Fujitsu Q802 Operating Manual

Text of Fujitsu Q802 User Guide:

• Fujitsu Q802, GNU GENERAL PUBLIC LICENSE 66 Fujitsu • c) Prohibiting misrepresentation of the origin of that material, or requiring that modified versions of such material be marked in reasonable ways as different from the original version; or • d) Limiting the use for publicity purposes of names of licensors or authors of the material; or • e) Declining to grant rights under trademark law for use of some trade names, trademarks, or service marks; or • f) Requiring indemnification of licensors and authors of that material

• Troubleshooting RAID operation errors Fujitsu 55 Troubleshooting RAID operation errors If the RAID configuration for the NAS is incorrect or error messages are displayed, please try the following solutions: i It is essential to back up all important data on the NAS first to mitigate any potential data loss. Check the following to determine if the RAID rebuild has failed: �

• Fujitsu Q802, Installing the NAS Fujitsu 9 Installing the NAS For information on hard disk installation, please refer to the "Quick Start Guide". List of recommended hard disks This product will work with 2,5/3,5 inch SATA hard disks from major hard disk manufacturers. A list of compatible drives can be found at http://support.ts.fujitsu.com. ! Fujitsu Technology Solutions will accept no liability whatsoever for any product defects/faulty operation, and/or any time and costs associated with data loss/data recovery, insofar as the cause can be attributed to misuse or improper i

• Fujitsu Q802, NAS maintenance Fujitsu 53 Failure or malfunction of a hard disk Please proceed as follows if a hard disk malfunctions or fails: ► Make a note of all unexpected behaviour and/or error messages to assist the technician. ► Stop using the NAS for any purpose and switch it off. ► Contact technical support. i The NAS must be repaired by a trained technician. Never try to repair the NAS yourself. Power failure or abnormal shutdown Following a power failure or improper shutdown of the NAS, when the system is restarted it should normally restore to the same state it was in before the shutdown or power failure. If the system does not function properly a

• Fujitsu Q802, FTP server Fujitsu 41 FTP server The NAS supports the FTP service. To use the FTP service, enable this function in Network Services and follow the steps below: ► Open Internet Explorer and enter ftp://[NAS IP] or ftp://[NAS Name]. i It is essential that secure passwords are used when using the FTP server. A secure password contains numbers, letters and special characters.

• Fujitsu Q802, NAS maintenance 54 Fujitsu EuP mode configuration (for compliance with legal standby requirements) The EU directive 2009/125/EC defines ecodesign requirements for energy-related products. In order to comply with this directive, the EuP mode needs to be activated. ► Activate EuP mode under Control Panel - System Settings - Power. When EuP mode is enabled, the following settings will be affected so that the server maintains low power consumption (less than 0.5W) when the server is powered of

• Fujitsu Q802, NetBak Replicator Fujitsu 45 NetBak Replicator NetBak Replicator is a powerful data backup program (Windows only). Selected files and folders from the local PC can be backed up in user-defined share folders on the NAS. Data is transferred via LAN or WLAN. Installing NetBak Replicator ► Select Install NetBak Replicator from the menu on the NAS CD. ► Follow the on screen instructions to install the application. ► A shortcut icon will appear on the desktop upon successful completion of the installation process.

• Fujitsu Q802, GNU GENERAL PUBLIC LICENSE Fujitsu 69 16. Limitation of Liability. IN NO EVENT UNLESS REQUIRED BY APPLICABLE LAW OR AGREED TO IN WRITING WILL ANY COPYRIGHT HOLDER, OR ANY OTHER PARTY WHO MODIFIES AND/OR CONVEYS THE PROGRAM AS PERMITTED ABOVE, BE LIABLE TO YOU FOR DAMAGES, INCLUDING ANY GENERAL, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING OUT OF THE USE OR INABILITY TO USE THE PROGRAM (INCLUDING BUT NOT LIMITED TO LOSS OF DATA OR DATA BEING RENDERED INACCURATE OR LOSSES SUSTAINED BY YOU OR T

• Fujitsu Q802, CELVIN® NAS Server Operating Manual Your CELVIN® NAS Server … 3 Installing the NAS 9 Connecting to the NAS 30 Copying data using the front USB port 37 Web Server 39 FTP server 41 Using the QGet download software 42 NetBak Replicator 45 Firmware update 47 NAS maintenance 50 Troubleshooting RAID operation errors 55 Technical data 59

• Fujitsu Q802, Installing the NAS 14 Fujitsu Use the Select button to select further options, e.g. RAID 6. Proceed as follows to select a standard drive configuration: ► Press Enter. The following message is displayed: Choose RAID5? No ► Use the Select button to select Yes. ► Confirm your selection by pressing Enter. When you execute RAID 1, RAID 5, RAID 6 or RAID 10 configuration, the system will initialize the hard drives, create the RAID device, format the RAID device, and mount it as a volume on the NAS. The progress will be shown on the LCD panel. When it

• Fujitsu Q802, Your CELVIN® NAS Server … Fujitsu 3 Your CELVIN ® NAS Server … Thank you for purchasing a CELVIN ® NAS Server. These operating instructions provide detailed information on the use of this product. Please read the instructions carefully to enjoy the full benefit of the powerful functions offered by the CELVIN ® NAS Server. Safety Warnings ! Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. Dispose of used batteries according to the manufacturer’s instructions. Do NOT touch the fan inside the system to avoid serious injuries.

• Using the QGet download software 42 Fujitsu Using the QGet download software QGet is a powerful software tool for managing BT, HTTP and FTP download tasks on multiple NAS servers over LAN or WAN. QGet does away with the need to use the Web interface to log in to individual Download Stations on multiple servers separately to modify the settings one after

• Installing the NAS Fujitsu 15 When the configuration is finished, the NAS name and IP address will be shown. If the NAS fails to create the disk volume, the following message will be shown. Creating... RAID5 Failed View system information by the LCD panel When the LCD panel shows the NAS name and IP address, you may press the “Enter” button to enter the Main Menu. To d

• Fujitsu Q802, GNU GENERAL PUBLIC LICENSE Fujitsu 63 The Corresponding Source need not include anything that users can regenerate automatically from other parts of the Corresponding Source. The Corresponding Source for a work in source code form is that same work. 2. Basic Permissions. All rights granted under this License are granted for the term of copy right on the Program, and are irrevocable provided the stated conditions are met. This License explicitly affirms your unlimited permission to run the unmodified Program. The output from running a covered work is covered by this License only if the output, given its content, constitutes a covered work. This License acknowledges you

• Fujitsu Q802, GNU GENERAL PUBLIC LICENSE Fujitsu 65 A “User Product” is either (1) a “consumer product”, which means any tangible personal property which is normally used for personal, family, or household purposes, or (2) anything designed or sold for incorporation into a dwelling. In determining whether a product is a consumer product, doubtful cases shall be resolved in favor of coverage. For a particular product received by a particular user, “normally used” refers to a typical or common use of that class of product, regardless of the status of the particular user or of the way in which the particular user actually uses, or expects or is expected to use, the product. A product

• Fujitsu Q802, GNU GENERAL PUBLIC LICENSE 62 Fujitsu TERMS AND CONDITIONS 0. Definitions. “This License” refers to version 3 of the GNU General Public License. “Copyright” also means copyright-like laws that apply to other kinds of works, such as semiconductor masks. “The Program” refers to any copyrightable work licensed under this License. Each licensee is addressed as “you”. “Licensees” and “recipients” may be individuals or organizations. To “modify” a work means to copy from or adapt all or part of the work in a fashion requiring copyright permission, other tha

• Installing the NAS 24 Fujitsu RAID 5 Disk Volume The data are striped across all the hard drives in a RAID 5 array. The parity information is distributed and stored across each hard drive. If a member hard drive fails, the array enters degraded mode. After installing a new hard drive to replace the failed one, the data can be rebuilt from other member drives that

• Fujitsu Q802, Web Server Fujitsu 39 Web Server The NAS can be used to upload web pages, with the Web Server function providing a convenient way to manage a website. Interactive websites using Joomla!, PHP, and SQLite are also supported. ► Activate the Web Server function and enter the port number in Control Panel – Applications - Web Server. ► Web pages can be uploaded to the web folder using the following methods: – Using Samba: Open a web browser and enter \\[NAS IP]\Web or \\[NAS Name]\Web. Log in to the folder and upload the web pages. – By FTP: Log in to the FTP service and upload the web pages to the folder. – Using Web File Manager: Lo

• Fujitsu Q802, Copying data using the front USB port 38 Fujitsu Q902 ENTER SELECT POWER COPY STATUS LAN USB eSATA 1 2 1 = Copy button 2 = USB 2.0 i This function performs an incremental backup. After the first time data backup, the NAS only copies the files that have changed since the last backup. i If several partitions are available on the source storage device, a new folder for each partition is created on the target device as a backup folder. The backup folder is named after the backup date and the partition number, YYYYMMDD-1 for partition 1, YYYYMMDD-2 for partition 2, etc. If the source storage device only contains one partition, the backup f

• Fujitsu Q802, Remarks Information on the product description meets the design specifications of Fujitsu and is provided for comparison purposes. Several factors may cause the actual results to differ. Technical data is subject to change without prior notification. Fujitsu rejects any responsibility with regard to technical or editorial mistakes or omissions. Trademarks Fujitsu and the Fujitsu logo are registered trademarks of Fujitsu Limited or its subsidiaries in the United States and other countries. Microsoft and Windows are trademarks or registered trademarks of the Microsoft Corporation in the United States an

Related Products and Documents (Network Storage Server):

Comparable Devices:

Similar Resources:

• Imation NEXSAN E60 (6 pages) This Quick Start Guide covers all variants of the E60 and E48 and is intended to help you quickly get your unit unpacked, mounted, and connected. For detailed instructions, see the relevant Installation and Maintenance Manual or the Nexsan RAID Storage User Manual.Quick Start Guide1NEXSAN E60™/E48™ form-factor unitsTaking DeliveryUpon receipt of your Nex …

• Western Digital WDBLVH0080KBK (7 pages) TechnicalSupport Serviceshttp://support.wd.comwww.wd.comWD SENTINEL™ RX4100Basic Installation GuideIf you encounter problems with this pr oduct, please contact WD Technical Support.Western Digital, WD, and the WD logo, are register ed trademarks of Western Digital T echnologies, Inc. in the U.S. and other countries; andWD Sentinel is a trademark of Western …

• NETGEAR RNDU4000-100NAS (163 pages) 350 East Plumeria DriveSan Jose, CA 95134USASeptember 2011202-10654-06ReadyNAS for Home RAIDiator 4.2Software Manualx86 Models: Ultra Series (2, 4, 6)Ultra Plus Series (2, 4, 6)Pro PioneerNVX Pioneer …

• LaCie 12big Rack Network (83 pages) LaCie 12big Rack Storage ServerUser Manual page 1Table of ContentsTable of Contents1. Safety Guidelines ........................................................................................................ 71.1. Safe Handling .............................................................................................................................. 7 …

• Seagate BlackArmor WS 110 (2 pages) Perfect for when you need to:• Have extra data storage space for your PC or server.• Securely back up les.• Recover your entire system from a PC crash.• Protect backed up les with encryption.Interface USB 2.0, eSATACapacities 1TB, 2TBExternal Storage & Backup SystemBusiness-grade backup solution for PCs and serversBusiness-grade software …

• D-Link DSN-4000 (97 pages) D-Link System, Inc.™ xStack Storage DSN-1000 / 2000 / 3000 / 4000 / 5000 series Command Line Interface User’s Guide Version 1.5 …

Comments, Questions and Opinions: