Canon Stacker-C1 Operation & User’s Manual

Text of Canon Stacker-C1 User Guide:

• 2-6 Removing Sheets Operating Procedures 2 3 Replace the empty stack tray and close the front cover. The stack tray will move up automatically. · After you place the stack tray on the support, remove the handle. (If the handle is att ached to the stack tray, you will not be able to close the front cover.) · Push the stack tray to the rear until it is held by

• Canon Stacker-C1, 1-1 1 CHAPTER Before You Begin Features of the Machine ...................................................................................................................... 1-2 Machine Description ............................................................................................................................ 1-3 Section Descriptions ............................................................................................................................ 1-4 [1] Entrance Section........................................

• Canon Stacker-C1, Correcting Paper Curl 3-7 Troubleshooting 3 3 Press the +/- key on the operation panel and setup the curl correction. When + key is pressed, [AUTO] - [OFF] - [CONVEX +1] - [CONVEX +2] - [CONVEX +3] - [CONVEX +4] is displayed in order on LCD. When - key is pressed, [AUTO] - [CONCA VE -1] is displayed on LCD. If the stacked sheets are curled upward, select [CONCAVE]. If the stacked sheets are curled downward, select [CONVEX]. - If the curl correction function is set incorrectly , paper jam or stacking error may occur. - Curl correction function is availab

• Canon Stacker-C1, 3-1 3 CHAPTER Troubleshooting This section explains how to identify problems and correct them. Error Messages.................................................................................................................................... 4-2 Service Call Error............................................................................................................................ 4-2 Error Message Chart....................................................................................................................... 4-3 Clearing Paper Jams .....................................................................................

• 1-12 Control Displays Before You Begin 1 Control Displays Power On Machine processing settings. Preparation complete. Ready message Operating message Ready message Ejecting to the OUTPUT TRAY Ready message Operating message Ready-Paper removal message Ejecting to the Stack Tray Ready message Paper is output to the OUTPUT TRAY. Operation complete. Paper is output to the stack tray. Operation

• Canon Stacker-C1, 2-4 Removing Sheets Operating Procedures 2 Removing Sheets 1 When the stacking operation is complete, press the Front Cover Open button and remove the stacked sheets. While the stack tray is moving down, the button blinks. When pressing Front Cover Open Button during the machine is running, wait until the lamp lights up, and then open the cover. Front Cover Open Button Lit: Front cover can be opened. Blinking: Do not open the front cover. CAUTION

• Canon Stacker-C1, 2-1 2 CHAPTER Operating Procedures Stacking Sheets ................................................................................................................................... 2-2 Removing Sheets................................................................................................................................. 2-4

• Canon Stacker-C1, Paper Path 1-11 Before You Begin 1 Paper Path Single-Unit Operation [7] OUTPUT TRAY Section [2] Horizontal Transport Section [3] Left Turn-Over Section [D] Downstream Exit Section [1] Entrance Section [5] Right Turn-Over Section [4] Offset Section [6] Stacking Section

• Canon Stacker-C1, Clearing Paper Jams 3-5 Troubleshooting 3 Clearing Paper Jams Jam in the down- stream exit section • Paper chip is left. (See the Remedy 1) Jam in the left turn- over section • Paper chip is left. (See the Remedy 1) Jam in the stacking section • Paper chip is left. (See the Remedy 1) Jam in the entrance section • Paper chip is left. (See the Remedy 1) • Sheet loaded on the printer does not fit the setting on the printer. (See the Rem- edy 2) Jam in the horizontal transport section. • Paper chip is left.

• Canon Stacker-C1, 2-2 Stacking Sheets Operating Procedures 2 Stacking Sheets When different sizes paper are stacked together, the paper cannot be squared-up neatly. To square-up the paper neatly, stack only same size paper. 1 Turn on the power switch of the main unit, then turn on the power switch of the stacker. The LCD display presents the Wait screen. 2 When the machine preparation completes, the LCD display changes to the Ready screen. If the power switch on the machine is turned on while the power of the upstream machine (pri

• 4-2 Specifications Appendix 4 Specifications Specifications Product Name High Capacity Stacker-C1 Sheet Size/Paper Weight Range Stack Tray A3, A4, B4, B5, 11” x 17”, 12” x 18”, 13” x 19”, LGL, LTR, LTRR, EXEC, 8K (270 x 390 mm), 16K (270 x 195 mm), Tab Paper (A4, LTR) *1 , 320 x 450 mm (SRA3), User custom size (Max: 330.2 x 487.7 mm, Min: 216 x 182 mm) 64 to 325 gsm *2 OU

• 1-6 Section Descriptions Before You Begin 1 [3] Left Turn-Over Section This section turns over sheets delivered from the horizontal transport section. The second gate sends the sheets to the stack tray or to the next machine in the line. Second Gate This gate sends the sheets, to the stack tray of this machine, or to the con- nected downstream unit. Downstream Exit Section Any

• Canon Stacker-C1, 3-6 Correcting Paper Curl Troubleshooting 3 Correcting Paper Curl If the stacked sheets are curled, correct the curl from the operation panel. To correct the curl, perform the steps below in order. 1. Set up the curl correction to [AUTO]. 2. If the sheets are still curled after step 1 is performed, change the curl correc- tion amount on the printer. 3. If the sheets are still curled after step 2 is performed, set up the curl correction to [CONVEX], [CONCAVE], or [OFF]. 1 Press the [Menu] on the Standby screen [MENU CURL CORRECTION] will be displayed on LCD. 2 Press [Enter] on the operation panel. Error Enter Menu Stack ON/OFF +// Enter + Key Menu - Key Curl Correction

• Canon Stacker-C1, 3-4 Error Messages Troubleshooting 3 REMOVE JAMMED PAPER C A paper jam occurred in C section. Open the top cover , C guide and remove the jammed paper. Close the guide and the cover, and the printing will be restarted. *1 REMOVE JAMMED PAPER D1 2 A paper jam occurred in D1 and D2 E2 section. Open the top cover , C guide, front cover, D1 guide and turn the D2 E2 dial counterclockwise to remove the jamm ed paper. Close the guide and the cover, and the printing will be restarted. *1 REMOVE JAMMED PAPER D1 A paper jam occurred in D1 section. Open the front cover,

• Canon Stacker-C1, Machine Description 1-3 Before You Begin 1 Machine Description ON OFF [B] [A][8] [4] [7] [C] [3] [D] [6] [5] [1][2] [E] [F] [G] [H] [1] Entrance Section (See page 1-4). [2] Horizontal Transport Section (See page 1-5). [3] Left Turn-Over Section (See page 1-6). [4] Offset Section (See page 1-7). [5] Right Turn-Over Section (See page 1-8). [6] Stacking Section (See page 1-9). [7] Top Cover-OUTPUT TRAY Section (See page 1-10). [8] Control Panel (See page 1-10). [A] Power Switch [B] Stack Status LED Lit :Stacker is full. Blinking :Stacker is operating. [C] Front Cover Open Button (and LED) Lit: Cover unlocked. Blinking: Stack tray is moving up or down. [D] Downstream Exit Se

• Canon Stacker-C1, Control Displays 1-13 Before You Begin 1 - To correct the curl, perform the steps below in order. 1. Set up the curl correction to [AUTO]. 2. If the sheets are still curled after step 1 is performed, change the curl correc- tion amount on the printer. 3. If the sheets are still curled after step 2 is performed, set up the curl correction to [CONVEX], [CONCAVE], or [OFF]. - If the curl correction function is set incorrectly, paper jam or stacking error may occur. Refer to 3-6 [Correcting Paper Curl] for details. - Curl correction function is available only for the sheets delivered to the stack tray. JAPANESE - ENGLISH - FRENCH - GERMAN - ITA

• Canon Stacker-C1, 1-4 Section Descriptions Before You Begin 1 Section Descriptions [1] Entrance Section This section receives each sheet as it is delivered from the upstream machine (printer). The first gate sends the sheets to the stack tray or to the OUTPUT TRAY. First Gate This gate diverts the sheet transport path, to the stack tray/downstream unit, or to the OUTPUT TRAY. Entrance Transport Guide [ B] If any sheets jam in the entrance section, open the top cover, hold the green handle and open this guide, and r

• Canon Stacker-C1, i Important Information • This manual is designed to help you to install, operate and maintain the stacker. Please read and under- stand this manual, and keep it in a safe and convenient place. • Do not operate the stacker until you read and understand the instructions in this manual. • Canon shall not be liable for incidental or consequential damages resulting from: improper or inadequate maintenance by the customer, unauthorized modification or misuse, or operation outside of the environmen- tal specifications for the product. • Canon pur

• Canon Stacker-C1, Section Descriptions 1-5 Before You Begin 1 [2] Horizontal Transport Section Sheets delivered from the entrance section, pass here before being carried to the Left Turn-Over section. Left Turn-Over Section

• Canon Stacker-C1, © CANON INC. 2011 CANON SINGAPORE PTE. LTD. 1 HarbourFront Avenue #04-01 Keppel Bay Tower, Singapore 098632 CANON HONGKONG CO., LTD 19/F., The Metropolis Tower, 10 Metropolis Drive, Hunghom, Kowloon, Hong Kong CANON INC. 30-2, Shimomaruko 3-chome, Ohta-ku, Tokyo 146-8501, Japan CANON U.S.A., INC. One Canon Plaza, Lake Success, NY 11042, U.S.A. CANON CANADA INC. 6390 Dixie Road Mississauga, Ontario L5T 1P7, Canada CANON EUROPA N.V. Bovenkerkerweg 59-61 1185 XB Amstelveen, The Netherlands (See http://www.canon-europe.com/ for

• Canon Stacker-C1, Error Messages 3-3 Troubleshooting 3 Error Message Chart Error Message Cause Remedy CLOSE COVER TOP COVER The top cover is open. Close the top cover . CLOSE COVER OUTPUT TRAY COVER The OUTPUT TRAY cover is op en. Close the OUTPUT TRAY cover . REMOVE PAPER FROM OUTPUT TRAY The OUTPUT TRAY is full. Remove the paper from the OUT- PUT TRAY. REMOVE PAPER FROM STACKER The stack tray is full. Remove the paper from the stack tr ay. UNEVEN STACK REMOVE STACKER PAPER / IF PAPER IS CURLED PERFORM CURL ADJUST. 1. The paper is curled. 2. Paper on the stack tray is leant. Check the message displayed on t he host machine (printer) control panel. STACK

• Canon Stacker-C1, 4-1 4 CHAPTER Appendix Specifications ....................................................................................................................................... 4-2 Index .................................................................................................................................................... 4-3

Related Products and Documents (Tools):

Comparable Devices:

Similar Resources:

• Peak PAC Auto PAC 300 (189 pages) Peak Business Equipment, Inc. Ph. 888-584-7272 Fax. 314-209-7282 [email protected]: 888-584-7272Fax: 314-209-7282PAC Auto PAC 300 Strapping Machine Operation ManualSpare Parts ManualEmail: [email protected] …

• ITC KuDos HYCP-240R (14 pages) KuDos Mechanical Safe Operation & Maintenance InstructionsHydraulic Compression ToolHYCP-240RVersion: 2018/09Hydraulic Compression Tools are carefully inspected for qualityand tested for safety. We follow ISO 9001: 2015/ ISO 14001: 2015/ IECQ QC080001/ OHSAS 18001: 2007, CE Standards & UVDBATTENTION! Safe Operation & Maintenance Instructions m …

• Komet DIHART DAH 50 HS (2 pages) Bedienungsanleitung399 24 276 20-1T-08/10 Printed in Germany© 2010 KOMET GROUP GmbH Technische Änderungen, bedingt durch Weiterentwicklung, vorbehalten.We reserve the right to make modifications.DDIHART DAH® 50 HSKOMET GROUP GmbH74354 Besigheim · Zeppelinstr. 3 · GERMANYTel. +49(0)7143.373-0 · Fax +49(0)[email protected] · www.kometgro …

• Tennant TennantTrue 9045253 (4 pages) IB 9045270 (02- 2021) 1INSTRUCTION BULLETINNo. 9045270Machine: S16Published: 02- 2021Rev. 00NOTE: DO NOT DISCARD the Parts List from the Instruction Bulletin. Place theParts List in the appropriate place in the machine manual for futurereference. Retaining the Parts List will make it easier to reorderindividual p arts and will save th e cost of ordering an e …

• Forch 6600 6270 (36 pages) SLOProfi-Verbundglas-Reparatur-SetProfesionální sada pro opravy vrstveného sklaProfi stenslagsreparationssætVeiligheidsglas-reparatieset professioneelProfessional Windscreen Repair SetSet Professionnel de réparation pare-briseProfi-szélvédő javító készletKit riparazione cristalli auto IIZestaw do naprawy szyb samochodowychProfi set za popravak vje …

• Rittal 4055.000 (28 pages) Hand-Hydraulikstanze gerade, 90°, flexibelManual hydraulic punch straight, 90°, flexibleMontage- und BedienungsanleitungAssembly and operating instructions4055.0004055.0104055.020 …

Comments, Questions and Opinions: