Manualios.com

Crestron TPS-IMW Operation Manual

Crestron TPS-IMW Manual Online:

4.6, 849 votes
Crestron TPS-IMW User Manual
Crestron TPS-IMW User Guide
Crestron TPS-IMW Online Manual

Text of Crestron TPS-IMW User Guide:

  • Crestron TPS-IMW, Wall-Mounted Interface Module Crestron TPS-IMW AUDIO INPUT The port mates with a six-position mini-terminal block connector (supplied) and provides balanced and/or unbalanced audio input. A description of the pinouts is shown in the following table. AUDIO INPUT Pinouts PIN DESCRIPTION PIN DESCRIPTION S Shield L + Left Positive R + Right Positive L- Left Negative R - Right Negative S Shield MIC OUT The port mates with a three-position mini-terminal block connector (supplied) and produces line level differential output. Description of the pinouts is

  • Crestron TPS-IMW, Wall-Mounted Interface Module Crestron TPS-IMW Physical Description The TPS-IMW, shown in the following diagram, mounts into a 2-gang electrical box (recommended 2.5" depth). The back of the unit is labeled and provides a network connector, video input connector, audio input, and microphone output. Once installed, there are only two RJ-45 connectors (for audio/network/video) visible that provide connections to the touchpanel via the cables supplied with the touchpanel. Physical Views of the TPS-IMW 1.51 in (3.82 cm) 4.11 in (10.44 cm) 3.50 in (8.89 cm) 2 • Wall-Mounted Interface Module

  • Crestron TPS-IMW, Crestron Electronics, Inc. Operations Guide – DOC. 5857A 15 Volvo Drive Rockleigh, NJ 07647 11.04 Tel: 888.CRESTRON Fax: 201.767.7576 Specifications subject to www.crestron.com change without notice.

  • Wall-Mounted Interface Module Crestron TPS-IMW Installation into the Electrical Box The TPS-IMW mounts into a 2-gang electrical box (recommended 2.5" depth). Verify that the unit is installed into the electrical box as shown in the following diagram. Secure the TPS-IMW to the electrical box with the four #6-32 flat-head slotted screws (supplied). Installation of the TPS-IMW O

  • Crestron TPS-IMW, Crestron TPS-IMW Wall-Mounted Interface Module Wall-Mounted Interface Module: TPS-IMW Introduction Features & Functions The TPS-IMW is designed to serve as an optional interface module for the Crestron TPS-3000, TPS-4000, TPS-5000 and TPS-6000 tilt touchpanels. The module provides a clean, 2-gang mountable interface for direct connection to the touchpanel. The TPS-IMW creatively hides most of the connections behind a wall. The two visible telephone-type jacks can be camouflaged with a Decora™ wallplate (not supplied) so that the unit blends into any setting. NOTE:

  • Crestron TPS-IMW, Crestron TPS-IMW Wall-Mounted Interface Module Ports There are six ports that serve various functions on the TPS-IMW. Refer to the following diagrams and descriptions of each port. NTSC/PAL VIDEO The NTSC/PAL video input uses a 6-position mini-terminal block connector for twisted pair wiring of balanced or unbalanced video signals. The video signal is connected to these ports and requires a TPS-3000, TPS-4000, or installation of the TPS-VID-1 or TPS-VID-2 video card in a TPS-5000 or TPS-6000 touchpanel to display video. Consult the latest revision of

  • Crestron TPS-IMW, Wall-Mounted Interface Module Crestron TPS-IMW Further Inquiries If you cannot locate specific information or have questions after reviewing this guide, please take advantage of Crestron's award winning customer service team by calling the Crestron corporate headquarters at 1-888-CRESTRON [1-888-273-7876]. For assistance in your local time zone, refer to the Crestron website (www.crestron.com ) for a listing of Crestron worldwide offices. You can also log onto the online help sec

  • Crestron TPS-IMW, Crestron TPS-IMW Wall-Mounted Interface Module Hardware Hookup Connections to the Back of the TPS-IMW MICROPHONE OUTPUT: PROVIDES LINE-LEVEL BALANCED OUTPUT CRESNET: TO CONTROL SYSTEM AND OTHER CRESNET DEVICES BALANCED VIDEO INPUTS USING TWISTED PAIR CABLE: COMPOSITE OR S-VIDEO AUDIO INPUT: LINE-LEVEL, BALANCED & UNBALANCED AUDIO SOURCES A video source can be connected to a TPS-3000, TPS-4000, or a TPS-VID1/2 installed in a TPS-5000 or TPS-6000 touchpanel. The TPS-IMW allows for the connection of balanced or unbalance

  • Crestron TPS-IMW, Crestron TPS-IMW Wall-Mounted Interface Module NET/VIDEO Pinouts TYPE PIN DESIGNATION DESCRIPTION 1 +24V Power (Network) 2 GND Ground (Network) 3 C+ Chrominance (Positive) /Composite 2 4 C- Chrominance (Negative) /Composite 2 5 Y Data (Network) 6 Z Data (Network) 7 Y+ Luminance (Positive) /Composite 1 8 Y- Luminance (Negative) /Composite 1 9 GND Ground (Network) 10-pin RJ-45 Pin 1 Pin 1 10 +24V Power (Network) To determine the location of pin 1, hold the cable so that the end of the 10-pin RJ-45 connector is facing away from you, with the clip side down and the copper side up. The copper connector on the fa

  • Wall-Mounted Interface Module Crestron TPS-IMW Problem Solving Troubleshooting The following table provides corrective action for possible trouble situations. If further assistance is required, please contact a Crestron customer service representative. TPS-IMW Troubleshooting TROUBLE POSSIBLE CAUSE(S) CORRECTIVE ACTION Touchpanel is not receiving power. Confirm that power i

  • Crestron TPS-IMW, Wall-Mounted Interface Module Crestron TPS-IMW Wire Gauge Values RESISTANCE (R) WIRE GAUGE 4 16 6 18 10 20 15 22 13 Doubled CAT5 8.7 Tripled CAT5 NOTE: When daisy-chaining Cresnet units, strip the ends of the wires carefully to avoid nicking the conductors. Twist together the ends of the wires that share a pin on the network connector, and tin the twisted connection. Apply solder only to the ends of the twisted wires. Avoid tinning too far up the wires or the end becomes brittle. Insert the tinned connection into the Cresnet connector and tighten the retaining screw. Repeat the procedure for the other three

  • Crestron TPS-IMW, Crestron TPS-IMW Wall-Mounted Interface Module Orientation of the Insert Plates VIDEO NET/ AUDIO Connect the TPS-IMW to the touchpanel using the supplied network/video (10-pin) and audio (eight-pin) cables. NOTE: The included AUDIO cable has a connector with a blue cover to match the blue lettering on the TPS-IMW. As older AUDIO cables may not have the blue cover, be sure to insert the AUDIO cable into the AUDIO port. NOTE: Do not confuse the 8-pin audio cable with the 10-pin net/video cable. Operations Guide – DOC. 5857A Wall-Mounted Interface Module: TPS-IMW • 11

  • Crestron TPS-IMW, Wall-Mounted Interface Module Crestron TPS-IMW AUDIO Pinouts TYPE PIN DESIGNATION DESCRIPTION 1 L+ Left Input (Positive) 2 L- Left Input (Negative) 3 GND/Shield Audio Input Ground/Shield 4 R+ Right Input (Positive) 5 R- Right Input (Negative) 6 GND/Shield Mic Output Ground/Shield 7 M+ Mic Output (Positive) 1 8 1 8 Front Top 8 M- Mic Output (Negative) To determine the location of pin 1, hold the cable so that the end of the 8-pin RJ-45 connector is facing away from you, with the clip side down and the copper side up. The copper connector on the far left is pin 1. Industry Compliance

  • Crestron TPS-IMW, Crestron TPS-IMW Wall-Mounted Interface Module TPS-IMW Troubleshooting (continued) TROUBLE POSSIBLE CAUSE(S) CORRECTIVE ACTION Incorrect video format selection. Select the proper video input configuration in the touchpanel configuration SETUP MENU. Incorrect VT Pro-e project file loaded. Make sure that video window object resides in project, re- compile, and reload. Video window on touchpanel has no display. Damaged connector pins. Inspect connector pins. If bent, carefully re-straighten. If broken, contact Crestron cu

  • Crestron TPS-IMW, This document was prepared and written by the Technical Documentation department at: Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 1-888-CRESTRON All brand names, product names and trademarks are the property of their respective owners. ©2004 Crestron Electronics, Inc.

  • Crestron TPS-IMW, Crestron TPS-IMW Wall-Mounted Interface Module Return and Warranty Policies Merchandise Returns / Repair Service 1. No merchandise may be returned for credit, exchange, or service without prior authorization from CRESTRON. To obtain warranty service for CRESTRON products, contact the factory and request an RMA (Return Merchandise Authorization) number. Enclose a note specifying the nature of the problem, name and phone number of contact person, RMA number, and return address. 2. Products may be returned for credit, exchange, or serv

  • Crestron TPS-IMW, Crestron TPS-IMW Wall-Mounted Interface Module NOTE: When installing network wiring, refer to the latest revision of the wiring diagram(s) appropriate to your specific system configuration, available from the Downloads | Product Manuals | Wiring Diagrams section of the Crestron website (www.crestron.com). NOTE: Do not power up system until all wiring is verified. Care should be taken to ensure data (Y, Z) and power (24, G) connections are not crossed. NOTE: All network wiring must consist of two twisted-pairs. One twisted pair is the +24V conductor and the GND conductor and the other twisted pair is the Y conductor and the Z conductor. NOTE: For larger networks (

  • Crestron TPS-IMW Wall-Mounted Interface Module Contents Wall-Mounted Interface Module: TPS-IMW 1 Introduction......................................................................................1 Features & Functions.............................................................1 Specifications.........................................................................1 P

Related Products and Documents (Network Card):

Comparable Devices:

# Manufacturer Model Document Type File Updated Pages Size
1 Sanyo DRW-1000 Instruction manual sanyo/drw-1000-AFT.pdf 20 Mar 2024 59 2.24 Mb
2 GE JGBP32GEL Use and care manual ge/jgbp32gel-8F4.pdf 27 Mar 2024 28
3 Panasonic NNL531WF Operating instructions manual panasonic/nnl531wf-1TT.pdf 26 Jul 2023 28 1.08 Mb
4 3B SCIENTIFIC PHYSICS 1012404 Instruction manual 3b-scientific-physics/1012404-F54.pdf 22 Jun 2023 4
5 Hasbro Smokescreen 7051 Instruction manual hasbro/smokescreen-7051-BBQ.pdf 05 Feb 2024 16 15.16 Mb
6 AIRLESSCO 450 Service & operation manual airlessco/450-1TW.pdf 13 Jan 2024 28 2.6 Mb

Similar Resources:

  • Tripp Lite

    SNMPWEBCARD

    (20 pages)
    1Installation ManualWARRANTY REGISTRATIONRegister online today for a chance to win a FREE Tripp Lite product! www.tripplite.com/warrantySNMP/Web Management Accessory CardModel: SNMPWEBCARD1111 W. 35th Street, Chicago, IL 60609 USAwww.tripplite.com/supportRead this manual carefully before installation. A separate User's Guide (PDF format) is included …
  • HP

    Pavilion dv9000

    (280 pages)
    Maintenance and Service GuideHP Pavilion dv9000 Notebook PCDocument Part Number: 417615-002September 2006This guide is a troubleshooting reference used for maintaining and servicing the computer. It provides comprehensive information on identifying computer features, components, and spare parts; troubleshooting computer problems; and performing computer disa …
  • Panasonic

    MA2Z7850G

    (4 pages)
    Schottky Barrier Diodes (SBD)1Publication date: October 2007 SKH00188AEDThis product complies with the RoHS Directive (EU 2002/95/EC).MA2Z7850GSilicon epitaxial planar typeFor super high speed switchingFor small current rectification■ Features•High-density mounting is possible•Forward current (Average) IF(AV) = 100 mA rectification ispossible•Optimum …
  • MiLAN

    MIL-W0311

    (100 pages)
    ShAir OfficeMulti-FunctionInternet & Wireless GatewayModels MIL-W0311 & MIL-W1311Broadband Internet AccessWireless Access PointDial-in RASPrint ServerUser’s Guide …
  • D-Link

    AirPremier AG DWL-AG530

    (12 pages)
    1DWL-AG530©2003 D-Link Systems, Inc. All rights reserved. Trademarks or registered trademarks are the property of their respective holders. Software andspecifications subject to change without notice. DWL-AG530 11132003If any of the above items are missing, please contact your reseller.CD-ROM (containing Drivers, Manual and Warranty)This product works with …
  • TDK

    DEA Series DEA200710LT-1238A1

    (2 pages)
    (1/2)001-02 / 20080113 / e731_dea200710lt_1238.fm• All specifications are subject to change without notice.Multilayer Chip Low Pass FiltersConformity to RoHS Directive For DVB-H/ISDB-TDEA Series DEA200710LT-1238A1SHAPES AND DIMENSIONS0.65±0.10.2±0.15 0.35±0.12.0±0.1654123Dimensions in mm0.3+0.1–0.150.25+0.1–0.20.6±0.11.25±0.11 GND2IN3 GND4 GND5 …

Comments, Questions and Opinions: