Manualios.com

Gasmate GM160-018 Manual 

Gasmate GM160-018 Manual Online:

3.35, 735 votes
Gasmate GM160-018 User Manual
Gasmate GM160-018 User Guide
Gasmate GM160-018 Online Manual

Text of Gasmate GM160-018 User Guide:

  • Gasmate GM160-018, Vertical Gas Smoker Retain these instructions for future use. Important: The installer or seller must leave these instructions with the consumer. 4768-07/17 Model No. GM160-018 FOR OUTDOOR USE ONLY - OPERATES ON LPG

  • 2 3 GENERAL INFORMATION Gas Installation Codes • Smokers must be used in accordance with AS/NZS Standard 5601 “Gas Installations”. • Smokers for use with bottled gas are labelled LPG/ULPG. • Smokers for use with natural gas are labelled ‘natural gas’ and must be installed by an authorised person. Check the gas type sticker attached

  • 2 3 Location of your Smoker DO NOT use your smoker in garages, porches, sheds, breezeways, or other enclosed areas. Your smoker is to be used OUTDOORS only. DO NOT use this smoker in a manner other than its intended purpose. It is NOT intended for commercial use. The smoker is not intended to be installed in or on recreational vehicles and/or boats. The smoker is not to be used as

  • Gasmate GM160-018, 4 5 • DO NOT wear loose clothing while operating the smoker. Tie back long hair while operating the smoker. ALWAYS wear fully-covering shoes while operating the smoker. • Allow the smoker and its components to cool completely before conducting any routine cleaning or maintenance. • NEVER use glassware, plastic, or ceramic cookware on or in your smoker. • NEVER operate the smoker without water in the water/wood chip tray. NEVER allow the water to completely evaporate. Check the water level at

  • Gasmate GM160-018, 4 5 EXPLODED DIAGRAM No. Description Qty 1 Air vent 1 2 Smoker Body 1 3 Cooking rack support 8 4 Handle 2 5 Thermometer Base 1 6 Thermometer 1 7 Gasmate Badge 1 8 Upper Door 1 9 Door Hinge 4 10 Door Handle Base 4 No. Description Qty 11 Door Handle 2 12 Lower Door 1 13 Valve Assembly & Regulator 1 14 Control Panel 1 15 Knob Base 1 16 Knob 1 17 Cooking Rack 4 18 Left Leg 2 19 Right Leg 2 20 Heat Shield Plate 1 No. Description Qty 21 Burner 1 22 Ignition Pin 1 24 Burner Box 1 25 Match Holder 1 26 Fastener 1 27 Water/Wood Chip Tray 1 28 Hook 1 29 Latch 2 30 Air Vent Handle 1 PARTS LIST Make sure you have all items listed under PARTS L

  • 6 7 ASSEMBLY INSTRUCTIONS Before assembling the smoker, read these Instructions carefully. Assemble the smoker on a at, clean surface. The smoker is heavy. NOTE: Do not fully tighten all the nuts during the initial stages of assembly. Caution: Sheet metal can cause injury. Wear gloves when assembling the smoker. Tools required: Philips head screwdriv

  • Gasmate GM160-018, 6 7 ASSEMBLY INSTRUCTIONS Step 3 Remove the air vent handle, then slot through opening in rear of cabinet. Secure using 4 x M6 x 12 screws (AA) and 4 x M6 tailor-made screws (CC) to assemble the air vent (E). Then re-attach the air vent handle. Step 4 Attach the side carry handles (4) to each side of the cabinet using the holes provided. Secure with 8 x M6 x 10 screws (DD), 8 x washers (GG) and 8 x M6 nuts (FF). 1 CC 30 AA 30 DD 4 GG FF 1 CC 30 AA 30 DD 4 GG FF

  • Gasmate GM160-018, 8 9 Step 6 Repeat Step 5 to attach the lower door handle (11) to the lower door (12). ASSEMBLY INSTRUCTIONS Step 5 Remove the pre-assembled screws and attach the upper door handle (11) by inserting it through the holes in upper door (8). Secure door handle bracket to the inside of the door. 11 螺钉 8 screw 11 螺钉 12 screw 11 螺钉 8 screw 11 螺钉 12 screw

  • Gasmate GM160-018, 8 9 ASSEMBLY INSTRUCTIONS Step 7 Attach the door hinges (4) using 8 x M6 x 40 screws (EE) to the side of the cabinet as shown. Step 8 Use 8 x M6 x 40 screws (EE) to assemble the upper door (8) and lower door (12) to the hinges. 4 EE EE 8 12 4 EE EE 8 12

  • Gasmate GM160-018, 10 11 ASSEMBLY INSTRUCTIONS Step 9 Insert the support racks (3) into the four slots on each side of the inside of the upper cabinet and angle downward until they sit at as shown. Step 10 Slide the cooking grills (17) into the support racks as shown. 3 17 3 17

  • Gasmate GM160-018, 10 11 ASSEMBLY INSTRUCTIONS Step 11 Slide the water/wood chip tray (27) into the lower cabinet as shown. Step 12 Use 1 x M6 x 12 screw (AA) to secure the regulator hose fastener (26) onto right front leg. Locate the hose through the fastener to secure the hose above the ground. By securing the hose it prevents the hose from coming in contact with the hot burner assembly. Locate the S-hook (28) onto the right side carry handle. When the smoker is not in use, hang the hose/regulator from the side handle. This will help prevent dirt or other particles from entering the regulator. 27 AA 26 27 AA 26

  • Gasmate GM160-018, 12 13 ASSEMBLY INSTRUCTIONS Step 13 Use 1 x M5 x 20 screw (HH) to secure the match holder (25) to the bottom of the side panel of the smoker as shown. Step 14 Remove the pre-assembled latch screws, then assemble the latches (29) as shown. HH 25 29 HH 25 29 HH 25 29

  • 12 13 ASSEMBLY INSTRUCTIONS STEP 15 Ensure cylinder valve is in its full ‘CLOSE’ position. Check for any damage to either the cylinder connection or the hose. NEVER attempt to use damaged equipment. Attach the regulator and hose to your gas cylinder. Tighten the nut to a positive stop by hand. STEP 16 Turn on the gas cylinder ensuring that the control knob on the sm

  • Gasmate GM160-018, 14 15 OPERATING INSTRUCTIONS Pre-Use Procedures Before you cook food in your smoker, it is important to “season” your smoker. Seasoning seals the paint and interior of your smoker to enhance avoring, durability, and overall performance. This is also referred to as the “breakin” process. If your smoker requires any touch-up paint on the inside of the cabinet, the only time you should apply paint to the inside is before the seasoning process. Paint should not be applied to the interior of your smoker after your smoker has been used. Paint toxins may co

  • Gasmate GM160-018, 14 15 LIGHTING PROCEDURES Igniter Lighting System: 1. Perform leak test at least twice yearly or after connecting LPG cylinder. Check all connections for leaks using the “soapy water” test as explained on page 13. 2. Open the smoker bottom cabinet door. It must always be open when lighting the smoker. 3. Check for any blockage to the burner. Remove any foreign objects or matter. 4. Be sure the burner control knob is in the “OFF” position. 5. Open the LPG cylinder valve by turning counter-

  • Gasmate GM160-018, 16 17 COOKING INSTRUCTIONS IMPORTANT: Before each use, clean and inspect the hose and the connection to the LPG cylinder. If there is evidence of abrasion, wear, cuts or leaks, the hose must be replaced before the smoker is used. Refer to the “leak test” instructions in the LPG cylinder connection portion of this manual. • Fill the water/wood chip tray. First add a cup of avouring wood chips and place the tray inside the smoker as instructed in the assembly section of this manual. Also, refer to Cooking Tips for Flavouring Wood in Operating Instructions section. �

  • Gasmate GM160-018, 16 17 AFTER USE SAFETY AND MAINTENANCE • If rust is present on the exterior surface of the smoker, clean the area with steel wool or emery cloth and use heavy duty, heat resistant paint. • NEVER apply additional paint to the interior of the smoker. If rust is present on the interior of the smoker, clean it thoroughly with steel wool or emery cloth and lightly coat the area with cooking oil or cooking spray to help minimize recurring rust. • When an LPG cylinder is not connected, and to help prevent dirt

  • Gasmate GM160-018, 18 19 TROUBLESHOOTING PROBLEM CAUSE CORRECTION Burner will not light 1. Check LPG cylinder fuel level. 2. Bad electrode spark. 3. Burner may not be properly seated. 4. Burner may be obstructed. 5. The cylinder valve may be closed. 6. Regulator is not properly seated on cylinder valve. 1. Replace LPG Cylinder. 2. Check to see if the smoker will match light. Electrode or collector may need adjustment. 3. Reseat burner. 4. Clear obstructions from burner. 5. Open cylinder valve. 6. Reseat regulator on cylinder

  • Gasmate GM160-018, 18 19 DIAGRAMMATIC REPRESENTATIONS OF OUTDOOR AREAS The following figures are diagrammatic representations of outdoor areas. Rectangular areas have been used in these figures – the same principles apply to any other shaped area. SAFE APPLIANCE LOCATIONS This appliance shall only be used in an above ground open-air situation with natural ventilation, without stagnant areas, where gas leakage and products of combustion are rapidly dispersed by wind and natural convection. Any enclosure in which the appliance is used shall comply with the following: An enclosure with walls on all sides, bu

Related Products and Documents (Smoke Alarm):

Comparable Devices:

# Manufacturer Model Document Type File Updated Pages Size
1 Moulinex AFW2 Operation & user’s manual moulinex/afw2-NHY.pdf 16 Jul 2023 10
2 Able Planet PS1600BTE Operation & user’s manual able-planet/ps1600bte-T9E.pdf 17 Jul 2023 24 1.58 Mb
3 Hitachi HV-HD201 Operation manual hitachi/hv-hd201-3KZ.pdf 19 Jun 2022 86 1.4 Mb
4 Vitamix 3600 Container Use and care manual vitamix/3600-container-S49.pdf 20 Mar 2024 16 0.91 Mb
5 Tripp Lite SU16KRTHW Manual  tripp-lite/su16krthw-843.pdf 15 May 2023 6 0.57 Mb
6 Blackberry CURVE 9300 - V6.0 Operation & user’s manual blackberry/curve-9300-v6-0-38H.pdf 19 Nov 2022 314 5.54 Mb

Similar Resources:

  • Kidde

    10SCO

    (29 pages)
    Manual P/N 2540-7205-02User Guide for Model 10SCO• Battery Operation: 9V Battery• 2-LED Display• Front Load Battery• Peak Level Memory• Hush®• Voice Message SystemFor your convenience, write down the following information. If you callour consumer hotline, these are the first questions you will be asked:Alarm Model Number(located on back of the a …
  • Kidde

    P4010ACS-W

    (32 pages)
    1INTELLIGENT WIREFREESmoke Alarm User GuidePhotoelectric Smoke Alarm with Voice and Hardwire/Wireless InterconnectModel P4010ACS-W Model P4010LACS-W (Safety Light)WIREFREE INTERCONNECT: You do NOT need a home wi-fi system to use these units. Multiple wireless units create their own independent wireless alarm network. 120V HARDWIRE 10YEAR BATTER …
  • System Sensor

    2WTR-B

    (4 pages)
    3825 Ohio Avenue, St. Charles, Illinois 601741-800-SENSOR2, FAX: 630-377-6495www.systemsensor.comINSTALLATION AND MAINTENANCE INSTRUCTIONSPhotoelectric Smoke Detector2-Wire: 2WTR-B (Form C Relay), 2WTA-B (Sounder)4-Wire: 4WTR-B (Form C Relay), 4WTA-B (Sounder) 4WTAR-B (Form C Relay, Sounder), 4WITAR-B (Isolated Thermal, Form C Relay, Sounder)SeriesBEFORE …
  • Notifier

    FSB-200

    (4 pages)
    DN-6985 • 04/14/05 — Page 1 of 4GENERALThe System Sensor FSB-200 and FSB-200S are intelli-gent, addressable projected beam smoke detectors for pro-tecting open areas with high and sloping ceilings, and wide-open areas, where spot-type smoke detectors are difficultto install and maintain. Ideal applications are atriums, ca-thedral ceilings, aircraft han …
  • Faraday

    MPC-6000

    (76 pages)
    Siemens Building Technologies, Inc. 8 Fernwood Road • Florham Park, NJ 07932 Tel: (973) 593-2600 • Fax: (973) 593-6670 Web: www.faradayfirealarms.com P/N 315-447309-5 MPC-6000 / MPC-7000 / RND-2 Fire Alarm System Control Unit Installation, Operation and Maintenance Manual …
  • Lince

    ZENITH GOLD 869 Series

    (20 pages)
    GOLD 869 UNIVERSAL TRANSCEIVERART. / ITEM: 9588-GOLD-TXRX-MGOLD 869 UNIVERSAL TRANSCEIVERMADE IN ITALYThe CE declaration of this item can be found on the www.lince.net website.installation, operation and maintenance manual …

Comments, Questions and Opinions: