Manualios.com

Apple ImageWriter II Service Source

Apple ImageWriter II Manual Online:

4, 2034 votes
Apple ImageWriter II User Manual
Apple ImageWriter II User Guide
Apple ImageWriter II Online Manual

Text of Apple ImageWriter II User Guide:

  • Apple ImageWriter II, Troubleshooting General/ - 1 General The Symptom Charts included in this chapter will help you diagnose specific symptoms related to your product. Because cures are listed on the charts in the order of most likely solution, try the first cure first. Verify whether or not the product continues to exhibit the symptom. If the symptom persists, try the next cure. (Note: If you have replaced a module, reinstall the original module before you proceed to the next cure.) If you are not sure what the problem is, or if the Symptom Charts do not resolve the problem, refer to the Flowchart f

  • Apple ImageWriter II, Specifications Ribbons - 5 Ribbons Type Fabric; continuous loop Available Colors Black (Typical life: two million characters) Four-color (magenta, cyan, yellow, black) (Typical life: one million characters per color)

  • Specifications Performance - 2 Performance Print Modes/Speed Draft: 250 characters per second (cps) at 10 characters per in. (cpi) (2.5 pages per minute) Standard: 180 cps (2 pages per minute) Near-Letter Quality: 45 cps (.5 pages per minute) Line-Feed Rate Actual throughput will vary depending on computer and software.

  • Specifications Miscellaneous - 7 Miscellaneous Print Method Impact dot matrix Built-In Character Sets American, Italian, Danish, British, German, Swedish, French, and Spanish Selectable by using DIP switches or appropriate software Line Spacing 6 or 8 lines per in.; user programmable in increments of 1/144 in. (up to 99/144 in.) Graphic Densities

  • Troubleshooting Symptom Charts /Quick Problems - 2 Symptom Charts Quick Problems Error light blinks 1 Verify that carrier cover is secure. 2 Verify that carrier cover magnet is in place. 3 Try known-good software. 4 Verify that option card dip switch is open/off with no card installed. Select light off, error light on 1 Add paper or reset paper feed tray. 2 Check for p

  • Apple ImageWriter II, Specifications Paper Options - 6 Paper Options Format Cut sheet or fanfold continuous Width 3–10 in. (on pin-feed paper, hole centers must be spaced between 4 and 9.5 in.) Thickness .05–.28 mm

  • Apple ImageWriter II, Troubleshooting Symptom Charts/Carriage Movement - 7 Carriage Movement Carriage doesn’t move; LEDs are not lit 1 Replace drive board. 2 Replace transformer. 3 Replace filter assembly. Carriage doesn’t move; LEDs are lit 1 Replace main board. 2 Replace drive board. Carriage assembly moves to left and does not return to center 1 Check switch on print head board. If switch is frozen, replace print head board. 2 Replace main board. 3 Replace print head board. 4 Replace flexible ribbon cable. 5 Replace drive board.

  • Apple ImageWriter II, Troubleshooting Symptom Charts /Print Quality - 6 Power light on, no printing 1 Verify that ribbon frame assembly is riding on spiral ridge of color ribbon cam (see Adjustments). 2 Remove dot head, and verify that pins in connector on dot head board are not bent. 3 Go to Troubleshooting Table 2. Missing dots 1 Check flexible cable connection. 2 Remove dot head, and verify that pins in connector on dot head board are not bent. 3 Go to Troubleshooting Table 5.

  • Apple ImageWriter II, Troubleshooting Symptom Charts /Quick Problems - 4 Printing has squashed lines, misregistration problems when using pin feed paper 1 Clear entry and exit path of obstructions. 2 Check whether manual paper sensor, paper guide, or paper bail exerts too much pressure on paper. 3 Verify that tractor assembly does not let paper slip. 4 Check printhead gap (see Additional Procedures). 5 Avoid printing in top and bottom one inch of paper. 6 Try using 20-pound paper.

  • Apple ImageWriter II, Troubleshooting Symptom Charts /Carriage Movement - 8 Carriage moves to left and hums very loudly 1 Check flexible ribbon cable connection between drive board and carriage assembly. 2 Replace flexible ribbon cable. 3 Replace print head board. Self-test after take- apart produces no carrier movement (panel lights on) 1 Remove bottom cover and verify that wires to carrier motor are not pinched. Replace worn wires. 2 Replace fuse on drive board. 3 Replace drive board. Carriage assembly grinds or is h

  • Apple ImageWriter II, Specifications Character Format - 3 Character Format Fixed Alphanumeric Symbols Draft mode: up to 12 by 8 dot matrix Standard mode: up to 7 by 8 dots Near-letter-quality mode: up to 16 by 16 dots Custom (Downloaded) Characters Variable width, up to 16 by 8 dots

  • Apple ImageWriter II, Troubleshooting Symptom Charts /Paper Feed - 9 Paper Feed Grinding during paper feed 1 Remove platen knob and verify that there are no obstructions in gearing beneath knob. 2 Adjust paper guide (refer to Adjustments). 3 Replace paper feed motor. 4 Replace drive board. Paper-out sensor interferes with paper path; left side of paper fits “tighter” under platen than does right side 1 Verify that mechanical paper sensor is properly positioned.

  • Apple ImageWriter II, Specifications Character Pitches - 4 Character Pitches Draft, Standard, and Near-Letter Quality 9–17 cpi (72–136 characters per line), through use of normal and double-width modes Proportional Text 144 or 160 dpi

  • Apple ImageWriter II, Basics General Information - 1 General Information Paperless Printer Microviewer This manual contains only the Specifications, Symptom Charts and the Illustrated Parts List chapter for the ImageWriter LQ. The rest of the procedures are in the form of a Paperless Printer file located in the Printables folder. Troubleshooting Take Apart Adjustments

  • Apple ImageWriter II, Troubleshooting Symptom Charts /Print Quality - 5 Print Quality Compressed first or second line Replace main board. Print is darker or lighter on one side Remove or install shims. See General Information topic in Basics chapter. Open Additional Procedures document and refer to Shims topic. Top row of dots missing Perform ribbon adjustment (refer to Adjustments). Characters sometimes appear smudged, or top of form gradually creeps down page in one-line increments Verify that ImageWriter II driver software is most current version.

Related Products and Documents (Printer):

Comparable Devices:

# Manufacturer Model Document Type File Updated Pages Size
1 ADS L200e Owner's manual ads/l200e-X75.pdf 13 Aug 2022 6 3.44 Mb
2 RCA MAF90 Owner's manual rca/maf90-H5B.pdf 13 May 2023 2 0.45 Mb
3 Ewave EWDF25W Instruction manual ewave/ewdf25w-A5L.pdf 20 Dec 2023 14 0.23 Mb
4 Altec Lansing 1681A SIGNAL PROCESSING Manual  altec-lansing/1681a-signal-processing-F28.pdf 24 Oct 2023 1 0.04 Mb
5 Panasonic Viera TC-32LX700 Manual de instrucciones panasonic/viera-tc-32lx700-IAF.pdf 18 Oct 2023 53 24.08 Mb
6 EnGenius EGS5110P Operation & user’s manual engenius/egs5110p-4W8.pdf 28 Oct 2023 48 1.84 Mb

Similar Resources:

  • Canon

    PowerShot SX100 IS

    (412 pages)
    11111111111111111CDI-E331CanonHwerShotSXTOOISCameraUserGuide··············Get'ing······Sta.r;t~.~·.. ::---......:----_.=...--:::.----.···••••••••l·~.Cl··rr")i{"l.~•••••····M0r~·····....ComponentsGuideIIBasicOperationsIICommonlyUsedShootingFunctionsIIShooting Using the ModeDialIIVari …
  • Epson

    Stylus Pro 10000

    (104 pages)
    EPSON Professional Graphics Group Page 1.EPSON PRODUCT SUPPORT BULLETINDate: 3/25/04 Originator: rwsBulletin #: PSB.2004.03.006 Authorization:Reference: TE03-461 Rev.A, epson10997, TE03-620Rev.A, TE03-620 Rev.B Total Pages: 1Product: Stylus Pro 5500, 7600DYE, 7600UCM, 9600DYE, 9600UCM, 10000DYE, 10000CF, 10600UCMSubject: Driver Plug-in Up-Date v1.0cE for …
  • BIXOLON

    SRP-350II

    (8 pages)
    ◈ 안내 본 설치 안내서는 제품 설치에 필요한 간단한 정보만 기록하고 있습니다. 자세한 설치 안내는 첨부된 CD 의 사용 설명서를 참고하십시오. CD 에 포함되어있는 내용은 아래와 같습니다. 1. 매뉴얼: 사용 설명서, 코드표, 제어명령 2. 드라이버: Windows 드라이버, OPOS 드 …
  • Oki

    Microline 420

    (2 pages)
    It’s designed for commanding performance indemanding environments.The OKI®MICROLINE®420 9-pin printer and its wide-carriage counterpart ML421 are a quantum leapforward in Impact printer performance.Engineered for dedicated forms printing in the mostdemanding point-of-sale, automation and utilityenvironments, ML420/421 printers are right at homein applica …
  • LaserPro

    Mercury

    (13 pages)
    MercuryBeam AlignmentRemember to always wear safety glasses while doing any open beam tests.Copyright Koser Enterprises, Inc 2006Member of the LaserProNA.com groupRev 1.00002 …
  • Seiko

    FB-380

    (2 pages)
    FB-380 and FB-390DOT MATRIX PRINTERFast and cost effective!Customer service areaFront office applications Continuous forms and duplicates The ideal printer for:SSEEIIKKOO PPrreecciissiioonn MMaattrriixxpprriinntteerr FFBB--338800 && 339900Matrixprinter FB-380 and FB-390These two flatbed printers are fast, cost-efficient and provide convincing p …

Comments, Questions and Opinions: