CES GPS-207 Operation & User’s Manual

Text of CES GPS-207 User Guide:

• CES GPS-207, GPS-207, GPS-207DC USER MANUAL CES WIRELESS TECHNOLOGIES, CORP. 925-122 South Semoran Boulevard Winter Park, Florida 32792 April 17, 2012 GPS207 Manual v1p1.doc Revision 1.1 © Copyright CES WIRELESS TECHNOLOGIES CORP. (2012) The information contained in this document is subject to change without notice and should not be construed as a commitment by CES WIRELESS TECHNOLOGIES CORP. unless such commitment is expressly given in a covering document.

• REGULATORY COMPLIANCE FCC The GPRS modem was tested and certified to meet FCC Parts 15 in a stand-alone configuration, which demonstrated that it complies with Part 15 emission limits. The GPS-207 uses an Enfora manufactured GPRS modem. FCC Part 22 & Part 24 is covered by the "modular approval" process for a transmitter. This approach, described by FCC Public Notice DA 00-131407

• CES GPS-207, TABLE OF CONTENTS REGULATORY COMPLIANCE ...............................................................................................................2 TABLE OF CONTENTS.............................................................................................................................3 TABLE OF FIGURES.................................................................................................................................3 WARRANTY...................................................

• WARRANTY Complete Warranty details can be found at the CES Wireless web site: www.ceswireless.com CES Wireless Technologies Corp., (CES Wireless), warrants this product to be free from defects in material and workmanship for 12 months from date of shipment. If such malfunction occurs, it will be repaired or replaced (at our option) without charge for materials or labor if returned to the factory

• CES GPS-207, CHANGE LOG Date Author Release Description 2010-08-26 Doug Hamilton A.0 Initial release (A.0) 2011-01-06 Doug Hamilton A.1 Added Change Log. Added note that SIM card should be removed before programming the device (3.1) 2011-01-28 Doug Hamilton A.2 Modified the instructions for opening the enclosure to reflect the process for the current enclosure. Removed the old instructions. 2011-12-08 Doug Hamilton 1.0 Added information about version of GPS207 that has a DC cable. 2012-04-17 Doug Hamilton 1.1 Added additional information in regards to the GPS-207DC. © CES Wireless Technologies Corp – 2012 Page 5 of 17

• CES GPS-207, 1.0 Introduction There are two versions of the GPS-207. One (CES P/N GPS-207) is designed for monitoring the position of non-powered mobile and fixed assets. The other (CES P/N GPS-207DC) is designed for monitoring the position of sometimes-powered mobile and fixed assets. GPS-207: There is no need for an external power source or antenna. This device is optimized for assets that are fixed or move infrequently. This device is programmed with the GPS-207S software. GPS-207DC: There is no need for an external power source or antenna but the device comes with a DC cable that can be

• CES GPS-207, • GPS-207S: Programming Software for the GPS-207 (available on the CD-SOFT1 CD). • GPS207_ExPwr: Programming Software for the GPS-207DC (available on the CD-SOFT1 CD). 1.5 System Requirements It is necessary to have a computer running Windows 2000, Windows XP or Windows Server 2003 to program the device. The system must include a USB 2.0 port in order to configure the GPS-207. 1.6 GPS-207 Top, Internal and Bottom View Figure 1: Top View of the GPS-207. Figure 2: Internal View of the GPS-207. Note the locations of the SIM Holder, Battery Connector, Battery Pa

• CES GPS-207, 1.7 GPS-207 Activation and Deactivation On the bottom of the GPS-207 is the LED Indicator and Power Switch. The Power Switch has two functions – it acts as a power switch and as an activation switch. Deactivate: Press and hold the power switch, located on the underside of the unit, for three to five seconds to deactivate the GPS-207. The LED will go solid red and then go off. When the LED is off the unit has been deactivated. Activate: To activate the GPS-207 press and hold the power switch for three to five seconds until the LED blinks.  LED blinks 12 times within a 3 second period - the battery is in its highest range  LED goes on for one second, goes o

• CES GPS-207, 2.0 Specifications Note: Specifications subject to change without notice. 2.1 System Information Dimensions 170 x 69 x 21 mm L x W x H Dimensions (GPS-207DC) 170 x 87 x 21 mm L x W x H Weight (GPS-207) 207 grams with battery 150 grams without battery Weight (GPS-207DC) 358 grams with battery 301 grams without battery Housing: Rugged plastic enclosure TX Power: Class 4 (2W @850/900 MHz) Class 1 (1W @1800/1900 MHz) Frequency: 850/900/1800/1900 Sensitivity: 108 dBm (typical) 2.2 GPRS Packet Data Mode: Cla

• CES GPS-207, 2.7 Battery Specifications The GPS-207 uses an internal Lithium-Thionyl Chloride battery pack (CES P/N: BATTxx). The battery specifications are as follows: Cell Size AA Operating Temperature -40 to 85º C (-40 to 185º F) Maximum Rated Voltage 3.9VDC Capacity 4200 mAh @ 500 mA Shelf Life 10 years @ < 30º C (86º F) Lithium Metal Content Approximately 1.3g Weight 60g (maximum) © CES Wireless Technologies Corp – 2012 Page 11 of 17

• 3.0 Installation After the GPS-207 has been programmed with the GPS207S programming software the device is ready to be installed. The instructions in this section describe the hardware installation of the GPS-207. 3.1 Installing the SIM (Subscriber Identity Module) Card NOTE: Program the GPS-207 before installing the SIM card. If reprogramming the device the SIM card should be

• CES GPS-207, Figure 8: Battery position Next, plug the battery connector into the mating connector on the circuit board. The GPS-207 can now be closed. Replace the top cover, snap it into place and tighten the screws. 3.3 Choose a location The GPS-207 should be mounted outdoors, ensuring that the top of the device has a clear view of the sky. Other items to consider in choosing a location for the device. • For maximum antenna performance the GPS-207 should be mounted with the label facing down towards the ground. This will give the top of the unit a clear view of the sky. • If the mounting noted above is no

• CES GPS-207, Figure 9: GPS-207 Screw Holes (GPS-207 shown) Once the center points of the mounting screw holes have been marked drill the holes using the appropriate size drill bit. 3.5 External Power Cable (GPS-207DC Only) The connections for the external power cable are: Power (7-18Vdc) Blue Ground White © CES Wireless Technologies Corp – 2012 Page 14 of 17

• CES GPS-207, 4.0 Battery Replacement When the battery needs to be replaced in the GPS-207 follow these steps to remove it. Section 3.2 details the steps required to insert the new battery. First, remove the GPS-207 from its installed location and open it by loosening the 4 screws. Remove the top. Disconnect the existing battery by grasping the battery cable close to the connector and pulling gently sideways. Remove the battery and dispose of it properly. Insert the new battery as shown in Section 3.2. © CES Wireless Technologies Corp – 2012 Page 15 of 17

• CES GPS-207, 5.0 Turning the GPS-207 On and Off The button/LED on the bottom of the GPS-207 has two functions. It acts as both the power switch and the activation switch. Once the GPS-207 has been programmed with the GPS-207S programming software it will be activated. If you do not wish to immediately deploy the device it should be turned off so that the battery is not drained unnecessarily. 5.1 Turn off the GPS-207 To turn off the GPS-207 the button on the bottom of the device should be pressed and held for three to five seconds. The LED will go solid and then off. Once off the device is turned o

• CES GPS-207, 6.0 Support If you need help, we are easily accessible …. Telephone: Call 407-679-9440, and ask for product support. Fax: 407-679-8110 Email: [email protected] Skype: Please email [email protected] to obtain your currently assigned support engineer’s Skype address. Product support may ask you to E-MAIL a copy of the programmed parameters to us for analysis. To do this, go to FILE on the DP-1000S main menu, and click on SAVE AS. Note the path to the saved file in the save file dialog. Attach this file to an e-mail and send it to you product support representative or to the e-mail address noted a

Related Products and Documents (GPS):

Comparable Devices:

Similar Resources:

• Parrot CK3100 LCD (14 pages) SCIROCCO The VOLKSWAGEN SCIROCCO marque and VOLKSWAGEN logo are the property of the VOLKSWAGEN France Group s.a or VOLKSWAGEN AG. This document is only valid for the vehicle model SCIROCCO® year 2009, excluding all other models in the same range and excluding later modifications made to the vehicle by the manufacturer. The Parrot brand name and logos are t …

• Fastrax IT430 (42 pages) REV 1.5 TECHNICAL DESCRIPTION Fastrax IT430 OEM GPS Receiver This document describes the electrical connectivity and main functionality of the Fastrax IT430 OEM GPS Receiver. June 30, 2010 Fastrax Ltd. …

• Track24 PackMaster Lo-Pro II (2 pages) PMLP II Quick Start Guide The PackMaster Lo-Pro II is powered by a 1.95 A-Hr Lithium-Ion battery which is supplied in a partially charged state. It can either be charged using a mains power supply or a USB-mini cable. The mains power supply can recharge the PackMaster Lo-Pro II rechargeable battery in approximately five hours. A USB 1.0 should be able to c …

• TICATAG Tibe Connect (5 pages) Démarrage du TiBe1- Tirez délicatement la languette2- Appuyez sur le bouton 5sec. jusqu’au signal sonoreSi pas de signal sonore :3- Ouvrez le boitier 4- Enlevez et replacez la pile 1.2.4.3.5- Appuyez à nouveau 5 sec jusqu’au signal sonore Recommencez l’opération si nécessaire.6- Fermez le boitier7- Reliez le TiBe à l’application mobil …

• Mobile Crossing COMPACTFLASH GPS (14 pages) CompactFlashCompactFlashCompactFlashGPGPGPSSSUs er ’s Guid eUs er ’s Guid eUs er ’s Guid eMa y 2 004Ma y 2 004Ma y 2 004CompactFlash GPS User’s Guide May 2004 …

• Alpine INA-W910R (105 pages) Designed by ALPINE Japan68-16909Z49-A ENDEFRESITSENLRUPLGRADVANCED NAVI STATIONINA-W910R• OWNER’S MANUAL Please read before using this equipment.• ANVÄNDARHANDLEDNING Innan du använder utrustningen bör du läsa igenom denna användarhandledning.• BEDIENUNGSANLEITUNG Lesen Sie diese Bedienungsanleitung bitte vor Gebrauch des Gerätes.• GEBRUIKERS …

Comments, Questions and Opinions: