dealer or the manufacturer concerning the warranty of your modules. If you have any further questions, your dealer and ET Solar will gladly assist you. Subject to technical modificaon …
  • Sunsystem

    PK SL AL Series

    (16 pages)
    TECHNICAL PASSPORT INSTALLATION and OPERATION MANUAL For SOLAR COLLECTORS - РК SL AL With full plate aluminum absorber model: ............................ serial number: ..................................... version 01/SRCC-2-2011/ …
  • Bosch

    Crystalline Solar Modules

    (12 pages)
    dedeutschBosch Solar Module c-Si M 48 I Bosch Solar Module c-Si M60 I Bosch Solar Module c-Si M60 S I Bosch Solar Module c-Si P60       Robert Bosch GmbHAustralia Operating instructions for products with module manufacturer code: 14, 17, 23Issue 08/2013Installation and Operation Guide Crystalline Solar ModulesBosch Solar Module c-Si M 60 EU …
  • ensol

    ES2H/2.65

    (32 pages)
    Installation instruction For flat solar collectors on flat roof or foundation. Installation instruction for flat solar collectors on flat roof or foundation 01/2019 Read before installation …
  • Trina Solar

    DUOMAX Series

    (20 pages)
    INSTALLATION MANUAL IEC Version THE MODULE Screw TSM-DEG6HC.27(II) TSM-DEG15HC.27(II) TSM-DEG6HC.20(II) TSM-DEG15HC.20(II) TSM-DEG6MC.27(II) TSM-DEG15MC.27(II) TSM-DEG6MC.20(II) TSM-DEG15MC.20(II) TSM-NEG6MC.20(II) TSM-NEG6MC.27(II) TSM-NEG15MC.20(II) TSM-NEG15MC.27(II) Clamp TSM-DEG6HC.07(II) TSM-DEG15HC.07(II) TSM-DEG6HC(II) TSM-D …
  • SolarWorld

    Sunmodule Plus SW xxx poly series

    (12 pages)
    Benutzerinformation - User Instructions - Indicaciones para el usuario - Informazioni per l’utente - Informations pour l’utilisateur - Gebruikersinformatie - Πληροφορίες χρήστη - Informace pro uživatele Sunmodule Plus SW xxx polySunmodule Plus SW xxx Compact polySunmodule Plus SW xxx monoSunmodule Plus SW xxx Compact mono12/2011www.sol …

Comments, Questions and Opinions: