Manualios.com

Efficient Networks SpeedStream 4000 Installation Manual

Efficient Networks SpeedStream 4000 Manual Online:

3.2, 797 votes
Efficient Networks SpeedStream 4000 User Manual
Efficient Networks SpeedStream 4000 User Guide
Efficient Networks SpeedStream 4000 Online Manual

Text of Efficient Networks SpeedStream 4000 User Guide:

  • Efficient Networks SpeedStream 4000, Efficient Networks, Inc. 1  Copyright 1999, Efficient Networks, Inc. All rights reserved. Printed in the U.S.A. Product names mentioned herein may be trademarks and/or registered trademarks of their respective companies. Ef- ficient Networks, Inc. shall not be liable for technical or editorial errors or omissions in this document; nor for inci- dental or consequential damages resulting from the furnishing, performance, or use of this material. Efficient Networks, Inc. – Single-use Software License and Warranty This docume

  • 2 Efficient Networks, Inc. 7. No Other Rights Granted. Other than the limited license expressly granted herein, no license, whether express or implied, by estoppel or otherwise, is granted to any copyright, patent, trademark, trade secret, or other proprietary rights of ENI. 8. Licensee Responsibilty And Indemnification. The End User understands and acknowledges t

  • Efficient Networks SpeedStream 4000, Efficient Networks, Inc. About the 4000 Series Modems 3 Introduction About the 4000 Series Modems The SpeedStream 4000 series external Asymmetric Digital Subscriber Line (ADSL) modem provides a high-speed internet connectivity for a single PC running Windows 98. The modem sends and receives data over standard phone lines using Discrete Multi-tone (DMT) digital subscriber line (DSL) transmission. The modem is connected to your PC through a Universal Serial Bus (USB) port. The modem requires a tele

  • Efficient Networks SpeedStream 4000, 4 About the 4000 Series Modems Efficient Networks, Inc. instructions for removing the modem software on page 16. Then follow the instructions in the next section to install the new revision of the driver software. Terminology ADSL Asymmetric Digital Subscriber Line ATM Asynchronous Transfer Mode CIP Classical IP over ATM CO Central Office DMT Discrete Multi-tone DSL Digital Subscriber Line Firmware Software, in binary form, stored within a flash PROM POST Power-On Self Test PPP Point-to-Point Protocol USB Uni

  • Efficient Networks SpeedStream 4000, Efficient Networks, Inc. Installation Instructions 5 Hardware Installation Installation Instructions NOTE: The labels for the back panel of the modem are located on the underside of the unit. 1 Connect the power cable to the power connector on the back of the modem; then connect it to a power outlet. 2 Locate the ferrite choke and open it by pulling up on the lip on the non-hinged side. Attach the choke to the USB cable (marked with this symbol: ) as shown in the figure below. USB Port Power Conn

  • Efficient Networks SpeedStream 4000, 6 Installation Instructions Efficient Networks, Inc. 3 After attaching the ferrite choke, attach the USB cable to the USB port on the back of the modem and connect the other end of the cable to the USB port on your computer. 4 Connect one end of the USB cable (marked with this symbol: ) to the USB port on the back of the modem and connect the other end of the cable to the USB port on your computer. 5 Connect one end of an RJ11 telephone cable to the modem’s DSL port and the other end to the DSL service port (wall jack). 6 Proceed with the software installation desribed in the next

  • Efficient Networks SpeedStream 4000, Efficient Networks, Inc. Product Overview 7 Software Installation Product Overview The SpeedStream 4000 Series Modem provides high-speed connectivity using Asynchronous Transfer Mode (ATM) over an Asymmetric Digital Subscriber Line (ADSL). There are two types of software that can be installed on the 4000-series modem: • Point-to-Point Protocol (PPP) software driver • CIP/1483 (Classical IP/RFC 1483 Multiprotocol Encapsulation) software driver. The main difference between the two is the way that the modem connects. With the PPP software, the user must initiate the connection using the Microsoft D

  • Efficient Networks SpeedStream 4000, 8 PPP Driver Installation Efficient Networks, Inc. 3 If not, select the Add button and double-click on Adapter. 4 Scroll down in the Manufacturers list and select Microsoft. 5 Under Network Adapters, double-click Microsoft Virtual Private Networking Adapter . PPP Driver Installation 1 When the power is connected to the modem and the USB cable is connected from the modem to the PC, the Add New Hardware Wizard will appear. This dialog indicates that an unknown device is installed. Insert the installation CD-ROM and click Next. 2 O

  • Efficient Networks SpeedStream 4000, Efficient Networks, Inc. PPP Driver Installation 9 3 On the next dialog, select only the checkbox labeled Specify a location . Then click the Browse button. 3-a In the browse list, locate your CD-ROM drive letter and double-click on it; then double-click the W98 folder followed by the Ppp folder. Click OK.

  • Efficient Networks SpeedStream 4000, 10 PPP Driver Installation Efficient Networks, Inc. 3-b Click Next on the Add New Hardware Wizard dialog box. 4 The next dialog box states that “Windows is now ready to install the best driver for this device.” Click Next. Windows will then copy the driver files from your CD-ROM. As the files are being copied, you may be prompted for the Windows 98 CD. If so, insert the CD and click OK. 5 Next you may see the Insert Disk dialog box. Click OK. 6 On the Copying Files dialog box, pull down the “Copy files from:” list and select <drive>: W98. Click OK. 7 Click Finish on the Add New Hardware

  • Efficient Networks SpeedStream 4000, Efficient Networks, Inc. PPP Driver Installation 11 Setting up a PPP Connection After installing the PPP software, you may be required by your service provider to configure the IP address before you connect using the Dial-Up Networking applet. 1 Select My Computer, then Dial-Up Networking. 2 You will see an icon for the ADSL PPP connection that was defined when you installed the driver. Double-click on the connection icon. 3 Enter a password. Select the “Connect” button to create the connection. 4 A modem

  • 12 CIP/1483 Driver Installation Efficient Networks, Inc. CIP/1483 Driver Installation 1 When the power is connected to the modem and the USB cable is connected from the modem to the PC, the Add New Hardware Wizard will appear. This dialog indicates that an unknown device is installed. Insert the installation CD-ROM and click Next. 2 On the next dialog, the first op

  • Efficient Networks SpeedStream 4000, Efficient Networks, Inc. CIP/1483 Driver Installation 13 3 On the next dialog, select only the checkbox labeled Specify a location . Then click the Browse button. 3-a In the browse list, locate your CD-ROM drive letter and double-click on it; then double-click the W98 folder followed by the Cip-1483 folder.

  • Efficient Networks SpeedStream 4000, 14 CIP/1483 Driver Installation Efficient Networks, Inc. 3-b Click Next on the Add New Hardware Wizard dialog box. 4 The next dialog box states that “Windows is now ready to install the best driver for this device .” Click Next. Windows will then copy the driver files from your CD-ROM. As the files are being copied, you may be prompted for the Windows 98 CD. If so, insert the CD and click OK. 5 Next, a series of configuration dialog boxes will be presented. Use your service provider’s instructions to set the parameters on each dialog or click Next to select the default values. 6 Click the Finish button to complete t

  • Efficient Networks, Inc. SpeedStream Status 15 4 When configuration is complete, click OK. You may be prompted to reboot the computer. If so, click Yes. SpeedStream Status After the driver software is properly installed and a connection has been established, you will see the following icons on the taskbar: Indicates that the modem has an active connection. The lights will blink w

  • Efficient Networks SpeedStream 4000, 16 Removing the Modem Software Efficient Networks, Inc. 4 Select the Configuration tab, and select our product from the list. 5 Click on the Remove button and select OK to close the Network dialog. 6 When prompted, restart Windows.

  • Efficient Networks, Inc. SpeedStream 4000 Series Specifications 17 Technical Reference SpeedStream 4000 Series Specifications Size 5.56 in. x 7.3 in. x 1.75” (14.12 cm x 18.54 cm x 4.44 cm) Weight 2 lbs, 11 oz (1.2 Kg ) (includes modem, power supply and cable) Power (standard) Wall-mount AC to DC adapter. 10-21vDC @ 1.1 amp output. AC input to meet count

Related Products and Documents (Modem):

Comparable Devices:

# Manufacturer Model Document Type File Updated Pages Size
1 Tripp Lite SmartPro Rackmount Owner's manual tripp-lite/smartpro-rackmount-M6S.pdf 05 Apr 2023 40 7.91 Mb
2 NEC MOBILE TERMINAL EX Operation & user’s manual nec/mobile-terminal-ex-MB7.pdf 12 Dec 2022 24
3 Philips RFX9400 Specifications philips/rfx9400-P19.pdf 13 Apr 2023 2 0.14 Mb
4 Panasonic TXP42C2L Operating instructions manual panasonic/txp42c2l-FQT.pdf 06 Aug 2023 68
5 Cooper Lighting Staggered Striplight Accessory Reflector SSL-ASY Specification cooper-lighting/staggered-striplight-accessory-reflector-ssl-asy-F9V.pdf 12 Feb 2024 2 0.25 Mb
6 Kenmore 153.32562 Owner's manual kenmore/153-32562-OGC.pdf 13 Feb 2023 28

Similar Resources:

  • Huawei

    E160E

    (16 pages)
    Copyright © Huawei Technologies Co., Ltd. 2009. All rights reserved. No part of this document may be reproduced or transmitted in any form or by any means without prior written consent of Huawei Technologies Co., Ltd. The product described in this manual may include copyrighted software of Huawei Technologies Co., Ltd and possible licensors. Customers shall …
  • ICP DAS USA

    ZT-USBC

    (29 pages)
    ICPDAS,ZT‐USBSeriesUserManual,Version1.0Page1 Copyright@2013byICPDASCo.,Ltd.AllRightsReserved.ZT-USB Series User Manual WarrantyAll products manufactured by ICP DAS are under warranty regarding defective materials for a period of one year, beginning from the date of delivery to th …
  • D-Link

    DWM-156

    (12 pages)
    --1- FAQ : How to manually create a profile on the D-Link Connection Manager Technical Support Set-up Procedure FAQ : How to manually create a profile on the D-Li …
  • PROLiNK

    PCM100

    (2 pages)
    www.prolink2u.com PROLiNK® PCM100 EVDO USB Modem Quick Installation Guide (QIG) Revision: 1.00 (English) BEFORE GETTING STARTED This QIG is designed to aid in the quick installation of your PROLiNK® PCM100 EVDO USB Modem. If you experience problems following these procedures or need further information regarding your adapter, visit www.prolink2u.c …
  • 4G Systems

    XSStick W12

    (2 pages)
    3XSStick ® W12124©4G Systems GmbH & Co. KG, Jarrestraße 2-6, 22303 Hamburg, Germany, www.4g-systems.comSIM CARDOPENSIM123Einsetzen der SIM-KarteKurzanleitung3XSStick ® W12124©4G Systems GmbH & Co. KG, Jarrestraße 2-6, 22303 Hamburg, Germany, www.4g-systems.comSIM CARDOPENSIM123Insert your SIM CardQuick Start GuideWenige Sekunden nachdem der X …
  • ATC Technology

    277SM

    (2 pages)
    High-Speed RS-232/RS-485/RS-422 Single-Mode Fiber Optic Modem User’s Manual MODEL 277SM 1.0 Description: The MODEL 277SM was designed to provide the most versatile connection possible between any asynchronous serial equipment using Fiber Optic cable. It allows any two pieces of asynchronous serial equipment to communicate full or half-d …

Comments, Questions and Opinions: