Manualios.com

Alpine HCE-C500 Owner's Manual

Alpine HCE-C500 Manual Online:

4.1, 1485 votes
Alpine HCE-C500 User Manual
Alpine HCE-C500 User Guide
Alpine HCE-C500 Online Manual

Text of Alpine HCE-C500 User Guide:

  • Alpine HCE-C500, ALPINE HCE-C500 EN 68-18693Z84-A (A5) 21-EN es g tion ile line er’s tion er’s d, ker. y if n , the ead. r wipe loth Others Symptom Cause/Solution There are noises on the radio. If there are noises on the radio, keep the camera cables and the video cables away from the wire harness, the radio antenna, and the antenna cables of the vehicle. If there is a serious symptom, for example, the distance guidance marks deviates significantly from the actual distance, stop using this system and con

  • Alpine HCE-C500, ALPINE HCE-C500 EN 68-18693Z84-A (A5) 5-EN g ects and Rear View Display Indications <Rear Panorama View> <Rear Mirror View> <Rear Top View> <Rear View> With this system, the brightness and tint of each camera is automatically adjusted. When driving in areas where the brightness or tint varies widely, the brightness or tint of the camera image on the screen may become unstable. Depending on the condition of the car or road surface, the range of vision may vary. Refer to “About the Front Camera Image and Camer

  • Alpine HCE-C500, ALPINE HCE-C500 EN 68-18693Z84-A (A5) 10-EN Distance guidelines The distance guides represent the ground level distance from the rear bumper. It is difficult to accurately estimate the distance to objects above ground level. <Screen> C B A (about 0.5m) <Positions of A, B and C> about 1m In the screen, according to the distance guidelines, the truck seems to be parked about 1 m away (at the position B). In actual fact, however, if you reversed to position A, you would collide with the truck. In the screen, positions A, B and C seem to be located in order of proximity. However, in actual fact, the position A and C are the same distance, and B is farther

  • Alpine HCE-C500, ALPINE HCE-C500 EN 68-18693Z84-A (A5) 2-EN Operating Instructions WARNING WARNING This symbol means important instructions. Failure to heed them can result in serious injury or death. WHEN USING A CAMERA SYSTEM, THE DRIVER MUST VISUALLY CHECK ACTUAL CONDITIONS AROUND THE VEHICLE. MAKE SURE THERE ARE NO PERSONS OR ANIMALS IN THE AREA IN WHICH YOU ARE MANEUVERING OTHERWISE YOU COULD INJURE THEM. A camera assists the driver by sending images to the screen showing conditions in view of the camera. T

  • ALPINE HCE-C500 EN 68-18693Z84-A (A5) 12-EN About Calibration Before using this camera system, calibration is required to set the vehicle width and guidelines for the specific vehicle model. A special measuring kit is needed and the system can only be calibrated by an authorised ALPINE dealer. For details, contact your ALPINE dealer. If the height of the vehicle is changed due t

  • Alpine HCE-C500, ALPINE HCE-C500 EN 68-18693Z84-A (A5) 11-EN the nt a ard ) nce in ar, o . e y n When there is a steep downward slope behind the car (example) <Screen> <Situation of the car> Error Error In the case of a downward slope behind the car, the distance guides are displayed farther from the rear bumper than the actual distance. If there is an obstacle on the downward slope, it seems closer than its actual position. Also, an error may occur between the guidance and the actual path of the car on the road surface. e

  • Alpine HCE-C500, ALPINE HCE-C500 EN 68-18693Z84-A (A5) 4-EN Feature About the TOPVIEW® CAMERA SYSTEM The TOPVIEW® CAMERA SYSTEM displays the blind area outside the driver’s range of vision, using four cameras installed on the front, back, right and left of the vehicle. It is useful for checking for objects around the vehicle. For example, when parking, when navigating narrow roads and “blind” corners, and when reversing. Example of Camera Installation Front camera Side camera Rear camera Side camera An inst

  • Alpine HCE-C500, ALPINE HCE-C500 EN 68-18693Z84-A (A5) 3-EN ONS. ny used s es, g r DER EL ment N al hat , gear arts, to e or em, ard x, has fire t, fire, ED ORE O ND WHEN USING A DRILL TO MAKE A HOLE, TAKE PRECAUTIONS SUCH AS WEARING GOGGLES SO FRAGMENTS DO NOT GET INTO THE EYES. Failure to do so may result in injury. CAUTION This symbol means important instructions. Failure to heed them can result in injury or material property damage. HAVE THE WIRING AND INSTALLATION DONE BY EXPERTS. The wiring and installation of this unit requires special techn

  • Alpine HCE-C500, ALPINE HCE-C500 EN 68-18693Z84-A (A5) 6-EN Abo Cam F Disp front Use t chec emer wher D F The side Use t on ea hard Le I A G a B G a e * e p Camera Image Image Patterns and Distance Guidelines This camera system synthesises and combines four camera images, enabling you to select and switch to any image pattern. The distance guidelines displayed vary for each pattern. For details of how to switch image patterns, refer to “Camera Operation” (page 14). How to Interpret a Camera Image <Front Panorama View> AB Camera Image Range Varies with image pattern* Caution message *1 <Rear View> Distance guidelin

  • Alpine HCE-C500, ALPINE HCE-C500 EN 68-18693Z84-A (A5) 16-EN In C Be s befo any Be s the ma l Wh be a com for fus e HC do s Wh Rou par dam circ Wh veh veh If th will The and If th sho The syst Thi oth mo a h o A m P t c t P r d c t A t a c • • • • • • • • • • • • Switching Image Patterns The image pattern switches with operation (B) of the iDrive Controller. For details of the image patterns, refer to “Camera Image” (page 6). <Front view> Front Panorama View Front Side View Front Top View Front Corner View <Rear view> Rear Panora

  • Alpine HCE-C500, ALPINE HCE-C500 EN 68-18693Z84-A (A5) 18-EN Connections FRONT CAMERA OUT ILLM ACC BATT REVERSE VIDEO OUTPUT FRONT REAR RIGHT LEFT REAR CAMERA OUT CAMERA CONTROL (Grey) (Green) (Violet) (White) (Yellow) (Yellow) (Blue) (Orange/Black) (Orange) (Red) (Yellow) (Black) (Orange/White) Fuse (7.5A) SETUP switch (ON/OFF) This switch is used by your ALPINE dealer when calibrating this system. It is normally set to “OFF”. If you accidentally set it to “ON”, the system may need to be recalibrated. Front Camera Input Connector Rear Camera Input Connector Side Camera Input Connecto

  • Alpine HCE-C500, ALPINE HCE-C500 EN 68-18693Z84-A (A5) 1-EN ENGLISH Contents Operating Instructions WARNING WARNING ........................................ 2 CAUTION ......................................... 3 NOTICE ............................................. 3 Feature About the TOPVIEW® CAMERA SYSTEM ..........................................4 Example of Camera Installation .............. 4 Example of Camera Image ....................... 4 Camera Image Image Patterns and Distance Guidelines .......................................6 How to Interpret a Camera Image .......... 6 About the Front Camera Image an

  • Alpine HCE-C500, ALPINE HCE-C500 EN 68-18693Z84-A (A5) 20-EN In Case of Difficulty The camera image does not appear. (Images other than that of the camera are normal.) Cause Solution The ignition key is set to a position other than ON. Set the ignition key to ON. No fuse is installed, or there is a break in the connection. Install a fuse, or replace a relevant fuse after checking the cause. The connection is not correctly established. Check whether the connection is correctly established while referring to this owner’s manual. The reverse signal line of the connected product is not connected. Connect the reverse signal line while referring t

  • Alpine HCE-C500, ALPINE HCE-C500 EN 68-18693Z84-A (A5) 9-EN ach en A View cle. view hen Indication mark meaning C Guidelines representing a distance of approx. 0.5 m all round the vehicle. Rear View: Refer to “Rear View” (page 9). Top View synthesises images from four cameras and displays the combined view on the monitor. As the sensitivity of each camera is individually adjusted to the optimal degree, the image on the monitor may appear rather unnatural (brightness, tint, etc.). With Top View, the camera image around the joins or borders may not be displayed. For details, refer to

  • ALPINE HCE-C500 EN 68-18693Z84-A (A5) 8-EN With Top View, the camera image around the joins or borders may not be displayed. For details, refer to “About Top View Blind Spots” (page 13). Do not use Top View while retracting the door mirrors or when the vehicle doors are not completely closed, as the image will not be displayed properly. For details of how to switch imag

  • Alpine HCE-C500, ALPINE HCE-C500 EN 68-18693Z84-A (A5) 15-EN ge m e ayed, the d is Displaying the Camera Image using the iDrive Controller iDrive Controller (A) (B) (C) MENU switch (A) (B) (C) MENU switch 1 Press and hold the MENU switch. The front or rear view image previously displayed is displayed again. The iDrive Controller enables you to perform the following operations. (A) The display switches between the front view image and rear view image. (B) The display switches the Image Patterns (Front v

  • Alpine HCE-C500, ALPINE HCE-C500 EN 68-18693Z84-A (A5) 14-EN Camera Operation This camera system enables you to perform the following operations in the camera view, using the iDrive Controller. iDrive Controller Operation (A) (B) (C) (A) (B) (C) (A) The display switches between the front view image and rear view image. (B) The display switches the Image Patterns. For details, refer to “Switching Image Patterns” (page14). (C) The display switches the Screen Format. [4:3] → [5:4] → [16:9] → [21:9] → [16:9 (left screen

  • ALPINE HCE-C500 EN 68-18693Z84-A (A5) EN 2 2 TOPVIEW ® CAMERA SYSTEM HCE-C500 OWNER’S MANUAL Please read before using this equipment. • Designed by ALPINE Japan Printed in Japan (Y_A5) 68-18693Z84-A ALPINE ELECTRONICS MARKETING, INC. 1-1-8 Nishi Gotanda, Shinagawa-ku, Tokyo 141-0031, Japan Phone 03-5496-8231 ALPINE ELECTRONICS OF AMERICA, INC. 19145 Gramercy Place, Torrance, Californi

Related Products and Documents (Digital Camera):

Comparable Devices:

# Manufacturer Model Document Type File Updated Pages Size
1 Sonos Play 5 Product manual sonos/play-5-671.pdf 29 Nov 2022 14 0.66 Mb
2 Hama Elegance Duo Operating instructions manual hama/elegance-duo-H75.pdf 07 Nov 2022 14 6.01 Mb
3 Frigidaire ATF6500F Factory parts catalog frigidaire/atf6500f-7A9.pdf 15 Dec 2023 8 1.28 Mb
4 Marshall Electronics V-LCD70XHB-HDA Operating instructions manual marshall-electronics/v-lcd70xhb-hda-4FW.pdf 03 Jan 2023 14
5 Samsung MW81Y Owner's instructions manual samsung/mw81y-I87.pdf 10 Nov 2022 12 1.92 Mb
6 Sangean HDT-1 Operation & user’s manual sangean/hdt-1-5RZ.pdf 09 Feb 2023 23 0.86 Mb

Similar Resources:

  • Argus

    P-Type

    (4 pages)
    A1A-775897 Version 1, January 2013: 114027www.argusdirect.comthermal imaging from e2vArgus® P-Type:Thermal Imaging Camera for Marine NavigationThe Argus® P-Type yellow thermal imaging camera is specically designed for the Marine market with applications in mind such as spotting other vessels and nding men overboard. Unique Argus colour modes are als …
  • Sony

    NEX-3D - alpha; Nex-3 With Sel-16f28

    (7 pages)
    The performance of a DSLR without the size and weight. The NEX-3 stands apart as the world’s smallest interchangeable lens camera.3 Experience gorgeous HD movies,1 astounding low-light pictures, continuous shooting up to 7 fps, incredible panorama shots, and Live View on a tilting 3” LCD4.NEX-3D/PSmallest in classThis is the world's smallest inter …
  • Apple

    Aperture

    (32 pages)
    1 Late-Breaking NewsAbout Aperture This document provides updated information about Aperture and covers these topics:Â Late-Breaking News About Aperture 1.5.2 (p. 2)Â Previous Release Information About Aperture 1.5 (p. 4)Â Previous Release Information About Aperture 1.1 (p. 24)Â Previous Release Information About Aperture 1.0 (p. 27)This document …
  • Canon

    POWERSHOT A700

    (139 pages)
    CDI-E224-010C&IlOllXXXXXXX © 2006 CANON INC. PRINTED IN JAPAN9a_m<m3c!S.8-C&IlOllDIGITALIIIIIIIIIIIIIIIIICDI-E224A700CAM E RABefore Using the CameraShootingPlayback/ErasinggsI Viewing Images on a TV setTroubleshootingI List of MessagesAppendixCamera User GuideThis guide explains camera features and procedures in detail.PictBddgeDIRECi" BUBBL …
  • Kodak

    Z812 - EASYSHARE IS Digital Camera

    (27 pages)
    www.kodak.com/go/z812support 1ENGLISH Installing the software Attaching the lens cap and strapBefore connecting any cables, install the software that was included with your camera. Follow the on-screen instructions.After installing the software, return to this Getting Started Guide. …
  • FujiFilm

    Finepix Z20FD

    (145 pages)
    FUJIFILMDIGITAL CAMERAFINE PIX220mJOwner'sManualThankyoufor yourpurchaseofthisproduct.Thismanualde-scribeshow touseyourFUJIFILMFinePixZ20fddigitalcameraandthe supplied software.Besurethatyouhavereadandunderstooditscontents beforeusingthecamera.BL00708-200(1)lEI-BeforeYouBeginIFirstSteps!,BasicPhotographyandPlaybackI...................................... …

Comments, Questions and Opinions: