Manualios.com

AOpen AOP-111 Operation & User’s Manual

AOpen AOP-111 Manual Online:

4.35, 2388 votes
AOpen AOP-111 User Manual
AOpen AOP-111 User Guide
AOpen AOP-111 Online Manual

Text of AOpen AOP-111 User Guide:

  • 6.3 Setup Print Server’s IP Address The print server must have a unique IP address in order to be recognized by the network. You can set up the IP address on the various Unix systems using any one of the following methods: 1. ARP & Ping Assignment (Recommend for Unix) 2. DHCP (Dynamic Host Configuration Protocol) 3. BOOTP (Bootstrap Protocol) 4. RARP (Reverse

  • AOpen AOP-111, The page allows you to set: System Contact, the system Administrator information of this print server. System Location, the System location of this print server. 8.3.11 System Utilities You can perform several tasks from this Utilities page, as described below: The Software reset: which determines whether or not to reset the print server. The Restore to factory default: which determines whether or not to erase all of the print server’s setting and restore to the default configuration the print server had when it was shipped from the factory. The Print diagnostic page: which determines whether or not to print a diagnostic pag

  • AOpen AOP-111, spaces (/nt). If the program does not explicitly signal end-of-job, the capture facility will wait 10 seconds (/ti=10) before assuming that the print job is complete. 7. Reset the print server to have the changes take effect. Before printing, you may want to verify that the setup was complete. Using the Print Server Status option of the PSETUP command (as described in the following section), you can verify that the print server is connected to the right file server, is using the correct network frame type, and so on. You may also want to use the NetWare PCONSOLE program to verify that:

  • AOpen AOP-111, Please be aware that Network Ports Quick Setup Utility can only detect and configure all print servers on the same network, it cannot search and configure print servers on other subnets across network segments. You must use Remote Ports Utility described in the next section to manage remote (across network segments) print servers. 3.5.2 Remote Ports (Utility) Remote Ports Utility offers a convenient way for you to manage and add printer port of the remote print server. From the assistant of this utility, you can print t

  • AOpen AOP-111, 8.1 Introduction Print server can be configured and managed on the Web. Through Local Area Network, or even Internet, administrator can easily configure and manage print server’s various main functions in browsers. Simply enter print server’s IP address into your browser’s address field to manage a print server by print server’s built-in Web Server. In addition, in order to increase the convenience of management, print server provides Web Manager Utility to assist you in browsing all print servers and managing print server’s printing environment on your Local Area Network systematically. Please refer to next section for

  • AOpen AOP-111, 6.4 Verify Print Server’s IP Address To verify that your print server is responding to the newly assigned IP address using a PING command: ping ip-address 6.5 Configure Remote lpd Printing on the Host The procedure you use to configure your Unix host(s) to allow printing to your network remote print server varies between different varieties of Unix. The procedure below can be used for Unix variants that are related to BSD Unix, such as SunOS or Linux. For other versions of Uni

  • AOpen AOP-111, 7. Now, the installation procedure is completed, and the next step is to set up the client’s computer. Click “Continue”, and all the print server’s network ports detected on the network will be added to your PC. 8. Finally, the “Installation complete” window is displayed to indicate that the Client Installation procedure is finished. After the installation, you have completed the following tasks : Install all utilities and drivers to the client’s PC. Add all the print server’s network ports of the network to the client’s PC. You can then perform the Windo

  • web browser to set a permanent IP address (refer to section 8.3.7 for detailed IP configuration). 6.3.2 DHCP There are many Unix systems that support DHCP protocol, and the procedures to configure the DHCP server database are different. This manual does not describe the DHCP server configuration on the Unix systems. It is highly recommended that the DHCP server should be located

  • AOpen AOP-111, 7.11 Upgrade - Firmware Upgrade / Update The print server stores its internal programs in “flash” memory, which you can upgrade when new versions of the print server’s software become available. To perform an upgrade, Make sure the updated PxxxM_xP.BIN (depending on your model) file is stored in your computer or CD-ROM. Choose the updated firmware in File Name field. For example, <CD Driver>\FLASHROM\<Model Path>\PSxxROM.BIN <Model Path> Mapping PS10M_1P => 10Mbps LAN &am

  • AOpen AOP-111, 7.9 Print Server Cfg – Print Server Network Ability Setting The Print Server Cfg page allows you to set: The Diagnostic Printout, which determines whether or not a diagnostic printout should be printed on the printer to which the print server is connected. The TCP/IP Support, which determines whether or not TCP/IP network printing is supported The NetWare Support, which determines whether or not NetWare network printing is supported The NetBEUI Support, which determines whether or not NetBEUI network printing is supported The Write button: save the configuration to the print server.

  • AOpen AOP-111, 25. Reset the print server to have the changes take effect. NOTE: If the print server you have is with multiple printer connectors, you may create multiple print queues and printer objects. Your print server should now be ready to use. You should be able to redirect printing to your print server using a CAPTURE command such as the one shown in the previous section. 48

  • 4.1 System Architecture In Windows network environment, other than the Peer-to-Peer network printing architecture described in the previous chapter, we also offer the Server-Based Printing architecture for Windows NT/2000 server. Only one Windows NT/2000 is required to have Windows PTPP (Peer-to-Peer Printing) driver installed and share the printing service on the network. O

  • AOpen AOP-111, 10.2 System Setup 10.2.1 Print Server Side It is needless to do any setting on the print server side. Make sure the print server has correct IP settings. If you want to share the printers to Internet users, you have to set a real IP to the print server. You also have to make sure that any gateway, router or firewall does not block IPP protocol if you have these gateway devices installed in your network. 10.2.2 Client Side You only need to perform Window’s standard Add New Printer procedure, select “Network Printer” shown in the screen below and click “Next >”. Select “Connect to a printer on the Internet or on a home or office network” and enter t

  • AOpen AOP-111, 1. Introduction 1.1 Product Introduction Thank you for purchasing and using our print server. This print server allows your printer to become a shared device on the network. It offers printing flexibility and manageability on your Local Area Network at an extremely low cost and with an absolute minimum setup and maintenance required. This print server provides a network port (10/100Mbps Ethernet) and one printer's USB port. This print server supports IPX, TCP/IP and NetBEUI protocols. It is the best network printing solutions for various common network operating systems; such as Windows 95/98/Me Peer-to-Peer Printing, Windows NT/2000/XP, NetWare, Unix/Linux, etc. Wi

  • AOpen AOP-111, 7.5 IP Cfg - IP Address Configuration The IP Cfg page allows you to configure the IP address where the print server is to be located. The print server will obtain its IP address automatically if you configure the IP address as Auto. Click Write button to save the configuration to the print server and Click Reset button to reset the print server and have the changes take effect. 63

  • AOpen AOP-111, 9.1 Introduction Email Printing provides a new way of printing service. After installation, Windows will establish a new Printer Driver which will convert the printing document to an Email and send to the mail account assigned by print server. Print server will periodically retrieve Emails in the mail account and print it to the attached printer directly. 88

  • AOpen AOP-111, You can assign a meaningful name for the management consideration. But note that, this name will be the “Identifier” for the Peer-to-Peer Printing (PTPP). 10. Click “Next” to configure network protocol in the following screen. In the system default, IPX and NetBEUI protocols are enabled. About the TCP/IP, you can either (1) assign a fixed IP address for the print server or (2) configure it later by the configuration utility. 11. Click “Next”, and the configuration summary is displayed in the window. Now, you have completed the “Print Server Setup”. By clicking “Next”. Your system will perform “Add netw

  • AOpen AOP-111, 6.5 Configure Remote lpd Printing on the Host........................................................55 6.6 Print a Test Page ....................................................................................................57 7. CONFIGURATION UTILITY........................................................................................................... 58 7.1 Introduction ............................................................................................................59 7.2 General - General Information of Print Server ....................................................60 7.3 Print Server Status..........

  • :lp=:\ :rm=203.66.191.186:\ :rp=lpt1:\ :lf=/var/spool/lpd/pserverd.log:\ :sd=/var/spool/lpd/pserverd:\ :mx#0: Lines should be indented with tabs. More than one printer name can be used, with variants separated by vertical bars (name1|name2). The rm= entry should correspond to the IP address you have assigned to the print server. You can also use a host name if you have as

More Instructions:

DOWNLOAD

Related Products and Documents (Printer):

Comparable Devices:

# Manufacturer Model Document Type File Updated Pages Size
1 Lenovo NetVista A22p Benutzerhandbuch lenovo/netvista-a22p-194.pdf 27 Oct 2022 92
2 ZUCCHETTI L50BEU Operation & user’s manual zucchetti/l50beu-46D.pdf 20 Apr 2023 23
3 Kenwood DVF-5500 Instruction manual kenwood/dvf-5500-GOL.pdf 15 Mar 2023 36
4 Zenith TELEVISION RECEIVER Operating manual zenith/television-receiver-M3S.pdf 23 Jan 2023 8 0.61 Mb
5 Insignia NS-50L240A13 Important information manual insignia/ns-50l240a13-6ZA.pdf 29 Feb 2024 8
6 Kogan KALED19XXXA Operation & user’s manual kogan/kaled19xxxa-164.pdf 29 Apr 2023 28

Similar Resources:

  • Epson

    GT-20000

    (2 pages)
    Epson GT-20000 High Performance Color ScannerThe affordable choice for large format scans and convenient workgroup document management capabilities.Epson GT-20000 High Performance ScannerThe GT-20000 offers the productivity benefits of advanced scanning technology in an affordable, large-format scanner. A versatile workgroup performer, this powerful produc …
  • Xante

    IMPRESSIA

    (3 pages)
    Power SourceConnect the power cord to a power source of the following specification: •120 V, 60 Hz, 12 A or moreQuick Installation GuideUnpackingPull out the handle from the right side ofthe printerLift the printer using the side handles andcarefully place on a stand or table.Return the handle you pulled out fromthe printer to its original posit …
  • Brother

    HL-2140

    (30 pages)
    STEP 1STEP 2Setup is Complete!Quick Setup GuideHow to use the printer, see the User’s Guide on the CD-ROM.Setting Up the MachineInstalling the Printer DriverLaser PrinterHL-2140HL-2150N Before you can use the printer, you must set up the hardware and install the driver. Please read this ‘Quick Setup Guide’ for proper set up and installation instruction …
  • Canon

    imagePROGRAF SD-33

    (8 pages)
    プリンタースタンド セットアップガイドPrinter Stand Setup GuideGuide d'installation du socle de l'imprimanteGuía de conguración del Soporte de la impresoraGuia de conguração de suporte da impressoraSetup-Handbuch für das DruckergestellGuida all'installazione del supporto della stampanteInstallatiehandleiding print …
  • Epson

    DFX-5000+

    (5 pages)
    EPSON AMERICA, INC.EPSONProduct Support BulletinSubject: DFX-5000, DFX-8000 and Avatar EP-ConnectDate: 10/9/92Page(s): 1 of 1PSB No: P-0091Originator: REWAvatar Corporation distributes the EP-Connect coax interface for the Epson DFX-series and other Epson dot-matrix printers that use A-type interfaces. This EP-Connect coax interface allows a connection to an …
  • Lexmark

    W820

    (80 pages)
    Clearing print media jamsPaper handlingMaintenanceTroubleshootingAdministrationIndex1Printingwww.lexmark.comLexmark W820For tips on avoiding jams, see Avoiding jams.If you do experience a jam, see the following instructions in this topic to clear the jam andcontinue printing.• Understanding jam messages• Locating jams with messages• Clearing jams from …

Comments, Questions and Opinions: