Manualios.com

Epson RTC-4573 Manual 

Epson RTC-4573 Manual Online:

3.35, 2521 votes
Epson RTC-4573 User Manual
Epson RTC-4573 User Guide
Epson RTC-4573 Online Manual

Text of Epson RTC-4573 User Guide:

  • Epson RTC-4573, Page-1 Aug. 1998 Serial RTC with Alarm and Timer RTC - 4573 · Built-in frequency adjusted 32.768KHz crystal oscillator · Serial interface that can be controlled through three signal lines · Week , Day , hour , and minute alarm interrupt functions · Interval timer interrupt function that can be set with an interval ranging from 1/4096th of a second to 255minutes · Dual dedicated interrupt outputs for software maskable alarms and for timers · Functions that detect halting of crystal oscillation, and when the time is being updated · Automatic leap ye

  • Epson RTC-4573, Page-2 Aug.1998 n nn n Pin Connection 2. 3 4 5 6 1. 7. 9 8. GND DD V N.C N.C N.C #1 #9 #10 #18 17 16 15 14 13 18 12 10 11. CLK DATA N.C / AIRQ CE1 N.C N.C N.C N.C / TIRQ N.C FOUT CE0 Symbol Pin-No. I / O Function CE1 5 Input Chip enable 1 input pin. This terminal has pull-down resistor built-in. Access to this RTC is possible in "H" level both CE0,CE1 terminal. FOUT terminal can output frequency when inputs "H" level into this terminal re

  • Epson RTC-4573, Page-3 Aug.1998 n Electrical Characteristics 1. Absolute Maximum Ratings Description Symbol Conditions Rated values Unit Power supply Voltage V DD - -0.3 to +7.0 V Input Voltage V IN1 input pins GND-0.3 to V DD +0.3 V Output Voltage V OUT1 / TIRQ,/ AIRQ -0.3 to +8.0 V V OUT2 FOUT,DATA GND-0.3 to V DD +0.3 Temperature T STG - -55 to +125 °C 2. Operating Condition Item Symbol Conditions MIN. MAX. Unit Supply Voltage V DD -1.65.5V Data Holding Voltage V CLK -1.65.5V Operating Temperature Range T OPR ° C 3. Frequency Characteristics Item Symbol Conditions Specifications Unit Frequency accuracy f / fo Ta=25 °C,V D

  • Epson RTC-4573, Page-4 Aug.1998 5. AC Characteristics ( CL=50pF,Ta=-40 to 85 ) V DD =3.0V±10% V DD =5.0V±10% Description Symbol MIN. TYP. MAX. MIN. TYP. MAX. Unit CLK clock cycle t CLK 1200 600 ns CLK H Pulse Width t WH 600 - - 300 - - ns CLK L Pulse Width t WL 600 - - 300 - - ns CE setup time t CS 300 - - 150 - - ns CE hold time t CH 400 - - 200 - - ns CE recovery time t CR 600 - - 300 - - ns CLK hold time t CKH 100 - - 50 - - ns Write DATA in setup time t DS 50 - - 50 - - ns Write DATA in hold time t DH 50 - - 50 - - ns Read DATA in delay time t RD 0 - 400 0 - 200 ns Output disable delay time t RZ - - 200 - - 1

  • Epson RTC-4573, Page-5 Aug.1998 n Register Table Address Function bit7 bit6 bit5 bit4 bit3 bit2 bit1 bit0 0Secfos4020108421 1 Min fr 40 20 10 8 4 2 1 2 Hour fr * 20 10 8 4 2 1 3 Week fr 6 5 4 3 2 1 0 4Dayfr*20108421 5 Month fr * * 10 8 4 2 1 6 Year 80 40 20 10 8 4 2 1 7 Minutes Alarm AE 40 20 10 8 4 2 1 8 Hours Alarm AE * 20 10 8 4 2 1 9 Week Alarm AE 6 5 4 3 2 1 0 A Day Alarm AE * 20 10 8 4 2 1 B FOUT control FE * FD4 FD3 * FD2 FD1 FD0 C Timer interrupt control TE * TD1 TD0 * * * * D Count Down Timer 128 64 32 16 8 4 2 1 E Control 1 * * * TI/TP AF TF

  • Epson RTC-4573, 1.2 Alarm registers (register 7 to register A) Alarms can be set for days of the week, hours, and minutes. Bit 7 of each alarm register is an AE bit that can be used to set an hourly alarm or a daily alarm. An alarm can also be set for multiple days of the week.However, when using the day of the week alarm, also set either or both the hour and minute alarms. If the day of the week alarm is set by itself, the alarm may not be output properly.When the AE bit is "0", the register in question and the timekeeping r

  • Epson RTC-4573, Page-7 Aug.1998 1.5. Control register1 ( Reg-E ) Address bit 7 bit 6 bit 5 bit 4 bit 3 bit 2 bit 1 bit 0 E * * * TI/TP AF TF AIE TIE TI / TPbits : ( Interrupt Signal Output Mode Select. Timer-Interrupt / Timer-Periodic ) output mode of timer signaling. bit 0 1 TI / TP TIRQ terminal is maintained by "L" till it is written in "0" at TF bit when turn into interrupt mode, and timer interrupt occurs, and, but, timer interrupt signal does it with TIE=1 Timer interrupt signaling is set in a mo

  • Page-8 Aug.1998 n Usage Functional Overview The basic sequence for reads and writes is the same: after the CE input goes high, the 4-bit mode is set, the 4-bit address is specified, and then the data is read or written in 8-bit units.If the input of an 8-bit unit of data is not yet complete when the CE input is set low, the 8-bit

  • Epson RTC-4573, Page-9 Aug.1998 n Examples of External Connections RTC4573 VDD CE1 GND + Voltage Detector 4.7uF 0.1uF Schottky Barrier Diode Note VDD D 1 D 1 : 1SS108 or Equivalent Vf = 0.1V VO VDD VSS SCI7701 or SCI7721 CE0 DATA CLK / TIRQ / AIRQ FOUT n Package Outline 7.8 0.2 5.4 11.4 0.2 1.270.4 1.8 2.0 0.12 0.1 MAX. 0 0.15 0.6 0 - 10 0.2 MIN.

  • Epson RTC-4573, Page-10 Aug.1998 n Reference data ( 1 ) Frequency temperature characteristics ( typical ) q T = 25°C TYP. a = -0.035ppm/°C² TYP. Temperature [°C] Frequency dft[ppm] -120 -110 -100 -90 -80 -70 -60 -50 -40 -30 -20 -10 0 10 -40-30-20-10 0 1020304050607080 Finding the frequency stability (clock error) 1. The frequency temperature characteristics can be approximated by using the following expression: D f T (ppm)= a ( q T - q X ) 2 D f T (ppm) : Frequency deviation at target temperature a (ppm/ 2 :

  • Epson RTC-4573, Page-11 Aug.1998 n Notes on Use ( 1 ) Notes on handling In order to attain low power consumption, this module incorporates a CMOS IC. Therefore, the following points should be kept in mind when using this module. 1. Static electricity While this module does have built-in circuitry designed to protect it against damage from electrostatic discharge, the module could still be damaged by an extremely large electrostatic discharge. Therefore, packing materials and shipping containers should be made of conductive materials.Furthermore, use soldering equipment, t

  • Page-12 Aug.1998 ( 2 ) Notes on mounting 1. Soldering temperature conditions If the internal temperature of the package exceeds 260°C, the characteristics of the crystal resonator may deteriorate and the package may be damaged. Therefore, before using this module, be sure to confirm what temperatures it will be exposed to during the mounting pro

Related Products and Documents (Control Unit):

Comparable Devices:

# Manufacturer Model Document Type File Updated Pages Size
1 Gigabyte GA-6WMMC7 Operation & user’s manual gigabyte/ga-6wmmc7-OE3.pdf 13 Aug 2022 91 0.95 Mb
2 Nextar SNAP3 Hardware instruction manual nextar/snap3-EDV.pdf 31 Mar 2023 41
3 protech PMB-562LF Operation manual protech/pmb-562lf-YEB.pdf 25 Mar 2024 93
4 Warmup OTN-1991-WA Instructions manual warmup/otn-1991-wa-8FO.pdf 27 Nov 2022 8
5 Philips HD4815 Operation & user’s manual philips/hd4815-445.pdf 14 Feb 2024 2
6 Samsung 150N Manual de usuario samsung/150n-9AA.pdf 24 Dec 2023 67 5.79 Mb

Similar Resources:

  • Honeywell

    MK V

    (68 pages)
    EGPWS LINE MAINTENANCE MANUAL CAGE CODE: 97896 SCALE: NONE SIZE: A DWG NO.: 060-4199-180 REV: G SHEET 1 of 68 MK V MK VI MK VII MK VIII MK XXII Enhanced Ground Proximity Warning Systems Line Maintenance Manual Document No: 060-4199-180, Rev G Release date: 29 Mar 2010 Honeywell International, Inc. Redmond, Washington 980 …
  • PVA

    MV600 Series

    (41 pages)
    PrecisionValve&AutomationOneMustangDriveCohoes,NY12047www.pva.netMV600 Series Metering ValveVersion: 112-10423 OWNER’S MANUAL Rev A WHERE PRECISION DRIVES PRODUCTION …
  • SSS Siedle

    ZDS 601-0

    (8 pages)
    Produkt-informationZubehör DiebstahlschutzZDS 601-0Theft guard accessoryZDS 601-0Accessoire antivolZDS 601-0Accessorio antifurtoZDS 601-0DiefstalbeveiligingZDS 601-0Tilbehør til tyverisikringZDS 601-0Tillbehör stöldlåsZDS 601-0 …
  • Watts

    009 Series

    (12 pages)
    Installation, Maintenance, & Repair Series 009 and LF009Reduced Pressure Zone AssembliesSizes: 1⁄4" – 3" (8 – 80mm)RP/IS-0093" (80mm) 009NRS TestingFor field testing procedure, send for IS-TK-DP/DL, IS-TK-9A, IS-TK-99E AND IS-TK-99D.For other repair kits and service parts, send for PL-RP-BPD.For technical assistance, contact your loc …
  • Madas

    EVP Series

    (60 pages)
    ELETTROVALVOLA NORMALMENTE CHIUSA AUTOMATICA PER GASAUTOMATIC NORMALLY CLOSED SOLENOID VALVE FOR GASÉLECTROVANNE AUTOMATIQUE NORMALEMENT FERMÉE POUR GAZELECTROVÁLVULA AUTOMÁTICA NORMALMENTE CERRADA PARA GASEVP.../NC - EVPC.../NCCE-51CM4100MADE IN ITALYIT EN FR ESOmologazione CE secondo EN 161, conforme Regolamento (UE) 2016/426EC approval according to EN …
  • Watts

    AMES LF985GD-20 Series

    (21 pages)
    ES-A-ACV-LF985GD-20Engineering Specification, Installation, Operation and MaintenanceDeep Well Control Valve with Pressure Relief FeatureSizes: 2" to 24" NOTICEFor Australia and New Zealand: Pipeline strainers should be installed between the upstream shutoff valve and the inlet of the backflow preventer.It’s important that this device be tested …

Comments, Questions and Opinions: