Manualios.com

Apple iMac G5 Inverter, 17-inch Replacement Instructions Manual

  • iMac G5 Inverter, 17-inch Computer Hardware
  • ma7AmoAURkYaw
  • Replacement Instructions Manual
  • PDF / Adobe Acrobat Reader
  • 19

Apple iMac G5 Inverter, 17-inch Manual Online:

3.55, 2977 votes
Apple iMac G5 Inverter, 17-inch User Manual
Apple iMac G5 Inverter, 17-inch User Guide
Apple iMac G5 Inverter, 17-inch Online Manual

Text of Apple iMac G5 Inverter, 17-inch User Guide:

  • 033-2502 Rev. D  iMac G5 Inverter, 17-inch Replacement Instructions Follow the instructions in this sheet carefully. Failure to follow these instructions could damage your equipment and void its warranty. Note: Online instructions are available at http://www.apple.com/support/doityourself/. Tools Required • Use the tool provided, or a Phillips #2 screwdriver, pre

  • Apple iMac G5 Inverter, 17-inch, 2 - iMac G5 Inverter, 17-inch Important Things to Know 1. All customer removable screws are brass colored. Do not remove screws unless they are brass colored, or you will void your warranty . 2. A magnetized “L”-shaped Phillips screwdriver is included with the replacement part. 3. Remove the gray plastic inverter cover before returning the inverter to Apple. The procedure will show you how. 4. Ground yourself when working on the computer. The procedure will show you how to ground yourself. 5. Do not pull on individual wires when disconnecting a part; pull on the connector. 6. Keep drinks and other liquids

  • Apple iMac G5 Inverter, 17-inch, iMac G5 Inverter, 17-inch - 3 Opening the Computer Note: These instructions cover the iMac G5 (17-inch) models. The models may look slightly different from one shown in the illustration; however, the following procedure applies to both models. 1. Turn your computer off by choosing Shut down from the Apple ( K ) menu. 2. Disconnect all cables and the power cord from your computer. 3. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of the computer and slowly lay the computer face down as shown.

  • Apple iMac G5 Inverter, 17-inch, 4 - iMac G5 Inverter, 17-inch 4. Locate the three silver case screws circled below. You may have to lift the stand to locate the middle case screw. Note: These screws are captive; they are part of the display/bezel assembly and cannot be removed. Using the tool provided, or a Phillips #2 screwdriver, loosen the three captive screws. Turn the screws to the left until they stop turning. Don’t force the screws once they stop turning . 5. Holding the back cover by the metal stand, tilt the cover up and lift it off the computer. Set the back cover aside.

  • iMac G5 Inverter, 17-inch - 5 Removing the Inverter 1. To access the inverter assembly other service modules have to be removed. This procedure will show you how to remove and replace each module. As you remove each module, set it aside, along with the screws for that module. 2. Ground yourself. Touch the metal surface (as shown below) on the inside of the computer to discharge any

  • Apple iMac G5 Inverter, 17-inch, iMac G5 Inverter, 17-inch - 9 9. Lift the inverter straight up to disconnect the inverter board. 10. Disconnect the white connector (circled below) on the inverter board by pulling it straight up. Set the inverter board aside.

  • Apple iMac G5 Inverter, 17-inch, 10 - iMac G5 Inverter, 17-inch 11. Turn over the inverter as shown. Using your fingers or a flat-blade screwdriver, remove the gray plastic inverter cover by gently prying the tabs (circled below) away from the board. Note: Return the inverter board to Apple in the packaging provided. 12. Set the plastic cover aside. This cover will be attached to the replacement inverter board.

  • Apple iMac G5 Inverter, 17-inch, 12 - iMac G5 Inverter, 17-inch 3. Install the plastic cover on the replacement inverter board. Gently squeeze the board near each tab (circled) until all five tabs snap onto the board. 4. Connect the white connector on the inverter board to the midplane board. The connector is keyed, which means it can connect only one way. Route this cable around the silver post (to the right of the cable). Important: If the connector is not inserted correctly there will be no video on the display.

  • Apple iMac G5 Inverter, 17-inch, iMac G5 Inverter, 17-inch - 13 5. Lower the inverter into place and connect the black connector to the pins on the midplane board. Important: Make sure this connector is connected, or there will be no video. 6. Replace the inverter screw.

  • Apple iMac G5 Inverter, 17-inch, 14 - iMac G5 Inverter, 17-inch 7. Reconnect the inverter-to-display panel cable. Important: The connector is keyed (it fits together only one way). 8. Tuck the white connector under the metal tab and route the cable (near the top of the inverter board) under the logic board.

  • Apple iMac G5 Inverter, 17-inch, iMac G5 Inverter, 17-inch - 15 9. Locate the optical drive that you set aside. 10. With your thumb on the pull tab and your index finger behind the tab, push the optical drive in the direction of the arrow and then push down to seat the drive.

  • Apple iMac G5 Inverter, 17-inch, 16 - iMac G5 Inverter, 17-inch 11. The optical drive will click into place when you push down near the pull tab. Note: If the optical drive is not seated accurately, the rear case will not fit properly and the optical drive may not function. 12. Replace the three optical drive screws.

  • Apple iMac G5 Inverter, 17-inch, iMac G5 Inverter, 17-inch - 17 Closing the Computer 1. Replace the cover so that the slots on the top edge of the cover mate with the tabs on the display housing. 2. Tilt the back cover slightly and align the top edge with the tabs on the housing. Push the two together as you lower the back cover.

  • 18 - iMac G5 Inverter, 17-inch 3. Tighten the three captive case screws by turning them to the right. Don’t overtighten the screws. 4. Reconnect the power cord while the computer is face down and then position the computer in the upright position. Turn on the computer.

  • Apple iMac G5 Inverter, 17-inch, iMac G5 Inverter, 17-inch - 19  Apple Computer, Inc. © 2005 Apple Computer, Inc. All rights reserved. This document is protected under U.S. Copyright Law and International Treaties, and no part of this document may be reproduced in any form without written permission from Apple. Apple is not responsible for typographical, printing, or inadvertent errors. Apple Computer, Inc. 1 Infinite Loop Cupertino, CA 95014-2084 USA + 1 408 996 1010 http://www.apple.com Apple, the Apple logo, Mac, Macintosh, and the Mac logo are trademarks of Apple Computer, Inc., registered in the U.S. and other countries.

Related Products and Documents (Computer Hardware):

Comparable Devices:

# Manufacturer Model Document Type File Updated Pages Size
1 MyPressi Twist Operation & user’s manual mypressi/twist-1CG.pdf 08 Nov 2023 13
2 Sharp 27R-S100 Operation manual sharp/27r-s100-N95.pdf 17 Oct 2022 52 1.55 Mb
3 ViewSonic ViewPad 10s Specification sheet viewsonic/viewpad-10s-LE6.pdf 13 Aug 2023 2 0.63 Mb
4 Philips MCD179 Specifications philips/mcd179-82D.pdf 28 Nov 2022 3 0.51 Mb
5 Philips MC175 Specifications philips/mc175-251.pdf 11 Aug 2022 2 0.08 Mb
6 Texecom Premier 412 Installation manual texecom/premier-412-88B.pdf 19 Apr 2023 100

Similar Resources:

  • Carrier

    48GP (N) 024-060

    (30 pages)
    48GP (N) 024-060, 48JZ (N) 024-06050GL 024-060, 50JZ 024-060ICM FIOP Installation InstructionsInstallation, Start-Up, and Operating InstructionsNOTE: Read the entire instruction manual before starting theinstallation.TABLE OF CONTENTSSAFETY CONSIDERATIONS .....................................................1INTRODUCTION ..................................... …
  • Kontron

    CP6500-V

    (192 pages)
    CP6500-V6U CompactPCIIntel® Celeron® Based CPU BoardManual ID: 28945, Rev. Index 0104 March, 2005The product described in this manual isin compliance with all applied CE stan-dards.P R E L I M I N A R YUSER GUIDE28945.01.UG.VC.050304/090948 …
  • Crestron

    DGE-100

    (5 pages)
    The Crestron® DGE-100 and DM-DGE-200-C are high-performancedigital graphics engines for the Crestron TSD-2220 and third-party touchscreen displays. The DGE-100 and DM-DGE-200-C feature SmartGraphics® technology that may be used to create a custom graphicalenvironment for controlling audio, video, lighting, shades, HVAC, security,and other amenities, or use …
  • XSPC

    Razor 4870X2 Full Cover VGA

    (2 pages)
    www.xspc.bizRazor 4870X2Full Cover VGA1. The waterblock is designed for Crossfire setups so you can fit the G1/4” fittings to either side of the block. Decide which configuration is best for your system.Technical Details- Dimensions: 200 x 114 x 13mm (18mm at ports)- Ports: G1/4”Box Contents1 x 4870X2 Waterblock8 x Short Screws / Washers4 x Long Screws6 …
  • Acrosser Technology

    ACE-B8701

    (44 pages)
    Revision: 1.0 1 ACE-B8701 Board PCI I/O Board with discrete I/O, battery backup SRAM, Timer, Power-off intrusion Event Logger and Protect-U User Manual Manual Rev.: 1.0 Book Number: ACE-B8701-2010.08.19 …
  • Iomega

    ZIP drive 100

    (2 pages)
    Getting the Most out of Your Zip DriveA tremendous value ...Your Zip drive gives you unlimited, high capacity, high performancestorage. It's like having a hard disk upgrade, mobile storage, and a backupdrive all in one affordable and easy solution. With your Zip drive you can:Expand your computer storage – 100MB at a time ... Move your work todiffer …

Comments, Questions and Opinions: