Charnwood WOODBURNER Operating And Installation Instructions

Text of Charnwood WOODBURNER User Guide:

• Charnwood WOODBURNER, Before lighting the stove check with the installer that the work and checks described in the Installation Instructions have been carried out correctly and that the chimney has been swept, is sound and free from any obstructions. FUELS Wood Wood must be dry and well seasoned. Ideally it should be cut, split and stacked under cover for at least a year and preferably two years before being burnt. Hard woods, such as Ash, Beech and Oak are preferable to Soft woods such as Pine. The wood should be burnt in a bed of ash on the flat base of the stove. Burn

• Charnwood WOODBURNER, open for long periods as this can cause over-firing. For overnight burning they should be closed. The airwash control is used most of the time to control the burning rate and to keep the glass clean. Fully extended gives full airwash for faster burning and clean glass whereas fully closed gives slow overnight burning. It will not be possible to keep the glass clean if this control is fully closed, particularly just after refuelling. REFUELLING Keep the firebox well filled but do not allow fuel to spill over the top of the front fire bars. Care should be taken, espec

• Charnwood WOODBURNER, swept from the plate and into the fire. Return the throat plate to its correct position - raise the front of the plate, push it back and then lower it onto the retaining lugs. CHIMNEY SWEEPING The chimney should be swept at least twice a year. Where the top outlet or vertical rear flue connector is used it will generally be possible to sweep the chimney through the appliance. First remove the front fence and the throat plate. Then sweep the chimney ensuring that soot is removed from all horizontal surfaces after sweeping. In situations where it is not possible to sweep through the appliance the installer

• regulations state that the hearth must extend in front of the stove by at least 300mm (12 inches) and to the sides of the stove by at least 150mm (6 inches). If in doubt as to the positioning of the stove expert advice should be sought either from the supplier or the local building inspector. The fireplace must allow good circulation of air around the appliance to ensure that maximum heat is

• Charnwood WOODBURNER, FITTING THE OPTIONAL ADD-IN BOILER The boiler replaces the rear firebrick. Before fitting the boiler, remove the front fence, the throat plate and the rear firebrick. Knock out the knock-outs for the boiler tappings in the back of the firebox. Remove the back nuts and washers supplied with the boiler and fit the boiler into the appliance. Place the fibre washers over the tappings on the outside of the appliance and fit the two backnuts, ensuring that the boiler is held tightly against the rear inside face of the appliance and that the top edge of the boiler is level or runs up

• Charnwood WOODBURNER, chimney to be swept through the stove. Soot doors may either be in the actual brickwork of the chimney or in the register plate. Various positions of soot doors are shown in Figs. 4 to 7. PRE LIGHTING CHECK Ensure that the throat plate is fitted in the roof of the appliance. The location and positioning of the throat plate is shown in Fig. 2. Before initial lighting check that the front fence is fitted correctly and that the doors tighten properly. COMMISSIONING On completion of the installation and after allowing a suitable period of time for the fire cement and mortar to dry out, make a layer of ash or sand on the base of the stove, light a small fire and check

Related Products and Documents (Cooktop):

Comparable Devices:

Similar Resources:

• Maytag MEC4430W - 30 in. Electric Cooktop (12 pages) ELECTRIC BUILT-IN COOKTOPS30" (76.2 CM) AND 36" (91.4 CM)INSTALLATION INSTRUCTIONSINSTRUCTIONS D'INSTALLATION DELA TABLE DE CUISSON I_LECTRIQUE ENCASTRI_E DE30" (76,2 CM) ET 36" (91,4 CM)TableofContents/Tabledes Mati@resBUILT-IN COOKTOP SAFETY ....................................................... 2INSTALLATION REQUIREMENTS ........ …

• Frigidaire FGF366DQB (24 pages) 2Controls ............... 8Oven Control Functions ................ 9Setting Oven Controls ............ 10-14Self Cleaning ........................... 15-16General Care & Cleaning ....... 17-19Ill,ilIVisit the Frigidaire Web Site at:http://www.frigidaire.comAdjusting Oven Temperature ....... 19Before You CallSolutions to Common Problems ................ 2 …

• Viking RVDR33025BSS (14 pages) ®Viking Range, LLC111 Front StreetGreenwood, Mississippi 38930 USA(662) 455-1200For product information, call 1-888-845-4641or visit the Viking Website at vikingrange.comF21189 EN(053113)3 SeriesFreestanding 30” Dual Fuel Self-Clean Sealed Burner RangeInstallation …

• Kenmore 66592152300 (11 pages) JnstaJJatJoninstructions38" EJectHcFreestandin9RangeTabJe of Contents:Before you start ........................... 2Product dimensions ........................ 4Cabinet dimensions/requirements ........... 4-5EHectricaH requirements .................... 6-8Installation steps ........................ 9-17Jf range does not operate ................... 18Mov …

• Fisher & Paykel OR60SDBSX2 (8 pages) Installation instructions - Ceramic Glass Cooktop ModelsPlease follow the installation steps below to ensure your glass cooktop operates correctly.Ceramic Glass Cooktop ModelsDimensions and clearances• The cooker must be installed at least 50 mm away from any side walls higher than the cooktop. The cabinetrysurrounding the cooker must be made of heat-resis …

• GE PP945SMSS (2 pages) Dimensions and Installation Information (in inches)For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service, 800.626.2000.PP945SM GE Profile™ 30" Built-In CleanDesign Electric Cooktop 220591Listed by Underwriters Laboratories†Note: Check local codes for required breake …

Comments, Questions and Opinions: