Manualios.com

Barco Color Coronis 2MP Installation & User Manual

Barco Color Coronis 2MP Manual Online:

4.85, 1854 votes
Barco Color Coronis 2MP User Manual
Barco Color Coronis 2MP User Guide
Barco Color Coronis 2MP Online Manual

Text of Barco Color Coronis 2MP User Guide:

  • Barco Color Coronis 2MP, Table of Contents 6 Color Coronis 2MP BarcoMed Driver Tab ......................................................................... 76 Introduction ................................................................................ 76 Using the BarcoMed Driver Tab ................................................. 76 Status .......................................................................................... 78 Drawing Modes .......................................................................... 79 Monitor Configuration ..............................................

  • Barco Color Coronis 2MP, Display controller installation Color Coronis 2MP 33 Installing the BarcoMed 2MP2CF-3D display controller Caution: Wear a grounded, protective ESD strap during installation or handling of the display controller. Electrostatic charges can damage the display controller. Prior to installing your BarcoMed 2MP2CF-3D display controller in your PC please take a few minutes to familiarize yourself with both the display controller and the AGP slot in your computer. Figure 4: The BarcoMed 2MP2CF-3D display controll

  • Preface 12 Color Coronis 2MP Canadian notice This Class A digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la Classe A est conforme à la norme NMB-003 du Canada. Disposal Information The lamps inside the display contain mercury. Do not throw the display in the trash. Dispose of it as required by local ordinances or regulations.

  • Barco Color Coronis 2MP, Advanced display operation 130 Color Coronis 2MP Firmware Firmware is a submenu from General Information, containing the following items: Runtimes Runtimes is a submenu from General Information, containing the following items: Name Description Boot Code Version The version of the internal boot code Run Code Version The version of the internal run code CPLD Code Version The version of the internal CPLD code FPGA Version The version of the internal FPGA code Mezzanine Version The version of the internal Mezzanine cir- cuit code Preset Table Version The version of the predefined Preset table Na

  • Barco Color Coronis 2MP, Standard Display operation 106 Color Coronis 2MP Input Selection, all items from the main menu contain one or more sub-menus. The content of the OSD depends on the selected video input: A number of functions is not present when you have selected the digital (DVI) video input, because the digital video signal requires less adjustment than the analog video signal. It is indicated throughout this manual if a function is not present when DVI input is selected. Main menu and submenu MFCD 2320/2321 MAIN MENU Autoset Video Contrast Video Brightness Luminance Adjustments Input Selection Auto Settings Preset Information EXIT

  • Barco Color Coronis 2MP, Troubleshooting Color Coronis 2MP 143 No image during PC start- up • Check the VGA jumper settings on the display controller • Check the CMOS settings in the PC BIOS Nothing happens when you press or rotate the control wheel • The User Controls may be disabled. Please read the paragraph about the “User Controls” function. The image is non-propor- tionally spread out over the screen • Select another resolution in the Windows “Display Properties” control panel • Switch the “Scaling” function (Geometry menu) in the display OSD to “None” or “Best Fit” The image on the screen is rotated 90° • Select another resolution in the Windows “Display

  • Barco Color Coronis 2MP, Software installation Color Coronis 2MP 65 Figure 28: Windows XP Windows Logo Testing Warning When the Driver Install Wizard tells you that it has successfully installed the selected driver, click “Finish”. The wizard will now begin installing the next selected piece of BarcoMed Software. If you are working with the default selections, this will be the Barco DPMS Screen Saver. Please turn to the section, “Barco DPMS Screen Saver installation” on page 66. If the installation of the products you selected at the beginning is complete, click �

  • Barco Color Coronis 2MP, Parts, controls and connectors Color Coronis 2MP 29 7. USB upstream port USB 1.1 standard is supported. Connect this connector to the PC USB bus if you wish to control the display via the USB bus or if you simply wish to connect USB devices to the display’s USB downstream port. 8. DC power input Connect the external power supply, delivered with the display, to this connector. 9. RS-232 output (D-Sub 9 male) Connect this connector to the RS-232 input of the following display if you wish to control that display via RS-232. In tha

  • Advanced display operation Color Coronis 2MP 125 Advanced functions in the Settings menu Display Function See the Glossary section for more information about display functions. The display contains a number of factory-defined and user- defined lookup tables (LUTs) to define the display (transfer) function. Name Description Native If you select Native, a linear LUT wil

  • Barco Color Coronis 2MP, Troubleshooting 144 Color Coronis 2MP Windows 2000 display resolution Tip: These instructions apply to both Windows ® 2000 and Windows ® XP. Setting the resolution of your Color Coronis 2MP display In order to set the resolution of your Color Coronis 2MP display you must be logged in using an account with administrator privileges. 1. To set the resolution of your Color Coronis 2MP display(s) right click on the desktop and select “Properties”. 2. Select the “Settings” tab. 3. Select the rectangle that repr

  • Barco Color Coronis 2MP, Barco DPMS Screen Saver 94 Color Coronis 2MP Monitor Settings If you have a Barco Medical Display, select “Barco Quick Start.” If a non-Barco display is being used, select the amount of time it takes your display to warm up via the “Monitor Setting” section. Contact your display vendor for this warm-up time. On Barco C ORONIS displays, the I-GUARD will stabilize the image within a few seconds after the display returns to the active state so there is no need for a warm-up time period. Use As Logon Screen Saver Check the box to use the Barco DPMS Screen Saver when no one is logged into the system. Uncheck the

  • Barco Color Coronis 2MP, Warranty Statement Color Coronis 2MP 161 ARTICLE 1: SERVICES BarcoView warrants that the equipment will be free of defects in workmanship or material for the warranty period. Notwithstanding the provisions of clause 2, repair and replacement of defects in material and/or workmanship under this warranty shall be accomplished in our works in the following manner: 1.1 The Customer, upon the occurrence of any equipment failure, shall contact BarcoView Customer Support Center (or an authorized service center) by telephone, fax

  • Barco Color Coronis 2MP, Power connection Color Coronis 2MP 45 Power connection To connect the power: 1. To get access to the connectors, remove the connector compartment cover by pulling down the 2 clips at the top of the cover. 2. Connect the output of the 12V DC power supply to the DC input of the display. Figure 13 3. Connect one end of the proper power cable to the AC input of the 12V DC power supply. Figure 14

  • Barco Color Coronis 2MP, Advanced display operation 128 Color Coronis 2MP Extended input mode Name Description RBG->Y The RGB video signals from the imag- ing board are calculated and trans- formed into a single luminance value according to the formula 0.3R + 0.59B + 0.11G. This single luminance signal drives the RGB sub-pixels of the panel equally. GRB->Y The RGB video signals from the imag- ing board are calculated and trans- formed into a single luminance value according to the formula 0.3G + 0.59R + 0.11B. This single luminance signal drives the RGB sub-pixels of the panel equally. GBR->Y Th

  • Barco Color Coronis 2MP, Precautions Color Coronis 2MP 137 Precautions Precautions • Take care not to damage or scratch the glass or LCD panel. • Do not apply pressure on the glass or LCD panel. • Do not apply or spray liquid directly to the glass, panel or cabinet as excess liquid may cause damage to internal electronics. Instead, apply the liquid to the cleaning cloth. •DO NOT USE: - Lye or cleaning solutions containing lye* - Acid - Detergents with fluoride - Detergents with ammonia - Detergents with abrasives - Steel wool - Sponge with abrasives - Cloth with thread made of stee

  • Barco Color Coronis 2MP, BarcoMed Driver Tab 78 Color Coronis 2MP Figure 35: BarcoMed 2MP2CP-3D Driver Tab under Windows 2000 and Windows XP Status The Status section displays information about the current BarcoMed display controller, driver, and the currently selected display resolution. Graphics Board This displays the current BarcoMed display controller. Driver Version This displays the current BarcoMed driver version.

  • Barco Color Coronis 2MP, Driver re-installation, updates or removal 150 Color Coronis 2MP 10. When your system restarts, log in again using an account with administrator priveleges. DualView should now be disabled. 11. The “BarcoMed Product Installation Wizard” should automatically restart. Finish uninstalling the driver by clicking “Next” three times. Then click “Reboot”, “Finish” and “Yes”. If the “BarcoMed Product Installation Wizard” doesn’t automatically restart, finish uninstalling the driver by restarting the “Bar

  • Barco Color Coronis 2MP, Barco DPMS Screen Saver Color Coronis 2MP 91 Barco DPMS Screen Saver Introduction The Barco DPMS (Display Power Management Signaling) Screen Saver allows the user to set power and display saving features for medical displays controlled by BarcoMed display controllers. At the end of the work day, the display will enter certain DPMS states as requested by the display controller. Note: The Barco DPMS Screen Saver will not control any displays connected to a non-Barco display controller. The default state for the Barco DPMS Screen Saver is the Off state. In addition to simply entering the Off s

  • Copyright notice Color Coronis 2MP 3 Copyright notice Copyright This document is copyrighted. All rights are reserved. Nor this document, nor any part of it, may be reproduced or copied in any form or by any means - graphical, electronic, or mechanical including photocopying, taping or information storage and retrieval systems - without written permission of Barco ©

  • Barco Color Coronis 2MP, Package contents Color Coronis 2MP 25 Package contents Coronis System package Each Coronis system contains one or more display boxes (see below) and a system accessory box containing the following items: • Display controller(s) • CD-ROM with driver and documentation •MediCal Pro software • MediCal Pro user manual Display box Each display box includes one display and a display accessory box containing the following items: • Plastic cover of the tilt & swivel foot •Power supply • Digital video (DVI) cable (25-pins) • Analog v

Related Products and Documents (Monitor):

Comparable Devices:

# Manufacturer Model Document Type File Updated Pages Size
1 Stagg 40 GA DSP Operation & user’s manual stagg/40-ga-dsp-11P.pdf 28 Mar 2023 2 0.86 Mb
2 Clickfree C2 Quick start manual clickfree/c2-724.pdf 24 Jul 2023 3 0.11 Mb
3 JVC KW-R900BT Instructions manual jvc/kw-r900bt-STB.pdf 05 Jul 2022 66
4 Philips KALA 300 KALA 300 Operation & user’s manual philips/kala-300-kala-300-XYM.pdf 20 Aug 2023 22 3.16 Mb
5 Sony AZ-BS1 Operating instructions manual sony/az-bs1-XHF.pdf 13 Sep 2023 28 0.62 Mb
6 Palm SMS Operation & user’s manual palm/sms-M92.pdf 27 Mar 2023 24 0.26 Mb

Similar Resources:

  • Asus

    VG30V Series

    (32 pages)
    TUF Gaming Monitor VG30V seriesUser GuideQuesto manuale d’istruzione è fornito da trovaprezzi.it. Scopri tutte le offerte per Asus VG30VQL1Ao cerca il tuo prodotto tra le migliori offerte di Monitor …
  • Acer

    AL2016

    (45 pages)
    Acer Service Manual Service Manual LCD Monitor Acer AL2016 0 …
  • Sony

    PVM-X300

    (34 pages)
    ProfessionalVideo MonitorOperating InstructionsBefore operating the unit, please read this manual thoroughly and retain it for future reference.PVM-X300Software Version 1.14-451-638-14 (1)© 2012 Sony Corporation …
  • Sony

    LMD-A240

    (39 pages)
    4-527-034-12(1)Professional Video MonitorOperating InstructionsBefore operating the unit, please read this manual thoroughly and retain it for future reference.LMD-A240LMD-A220LMD-A170© 2013 Sony CorporationSoftware Version 1.1 …
  • Acer

    P201W

    (24 pages)
    TABLE OF CONTENTSSpecial notes on LCD monitors..................................................1Information for your safety and comfort..................................2Unpacking...................................................................................5Attaching/Removing the base....................................................6Screen position …
  • Sanyo

    DP19241

    (27 pages)
    ENGLISH© 2011 Sanyo Manufacturing Corporation19-Z6AEOwner’s ManualManual del usuarioDP1924147 cm diagonal / diagonale18. 5HDTV LCDTVHD de LCDPart No. / No. de parte:J3FR0321A- -Model No. / No. de ModeloLEDESPAÑOL3FR0321A_En.indd 13FR0321A_En.indd 1 1/7/11 4:31:53 PM1/7/11 4:31:53 PM …

Comments, Questions and Opinions: