Manualios.com

Enviro C-11150 Technical Manual

Enviro C-11150 Manual Online:

4.15, 900 votes
Enviro C-11150 User Manual
Enviro C-11150 User Guide
Enviro C-11150 Online Manual

Text of Enviro C-11150 User Guide:

  • Enviro C-11150, 9 hot enough to cause burns if touched by children. Non-combustible shielding or guards may be required. 3. Termination must exhaust above the inlet elevation. It is recommended that at least five feet of vertical pipe be installed outside when the appliance is vented directly through a wall, to create some natural draft to prevent the possibility of smoke or odor during appliance shut down or power failure. This will keep exhaust from causing a nuisance or hazard from exposing people or shrubs to high temperatures. In any case, the safest and pref

  • Enviro C-11150, Parts Diagram - Steel Mini - Steel Components November 2006                      30

  • Enviro C-11150, PELLET STOVE Mini PLEASE READ THIS ENTIRE MANUAL BEFORE INSTALLATION AND USE OF THIS PELLET BURNING ROOM HEATER. FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN PROPERTY DAMAGE, BODILY INJURY OR EVEN DEATH Contact your building or fire officials about restrictions and installation inspection requirements in your area. SHERWOOD INDUSTRIES IS AN ENVIRONMENTALLY RESPONSIBLE COMPANY. THIS MANUAL IS PRINTED ON RECYCLED PAPER. PLEASE KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE TECHNICAL MANUA

  • 33 Warranty 17. Damage to plated surfaces caused by fingerprints, scratches, melted items, or other external scores and residues left on the plated surfaces from the use of abrasive cleaners or polishes is not covered in this warranty. 18. The Limited Warranty does not cover tarnish, discoloration or wear on the plated surfaces. 19. The paint on the Metal

  • Enviro C-11150, 19 Installation THERMOSTAT INSTALLATION: 1. Install the wall thermostat in a location that is not to close too the unit but will effectively heat the desired area. 2. Install a 12 or 24 Volt Thermostat using an 18 x 2 gauge wire from the unit to the thermostat. OPTIONAL SLIDER/DAMPER INSTALLATION: If you wish to adjust the slider damper externally (NOT REQUIRED), please follow the instructions below. If the unit has been placed in the HI / LOW mode, the unit will be taken to a low or i

  • Enviro C-11150, Parts List Reference Number Description Part Number 17 Burn Pot 50-1166 18 Burn Pot Liner 50-1167 19 Burn Pot Bottom 50-1168 20 Front Louvers 50-1169 21 Lid Set 50-1171 22 Stove Top Assembly 50-1172 Hopper Guard 50-1174 23 Handle Bracket 50-1177 24 Draft Slider 50-1178 25 Door Assembly Complete 50-1179 26 Ash Pan Cover 50-1180 27 Ash Pan 50-1181 28 Ash Shelf Louver 50-1182 29 Cabinet Side Left 50-1183 30 Starter Pipe 3” 50-1185 31 60mm Tangential Blower Mini - 115V 50-1217 32 Mini Hearth Pad 50-1219 Mini Domestic Owners Manual 50-1220 M

  • Enviro C-11150, Wiring Diagram Connect Thermostat Here Red Red Red Red Brown Brown Brown Brown White White White White 115V White 220V Blue White White Orange Orange Orange Orange Yellow Yellow Grey Grey Grey Grey Purple Purple Blue 115V Black 220V Brown Black Black Black Blue Black Armor Cable Supplied Vacuum Switch Combustion Blower Optional Exterior Exhaust Blower Power Cord Ground Ignitor Exhaust Temperature Sensor 5 Amp Fuse High Limit Temperature Sensor Convection Blower Auger Motor CommonHot Thermostat 26

  • Enviro C-11150, Installation HORIZONTAL EXHAUST THROUGH WALL INSTALLATION: Vent installation: install vent at clearances specified by the vent manufacturer. A chimney connector shall not pass through an attic or roof space, closet or similar concealed spaces, or a floor, or ceiling. Where passage through a wall or partition of combustible construction is desired, the installation shall conform to CAN/CSA-B365 Installation Code for Solid-Fuel-Burning Appliances and Equipment. Only use venting of L or PL type with an inside diameter of 3 or 4 inches (7.6 or 10.1 cm). 1. Cho

  • Enviro C-11150, 15 Installation HEARTH MOUNT INSTALLATION: Rain cap Storm collar Seal plate (cover plate) Existing masonry flue Vent pipe (single wall stainless flex pipe or solid PL vent) Fireplace damper location Clean out tee Existing fireplace Flexible vent connector (use this 5 foot [152cm] section of pipe to vent past fireplace damper or small shelf) Figure 18: Freestanding hearth mount installation overview. Refer to Figures 17 and 18. 1. Install the hearth pad. 2. Lock fireplace damper in the open position. 3. Install a positive flue connector at the fireplace dampers or seal t

  • Enviro C-11150,                                       

  • 7 Installation APPLIANCE DIMENSIONS AND SPECIFICATIONS: Figure 2: Dimensions of Mini. 15 1 /2" (393 mm) 18 7 /8" (481 mm) 17 1 /2" (444 mm) 19 5 /8" (497 mm) 17 7 /8" (455 mm) 34" (864 mm) 18 1 /2" (470 mm) 22 1 /8" (562 mm) Weight (with full hopper): 238 lb (108 Kg) Hopper Capacity: up to 48 lb (21.8 Kg) Voltage: 110 - 120 V Max Current: 4.1 Amps

  • Enviro C-11150, 4 Introduction SOOT: Operation of the stove with insufficient combustion air will result in the formation of soot which will collect on the glass, the heat exchanger, the exhaust vent system, and may stain the outside of the house. This is a dangerous situation and is inefficient. Frequently check your stove and adjust the slider/ damper as needed to ensure proper combustion. See: “SLIDER/DAMPER SETTING”. CLEANING: There will be some build up of fly ash and small amounts of creosote in the exhaust. This will vary due to the ash content of the fu

  • Enviro C-11150, EXHAUST AND INTAKE LOCATIONS: 10 1 /16" (255mm) 6 1 /8" (156mm) 2 1 /16" (53mm) Figure 8: Mini Inlet and Outlet Location. EXHAUST Base of unit to center of flue 10 1 / 16” (255 mm) Center of unit to center of flue 0” (0 mm) [at center of unit] FRESH AIR INTAKE. Base of unit to center of intake 6” (156 mm) Center of unit to center of intake 2 1 / 16” (53 mm) Outside fresh air is mandatory when installing this unit in airtight homes and mobile homes. A Fresh-air intake is strongly recommended for all installations. Failure to i

  • Enviro C-11150, Installation EXTERIOR MOUNTED EXHAUST BLOWER (20-070): The Mini can be equipped with an externally mounted exhaust blower. This optional kit includes all components necessary to install the exhaust blower on any vertical wall surface. 1. Remove the left hand cabinet side by removing the two (2) screws down the front. Loosen the three screws on the back of the cabinet side and remove panel. 2. Loosen the six (6) screws that hold the back grill in place. Lift the back grill off the screws. 3. Disconnect the Exhaust blower wires from the wire harness. Remove the exhaust blower motor from the housing; six (6) screws. Cover hole in housing with co

  • 34 NAME OF OWNER: _________________________________________ ADDRESS: _________________________________________ _________________________________________ _________________________________________ PHONE:___________________________________ NAME OF DEALER: _________________________________________ ADDRESS: _________________________________________ _________________________

  • Enviro C-11150, Installation DECIDING WHERE TO LOCATE YOUR PELLET APPLIANCE: 1. Remove the right and left hand cabinet sides by loosening the three (3) T-20 Torx screws on the back of the each panel. 2. Remove the screw located on the front of the cabinet side, below the louvers and loosen the screw behind the ash door. 3. Using a 5 /16” socket of flat head screwdriver, remove the three (3) wood screws that are holding the bottom of the stove to the pallet. There is one (1) scre

  • Enviro C-11150, Installation CLEARANCES TO COMBUSTIBLES: IMPORTANT: Attach the Mini’s Hearth Pad when installing the unit on a combustible floor. The supplied hearth pad meet all the requirement of a proper hearth pad. If you do not use the supplied hearth pad a hearth pad must be used when on combustible material. ALCOVE CLEARANCES: This unit may be installed in an alcove. Maintain these clearances to combustibles. Minimum Alcove width 36 inches (91.5 cm) Minimum Alcove height 48 inches (122 cm) Maximum Alcove depth 30 inches (76 cm) Install vent at clearances specified by the vent manufacturer. Side Wall Back Wall A d j ac e n t Wal l 8" (20cm) 3&

  • Enviro C-11150, 13 Wall framing Wall thimble Termination cap Vertical section of vent pipe Horizontal frame for thimble 90° elbow Concrete Wall Clean out tee Wall framing Wall thimble Termination cap Vertical section of vent pipe Horizontal frame for thimble Clean out tee 90° elbow Wall strap Figure 13: Venting horizontally with rise. Figure 14: Venting with concrete wall behind unit . Installation 9. The pipe must extend at least 12” (30 cm) away from the building. If necessary, bring another length of pipe (PL type) to the outside of the home to connect to the fi

  • Enviro C-11150, 5 Introduction INSTALLATION: Contact your local building or fire official to obtain a permit and any information on installation restrictions and inspection requirements for your area. All local regulations, including those referring to national and European Standards need to be complied with when installing this appliance. Be sure to maintain the structural integrity of your home when passing a vent through walls, ceilings, or roofs. It is recommended that the unit be secured into its position in order to avoid any displacement. This appliance must be installed on a floor with an

  • 3 Introduction * This manual is designed for the technician in conjunction with the owner’s manual. * RATING LABEL LOCATION: The rating label is located on the back of the unit. SAFETY WARNINGS AND RECOMMENDATIONS: Please read this entire Owner’s Manual before installing or operating your ENVIRO Pellet Stove. Failure to follow these instructions may result in prop

Related Products and Documents (Cooktop):

Comparable Devices:

# Manufacturer Model Document Type File Updated Pages Size
1 Western Digital WD ShareSpace Operation & user’s manual western-digital/wd-sharespace-X67.pdf 29 Apr 2023 207 12.76 Mb
2 Daewoo DLT-26C2, DLT-26C3, DLT-32C1, Instruction manual daewoo/dlt-26c2-dlt-26c3-dlt-32c1-B3H.pdf 13 Oct 2023 61 7.14 Mb
3 Samsung SGH-S400I Service manual samsung/sgh-s400i-NC9.pdf 07 Jan 2023 65
4 Olympus VG-140 Quick start manual olympus/vg-140-84O.pdf 12 Dec 2023 2
5 TV One C2-2000 Series Operation manual tv-one/c2-2000-series-ZIL.pdf 21 Dec 2023 66
6 Datalogic DX8200A Reference manual datalogic/dx8200a-8RP.pdf 31 Jan 2023 97

Similar Resources:

  • Frigidaire

    FGGF3054KB - Gallery - Convection Gas Range

    (4 pages)
    frigidaire.comSignature Features30" GasQuick PreheatPreheat in less than six minutes.1True ConvectionMulti-rack baking is faster and more even with True Convection. Express-Select® ControlsEasily go from warm to boil.Quick BoilBoils water faster.Product DimensionsHeight (Max.) 47-1/2"Width 29-7/8"Depth (Including Handle) 28-1/2"More …
  • KitchenAid

    KDRS505XSS00

    (40 pages)
    INSTALLATIONINSTRUCTIONS30" (76.2 CM) DOUBLEOVEN DUALFUELRANGESINSTRUCTIONSPOURL'INSTALLATIONDESCUISINIERESA BI-COMBUSTIBLEETFOURDOUBLEDE 30" (76,2 CM)Table of Contents Table des mati_resRANGE SAFETY .............................................................................. 2INSTALLATION REQUIREMENTS ....................................... …
  • Miele

    KM 3034

    (60 pages)
    Operating and installation instructionsGas cooktopsTo prevent the risk of accidents or damage to the appliance, it isessential to read these instructions before it is installed and used forthe first time.en-AU, NZ M.-Nr. 09 317 810 …
  • Thermador

    Professional P24GE

    (64 pages)
    Models / Modèles:P24GEP24WKPC30PC36PC48For Thermador Professional® CooktopsCARE AND USE MANUALDes tables de cuisson Thermador Professional®MANUEL D’UTILISATION ETD’ENTRETIEN …
  • LG

    LRE30757SB

    (41 pages)
    OWNER’S MANUALELECTRIC RANGEPlease read this guide thoroughly before operatingand keep it handy for reference at all times.MODELSLRE30757SWLRE30757SBLRE30757STP/NO : MFL57206001 www.lg.comENGLISH ESPAÑOL …
  • KitchenAid

    KGCP483KSS03

    (5 pages)
    COOKTOP, BURNER AND GRATE PARTS1For Model: KGCP483KSS03(Stainless Steel)48" Stainless SteelProfessional Cooktop(with griddle)4−05 Litho in U.S.A. (cre)Part No.8186336 Rev.A …

Comments, Questions and Opinions: