Dacor 100500 Installation Instructions Manual

Text of Dacor 100500 User Guide:

• Dacor 100500, 1 Refrigerator Safety .......................................................................1 Design Specifications ...............................................................2-6 Product Dimensions ....................................................................2 Door Swing Dimensions ............................................................. 2 Custom Overlay Panels ...........................................................3-6 Installation Specifications ........................................................7-8 Tools and Parts ...............................................

• Dacor 100500, 2 dooR swing dimensions The area to the left and the right of the appliance must permit both doors to open to a minimum of 90°. Allow a minimum of 2 1/2” (64mm) space between the side of the refrigerator doors and a corner wall. NOTE: More clearance may be required if using an overlay panel or custom handles. PRoduCT dimensions ◊ Thedepthfromthefrontofthetopgrill(w/odecoratorpanel) to the back of the refrigerator chassis is 25 1/4” (641mm). ◊ Thedepthfromtherearofthetopgrilltothebackofthe refrigerator chassi

• Dacor 100500, 3 H (A) Grille Panel H W (C) Non-Dispenser Freezer Panel W (D) Refrigerator Panel W H W H1 H2 W1 W2 (B) Dispenser Freezer Panel design sPeCifiCaTions CusTom oveRlay Panels The decorator panels for overlay models cover the door trim for an attractive, seamless look that flows into the overall design of the room. This application is often accomplished by using three panels: the decorative front panel, a spacer panel of .10-inch thickness, and a 1/4-inch backer panel. (see page 4)

• Dacor 100500, 4 Overlay Panel Specifications (See Illustrations on page 3.) 42-Inch Model 48-Inch Model BACKER PANEL (A) Grille Panel W Width 40 1/4” (1022mm) 46 1/4” (1175mm) H Height 8 3/4” (222mm) 8 3/4” (222mm) (B) Freezer Dispenser Panel W Width 16 1/4” (413mm) 18 1/2” (470mm) W1 Width 2” (51mm) 2” (51mm) W2 Width 14 1/2” (368mm) 14 1/2” (368mm) H Height 69 1/8” (1756mm) 69 1/8” (1756mm) H1 Height 34 1/16” (865mm) 34 1/16” (865mm) H2 Height 48 1/8” (1222mm) 48 1/8” (1222mm) (C) Freezer Non-Dispenser Panel W Width 16 1/4” (413mm) 18 1/2” (470mm) H Height 69 1/8” (1756mm) 69 1/8” (1756mm) (D) Refrigerator Panel W Width 23 1/2”

• Dacor 100500, 5 design sPeCifiCaTions Custom Toe Kickplate Specifications If using custom toe kickplate with your Dacor ® Built-In Refrigerator, refer to the following specifications. “C” 3" 3 3/4" R. 1/2" Non-Dispenser 2 3/16" Typ 7/8" 5/16" 4 13/16" 5 5/8" 1 1/8" Typ 6 1/4" 15/16" Typ Panel thicker than 3/16" Cut out for Dispenser Allow relief here for dispenser models with panels thicker than 3/16" 1 13/16" 3/4" Typ (A) (A) (A) Angled cut for thicker plates (B)(B) (B)(B) Custom Handle Specifications Before installing the custom panel assembly, the custom handle hardware must be installed. It

• Dacor 100500, 6 design sPeCifiCaTions 0" 3/4" Overlay Panel 1/4" 90˚ Door Opening (Top View) 23 7/8" to Rear of Cabinet Cabinet Trim Door Open @ 90˚ Door Closed 1/2" 3/4" 1" 1 1/4" 1 1/4" 1" 3/4" 1/2" 1/4" 0" 1 1/2" 1 3/4" 2" 2 1/4" 2 1/2" 2 3/4" 3" 3 1/4" 3 1/2" 90° Door Stop Both doors are designed to open 135°. To restrict one or both doors to a 90° opening, use the door stops supplied in this kit. With the doors closed, screw a door stop into the underside of the lower hinge plate as illustrated above. Door Panel Lower Hi

• Dacor 100500, 7 insTallaTion sPeCifiCaTions Tools and PaRTs IMPORTANT: ◊ Installer: Leave these Installation Instructions with the homeowner. ◊ Homeowner: Keep these Installation Instructions for future reference. Save these Installation Instructions for the local electrical inspector’s use. Tools needed: Make sure that you have the necessary tools and materials available for a proper installation. ◊ Phillips screwdriver set ◊ Slotted screwdriver set ◊ Torx drive screwdriver set ◊ Provide sufficient length 8’ (2.4m) to allow for a minimum o

• Dacor 100500, 8 Rough-In Dimensions ◊ The solid sofit or ceiling should be within 1” (25mm) above the refrigerator. If the solid sofit is higher than 1” (25mm) or one is not available, then the refrigerator must be braced to prevent tipping during use. If the anti-tip blocking is need. (see “Anti-Tip Blocking” on page 9) NOTE: A clearance of 1/2” (13mm) must be maintained above the top grill in order for the top grill to be opened. ◊ A grounded 3 prong non-GFCI electrical outlet should be placed 2” (51mm) from the right side cabine

• 9 insTallaTion insTRuCTions unPaCk RefRigeRaToR WARNING TIP OVER HAZARD – Refrigerator is top heavy and tips easily when not completely installed, Keep doors taped closed until refrigerator is completely installed. Use two or more people to move and install refrigerator. Failure to do so can result in death or serious injury. IMPORTANT: ◊ Do not remove the protective film u

• Dacor 100500, 10 insTallaTion insTRuCTions waTeR line ConneCTion Plug in RefRigeRaToR move uniT To final PosiTion IMPORTANT: To prevent floor damage, make sure levelers are raised (not touching the floor) and the unit is on rollers before moving. ◊ Place top of cardboard carton or plywood under refrigerator. Remove unit from dolly. ◊ Do not remove protective film. ◊ Move the refrigerator straight back and evenly into the rough opening. Verify that the water tubing is not kinked and the power cord is not kinked. 1. Verify that

• Dacor 100500, 11 insTallaTion insTRuCTions insTall CusTom Panels Panel Installation Before you begin installing panels, refer to the “Custom Panel Specifications” for overlay models and verify that you are working with the panel design called for in your installation. If you have chosen the stainless steel design, your refrigerator has been shipped complete with a finished stainless steel front. It will not be necessary to install panels or handle hardware. Be aware that panels used on refrigerators with the overlay design have the potential for coming into contact with adjacent

• 12 7. Remove the four #15 Torx plastic collar screws from the fountain/escutcheon collar. 8. Place the fountain/ escutcheon collar onto the backer panel. Use tape to hold in place. 9. Open the freezer door and slide panel onto the door. 10. The holes in the fountain/escutcheon collar should line up with the mounting holes in the door panel. Reverse instructions 7 to 1

• 13 insTallaTion insTRuCTions Side Panel Installation If using side panels with the Dacor ® Built-In Refrigerator, they will need to be 1/4-inch thick. Slide the panel into position and secure with screws indicated by the shaded area. A 3/16-inch spacer is required between the cabinet and side panel. A 1/2-inch thick by 10 1/4- inch tall spacer is required if the side panel extends u

• 14 The importance of the proper installation of your Dacor Built-In Refrigerator cannot be overemphasized. Proper installation is the responsibility of the homeowner. IMPORTANT: To ensure a safe and proper installation, the following checklist should be competed by the installer to ensure that no part of the installation has been overlooked. Any questions or problems with this installation

• Dacor 100500, Web Site: www.dacor.com Phone: (800) 793-0093 The information and images in this book are the copyright property of Distinctive Appliances, Inc. Neither this book nor any information or images contained herein may be copied or used in whole or in part without the express written permission of Distinctive Appliances, Inc. ©Distinctive Appliances, Inc. all rights reserved.

Related Products and Documents (Refrigerator):

Comparable Devices:

Similar Resources:

• Whirlpool WUR35X24HZ (36 pages) W11515962 - 8336460163200UNDER COUNTER REFRIGERATORUse & Care GuideFor questions about features, operation/performance, parts or service, call: 1-800-253-1301In Canada, call for assistance 1-800-807-6777 or visit our website at...www.whirlpool.com or www.whirlpool.caREFRIGERADOR PARA INSTALARSEDEBAJO DEL MOSTRADORManual de Uso y CuidadoPara consultas res …

• Samsung RFG297AB (7 pages) quick start guideProduct featuresRFG297ABSurround Multi FlowUniform cooling for each shelf and even in corner in fresh food compartment by centerpositioned fan and duct with multiple flow effluences.Electronic control from outside of Pantry CoverAdjustable temperature control (around 41℉(5℃):Deli /around 38℉(3℃) : Fresh / around 34℉(1℃) Chilled …

• Samsung DA68-02952C-01 (44 pages) Refrigeratoruser manualimagine the possibilitiesThank you for purchasing this Samsung product.Free Standing ApplianceThis manual is made with 100 % recycled paper.DA68-02952C (EN)-01.indd 1 2015. 8. 25. �� 9:27 …

• Hach AS950 (444 pages) DOC026.98.80492AS950 Portable Sampler06/2016, Edition 5Basic Installation and MaintenanceGrundlegende Installation und WartungInstallazione e manutenzione baseInstallation de base et maintenanceInstalación y mantenimiento básicosInstalação e Manutenção BásicaZáklady instalace a údržbyStandaard installatie en onderhoudPodstawowa instrukcja montażu …

• U-Line U-1075WCS-00 (19 pages) ®1000, 29 & 75 SERIESWINE CAPTAIN® MODELSBEVERAGE CENTERSREFRIGERATORS, FREEZERSWINE CAPTAIN® MODELSBEVERAGE CENTERUSE AND CARE GUIDEREFRIGERATORFREEZERThe American Built-In Undercounter Leader Since 1962U-LINE.COMU-1075WCS-00U-1075WCS-02U-1075WCS-13U-1075WCS-15U-1075BEVS-00U-1075BEVS-02U-1075BEVS-13U-1075BEVS-15ULN-29RB-00 ULN-29RWH-02ULN-29RB-02 ULN …

• Kenmore 596.6928 (48 pages) Use & Care GuideManual de uso y cuidadoGuide d’utilisation et d’entretienEnglish / Español / FrançaisModels/Modelos/Modèles: 596.6928*, 6991*, 6992*, 6993*, 6994*, 6995*, 6996* 596.6997*, 6998* Kenmore®Bottom Mount RefrigeratorRefrigerador con congelador en la parte inferiorRéfrigérateur à congélateur en bas* = color number, número de color …

Comments, Questions and Opinions: