Manualios.com

Cisco Video Switch Operation & User’s Manual

Cisco Video Switch Manual Online:

4.35, 725 votes
Cisco Video Switch User Manual
Cisco Video Switch User Guide
Cisco Video Switch Online Manual

Text of Cisco Video Switch User Guide:

  • 1 Video Switch User guide D14794.02 Video Switch User Guide, October 2012 © 2011-2012 Cisco Systems, Inc. All rights reserved. www.cisco.com Video Switch User Guide - for the MXP Series and PrecisionHD 720p camera

  • Cisco Video Switch, 2 Video Switch User guide D14794.02 Video Switch User Guide, October 2012 © 2011-2012 Cisco Systems, Inc. All rights reserved. www.cisco.com TA - ToC - Hidden text anchor Table of contents Introduction About this guide .............................................................. 4 Download the user documentation .............................. 4 The Video Switch Unpacking the Video Switch ........................................... 6 What’s in the box ......................................................... 6 The Video Switch ......................................................... 6 Codec software ..................

  • Cisco Video Switch, 4 Video Switch User guide D14794.02 Video Switch User Guide, October 2012 © 2011-2012 Cisco Systems, Inc. All rights reserved. www.cisco.com About this guide The purpose of this document is to describe the Video Switch basics as well as how to set up different daisy chained solutions. The Video Switch (TVS) is a rack-mountable hardware option for the Cisco TelePresence MXP Series codecs (6000 MXP and 3000 MXP). The Video Switch delivers the ability to daisy chain multiple HD cameras and provides support for third party HD cameras. Download the user documentation Go to: http://www.c

  • Cisco Video Switch, What’s in the box 1 Video Switch Unit 4 Rubber Feet 1 HD Camera cable (1 m) for 6000MXP Codec 1 HD Camera cable (1 m) for 3000MXP Codec 1 Power supply kit incl. cables for Video Switch 1 Power supply kit incl. cables for existing camera 1 Rack ear set (left and right) 1 Control cable (6.5 m) for Video Switch to Precision HD camera 1 HDMI cable (6.5 m) for Video Switch to precision HD camera 1 TRC4 TANDBERG Remote Control Please report any discrepancies immediately. Unpacking the Video Switch 1 Unpack the unit. 2 Mount the rack ears and/or rubber feet and mount it in the rack, if ap

  • Cisco Video Switch, Physical Interface - Rear View 12 volt power supply. The power supply is the same as used for the PrecisionHD camera, Edge MXP and Set Top endpoints. 2 × Component (Y-Pr-Pb) video for Supporting 3 party cameras, like the Sony EVI-HD1 or BRCH700 cameras. 4 × DVI-D Video inputs from Precision HD cameras – PrecisionHD camera HDMI output to DVI-D on the Video Switch. 3 × Data ports: • Data port 1 is for controlling the PrecisionHD cameras from Cisco and 3 party cameras. • Data port 2 is for controlling SD type cameras like the TANDBERG WAVE II or Sony EVI cameras. • Data port 3 is for external control systems to cont

  • Cisco Video Switch, Connecting PrecisionHD cameras Audio out Data Net PC Card 1. Single 2. Single Video out Video in 3. Dual 2. Aux 3. Doc 4. VCR VCR Ethernet PC DVI-I in DVI-I out 1 2 4 Audio in 1 Mic.1 2 Mic.2 3 USBUSB DC in I O Camera A Connect Video Switch power supply here. B Connect camera power supply here. Cisco Video Switch Cisco TelePresence 6000 MXP Codec Cisco TelePresence 3000 MXP Codec Connecting up to four PrecisionHD 720p cameras: RJ11 – RJ45 RJ11 – RJ45 RJ11 – RJ45 DVI – HDMI DB 9 – RJ 45 RJ 45 – DB 9 DB 9–RJ 45 DVI – HDMI DVI – HDMI Camera 2 Camera 3 Camera 4 Primary chain A A A 8 Video Switch User guide D14794.02 Video Switch User Guide, October 201

  • Cisco Video Switch, Connecting third party cameras This diagram shows the connections needed to use a maximum of two analog sources equipped with component video outputs. Connection diagram uses Sony EVI-HD1 cameras as example. System supports 1280X720p50, 1280X720p59,94, and 1280X720p60 only. For full VISCA control Sony EV1-HDI cameras or true compatibles must be used. Other units may or may not be partly or fully controllable. SONY Part Numbers: DB9–Mini DIN cable: Part number RC893 Mini DIN–Mini DIN chain cable: Part number RC815 TANDBERG T

  • Cisco Video Switch, Camera software upgrade To upgrade the software of the PrecisionHD camera, connect the camera directly to the main camera socket of the Codec (the socket that otherwise is used when connecting the Video Switch to the Codec). Power the units and the upgrade will start automatically. The status will be shown on the video system’s monitor. Software upgrade 10 Video Switch User guide D14794.02 Video Switch User Guide, October 2012 © 2011-2012 Cisco Systems, Inc. All rights reserved. www.cisco.com

  • Cisco Video Switch, Camera cable pin-out RJ45 to RJ11 DSUB 9-pin RJ45 Top RJ45 Front 1 8 1 8 RJ11 Top RJ11 Front 18 16 RJ45 RJ11 1 2 3 6 7 2 1 3 4 5 TANDBERG RJ 45 – RJ 11 TANDBERG HD 6000 Camera cable pin-out SIGNAL NAME RJ-45 DSUB +12V DC 1 Twisted pair 4 GND 2 5 Rx 3 Twisted pair 2 TX 6 3 LVDS+ 4 Twisted pair 1 LVDS– 5 6 GND 7 Twisted pair 5 +12V DC 8 4 Cable is Category 7.5/ Class F AWG24. CAUTION! Extreme care should be taken if you choose to make your own version of this cable! 9-pin D-sub pin-out External view of socket 69 1 5 Cable pin-outs 11 Video Switch User guide D14794.02 Video Switch User Guide, October 2012 © 2011-2012 Ci

  • Cisco Video Switch, Configuring the Video Switch Basic Functionality Physical inputs refer to explicit codec input and explicit switch input. These can only be controlled from the command interface. The commands xconfiguration MainVideoSource, vidin and xconfiguration Switch Source always control the inputs directly. Example: To select physical input 3 on the codec, use xconfiguration MainVideoSource: 3, as usual. To see inputs on the switch, select codec input 1 with xconfiguration MainVideoSource: 1 and select switch input with xconfiguration Switch Source <1..6>. Logical inputs are used when accessing inputs from t

  • Cisco Video Switch, xConfiguration Switch LogicalInput [1..5] Mode: <On/Off> xConfiguration Switch LogicalInput [1..5] Map: <1..6> Default is LogicalInput [1..5] Mode: Off. 1. Main cam 2. Aux 3. Doc cam 4. VCR 5. PC Remaps the source buttons on top of the extended remote control. Will also remap inputs selected from the menu, and change FECC accordingly. If mode for a key is on, the table entry will be used to specify which input on the switch to activate. Command Interface – xCommands NOTE: All camera commands will get new ranges, Camera [1..13] instead of Camera [1..4] . These will behave as follows if a switch is connected: • 1 will be the sw

  • Cisco Video Switch, Communicating with the Video Switch VISCA Standard Commands Command Set Command Packet Comments CAM_IF_Clear 8x 01 00 01 ff Clear command buffer. Stop any current operation in progress. CAM_Address_Set 8x 30 0p ff p = address for this device. If x=8 (broadcast), increase p with 1 before sending to chain. CAM_Command_ Cancel 8x 2p ff p = Socket ID. Not supported in TVS CAM_Power 8x 01 04 00 0p ff p = 2: Power on. p = 3: Power off. VISCA Standard Inquiries Command Command Packet Comments IF_DeviceType_Inq 8x 09 00 02 ff y0 50 gg gg hh hh jj jj kk ff gggg = Vendor ID

  • VISCA Standard Push Messages Command Command Packet Comments CAM_Network_ Change x0 38 ff This indicates that cameras have been added to or removed from the camera chain. To avoid issues with (some) Sony cameras, the control system or codec should delay 9 seconds before reconfiguring the chain. Configuration Commands Messages starting with 8x-01-40-<00..1f> are configu

  • Boot command Command Command Packet Comments CAM_Boot 8x 01 42 ff Reboot the switch. This will also reset serial speed to 9600. Inquiries commands Messages starting with 8x- 09... Command set Command Packet Reply and comments CAM_ID_Inq 8x 09 04 22 FF Reply: 90 50 zz xx 00 yy FF zz xx = switch rev, zz=0x40 for TVS yy = firmware rev CAM_SWID_ Inq 8x 09 04 23 ff Reply: x0 50 [1-12

  • Cisco Video Switch, Safety Instructions Water and Moisture • Do not operate the apparatus under or near water – for example near a bathtub, kitchen sink, or laundry tub, in a wet basement, near a swimming pool or in other areas with high humidity. • Do not touch the product with wet hands. Cleaning • Unplug the apparatus from communication lines, mains power-outlet or any power source before cleaning or polishing. Do not use liquid cleaners or aerosol cleaners. Use a lint-free cloth lightly moistened with water for cleaning the exterior of the apparatus. • Unplug the apparatus from communication lines before cleaning or polishing. Do not use liquid cleaners or aerosol cleaners

  • Cisco Video Switch, Product Declaration A 级声明( A Class product declaration) 本产品为 A 级 ITE,在其使用说明,铭牌等显著位置中已包含如下内 容的声明(We declare here that the subject product is A Class ITE product, and the following statement is clearly marked in the user manual and nameplate : 声 明 此为 A 级产品,在生活环境中,该产品可能会造成无线电干扰。在这 种情况下,可能需要用户对其干扰采取切实可行的措施。 WARNING: This is a class A product. In a domestic environment this

  • Cisco Video Switch, 20 Video Switch User guide D14794.02 Video Switch User Guide, October 2012 © 2011-2012 Cisco Systems, Inc. All rights reserved. www.cisco.com On our web site you will find an overview of the worldwide Cisco contacts. Go to: http://www.cisco.com/web/siteassets/contacts Corporate Headquarters Cisco Systems, Inc. 170 West Tasman Dr. San Jose, CA 95134 USA Disclaimer THE SPECIFICATIONS AND INFORMATION REGARDING THE PRODUCTS IN THIS MANUAL ARE SUBJECT TO CHANGE WITHOUT NOTICE. ALL STATEMENTS, INFORMATION, AND RECOMMENDATIONS IN THIS MANUAL ARE BELIEVED TO BE ACCURATE BUT ARE PRESENT

Related Products and Documents (Switch):

Comparable Devices:

# Manufacturer Model Document Type File Updated Pages Size
1 Behringer DUAL DIAPHRAGM CONDENSER MICROPHONE B-2 PRO Specifications behringer/dual-diaphragm-condenser-microphone-b-2-pro-78Z.pdf 17 Feb 2023 2 0.72 Mb
2 EPIGY TECHNOLOGIES QUADRO2X Installation manual epigy-technologies/quadro2x-6VS.pdf 18 Nov 2023 63
3 ECS P5SJ-A Operation & user’s manual ecs/p5sj-a-O62.pdf 06 Jun 2023 86 1.37 Mb
4 Huawei G3620 Operation & user’s manual huawei/g3620-17M.pdf 07 Jun 2023 35
5 Vita-Mix XTG012 Owner's manual vita-mix/xtg012-3FG.pdf 12 Oct 2023 28 0.35 Mb
6 Bose L1 Compact Owner's manual bose/l1-compact-698.pdf 23 Aug 2023 24 8.95 Mb

Similar Resources:

  • MicroNet

    SP6005P4

    (2 pages)
    5Quick Installation Guide5-Port 10/100M PoE Switch, 4 PoE PortsModel No.: SP6005P46FCC CertificationsThis equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a …
  • H3C

    S9500 Series

    (167 pages)
    H3C S9500 Series Routing SwitchesOperation ManualHangzhou H3C Technologies Co., Ltd. http://www.h3c.com Manual Version: T2-08165E-20081225-C-1.24 Product Version: S9500-CMW310-R1648 …
  • Perle

    IDS-206

    (4 pages)
    IDS-206 Switches Quick Start Guide ____________________________ This guide covers the basic installation and configuration. It is intended for first time setup or for product evaluation purposes. Complete details can be found in the following guides at www.perle.com/downloads.  IDS-206 Hardware Installation Guide  IDS Managed Switches User Guide � …
  • Shinybow USA

    SB-3877

    (5 pages)
    SAFETY INFORMATIONTHIS SAFETY INFORMATION IS OF A GENERAL NATURE AND MAY BE SUPERSEDED BY INSTRUCTIONS CONTAINED WITHIN THIS MANUALPAGE 11SB-3877 INSTRUCTION & OPERATION MANUALSPECIFICATIONSVIDEO/AUDIO INPUTS 8x VIDEO INPUTS- 2x HDMI (Digital Video-TMDS & Digital Audio-PCM) via HDMI connectors- 2x CVBS/S-Video(Y/C)/Audio Via Composite(1x RCA), …
  • Linksys

    SGE2010P

    (3 pages)
    BUSINESS SERIESPRODUCT DATAModel: SGE201048-Port Gigabit Ethernet Switch Ethernet Switch with 48-Port 10/100/1000 and 4 Shared SFP SlotsThe Linksys SGE2010 Managed switch with WebView allows you to expand your network securely. Configuration of the switch is secured using SSL for Web access. The SGE2010 is optimized for maximum system availability with fully …
  • H3C

    H3C S7500E Series

    (112 pages)
    H3C S7500E Series Ethernet SwitchesACL and QoSConfiguration GuideHangzhou H3C Technologies Co., Ltd. http://www.h3c.com Document Version: 20100722-C-1.01 Product Version: Release 6605 and Later …

Comments, Questions and Opinions: