Manualios.com

Whirlpool WSR413YW0 Use And Care Manual And Installation Instructions

  • WSR413YW0 Water Dispenser
  • maFu7CE.Y3rFQ
  • Use And Care Manual And Installation Instructions
  • PDF / Adobe Acrobat Reader
  • 18

Whirlpool WSR413YW0 Manual Online:

4.05, 1980 votes
Whirlpool WSR413YW0 User Manual
Whirlpool WSR413YW0 User Guide
Whirlpool WSR413YW0 Online Manual

Text of Whirlpool WSR413YW0 User Guide:

  • Whirlpool WSR413YW0, Remove parts from packages. Check that you have all the parts. storage tank with base (A) filtration assembly cover (B) two mounting screws (C) g-volt battery (D) filtration assembly (E) 3/e” blue tubing (F) l/4” yellow tubing (G) l/4” orange tubing (H) RO membrane cartridge (I) I n %” red tubing wiih push-in connector attached (K) l/4” green tubing (L) drain saddle elbow (M) drain saddle valve assembly (N) air-gap faucet assembly: faucet spout (0) faucet base (P) chrome base plate (Q) LED indicator disk (R) rubber washer (S) slotted washer (T) spacer (U)

  • Whirlpool WSR413YW0, Before You Start . . . HOOK UP WATER I L, IMPORTANT: Read and save these instructions. It is recommended that this system be installed by a licensed plumber. It is the responsibility of the installer to comply with the installation specifications provided and with state and local plumbing codes. If you decided to install the system yourself, see “General Information” on page 13 before continuing. Water FlItration System IV can be installed In the basement if

  • Whirlpool WSR413YW0, - - Instructions At A Glance l For detailed instructions see following page. 1. Turn off cold water supply. (Steps la-lb) 3. Connect saddle valve to cold water supply. (Steps We or 1 h-lj) 2. Turn on faucet to drain water from line. (Step 1 b) 4. Turn saddle valve handle clockwise until piercing lance enters pope and stops. (Steps If-19 or 1 k-l I)

  • Whirlpool WSR413YW0, Product Damage DO NOT connect to a hot water supply line. Failure to follow this instruction could result in product damage. la Take note of water requirements listed . under the Use & Care section of this booklet. The filtration system’s feed line (orange tubing) connects to your cold water supply line using the saddle valve. Do not use saddle valve if it is prohibited by your state or local plumbing codes. The saddle valve is for use with 3/e” to %” outer diameter (O.D.), soft copper pipe (plain or

  • Whirlpool WSR413YW0, Instructions At A Glance l For detailed I. Connect faucet spout, chrome base plate, indicator light disk and rubber washer to faucet base. (Steps 2a-2b) nstructions see following page. 2. Connect green tubing and black tubing to faucet. (Steps 2c-2d) 3. Place faucet in sink opening. Secure faucet to sink 4. Connect faucet indicator wire to wire harness with slotted washer, spacer, flat washer, hex nut on filtration assembly. Insert battery. (Step 2k) and grey connector. Connect blue tubin bottom of faucet assembly. (Steps 2e- s to i) f-i -.

  • Whirlpool WSR413YW0, Front view of air gap faucet _ chrome base elate indicator - light wire t ;fby;; Fhex nut Is- %” grey connector with push-in end Side view of air gap faucet k spout air gap hole slnk %” tubing black %” tubing must ;lor; downward to blue %” tubing Property Damage l Contact a qualified installer or licensed plumber for cutting a faucet opening in your type of sink. l F!;IIwJ~ do so may result in damage to 2a A 741” to 1%” diameter opening in the sink is . required to install the faucet provided. Important: If you do not have an existing sink

  • Instructions At A Glance l For detailed instructions see following page. 1. Install RO cartridge into filtration assembly. Connect one end of red tubing to bottom of RO cartridge. Connect other end to green tubing from faucet. (Steps 3a-3e) 3. Use orange tubing from filtration assembly to fill storage tank with water. (Steps 3g-3h) Connect orange tubing saddle valve. (Step 3f) 4

  • Whirlpool WSR413YW0, The filtration assembly should already be . placed close to its final location. Move storage tank near its final location, which should be within four feet of filtration assembly. The filtration assembly may be installed under a sink or in the basement (mounted to wood floor supports or to the basement wall). For basement installation order Basement Installation Kit, Part No. 4373517 available from your Whirlpool dealer. Property/Product Damage DO NOT store or o 2 erate the RO water filtration system below 32 . Failure to follow above may result in water damage to property or product

  • Whirlpool WSR413YW0, Instructions At A Glance l For detailed instructions see following page. 1. Decide where drain saddle will be mounted. w , The best place is on a horizontal drain tailpiece I above (before) the trap. (Steps 4a-4b) , 2. Connect drain saddle to drain pipe. (Step 4c) 3. Drill hole in drain using o drain saddle as a guide. ( t ening in tep 4d) 4. Thread elbow into drain saddle. Connect black tubing to elbow. (Steps 4e-4f) in

  • Electrical Shock Hazard Special care must be taken when drilling into water pipes. Some water may remain in pipe. - If an electric drill is used, it must be properly grounded to prevent severe or lethal shock if water should enter drill. Use only an electric drill with a 3-wire power supply cord connected to a grounded recepta

  • Whirlpool WSR413YW0, Flush System Instructions At A Glance l For detailed instructions see following page. I. Slide filtration assembly onto mounting screws. 2. Turn on faucet and drain tank to flush (Step 5a) disinfectant from tank. (Step 5b) 3. Turn on cold water supply and saddle valve. (Step 5c) 4. Allow tank to fill - ap roximately 4 hours. Lift faucet handle to drain tank. Fill an B drain tank again - another 4 hours. Wait for tank to fill again. When faucet is turned on, green indicator light will indicate water is ready for use. (Steps 5d-5e) 12

  • Whirlpool WSR413YW0, Flush System 5a Slide filtration asse . mounting holes onto mounting screws that were installed in step 3b. DO NOT kink or bend tubing. Insulated staples may be used to secure tubing to cabinet walls. Tighten mount- ing screws to secure filtration assembly to wall. Replace fil- tration assembly cover. 5b In step 3h you filled the storage tank with , water to activate the special disinfectant. If that water has set in the tank for at least 15 minutes, you can now drain the tank. To do this, turn the storage tank’s blue valve on (up). Lift the faucet handle and allow tank t

  • Whirlpool WSR413YW0, Water Requirements The filtration system must be connected to a cold water supply line providing 40-l 00 psi water pressure. If psi is less than 40, a booster pump, (Part Number 4373525) will be needed. Review the water application guideline chart below to determine if your water meets the standards necessary to use this water filtration system. DO NOT use filtration system if water is microbiologically unsafe or water quality I is unknown. Pretreat water that exceeds limits for hardness, iron, manganese, and hydro- gen sulfide. 1 Failure to follow these instructions could result in personal injury.

  • Using your RO water filtration system To get purified water from the storage tank - Hold the faucet handle down for momentary flow, hold the faucet up for continuous flow. To stop water flow from the faucet - Return the faucet to the center or horizontal position. When faucet flow slows or drips - The storage tank is empty.

  • How to sanitize the storage tank You will need to order Tank Sanitizing Kit, Part No. 4373527. You will also need household bleach and a measuring spoon. 1. Turn off saddle valve in water line. Open faucet and drain storage tank. There will be no water dripping when tank is empty. 2. Turn off faucet. Push in grey connector to disconn

  • Whirlpool WSR413YW0, Performance Data Sheet @ Q This Reverse Osmosis System has been tested and listed by NSF International under Standard 58 for the water treatment claims listed below under “Contaminant Reduction Performance”. Whirlpool Reverse Osmosis Water Filtration System IV Model No. WSR413YW Test Parameters TDS = 200500 mg/L2 pH = 7.5 Turbidity = 1 NTU Temperature = 77°F Pressure = 50 psig ‘USEPA Maximum Contaminanl Level or Action Level (mg/L). 3arrium. Cadmium and Chromium were tested at 750 mglL TDS. 3The reduction of Radium was veri

Comparable Devices:

# Manufacturer Model Document Type File Updated Pages Size
1 Frigidaire GLWS1749AS5 Installation instructions manual frigidaire/glws1749as5-PG1.pdf 16 Mar 2024 6 0.47 Mb
2 Yamaha V-stan 1300 Owner's manual yamaha/v-stan-1300-V39.pdf 28 Jun 2022 98 3.87 Mb
3 Sennheiser HMDC 322 User manual manual sennheiser/hmdc-322-7N7.pdf 10 Nov 2023 144 3.25 Mb
4 Kuppersbusch EEH 6500.5 Instructions for use and installation instructions kuppersbusch/eeh-6500-5-KC8.pdf 30 Dec 2022 25
5 Motorola DCT3400 ALL-DIGITAL SET-TOP - TV GUIDE IGUIDE Specification sheet motorola/dct3400-all-digital-set-top-tv-guide-iguide-51N.pdf 23 Jul 2022 2
6 August DG400 Specification august/dg400-MG8.pdf 02 Sep 2022 1 0.22 Mb

Similar Resources:

  • Runxin

    Runlucky RL-Q01

    (9 pages)
    User Manual for High-efficiency Automatic Backwash Disk Prefilter 0WRX.466.671 1. Main Application Used for filtering municipal water treatment. Coarse filtration. Can filter PM larger than 0.05mm, for protecting the back water equipment. Suitable for installation in house. 2. Product Characteristics 3. Technic …
  • Cornelius

    CR50Aqua

    (32 pages)
    C CR50Aqua / CR70Aqua Tafelwasserschankanlage POU Waterdispenser Sprache / Language Seite /Page Deutsch Gebrauchsanweisung 2-17 English Operating Instructions 18-32 PN 14-1888-288 –04/2011 Version A Gebrauchsanweisung Operating Instructions CR50Aqua Obertheke CR50Aqua Tabletop PN 22-1000-508 CR50Aqua Untertheke CR5 …
  • Elkay

    EZH20 LZWSMD*

    (16 pages)
    Installation ManualezH2O® In-Wall Filtered Water Dispenser with optional Filter BoxAmbient with Filter BoxChilled (optional) with Remote FilterWWW.RESTROOMDIRECT.COM 704•937•2673 129 Oakpark Dr., Unit A, Mooresville, NC 28115 …
  • Hydrotech

    89

    (4 pages)
    Inlet OutetOutlet Intlet Upflow Valve Downflow ValveResinSupport BedGravel O-ring1. Media InstallationCAUTION: Make sure the power cord of the valve doesnt get caught between the threadsGrease port Orings using brush (not included) or your finger (Make sure to wear protective gloves)Attach Upper Basket123ClipsBypassUnscrew Spill CapD-Tube89 …
  • Hama

    Water filter kit

    (1 pages)
    0011088900110889/09.07d Bedienungsanleitung g Operating instructionsf Mode d‘emploiPackungsinhalt/Packing contents/Contenu d‘emballage:Montageanleitung/Assembly instruction/Instruction de montage:für/forUS-Kühlschränke, universell/US Refrigerators, universalMai 2007Wasserfi lter-SetWerkzeug und BefestigungsmaterialZur einfachen und korrekten Installa …
  • Aquasana

    EQ-AST-WH

    (5 pages)
    Installation InstructionsWhole House DescalerEQ-AST-WH & EQ-AST-WH-CWelcome to the Aquasana experience. You are about to enjoy clean, clear water and the peace of mind that comes from knowing award winning filter technology is working for you.Installation must comply with state and local laws. …

Comments, Questions and Opinions: