Goddess WFD 1025 M8 Instruction Manual

Text of Goddess WFD 1025 M8 User Guide:

• Goddess WFD 1025 M8, ENG ENG - 2 THE CONTENTS SECTION 1: BEFORE USING ............................................................................. 3 Safety warnings .................................................................................................... 3 Recommendations ................................................................................................ 3 SECTION 2: INSTALLATION .............................................................................. 4 Removal of transportation screws ........................................................................ 4 Adjustment of feet ...........................

• Goddess WFD 1025 M8, ENG ENG - 3 SECTION 1: BEFORE USING SAFETY WARNINGS • Do not use a multiple socket or extension cord. • Do not insert a plug with damaged or broken cord into the socket. • If the cord is damaged it should be replaced by the manufacturer or appointed service agent in order to avoid a hazard. • Never remove the plug from the socket by pulling from the cord section. Remove the plug by holding. • Do not plug the power supply with wet hands. • Never touch the machine with wet hands or feet.

• ENG ENG - 4 SECTION 2: INSTALLATION You must pay attention to the following issues before using your washing machine. REMOVAL OF TRANSPORTATION SCREWS • Transportation screws, which are located at the back side of the machine, must be removed before running the machine. • Loosen the screws by rotating counterclockwise by a suitable wrench. (DIAGRAM-1) • Remove the screws by pulling

• Goddess WFD 1025 M8, ENG ENG - 5 ELECTRICAL CONNECTION • Your washing machine works with 220-240V and 50Hz. • A special grounded plug has been attached to the network cable of your washing machine. This plug must denitely be inserted to a grounded socket with 10 ampere. The fuse ow value of the electricity line attached to this should also be 10 ampere. If you have no such sockets and fuses in your house, let it be made by a qualied electrician. • Our company will not be responsible for any damages that may occur as a result of usage without grounding. • Insert the machine’s plug to a grounded socket which you can easly reach. WATER SUPPLY CONNECTION •

• Goddess WFD 1025 M8, ENG ENG - 6 WATER DRAIN CONNECTION • Be sure that water inlet hoses are not folded, twisted, crushed or elongated by stretching. • Water drain hose should be mounted at a height of minimum 60 cm, maximum 100 cm from the ground. • The end of the water drain hose may directly be tted to the dirty water outlet hole or a special apparatus mounted on the outlet bracket of the wash-stand. • Never attempt to extend the water drain hose by adding extra parts. SECTION 3: TECHNICAL SPECIFICATIONS Brand Goddess Model WFD1025M8 Energy class A+ Voltage/Frekvency (V/Hz) (220-240) V/ 50Hz Electrical current (A) 10 Water presure (Mpa) Max. 1 Mpa/ Min. 0,1

• Goddess WFD 1025 M8, ENG ENG - 7 SECTION 4: CONTROL PANEL WFD1025M8 (3 buttons, adjustable thermostat) 1) Detergent drawer 2) Start/pause light 3) Function indicator lights 4) Temperature adjustment knob 5) Program ready light 6) Program knob 7) Start/pause button 8) Function buttons 9) Program end light

• Goddess WFD 1025 M8, ENG ENG - 8 START/PAUSE BUTTON Used to start a selected program or pause during running. WARNING! It is required for the program knob to be brought to O (off) position before selecting the program or changing a continuing program. FUNCTION INDICATOR LIGHTS When the start/pause button or any function button is pressed, the corresponding light turns on.The light turns off when the function button or start/pause button is re-pressed, or when the process the selected function is completed. The function indicator lights are also used in failure detection system mentioned in section 9. FUNCTION BUTTONS (depends on selected model – see the control panel of your washi

• Goddess WFD 1025 M8, ENG ENG - 9 TEMPARATURE ADJUSTMENT KNOB (FOR WFD1025M8 ONLY) By the temparature adjustment knob, you can adjust the washing water temparature of your clothes between O (cold wash) and 90˚C. When you are selecting the washing water temparature, pay attention to the international washing signs on your clothes. PROGRAM KNOB With the program knob, you can select the program with which you desire to wash your clothes. You can adjust the program selection process by turning the program knob in both directions. You must be careful that the adjustment sign of the program knob is exac

• Goddess WFD 1025 M8, ENG ENG - 10 BEFORE WASHING Discrimination of your laundry • Discriminate your clothes according to their types (cotton, synthetic, sensitive, woolen, etc.), washing temperatures and level of dirtiness. • Never wash your white and coloured clothes together. • Since your new coloured clothes may shed dye on the rst wash, wash them separately. • Be careful that no metal pieces are found on or in the pockets of your clothes, remove if there is any. • Zip and button your clothes. • Remove the plastic or metal hooks of the curtains and laces or place them inside a washing bag and tie. Pull the t

• ENG ENG - 11 Filling detergent in the machine The quantity of the detergent that you will ll in your machine depends on the following criteria: • Your detergent consumption will change according to the dirtiness level of your clothes. For your slightly dirty clothes, do not pre-wash and put a small amount of detergent in the compartment no.2 of the detergent drawer

• Goddess WFD 1025 M8, ENG ENG - 12 Cancellation of the Program If you desire to end a running program early: Press the start/pause button. Turn the program knob to O (off) status. Turn the program knob to “Draining” or “Spinning” programs. The program ready light will be on. Run the program you have selected by pressing the start/pause button. Program ending Your machine will automatically stop when the program you have selected ends. The program end light will be on. Turn the program knob to O (off) position • The door will be unlocked in approximately two minutes after the program ends.You can open the door by pulling the handle of the door towards yo

• Goddess WFD 1025 M8, ENG ENG - 13 SECTION 6: MAINTENANCE AND CLEANING • Unplug your machine. • Close the water tap. WATER INLET FILTERS On the tap part of your machine’s water inlet hose and at the ends of water inlet valves, there are lters to prevent entrance of the dirt and foreign materials in the water to the machine. If the machine is unable to receive sufcient water although your water tap is opened, these lters should be cleaned. PROGRAM Max. Temp. (°C) ** Program duration (min) DETERGENT COMPART. MAX DRY LOAD CAPACITY (kg) TYPE OF LAUNDRY EXPLANATI- ONS WFD1025M8 90˚ COT

• Goddess WFD 1025 M8, ENG ENG - 14 • Remove the water inlet hose. • Remove the filters found on the water inlet valves by using a pincer and wash thoroughly with a brush. • Clean the filters of the water inlet hoses located on the tap side by removing manually together with the seal. • After you clean the filters, you can fit them the same way as you have removed. PUMP FILTER The pump lter system elongates the life of your pump, which is used to drain the dirty water. It prevents lint to enter the pump. Cleaning o

• Goddess WFD 1025 M8, ENG ENG - 15 DETERGENT DRAWER Detergents may form a sediment in your detergent drawer or in housing of the detergent drawer in time. To clean the sediment, pull out the detergent drawer from time to time. To pull out the detergentdrawer: • Pull the detergent drawer to the end. (DIAGRAM-1) • Lift the front of the drawer, continue to pull until the drawer is pull out. (DIAGRAM-2) • Wash will an old toothbrush and excessiveamount of water. • Take off the leftover detergent avoid to drop into your machine. • After drying the detergentdrawer put into the housing in the same manner you pull out. DIAGRAM 1 DIAGRAM 2 SIPHON PLUG Pull out t

• ENG ENG - 16 THE DRUM Do not leave metal parts like needles, staples or coins inside your machine. These pieces cause formation of rust stains in the drum. To eliminate these stains of rust, use a cleaning substance without chlorium and follow the warnings of the cleaning substance producer. For cleaning of the rust stains, never use dish-washing wires or simila

• Goddess WFD 1025 M8, ENG ENG - 17 Blood stain: Lay your clothes in cold water for 30 minutes. If the stain still does not disappear, lay in mixture of water and ammonia (3 table-spoons of ammonia in 4 liters of water)for 30 minutes. Cream, ice-cream and milk: Lay your clothes in cold water and rub the stained area with detergent. If the stain has still not disappeared, apply lye on the fabric of your clothes in proper proportion.(Do not use lye on coloured clothes.) Mould: Mould stains should be cleaned as soon as possible. The stain should be washed with detergent, and if it does not disappear, it should be wiped with oxygenated water (in proportion of 3%). Ink: Hold the stained are

• ENG ENG - 18 SECTION 8: AVOIDING MINOR FAULTS All repairing which must be done on the machine should be done by authorized service. When a repairing is required for your machine or you are unable to eliminate the failure with the help of the information given below: • Unplug the machine. • Close the water tap. • Apply to the nearest authorized service station. FAULT POSSIBLE CAU

• Goddess WFD 1025 M8, ENG ENG - 19 FAULT POSSIBLE CAUSE REMOVING METHODS The water is drained from the machine as soon as it is lled. The end of the water drain hose is in a position too low according to the machine. Place the water drain hose in an appropriate height. (**) No water is seen in the drum during washing. No failure. The water is at the lower part of the drum. - There are residues of detergent on the clothes. The pieces of some detergents which do not dissolve in water may stick to your clothes as white stains. By calibrating your machine

• Goddess WFD 1025 M8, ENG ENG - 21 We reserve the right to change technical specifications. For any further information, please write to: [email protected] WARNING: Do not use this product near water, in wet areas to avoid re or injury of electric current. Always turn off the product when you don’t use it or before a revisi- on. There aren’t any parts in this appliance which are reparable by consumer. Always appeal to a qualied authorized service. The product is under a dangerous tention. Old electrical appliances, used batteries and accumulators disposal This symbol appearing on the product, on the product acc

Related Products and Documents (Washer):

Comparable Devices:

Similar Resources:

• Graco PRO-WASH 112634 (26 pages) Instructions – Parts ListGRACO INC.ąP.O. BOX 1441ąMINNEAPOLIS, MNą55440-1441Copyright 1999, Graco Inc. is registered to I.S. EN ISO 9001PRO-WASHt Gun WasherWith Huskyt 307 Pump100 psi (0.7 MPa, 7 bar) Maximum Working Pressure308393JRead warnings and instructions.See page 2 for List of Models and page 5 forGun Washer Descriptions.Model 112634 Model 11263 …

• GE Profile WPRE6150K (2 pages) For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service, 800.626.2000.Listed by Underwriters LaboratoriesWPRE6150K GE Profile™ ENERGY STAR® 4.1 IEC Cu. Ft. Colossal Capacity High-Efficiency WasherSpecification Revised 6/09260189Circuit Requirements: An individual, properly …

• Indesit IWE 71451 (84 pages) GB1ContentsInstallation, 2-3Unpacking and levellingConnecting the electricity and water suppliesThe first wash cycleTechnical dataDescription of the washing machine, 4-5Control panelDisplayRunning a wash cycle, 6Wash cycles and options, 7Table of wash cyclesWash optionsDetergents and laundry, 8Detergent dispenser drawerPreparing the laundrySpecial wash cycle …

• Miele G 7804 (60 pages) Operating instructionsWasher-disinfectorG 7804To avoid the risk of accidents ordamage to the machine it isessential to read these instructionsbefore it is installed, commissionedand used for the first time.M.-Nr. 05 841 051en - GB, AUS …

• Miele PFD 101i (2 pages) Vor dem Verschieben des Geschirr-spülers Füße eindrehen.Screw the feet in before moving the dishwasher.Faites entrer les pieds en les vissant avant de déplacer le lave-vais-selle.Draai de stelvoeten naar binnen voordat u de afwasautomaat verschuift.Avvitare i piedini prima di muovere la lavasto-viglie.Antes de deslizar el lavavajillas, atornillar las pat …

• Asko W6021 (2 pages) StartStopProgramsTemperature ˚F85105175120160205140NormalRinseQuickPermapressHeavyStainDrainSpinHand/DelicateWoolSuper quickWe know you’re excited about owning an ASKO washing machine and you’re anxious to get started, so here is a brief summary of theoperating procedures. To get the most of the features of your machine, we recommend that you read your …

Comments, Questions and Opinions: