Capital PSGR244 Installation Manual

Text of Capital PSGR244 User Guide:

• Capital PSGR244, contents 1 message i important safety warnings ii-iii contents 1 important installation instructions 2 STEP 1 unpacking, moving, and placing the range 3 STEP 2 ventilation requirements 4 STEP 3 3a cabinet preparation 4 cabinet clearances 6 3b backguard installation 7 3c electrical supply 8 STEP 4 installing anti-tip device 9 STEP 5 gas connection and hookup 11 testing and adjustments 13 caring for stainless steel 13 installer checklist 14 we're here for you 15 warranty 16

• Capital PSGR244, hello and welcome to Capital... We thank you for choosing our Performance Series™ cooking equipment. Because of the unique features found in our products, we recommend spending some time to familiarize yourself with this booklet before using your product. In it you will find valuable information on how to safely operate and maintain your appliance for years of enjoyable cooking. We understand that questions arise from time to time on use and care about our products, so we want to make it easy for you to find the answers. That’s why we pride ourselves on superior customer service and work harder to respond to your needs quickly and effectively. Our Customer S

• warnings ii IMPORTANT: Save these instructions for the Local Gas Inspector’s use. INSTALLER: Please leave these Installation Instructions with the unit for the owner. OWNER: Please retain these instructions for future reference. This range was designed for ease of installation and operation. However, we recommend that you read all sections of this m

• Capital PSGR244, warnings iii TESTED IN ACCORDANCE WITH ANSI Z21.1b-2003, 27th Edition, supplemented by CGA Interim Requirement 58b (IR58) STANDARD FOR HOUSEHOLD COOKING GAS APPLIANCES. IN CANADA TESTED IN ACCORDANCE WITH CUL 1.1 GAS RANGES, CURRENT ISSUE. Check your local building codes for the proper method of installation. In the absence of local codes, this unit should be installed in accordance with the National Fuel Gas Code No. Z223.1 Current issue and the National Electrical Code ANSI/NFPPA No. 70 Current issue or the Can B149 Installation Codes for Gas Burning Appliances and C22.1 Canadian Electrical Code Part 1. PLEASE NOTE: In the Commo

• Capital PSGR244, 2 important installation instructions INTRODUCTION: Capital’s Performance Series™ Gas Ranges are tested and approved in accordance with ANSI Z21.1b-2003/CGA IR 58, 1995, Household Cooking Appliances. It is STRONGLY RECOMMENDED that this appliance be installed in conjunction with a suitable overhead VENT HOOD. Due to the high heat output of this unit, particular attention should be paid to the hood and ductwork installation to assure it meets local building codes. special instructions for Massachusetts: Installation, electrical connections, grounding and gas connections must comply with all applicable codes. In the absence of local codes, the unit should

• Capital PSGR244, 3 step 1: unpacking, moving and placing the range CAUTION! Proper equipment and adequate manpower must be used in moving the range to avoid damage to the unit or the floor. The unit is heavy and rests on stainless steel legs. WARNING! DO NOT lift the range by the oven door handles! DO NOT remove the griddle and grill sections! 1) Remove the outer carton and packing materials from the shipping base. The all gas ranges are held to the skid by four (4) bolts. After removing the bolts the range must be lifted and removed from the skid. 2) It is strongly r

• 4 step 2: ventilation system requirements It is strongly recommended that a suitable exhaust hood be installed above the range. Downdraft ventilation should NOT be used (see chart A below) (A) SELECT A VENTILATION SYSTEM: For wall installations, the hood width must, at a minimum, equal the width of the range’s cooking surface. Where space permits, a hood larger in width

• 5 step 3: cabinet preparation (cont.) WARNING! 4. Any openings in the wall behind the range and in the floor under the range must be sealed. 5. When there is less than a 12” horizontal clearance between combustible material D and the back edge of the range above the cooking surface, a Capital Low Back or High Shelf back guard must be installed (see Fig. 2). Whe

• Capital PSGR244, 6 step 3a: cabinet preparation (cont.) Fig. 2 10-3/4" wall O" Clearance G H 40" Min. to Combustibles Combustible Materials LOW BACK 12" ISLAND TRIM HIGH SHELF 22" KICKPLATE A B J D E F I C 12" Min. to Combustibles without backguard MODEL # WIDTH A B C D E F G H I J PSGR24 23-7/8" 25" 43-1/4" 27-3/8" 38-5/8" 44-1/2" 58-1/2" 1-5/16" 28-1/4" 6" 36-1/2" PSGR30 29-7/8" 25" 43-1/4" 27-3/8" 38-5/8" 44-1/2" 58-1/2" 1-5/16" 28-1/4" 6" 36-1/2" PSGR36 35-7/8" 25" 43-1/4" 27-3/8" 38-5/8" 44-1/2" 58

• Capital PSGR244, 7 step 3b: backguard installation Fig. 2Ab 1. Remove the range back panel by removing the 6 screws -- 3 screws on each side (see Pics. A and B). 2. Remove, then discard the 4 screws (2 at each side at the top of range side trim). 3. Set IT, LB or HS on top of the range (Pic. C) and secure it with the two (2) screws at each end from the bottom of the range side-trim (Pic. D). 4. Replace the range back panel by sliding it under the bottom lip of high shelf (Pic E). 5. Secure the IT, LB, or HS to the range back panel with five (5) screw

• 8 step 3c: electrical supply Fig. 3 Installation of All Gas ranges must be planned so that the rough-in of the junction box for the receptacle or conduit connection allows for maximum clearance to the rear of the unit. This is especially critical if the junction box in the wall will be directly behind the junction box of the unit when the unit is installed. To minimize bi

• Capital PSGR244, 9 step 4: installing anti-tip device WARNING! • All ranges can tip • Injury to persons and property could result • Install anti-tip device packed with range • See installation instructions Fig. 5 WARNING! RANGE TIPPING HAZARD! 1) All ranges can tip and injury can result. To prevent accidental tipping of the range, attach it to the floor, wall or cabinet by nstalling the Anti-Tip Device supplied. 2) A risk of tip-over may exist if the appliance is not installed in accordance with these instructions. 3) If the range is pulled away from the wall for cleaning, service or any other reas

• Capital PSGR244, 10 step 4: installing anti-tip device (cont.) IMPORTANT INSTALLATION INFORMATION: 1) The Anti-Tip Bracket may be attached to a solid wood cabinet having a minimum wall thickness of 3/4”. 2) The thickness of the wall or floor may require use of longer screws, available at your local hardware store. 3) In all cases at least two (2) of the bracket mounting screws must be fastened to solid wood or metal. 4) Use appropriate anchors when fastening the mounting bracket to any material other than hardwood or metal. Prepare holes at fastener locations as identified below: • FOR WALLS, WALL STUDS, OR FLOORS COMPOSED OF SOLID WOOD OR METAL, DRILL 1/8” PILOT HOLES. • FOR WALLS

• Capital PSGR244, 11 step 5: gas connection and hook-up NEXT: HOOK UP: a) A manual shut off valve must be installed external to the range in an accessible location from the front for shutting off the gas supply when required (Fig. 7). b) The supply line MUST NOT protrude beyond the back of the range. c) Ensure that the gas supply is turned OFF at the external shut-off valve before connecting the range. d) The gas supply connection must be made by an experienced technician and in accordance with local codes or ordinances. In the absence of local codes or ordinances, please refer to National Fuel Gas Code ANSI Z223.1 / NF

• Capital PSGR244, 12 step 5: gas connection and hook-up (cont.) Fig. 7 CAUTION! The appliance must be isolated from the gas supply piping system by closing its individual manual shut-off valve during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2 psig (3.5kPa.). The Appliance and its individual shut off valve must be disconnected from the gas supply piping system during any pressure testing of the system at test pressures in excess of 1/2 psig (3.5kPa.). When chec

• Capital PSGR244, 13 testing and adjustments (cont.) Fig. 8 cleaning stainless steel The stainless steel surfaces may be cleaned by wiping with a damp soapy cloth, rinsing with clear water and drying with a soft cloth to avoid water marks. Any mild glass cleaner will remove fingerprints and smears. Always wipe in the direction of the grain, and never in a circular motion. For discolorations or deposits that persist, refer to the Use and Care Manual. To polish and protect the stainless steel, use a cleaner/polish such as Stainless Steel Magic ® . • DO NOT allow deposits to remain for long periods of time. • DO NOT use ordinary steel w

• Capital PSGR244, 14 final checklist INSTALLER: Please sign and date here and leave these instructions with customer: CUSTOMER: Ensure that installer completes checklist, explains each item before leaving. Please make sure the installer signs in the space provided. X GENERAL: c Placement of unit c Specified clearances maintained to cabinet surfaces c Unit level--front to back-- side to side c Burner caps positioned properly on sealed burner bases c All packing materials removed c Island trim or backguard attached (if horizontal clearance t

• Capital PSGR244, we're here for you 15 HOW TO OBTAIN SERVICE: For service, contact one of our PERFORMANCE SERIES SPECIALISTS at: 1-866-402-4600. Before you call, please have the following information ready: • Model Number ____________________________________ (please make a notation for future reference) • Serial Number ____________________________________ (please make a notation for future reference) • Date of purchase and Installation ____________________ (please make a notation for future refe

• Capital PSGR244, Two (2) years full parts and one (1) year labor covers the entire unit. Five (5) years on all Burners (Oven, Grill, Griddle Burners, Oven Racks, Sealed Burner), Burner Grates, Grill Grates, Griddle Plate and Porcelain Enameled Parts. PERFORMANCE SERIES ™ RANGES WARRANTY WILL PAY FOR: All repair labor found to be defective due to materials or workmanship for one full year “IN HOME” warranty during the first year of ownership. This does not apply if the unit was subjected to other than normal household use. Servic

• Capital PSGR244, All illustrations and specifications contained in this use and care guide are based on the latest product information available at the time of this printing. Because product improvement is an ongoing process, Capital reserves the right to make changes at any time, without notice, in colors, materials, equipment, specifications, features and models. Some product pictures may be shown with optional equipment. Further information can be obtained from your authorized Capital Cooking Equipment dealer or v

Related Products and Documents (Cooktop):

Comparable Devices:

Similar Resources:

• GE JBP72SMSS (2 pages) †Note: Check local codes for required breaker size.Effective January 1, 1996, the National Electrical Code requires that new construction (not existing) utilize a 4-conductor connection to an electric range.Receptacle Locations: Locally approved flexible service cord or conduit must be used because terminals are not accessible after range installation. Se …

• Frigidaire FGGS3045K F (7 pages) 30" Gasfrigidaire.com1 Based on single rack cooking performance, not set temperature, using Quick Preheat.2 Select models only.White (W)Black (B)Stainless (F)BurnersRight FrontRight Rear Left FrontLeft RearBTU17,0005,0009,50012,000Product DimensionsHeight (Max.) 36-5/8"Width 30"Depth 28-5/16"More Easy-To-Use FeaturesChicken Nugget Butt …

• Frigidaire FFEF3011LB (2 pages) SERVICE DATA SHEETElectric Ranges with ES 100/105 Electronic Oven ControlElectronic Oven Control(E.O.C. rear view)IMPORTANTDO NOT REMOVE THIS BAGOR DESTROY THE CONTENTSWIRING DIAGRAMS AND SERVICEINFORMATION ENCLOSEDREPLACE CONTENTS IN BAGRTD SCALETemperature (°F) Resistance (ohms)32 ± 1.9 1000 ± 4.075 ± 2.5 1091 ± 5.3250 ± 4.4 1453 ± 8.9350 ± 5.4 16 …

• Chef EHC946U (1 pages) cooktop dimensionsbuilding-in cut-out dimensionsinstallation guidechef electric ceramic cooktops models: EHC946UAll measurements in millimetres.Current as at Feb 2008. © 2008 Electrolux Home Products Pty Ltd. CDIMEHC946U930mm520mm45mm(built-in height) 490mm==880mm75mm min. Note: If a barrier is vrequired, a minimum gap of 25mm is needed under the cooktop.W …

• Jenn-Air JJW3430WS (6 pages) PRODUCT MODEL SERIES PRODUCT DIMENSIONSJJW2327WJJW2330WJJW2427WJJW2430WJJW2527WJJW2530WJJW2727WJJW2730WJJW2827WJJW2830WJJW3430WJJW3830W● Oven must be connected to the proper electrical voltageand frequency as specified on the model/serial numberrating plate. The model/serial number rating plate is locatedunder the control panel on single ovens and under th …

• Kenmore 79074503990 (24 pages) IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE,OBSERVE ALL GOVERNING CODES AND ORDINANCES.If the information in this manual is not followed exactly, a fire or explosion may resultcausing property damage, personal injury or death.FOR YOUR SAFETY:m Do not store or use gasoline or other flammable …

Comments, Questions and Opinions: