HP AB465A Installation Manual

Text of HP AB465A User Guide:

• HP AB465A, AB465A PCI-X 2-Port 2 Gigabit Fibre Channel and 2-Port Gigabit Ethernet Combination Card Installation Guide For fcd Driver Versions B.11.11.04 and B11.23.02 and For igelan Driver Versions B.11.11.17 and B.11.23.05 HP 9000 and HP Integrity Systems Manufacturing Part Number : AB465-90001 E0205 U.S.A. © Copyright 2005 Hewlett-Packard Development Company L.P.

• HP AB465A, 2 Legal Notices The information in this document is subject to change without notice. Hewlett-Packard makes no warranty of any kind with regard to this manual, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. Hewlett-Packard shall not be held liable for errors contained herein or direct, indirect, special, incidental or consequential damages in connection with the furnishing, performance, or use of this material. Warranty A copy of the specific warranty terms applicable to your Hewlett- Packard product and replacement parts can be obtained from your local Sales and Service Office. Restricted

• HP AB465A, Hardware and Software Installation Procedure Step 1: Access the system card bay 3 Hardware and Software Installation Procedure These instructions apply to AB465A PCI-X 2-Port 2 Gigabit Fibre Channel and 2-Port Gigabit Ethernet combination cards which can operate on HP-UX 11i v 1.0 of December 2004 or HP-UX 11i v 2.0 of September 2004 or later. If your system is running HP-UX 11i v 1.0, you can find the 11i v 1.0 LAN and fibre channel driver bundles on the December 2004 OE distribution media. For 11i v 1.0, you can either load the entire O

• Hardware and Software Installation Procedure Step 4: Connect the fibre channel devices 4 • Attach the free end of the LAN cable to any unused port on the switch. The Base-T connections on the card operate at 10 or 100 Mbit/s in either full- or half-duplex modes and at 1000 Mbit/s only in full-duplex mode. Set the ports on the card and on your switch according to the following t

• Hardware and Software Installation Procedure Step 6: Install the latest software. 5 • Check the Release Notes for GigEther-01 and FibrChanl-01 to see if you need to install any appropriate patches for your system. Release Notes are available on the Web at http://docs.hp.com under Networking and Communications. Step 6: Install the latest software. • Load the software media into the appropriat

• HP AB465A, Hardware and Software Installation Procedure Step 8: Verify the fibre channel installation 6 Step 8: Verify the fibre channel installation • To verify that the fc driver appears for each installed card, enter: ioscan -fk The ioscan output might look like the following: Class I H/W Path Driver S/W State H/W Type Description fc 4 1/0/8/1/0/4/0 fcd CLAIMED INTERFACE HP AB465-60001 PCI/PCI-X 2-port 2Gb FC/2-port 1000B-T Combo Adapter (FC Port 1) fc 5 1/0/8/1/0/4/1 fcd CLAIMED INTERFACE HP AB465-60001

• HP AB465A, Hardware and Software Installation Procedure Optional Step: Configure Jumbo Frames Size (Jumbo frames are supported only at 1000 Mbit/s) 7 • Installation is complete when you have successfully run linkloop, ping and netstat. To configure remote systems, see the Ethernet Support Guide available on the web at http://docs.hp.com. Do this step only if remote systems have not been previously configured. • Optionally, if you want to verify that the igelan driver appears for each installed card, enter: ioscan -fknClan The ioscan output

• Hardware and Software Installation Procedure For Further Information 8 An alternative way to temporarily configure jumbo frame size is to enter: lanadmin -M mtu_size PPA_number . Using lanadmin is temporary because it will not preserve your settings across reboots. The PPA_number is the one we obtained from the output of lanscan. For using Jumbo Frames with the igelan Gigabit Et

• HP AB465A, Hardware and Software Installation Procedure Network Configuration Worksheet 9 Network Configuration Worksheet Fill out one worksheet for the networking data of each LAN port on the combination card you are installing. Note 1: To configure values permanently, edit the configuration files using SAM or an editor such as “vi”. Using lanadmin will not preserve your settings across reboots. Note 2: The speed configuration of the card can be 10, 100, or 1000 Mbit/s and is determined by the speed setting of the hub or switch port to which the card is connected. The card automatically senses this speed. The Base-T card only runs at one speed at a time. To verify the speed select

• HP AB465A, Hardware and Software Installation Procedure Cable Specifications 10 Note 3: The valid MTU size for normal frames using the igelan driver on HP-UX 11i v 1.0 or v 2.0 is 1500 bytes. For Jumbo Frames, the valid MTU size on HP-UX 11i v 1.0 is 9000 , and for HP-UX 11i v 2.0, it is a number in the range of 1501 to 9000 bytes. Cable Specifications Operating Distance for 1000Base-T (Copper UTP): Up to 100 meters — Cat 5 and Cat 5E Operating distances for fibre channel using multi-mode fiber optic cable are as follows: Available HP Fiber Optic Cables: Description (Fibre Channel) Rate Operating Distance 50/125 micron MMF 2 Gbits/s 300 meters (984 f

• HP AB465A, Hardware and Software Installation Procedure 11 Figure 1 AB465A PCI-X 2-Port 2Gb FC/ 2-Port 1000B-T Combination Card (Duplex LC) Fibre Channel Connectors PCI-X 133 MHz 1000Base-T Connectors (RJ-45) Speed LEDS (Port 2) 1Gb 2Gb Speed LEDS (Port 1) 2Gb 1Gb Speed LEDs Off = 10 Mbit/s Green = 100 Mbit/s Yellow = 1000 Mbit/s Activity/Link LEDs Flashing = Data traffic Solid = Active link OFF = No link } Port 1 Port 2 LAN B LAN A

• Hardware and Software Installation Procedure Features 12 Features The AB465A PCI-X Combination cards have the following features: • PCI-X 133 MHz capable card. It can operate at 32-bit or 64-bit compatible modes and is supported in the following frequencies: PCI 66, PCI-X 66, and PCI-X 133. Best performance is achieved by putting the card in a “dual-rope”

• HP AB465A, Hardware and Software Installation Procedure Interoperability: Supported Systems 13 Interoperability: Supported Systems Supported Systems The combination card is supported in the HP Integrity (Itanium or Itanium2-based) systems specified in Table 3. The combination card is supported in the HP 9000 (PA-RISC processor-based) systems specified in Table 4. Table 3 Combination Card in HP Integrity Systems rx1600, rx1620 ; These servers accommodate 1 AB465A per system. rx2600 rx2620 rx4640 rx7620 HP Integrity Superdome IA 1

• HP AB465A, Card Physical and Environmental Specs and Regulatory Information Card Physical and Environmental Specifications 14 Card Physical and Environmental Specs and Regulatory Information Card Physical and Environmental Specifications Following are the product physical and environmental specifications of the AB465A PCI-X 2-Port 2 Gigabit Fibre Channel and 2-Port Gigabit Ethernet Combination Card. Physical Specifications Electrical Environmental Temperature Degrees F = (1.8 x Degrees C) + 32 Form Factor PCI-X (rev

• HP AB465A, Card Physical and Environmental Specs and Regulatory Information Card Physical and Environmental Specifications 15 Electromagnetic Compatibility This document contains regulatory statements for the United States and the European community. Operating Altitude 3,000 meters (9900) ft Non-operating Altitude 4,500 meters (14850 ft)

• HP AB465A, Card Physical and Environmental Specs and Regulatory Information FCC Statement (For U.S.A.) 16 FCC Statement (For U.S.A.) Federal Communications Commission Radio Frequency Interference Statement WARNING This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference and (2) this device must accept any interference received, including interference that might cause undesired operation. This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FC

• HP AB465A, Card Physical and Environmental Specs and Regulatory Information Laser Safety Statements 17 Laser Safety Statements Laser Safety Statements - U.S. FDA/CDRH - Optical (laser) Transceiver CAUTION The optical transceiver provided on the network interface card contains a laser system and is classified as a “Class-I Laser Product” under a U.S. Department of Health and Human Services (DHHS) Radiation Performance standard according to the Radiation Control for Health and Safety Act of 1968. The Class I label and compliance statement are located on

Related Products and Documents (PCI Card):

Comparable Devices:

Similar Resources:

• Vantec UGT-ST644R (24 pages) 4 Channel 6-Port SATA 6Gb/s PCIe RAID Host Card User Manual Model: UGT-ST644R All brand names and trademarks are properties of their respective owners www.vantecusa.com …

• ADLINK Technology NuDAQ PCI-9810 (80 pages) Advance Technologies; Automate the World.Manual Rev. 3.00Revision Date: March 10, 2005Part No: 51-11116-202NuDAQ PCI-9812/1020MHz Simultaneous 4-CH Analog Input Card User’s Manual …

• TEDIA OPT-1020 (2 pages) General descriptionThe OPT-1020 and OPT-1120 daughter boards provide the analog input signalisolation for the DAQ cards.OPT-1020 bandwidth 20kHz, isolation voltage 2.5 kV, screw terminalsOPT-1020B bandwidth 20kHz, isolation voltage 2.5 kV, BNC connectorOPT-1120 bandwidth 120kHz, isolation voltage 1.5 kV, screw terminalsOPT-1120B bandwidth 120kHz, isolation v …

• ADLINK Technology 72XX Series (74 pages) Advance Technologies; Automate the World.Manual Revision: 2.61Revision Date: July 4, 2009Part Number: 50-11104-202072XX Series24/48/96-CH Digital I/O CardUser’s Manual …

• Siemens CDC-4 (14 pages) Siemens Siemens Siemens Siemens Siemens IndustryIndustryIndustryIndustryIndustry,,,,, Inc. Inc. Inc. Inc. Inc.Building Building Building Building Building TTTTTececececechnologies Dihnologies Dihnologies Dihnologies Dihnologies DivisionvisionvisionvisionvisionP/N 315-034200-9INTRODUCTION The Model CDC-4 from Siemens Industry, Inc., is a card thatallows conve …

• Global American 1507603 (12 pages) Quick Reference Guide Mini PCI Serial Interface Module 1507603 …

Comments, Questions and Opinions: