Manualios.com

Insane Audio JK1001 Installation Tips Manual

Insane Audio JK1001 Manual Online:

3, 2223 votes
Insane Audio JK1001 User Manual
Insane Audio JK1001 User Guide
Insane Audio JK1001 Online Manual

Text of Insane Audio JK1001 User Guide:

  • Insane Audio JK1001, V. Installing the JK1001 •Connect the wiring harness, the GPS antenna, the AM/FM radio adapter, the iPod cable and USB cable to the rear of your JK1001 and simply slide it into the dash. •You’ll most likely want to route the iPod cable and USB cable to the glove box. •The GPS antenna has a magnetic mount and is best placed on the top of the JK1001. •If you’re installing a rearview camera, aux input or connecting an aftermarket stereo system just use the included accessory harness. 13

  • Insane Audio JK1001, SPECIAL NOTE FOR VEHICLES THAT PREVIOUSLY HAD OEM uCONNECT MODULES Insane Audio has recently become aware of a Jeep factory defect where certain uConnect modules will still remain active even after your OEM radio has been removed. This may result in your old uConnect module placing an un-necessary drain on your vehicle’s battery even after your Jeep is powered off. You don’t need that uConnect module anymore as your new Insane Audio JK1001 does everything it used to and a whole lot more. So, we

  • Insane Audio JK1001, •Insane NavEngine can be accessed both via the icon or by pressing the NAVI button on the face of your JK1001. This will get you where you’re going both on and off the road. •Your JK1001 comes with a microSD card slot on the bottom right hand side of the unit. Load up a data card with movies or music and access the content via the VIDEO or MUSIC icons on your JK1001 •Your JK1001 came with an OBD Bluetooth adapter and the Torque application already installed. Please refer to the Quick Start Guide for instructions on how to set this up for the first time. •Feel free to get creative! This is your Jeep and your new JK1001! Customize it,

  • Insane Audio JK1001, Thank you! If you haven’t gotten a chance yet, we recommend you check out our Quick Start Guide -- http://www.insanejeepaudio.com/IA_JK1001_Quick_Start_Guid e_current.pdf You can always find out more information or view user manuals online at -- www.insanejeepaudio.com In addition, feel free to “like” us here – www.facebook.com/insanejeepaudio We hope you enjoy your JK1001 and we’ll see you on the trail! 20

  • Insane Audio JK1001, IV. Removing the stock radio There are four 7mm bolts on the face of your stock radio that need to be removed then the whole thing will slide out. Disconnect the antenna and the old wiring harness from the factory harness. Once your old radio has been freed from your dash, it can now be used as a handy doorstop or paperweight. 9

  • Above is a picture of the back of your JK1001. If your JK1001 is equipped with a Wi-Fi antenna, then you will have this additional gold plated plug just above the RCA plug in. Your Wi-Fi antenna will screw on as shown above. Along with that, your GPS plug in is now on the far right hand side of the JK1001. 15 VI. Attachments

  • Insane Audio JK1001, Your JK1001 is designed to automatically display a backup camera anytime your vehicle is in reverse. If you don’t yet have a backup camera, then you may want to disengage the reverse wire in your JK1001’s wiring harness. Disengaging this wire will disable a“no signal” warning every time you put your Jeep into reverse when no camera is detected. You can always re-connect this wire when you are ready to install a backup camera. 16 VI. Attachments

  • Insane Audio JK1001, 4. Pry off the dash panel just below the steering wheel. Start with the top corners. Once it is off, you’ll see two 7mm bolts at the top corners. Guess what? Remove them too. 7 III. Opening the Dash

  • Insane Audio JK1001, III. Opening the Dash 1. On the top of your dash, there is a rubber insert that can be pried open with a plastic dash tool or a small screwdriver. That will reveal a single 7mm bolt that needs to be removed. 5

  • Insane Audio JK1001, VIII. Tips & Tricks •Your new JK1001 is packed with features… so much so that the best way to fully get familiar with it is to just go ahead and start using it! •Be sure to check out our online user forum. It’s a great place to share technical information and creative uses of your JK1001. It’s entirely free and here as a resource for our customers! http://www.insanejeepaudio.com/forum •Just about everything is customizable on your JK1001. You can change the icons, add widgets, change the background, etc. Your JK1001 is already pre-loaded with a bunch of cool widgets that can be found by

  • Insane Audio JK1001, V. Installing the JK1001 Before proceeding with the installation, vehicles with the OEM Alpine Premium Sound System will need to make a minor change on your new Insane Audio wiring harness. 12 F2 F1 R2 R1 6061E If your vehicle is not equipped with the OEM Alpine Premium Sound System or if you are using your own aftermarket amps and speakers you do not have to make any changes. F2 should be connected to F1 and R2 should be connected to R1 as shown above. If you DO have the OEM Alpine Premium Sound System, you will need to swap the speaker quick connect wires above. Simply connect F2 to R1 and R2 to F1 and you’ll b

  • Insane Audio JK1001, Your JK1001 comes with a built-in Bluetooth microphone, but we also include a complementary high quality external mic that will provide superior audio quality . 14 VI. Attachments This external mic will work at just about any location, but we do have some recommendations as to placement. Try to keep this mic away from any windows, air vents, or speakers to avoid background sounds or feedback. The external mic will plug into the back of the JK1001 via a 3.5mm headphone jack plug located just to the left of the RCA pigtail. Most folks place this directly on the steering column.

  • Insane Audio JK1001, Congratulations! If you are reading this, then you are most likely about to install the JK1001 in your 2007 to 2015 Jeep Wrangler. Don’t worry , installation should be a breeze and this document is intended to give you a few helpful hints and tips. This should go without saying, but PLEASE USE YOUR NEW JK1001 RESPONSIBLY. Never attempt to operate the unit or view videos while driving. When in doubt, pull over first then do what you need to do. While driving, always keep both hands on the wheel and your eyes on the road! Should you run into problems or need any additional assistance, feel fre

  • •Disconnect the negative battery terminal before beginning this installation! •Don’t run with scissors •If at any time during the installation you encounter a wild bear, you should avoid poking it with a stick. They don’t like that. 4 II. Safety Precautions

  • •There is plenty of room underneath the JK1001 to neaten any cables. •Secure your JK1001 with the four 7mm bolts you removed from the front of your factory unit. •Make sure you remembered to remove the two shipping screws from the top of your JK1001! •Put your dash back together, reconnect your battery, sit back and get ready to rock!! 17 VII. Fini

Related Products and Documents (Car Stereo System):

Comparable Devices:

# Manufacturer Model Document Type File Updated Pages Size
1 Night Owl CAM-MINI-B700 Quick setup manual night-owl/cam-mini-b700-SE6.pdf 23 Oct 2023 2
2 Ei Electronics Ei411H User instructions ei-electronics/ei411h-Y7U.pdf 26 May 2023 2 0.52 Mb
3 Scytek electronic PRECISION 5500 Product manual scytek-electronic/precision-5500-LI2.pdf 27 Mar 2023 52 0.73 Mb
4 Hilti TE5 Operating instructions hilti/te5-Q47.pdf 10 May 2023 4 0.52 Mb
5 Panasonic SL-MP75 Operating instructions manual panasonic/sl-mp75-11F.pdf 20 Aug 2023 6 0.35 Mb
6 Sharp GB-X18JR Operation manual sharp/gb-x18jr-2U5.pdf 19 Oct 2022 80 6.1 Mb

Similar Resources:

  • Sony

    XR-4740RDS

    (72 pages)
     1997 by Sony Corporation3-859-493-11 (1)Operating InstructionsManual de instruccionesBruksanvisningManual de instruçõesESSPENFM/MW/LWCassette CarStereoXR-4740RDSFor installation and connections, see the supplied Installation/Connectionsmanual.Con respecto a la instalación y las conexiónes, consulte el manual de Instalación/conexiones suministrado.Vi …
  • Juna

    4201

    (12 pages)
    Copyright 2021: © USB-Nachruesten.de Alle Rechte vorbehalten. Dieses Dokument wurde von USB-Nachruesten.de erstellt. Die geltenden Urheberrechte sind zu beachten. Die Reproduktion, Änderung und Übersetzung, ganz oder in Teilen, bedürfen der vorherigen schriftli-chen Genehmigung von USB-Nachruesten.de. Dok-Version: 20210530.1 Anleitung für die Instal …
  • Pioneer

    DEH-6150BT

    (8 pages)
    khicd9abFig. 8圖8Fig. 7圖7Fig. 10圖10Fig. 11圖11efgFig. 9圖923451687Fig. 1圖1Fig. 2圖2Fig. 3圖3Fig. 4圖4Fig. 5圖5 Fig. 6圖6 <KMINX> <08L00000>Installation ManualManual de instalaciónManual de instalaçãoCD RECEIVERRADIO CDCD PLAYERDEH-6150BT Printed in China<YRD5284-A/S> ESj …
  • Sony

    XM-GTR2202 Marketing

    (2 pages)
    XM-GTR22022/1 channel GTR amp 220 Watts x 2 RMS (20Hz-20kHz, <1%THD+N, at 4 Ohm, 14.4V) 1 Maximum power output of 440 Watts per channel at 4 Ohm.270 Watts x 2 RMS (20Hz-20kHz, <1%THD+N, at 2 Ohm, 14.4V) Maximum power output of 650 Watts per channel at 2 Ohm.540 Watts x 1 RMS (20Hz-20kHz, <1%THD+N, at 4 Ohm mono, 14.4V) This unit can be used as …
  • Audiovox

    UMP8015

    (59 pages)
    342156ULTRASERIESAM/FM/ CD/MP3/WMA/ CASSETTE RECEIVERUMP8015/LOUD/ENTERPAUSCNRPTSHFCD-CD+AMSD-AUDSCAN MUTE07WMA3 in 1 CD/MP3/WMA CASSETTE RECEIVER89UMP8015Owner's Manual/Manual del Usario/Manual de L'UtilisateurAM/FM/CD/MP3/WMA Cassette ReceiverReceptor Casete AM/FM/CD/MP3/WMAAmpli-Syntoniseur Cassette AM/FM/CD/MP3/WMA …
  • Pioneer

    AVH-P4100DVD

    (43 pages)
    English Français EspañolInstallation ManualManuel d’installationManual de instalaciónDVD AV RECEIVERAUTORADIO AV LECTEUR DE DVDRADIO AV CON DVDAVH-P4100DVD …

Comments, Questions and Opinions: