Hitachi W 6V3 Handling Instructions Manual
|
Hitachi W 6V3, W8VB Item No. Part time 34 Internal Wire (B) 35 Carbon Brush 36 Brush Holder 37 Hook (A) 38 HITACHI Label 39 Earth Terminal 40 Connector (50091) 41 Internal Wire 42 Noise Suppressor 43 Noise Suppressor 44 Tapping Screw (W/Flange) D4×16 45 Cord Clip 46 Cord Armor 47 Tube (D) 48 Cord 501 + Driver Bit (A) No.2 25L 502 Magnetic Bit Holder Parts are subject to possible modification without notice due to improvements. The drawing and the list are parts structural drawing and parts list of model W8VB. For other models refer to the drawing and the list. Item No. Part time W8VB The exploded assembly drawing should be used only for authoized service center. 1 M
Hitachi W 6V3, 3 English GENERAL OPERATIONAL PRECAUTIONS WARNING! When using electric tools, basic safety precautions should always be followed to reduce the risk of fire, electric shock and personal injury, including the following. Read all these instructions before operating this product and save these instructions. For safe operations: 1. Keep work area clean. Cluttered areas and benches invite injuries. 2. Consider work area environment. Do not expose power tools to rain. Do not use power tools in damp or wet locations. Keep work area well lit. Do not use power tools where there is risk to cause fire or explosion. 3. Guard against electric shock. Avoid body contact with earthed or grounde
Hitachi W 6V3, 4 English STANDARD ACCESSORIES (1) No. 2 Plus bit .......................................... 1 (W6V3, W6VA3) (2) Magnetic hex socket (H= 10 mm) ......... 1 (W6VB2, W8VB) (3) Hook.....................................................................................1 Standard accessories are subject to change without notice. Magnetic bit holder (Short type) Magnetic bit holder Non-magnetic bit bolder Hex-socket Sub-Stopper (B) Magnetic type H = 6.35 mm H = 7.94 mm H = 9.53 mm H = 10 mm Non magnetic type H = 6.35 mm H = 7.94 mm H = 9.53 mm H = 10 mm H 1/4 H 5/16 H 3/8 Bit type Sub-Stopper 2. For other screws Bit holder Scr
Hitachi W 6V3, 5 English 4. Confirm the direction of bit rotation (Fig.1) The bit rotates clockwise (viewed from the rear side) when the reversing switch lever is set to the “R” side position. When the lever is set to the “L” side position, the bit rotates counterclockwise and can be used to loosen and remove screws. 5. Adjusting the tightening depth (Fig.2) Pull the lock sleeve in the direction of arrow to remove it from the spline installed in the gear cover. While pulling the lock sleeve and turning it right and left, adjust the position of locator. Push the lock sleeve and align the gear cover spline with the lock sleeve spl
Hitachi W 6V3, 6 English (3) Remove the carbon brushes from the brush holders. Assembly (1) Insert the new carbon brushes into the brush holders. (2) Insert the brush holders together with the carbon brushes into the brush holder chambers in the housing. (3) Ensure that the lead wire and other parts are properly positioned, and that there is no possibility of the lead wire coming in contact with the armature or other moving parts. (4) Reinstall the handle cover while ensuring that the internal wiring does not become pinched between the handle cover and the housing, and secure the handle cover with the three scre
Hitachi VH650 - Fencing Nailer, Full Head Power Screwdriver Instruction manual and safety instructions
VH650 - Fencing Nailer, Full Head |
Hitachi CL 10SA Power Screwdriver Technical data and service manual
CL 10SA |
Hitachi BRD-E2-30K Power Screwdriver Operation manual
BRD-E2-30K |
Hitachi DH24PF3 Power Screwdriver Instruction manual
DH24PF3 |
Hitachi RH600T Power Screwdriver Handling instructions manual
RH600T |
Hitachi CJ 120V Power Screwdriver Safety instructions and instruction manual
CJ 120V |
Hitachi EN-082302-1 Power Screwdriver Engineering note
EN-082302-1 |
Hitachi TR-12 Power Screwdriver Instruction manual
TR-12 |
# | Manufacturer | Model | Document Type | File | Updated | Pages | Size |
---|---|---|---|---|---|---|---|
1 | McCall | 1-1024UF | Quick reference | mccall/1-1024uf-2R7.pdf | 20 Jan 2023 | 2 | |
2 | CONSTRUCTA | CK 612 Series | Operating instructions manual | constructa/ck-612-series-C35.pdf | 05 Feb 2024 | 16 | |
3 | Audiovox | MM801 | Operation manual | audiovox/mm801-W31.pdf | 01 Jun 2023 | 15 | 0.11 Mb |
4 | Grizzly | H3118 | Parts list | grizzly/h3118-W8D.pdf | 21 Oct 2022 | 4 | 0.79 Mb |
5 | RCA | D36120 | Specification sheet | rca/d36120-XA8.pdf | 10 Sep 2023 | 6 | 0.99 Mb |
6 | Panasonic | KX-NCP500 | Manual | panasonic/kx-ncp500-JUG.pdf | 10 Nov 2022 | 96 |
ASG
Convert From To Multiply Byozf.in lbf.in 0.0625lbf.in ozf.in 16lbf.in kgf.cm 1.1519lbf.in lbf.ft 0.083333lbf.in kgf.m 0.011519lbf.in N.m 0.1130lbf.in dN.m 1.130lbf.ft N.m 1.356lbf.ft kgf.m 0.1382lbf.ft lbf.in 12N.m dN.m 10N.m kgf.cm 10.20N.m kgf.m 0.10197N.m lbf.in 8.8507N.m lbf.ft 0.73756dN.m lbf.in 0.885dN.m N.m 0.100kgf.cm lbf.in 0.8681kgf.cm N.m 0.09807k …
Pre-Set(2 pages) |
Makita
GB Cordless Angle Screwdriver Instruction ManualFVisseuse Industrielle à Renvoi d’AngleManuel d’instructionsD Akku-Winkelschrauber BetriebsanleitungI Avvitatore ad angolo a batteria Istruzioni per l’usoNL Accu haakse schroevendraaier GebruiksaanwijzingE Atornillador Angular Inalámbrico Manual de instruccionesP Parafusadeira Angular a Bateria Manual d …
DFL201F(48 pages) |
Bosch
Robert Bosch GmbHPower Tools Division70745 Leinfelden-EchterdingenGermanywww.bosch-pt.com2 609 006 337 (2012.07) O / 77 WEUWEU WEUPSB 10,8 LI-2de Originalbetriebsanleitungen Original instructionsfr Notice originalees Manual originalpt Manual originalit Istruzioni originalinl Oorspronkelijke gebruiksaanwijzingda Original brugsanvisningsv Bruksanvisning i orig …
PSB 10,8 LI-2(6 pages) |
Makita
GB Cordless Angle Screwdriver Instruction ManualFVisseuse Industrielle à Renvoi d’AngleManuel d’instructionsD Akku-Winkelschrauber BetriebsanleitungI Avvitatore ad angolo a batteria Istruzioni per l’usoNL Accu haakse schroevendraaier GebruiksaanwijzingE Atornillador Angular Inalámbrico Manual de instruccionesP Parafusadeira Angular a Bateria Manual d …
BFL201F(48 pages) |
Makita
FS2200 FS2300 FS2300X ENDrywall Screwdriver INSTRUCTION MANUAL 4SVGipsskruvdragare BRUKSANVISNING 7NOGipstrekker BRUKSANVISNING 10FIVäliseinä ruuvinväännin KÄYTTÖOHJE 13LVSkrūvgriezis sausam mūrim LIETOŠANAS INSTRUKCIJA 16LTAtsuktuvas gipsokartono plokštėmsNAUDOJIMO INSTRUKCIJA 19ETElektriline kruvikeeraja KASUTUSJUHEND 22RUШуруповерт …
FS2200(28 pages) |
Sparky Group
© 2005-2006 SPARKY720 W BVR 60605R02www.sparkygroup.comwww.sparkygroup.comDECLARATION OF CONFORMITYWe declare under our sole responsibility that this product is in conformity with the provisions of the following directives and the corresponding harmonized standards: 73/23/EEC, 98/37/EC, 89/336/EEC, EN 60745-1, EN 60745-2-14, EN 55014-1,EN 55014-2, EN 61000- …
BVR 6(42 pages) |
Krups Coffee Maker EA69 SERIESEA69 SERIES Manual - Q19461 EA69 SERIES, 238 |
GE Air Conditioner AJCS 12 DCBGE Air Conditioner AJCS 12 DCB Specifications AJCS 12 DCB, 3 |
Webasto Heater Telestart T91Webasto Telestart T91 User Guide (Installation manual), @76E9V7 Telestart T91, 4 |
BenQ Monitor M2700HDMonitor Operation & user’s manual (BenQ M2700HD) M2700HD, 42 |
Alpha Boiler Alpha CD25CUser Manual: Alpha Alpha CD25C (8VXV8E, Upd.Sun 12.2023) Alpha CD25C, 8 |
Bravetti Slow Cooker KC272BNSlow Cooker #D8O823 KC272BN, 18 |
Hama Power Supply 00086514#O82DPW: 00086514 Power Supply Operating instruction 00086514, 16 |
Panasonic Telephone KX-TCM415BPanasonic Product User Manual: KX-TCM415B PDF Operation & user’s manual - A8G759 KX-TCM415B, 52 |
Brother Printer 2460 - HL B/W Laser PrinterPDF Manual (@I271PI), Brother 2460 - HL B/W Laser Printer Printer (Monday 25-09-2023) 2460 - HL B/W Laser Printer, 245 |
Halo Lighting System Indoor Furnishing H2TMPSMLIndoor Furnishing PDF Specification H2TMPSML, 2 |
Crestron Switch CLW-DIM1PDF User Manual (@BJD481), Crestron CLW-DIM1 Switch (05.09.2023) CLW-DIM1, 12 |
Bahco Power Tool P-SLBahco P-SL User Manual (Doc Type: Power Tool Brochure) P-SL, 4 |