Manualios.com

BigPlanes Cessna 185 Instruction Manual

BigPlanes Cessna 185 Manual Online:

4.5, 2565 votes
BigPlanes Cessna 185 User Manual
BigPlanes Cessna 185 User Guide
BigPlanes Cessna 185 Online Manual

Text of BigPlanes Cessna 185 User Guide:

  • BigPlanes Cessna 185, Cessna 185 Specification: Length :1550 mm(61") Wing Span :2200 mm(86.6") Wing Area :55.3 sq. dm 5.95 sq. ft Wing Loading :117.5 g/sq. dm 38.5 oz/sq. ft Flying Weight :6.5 kg(14.3 lbs) Radio :6ch&9 servos Engine :108 2-cycle 120 4-cycle SAFETY PRECAUTIONS INSTRUCTION MANUAL First-time builders should seek advice from people having building experience.If misused or abused,it can cause serious bodily injury and damage to property. Fly only in open ar

  • 4-cycle .120 15″X72.5 in Spinner 6 96 6 6 channel radio for aiplane is highly recommended for this model. 8 Optional parts: rubber wheel with metal hub. Warning Remove the covering with proper pressure to cut through only the covering itself.Otherwise, cutting down into the balsa structure may weaken the model part and cause accident. The pre-covered film on ARF kits may wrinkle due t

  • BigPlanes Cessna 185, Washer (3x6mm) Screw (3x25mm) Damp nut (3mm) 6 Blind Nut (3mm) 2 2 6 12 Washer (3x6mm) Screw(3x25mm) Float strut Float strut Float struts assembly. The side view of the Cessna 185 seaplane. The front view of the Cessna 185 seaplane. 80 79 78 16 Securely glue together. If coming off during flights, you 'll lose control of your airplane which leads to accidents! Make sure hinges are mounted in the same line. 1mm Aileron Tailing edge Make sure they are in the right position while installing. 8 8 2 2 2 4 2 4 2 2 Clevis Rod (2x300mm) Ret

  • BigPlanes Cessna 185, 4.2mm Blind Nut (3mm) Screw (3x25mm) Aluminum struts Washer (3x6mm) Fuselag 1.5mm 4 Blind Nut (3mm) 1 4 4 Washer (3x6mm) Screw(3x35mm) Aluminum struts 12 TP Screw (2.3x12mm) Seal cover 2 90 mm 90 mm 13 mm 13 mm 2 Float strut Washer (3x6mm) 8 TP Screw (2.6x14mm ) 6 24 Damp nut (3mm) Screw (3x35mm) 4 Screw (3x25mm) 6 2 Float strut 2 Float strut 2 1 Float strut Float strut 4 Blind Nut (3mm) 12 TP Screw (2.3x12mm) Seal cover 2 316mm 485mm Washer (3x6mm) 8 TP Screw (2.6x14mm ) 8 Centre line Thank you for purchasing ESM'S products. When we designed this model we have fore considered so

  • BigPlanes Cessna 185, Top view Position for right diagram. ELEVATOR Side View 25mm 25mm 97mm 20mm 15mm 15mm AILERON FLAP 30mm 30mm Top view RUDDER Side View FLAP AILERON Centre of Gravity. Adjustment. The front view when the kit install completion. Adjustment. Adjustment. 71 73 14 72 74 75 1.5mm 3mm TP Screw (2.3x12mm) Wood dowel (6x50mm) 4 1 2 Hook screw Rib template (3mm ply) 6mm 6mm Rib template (3mm ply) 1 2 Rubber band 2 Main wing joiner (25x810mm) 184mm wing tip Hook 1 Rod (2x300mm) Clevis Washer(3x15mm) Wa

  • BigPlanes Cessna 185, Hook 1 6mm 6mm Rib template (3mm ply) 1 B A" B" A A = A" B = B" 1.5mm 30mm Main joiner hole Hook screw Wood dowel (6x50mm) 2 2 4 Rubber band Assembly of main wing. Epoxy the wood dowels in the holes and set the hook screws to appropriate position Fetching out the servo line and air pipe. According the rib template drill two holes in the fuselage. Assemble the wing to fuselage and draw out the rubber band with hook from fuselage as below. Fasten another wing with the rubber band. 17 18 19 20 16 4 21 Wooden Block 2mm Wooden Block(20x15x15mm) 2 2 2 Wooden Block(20x10x15mm) Hatch

  • BigPlanes Cessna 185, Screw (3x20mm) Screw (3x30mm) 2 Screw (3x20mm) 2 Screw (3x20mm) Nut (3mm) 2 3.2mm Nut (3mm) 2 Nut (3mm) 329.5mm 64mm Cut away the surplus parts of plastic cover carefully along the shaded line. Glue windows to openings on fuselage. Find out the marked position in the wing and drill a hole, set nut in it. Fix one side of the strut with screw. Find out the marked position in the fuselage,drill a hole , set nut in it and fix the wing strut. Cut away surplus part along the shaded area carefully. 61 62 63 64 65 12 60 3mm Rudder Make sure hinges are mounted in the same line. 1mm Tailing edge Make sure they are in the right position while installing. 3 TP Screw (3x2

  • 4 Screw (3x20mm) 2 PVC part 2 PVC part 1.5mm Nut (3mm) 4 2 PVC part 2 PVC part 2 PVC part 1 PVC part 5 TP Screw (2.3x8mm) Ply (15x15x3mm) 5 Epoxy plies inside the fuselage under the cowing and mount the cowing with TP screw as illustration. 5 TP Screw (2.3x8mm) Ply (15x15x3mm) 5 Steel wire Aluminum tube Clevis Lock Nut (3mm ) Washer(3x15mm) Screw (3x65mm) 3mm 1

  • BigPlanes Cessna 185, Washer (6x13mm) Washer (6x13mm) Nut (6mm) Screw (6x45mm) Nut (6mm) 5.2mm Blind Nut 3 Screw(4x25mm) 3 1 Blind Nut (4mm) Main landing gear 3 1 Blind Nut (4mm) Main landing gear Washer (6x13mm) 6 3 Screw (4x25mm) 2 Screw (6x45mm) 2 Wheel (90 mm) 4 Nut (6mm ) Make sure to glue securely. If not properly glued, a failure in flight may occur. Temporarily fasten down the main wing and check its correct position. Securely glue together.If coming off during flihts, you'll lose control of your airplane which leads to accidents! C" D" C D C = C" D = D" 1 Stab joiner (16x260mm) Install the main landing gear. Assemble the wheel to the landing gear. The sketch map when the

  • BigPlanes Cessna 185, Washer (4x8mm) Screw (4x25mm) Nut (4mm) 4mm Set Screw (3x4mm) Set Screw (2mm) Rod (2x400mm) Set Screw (2mm) Washer (2mm) Linkage Stopper 1 1 1 1 1 4 4 Washer (4x8mm) 4 Rod (2x650mm) Blind Nut (4mm) Screw (4x25mm) Set Screw (3x4mm) Washer (4x8mm) Washer (4x8mm) Screw (4x35mm) Spring Washer (4mm) 5.2mm Blind Nut 160 mm In case of 2-cycle & 4-cycle engine. 4 Blind Nut (4mm) TP Screw (2.3x8mm) 5 1 Engine mount (68x105mm) Linkage Stopper 4 4 12 4 Washer(4x8mm) Screw (4x35mm) Spring Washer (4mm) Nut (4mm) 2 4 Screw (

Related Products and Documents (Toy):

Comparable Devices:

# Manufacturer Model Document Type File Updated Pages Size
1 Mi-T-M AW-7020-8006 Manual  mi-t-m/aw-7020-8006-2UF.pdf 05 Mar 2023 2
2 Melissa 645-057 Operation & user’s manual melissa/645-057-9YU.pdf 11 Mar 2024 20
3 Beko WMA 510 S Installation & operating instructions manual beko/wma-510-s-8MN.pdf 12 Aug 2022 20 3.82 Mb
4 JVC KD-R626 Instructions manual jvc/kd-r626-7O1.pdf 17 Sep 2023 22
5 Grizzly G6049 Instruction manual grizzly/g6049-2K9.pdf 03 Feb 2023 17 0.65 Mb
6 Sunbeam BVMC-BMH23 Service manual sunbeam/bvmc-bmh23-JPV.pdf 18 May 2023 2

Similar Resources:

  • Fancy Foam Models

    EPP 3Decathlon

    (5 pages)
    Rev. 1.0, 12-22-2011Fancy Foam Models, LLC635 Laramie Cir. Maize, Ks. 67101www.fancyfoam.comEPP 3Decathlon – Assembly Instructions. Recommended Electronics and motors:Motor: Park 250 outrunner or any equivalent motor Speed control: 6 amp minimum.Battery: 250 to 450, 2s , 20C rated or equivalent. Receiver: 4 channel.Servos: 9gr. for ailerons, a …
  • Troy Built Models

    P-51B Mustang

    (10 pages)
    P-51B MustangSpecification:Length :1583 mm(62.3")Wing Span :1800 mm(71")Wing Area :56.7 sq. dm 6.11 sq. ftWing Loading :100.5 g/sq. dm 33 oz/sq. ftFlying Weight :5.7 kg(11.46 lbs)Radio :6ch&8 servosEngine :108 2-cycle 12 …
  • skyangel

    Mini Warbirds Sea fury

    (11 pages)
    Assembly and Operating Manual Specification: *Length: 20-1/2"(520mm) *Wing Span: 23-3/5"(600mm) *Flying Weight: 10-3/4 oz (305g) Mini Warbirds Sea fury …
  • Faller

    3049

    (7 pages)
    Vor Beginn des Bastelns sollten Sie sich mit den Spritzlingen und der Anleitung vertraut machen.Sollte es einmal vorkommen, daß ein Teil im Bausatz fehlt, kreuzen Sie bitte das fehlende Teil inder Anleitung an und schicken Sie diese bitte an Fa. Gebr. FALLER GmbH, Abt. Kundendienst,Kreuzstraße 9, 78148 Gütenbach. Sie erhalten dann umgehend Ersatz.Before c …
  • Quick

    Sweet 16 EP

    (33 pages)
    QuickWorldwide.com Sweet 16 EP Helicopter Exclusively distributed by: Quick worldwide 201 South 3rd. St. & 309 N. Coopersburg, PA 18036 Phone: (610)-282-4811 Fax: (610)-282-4816 Websites: http://www.hhiheli.com http://www.quickheli.com http://www.giantscaleplanes.comE-mail: [email protected] [email protected] (Tech. Support) …
  • Fisher-Price

    GNG89

    (16 pages)
    1GNG89GNG90GNG91Press the saddle for sound effects and music!Appuyez sur la selle pour entendre des sons et de la musique!Den Sattel für Geräusche und Musik drücken!Premi la sella e attiva gli effetti sonori e la musica!Druk op het zadel voor geluidjes en muziek!¡Aprieta la montura para encender sonidos y música!Pressiona a sela para ativar os efeito …

Comments, Questions and Opinions: