Toshiba BG030 Instruction Manual

Text of Toshiba BG030 User Guide:

• Toshiba BG030, 38 / 85 Copyright © 2012 - 2013 TOSHIBA TELI CORPORATION, All rights reserved. http://www.toshiba-teli.co.jp/index.htm D4211908 E DeviceControl Registers of this category provide various information of the camera. And you can set the free user ID to the camera. ● Registers Register Visibility Access Description DeviceScanType Expert R Returns the scan type. DeviceVendorName Beginner R Returns the vendor name. DeviceModelName Beginner R Returns the model name. DeviceManufacturerInfo Beginner

• Toshiba BG030, 22 / 85 Copyright © 2012 - 2013 TOSHIBA TELI CORPORATION, All rights reserved. http://www.toshiba-teli.co.jp/index.htm D4211908 E I/O Specification ● Signal Specification - Trigger Input Input Circuit : Opto coupler input Input Level : Low 0 ~ 0.5V, High 3.3 ~ 24.0V Input Current : 5 ~ 15mA Polarity : Positive / Negative bipolar (initial factory setting: Negative) Pulse Width : Minimum 200µs - GPIO Output Output Circuit : LINE1 LVTTL output LINE2 Opto coupler output Output Level : LINE1 LVTTL LINE2 Open collector Maximum Current : LINE1 +/-24mA (drive current) LINE2 50mA (input curren

• Toshiba BG030, 56 / 85 Copyright © 2012 - 2013 TOSHIBA TELI CORPORATION, All rights reserved. http://www.toshiba-teli.co.jp/index.htm D4211908 E TimerControl This section describes TimerControl category for the BG series. This camera series is able to generate Timer0Active signal, derived from exposure start, by register setting. This signal can be used as strobe control signal. Fig. Timer0Active ● Registers Register Visibility Access Description TimerSelector Expert R Returns the name of the timer that selected. TimerDuration Expert R/W Sets the width of Timer0Active signa

• 5 / 85 Copyright © 2012 - 2013 TOSHIBA TELI CORPORATION, All rights reserved. http://www.toshiba-teli.co.jp/index.htm D4211908 E CASES FOR INDEMNITY (LIMITED WARRANTY) We shall be exempted from taking responsibility and held harmless for damage or losses incurred by the user in the following cases. ● In the case damage or losses

• Toshiba BG030, 47 / 85 Copyright © 2012 - 2013 TOSHIBA TELI CORPORATION, All rights reserved. http://www.toshiba-teli.co.jp/index.htm D4211908 E ● Note Changing “AcquisitionFrameRate” register value is invalid during image stream data output. When exposure time setting is longer than frame rate setting, camera operation gives priority to exposure time setting. Notes on Frame Drops of Image: Depends on your PC or Gigabit Ethernet interface board configurations, images may not be captured normally (e.g. frame drops may occur). In this case, change t

• Toshiba BG030, 28 / 85 Copyright © 2012 - 2013 TOSHIBA TELI CORPORATION, All rights reserved. http://www.toshiba-teli.co.jp/index.htm D4211908 E ● Random Trigger Shutter Operation Timed mode (Image format: Mono8bit, all pixel readout) TriggerWidth mode (Image format: Mono8bit, all pixel readout) Model T3 [µs] T4 [µs] BG030 1.0 2.5 BG031 1.0 2.5 BG080 2.2 34.0 BG130 1.2 7.1 BG202 1.5 5.9 BG030C 1.0 2.5 BG130C 1.2 7.1 * TDLY3, TDLY4: TriggerSamplingPeriod (typical value) Max TriggerSamplingPeriod x 1.625[µs], Min TriggerSamplingPer

• Toshiba BG030, 79 / 85 Copyright © 2012 - 2013 TOSHIBA TELI CORPORATION, All rights reserved. http://www.toshiba-teli.co.jp/index.htm D4211908 E ● Registers Register Visibility Access Description UserSetSelector Beginner R/W Selects a bank of user setting. UserSetLoad Beginner W Executes load of the user setting. UserSetSave Beginner W Executes to save the user setting. UserSetDefaultSelector Beginner R/W Selects a bank of user setting when camera powers up. ● Setting - Select a bank of the user setting Set the following value to “Use

• Toshiba BG030, 41 / 85 Copyright © 2012 - 2013 TOSHIBA TELI CORPORATION, All rights reserved. http://www.toshiba-teli.co.jp/index.htm D4211908 E Binning In the binning mode, a pixel is added with the neighboring pixel(s). This increases the sensitivity of the image. It’s alike scalable mode, the frame rate can be faster and Ethernet bandwidth occupation decrease. This function is available only in B/W models. Fig. Binning operation (e.g. VGA) ● Registers Register

• 11 / 85 Copyright © 2012 - 2013 TOSHIBA TELI CORPORATION, All rights reserved. http://www.toshiba-teli.co.jp/index.htm D4211908 E Installation Before using this product, you shall install application software to display image and control registers of camera, and IP configuration tool for network setting. You can download the SDK for our GigE camera products (Teli

• Toshiba BG030, 24 / 85 Copyright © 2012 - 2013 TOSHIBA TELI CORPORATION, All rights reserved. http://www.toshiba-teli.co.jp/index.htm D4211908 E ● I/O Timing The received external trigger signal delays by internal circuit. And LINE2 output delays from LINE1 output by the difference of internal circuit. - Trigger Input (a) Negative (b) Positive Fig. Trigger Signal Input Delay EXT_TRIG_WIDTH: The pulse width of the external trigger input (more than 200µs). Toff: The delay time of falling edge. Ton: The delay time o

• 34 / 85 Copyright © 2012 - 2013 TOSHIBA TELI CORPORATION, All rights reserved. http://www.toshiba-teli.co.jp/index.htm D4211908 E ● BG130C Relative Response ● BG130CF Relative Response

• Toshiba BG030, 81 / 85 Copyright © 2012 - 2013 TOSHIBA TELI CORPORATION, All rights reserved. http://www.toshiba-teli.co.jp/index.htm D4211908 E ● Setting - Set photometric area size for measuring luminance Set the following value to “ALCPhotometricAreaSize” register. The setting value is Enumeration type. setting value photometric area size Full (*) 100% (Full pixel) Medium 64% (H: 80% x V: 80%) Small 16% (H: 40% x V: 40%) * initial factory setting Fig. ALC Area - Set a value of the reference luminance Set the following va

• Toshiba BG030, 13 / 85 Copyright © 2012 - 2013 TOSHIBA TELI CORPORATION, All rights reserved. http://www.toshiba-teli.co.jp/index.htm D4211908 E ● GigEVision Ver 1.2 conformity This product is based on GigEVision Camera Interface Standard for Machine Vision Ver 1.2. ● GenICam Ver 2.3 conformity This product is based on GenICam Generic Interface for Cameras Ver 2.3. ● Random Trigger Shutter The Random Trigger Shutter function provides images in any timing by input of an external trigger signal. Trigger control from PC is available as well. ● Scalable Selectable video output area. This mode achieves higher frame rate by reduc

• Toshiba BG030, 49 / 85 Copyright © 2012 - 2013 TOSHIBA TELI CORPORATION, All rights reserved. http://www.toshiba-teli.co.jp/index.htm D4211908 E Anti-Chattering control filters noise and unstable logic value of the trigger input signal. Fig. Anti-Chattering Details of Random Trigger Shutter operation, refer to "Timing" of "Specification". ● Registers Register Visibility Access Description TriggerSelector Beginner R Returns the type of trigger. TriggerMode Beginner R/W Selects Random Trigger Shutter mode. TriggerSoftware Beginner

• Toshiba BG030, 58 / 85 Copyright © 2012 - 2013 TOSHIBA TELI CORPORATION, All rights reserved. http://www.toshiba-teli.co.jp/index.htm D4211908 E EventControl This section describes EventControl category for the BG series. This camera series provides Event notifications of ALC and trigger operation information. The detail of Event notifications is following; - FrameTrigger : Reception of Frame Start Trigger - FrameTriggerError : Rejection of Frame Start Trigger - FrameTriggerWait : Start of waiting for Frame Start Trig

• Toshiba BG030, 45 / 85 Copyright © 2012 - 2013 TOSHIBA TELI CORPORATION, All rights reserved. http://www.toshiba-teli.co.jp/index.htm D4211908 E ● Registers Register Visibility Access Description TestImageSelector Beginner R/W Selects a test pattern. ● Setting - Select a test pattern output Set the following value to “TestImageSelector” register. Setting value is Enumeration type. The camera generates a test pattern. setting value function Off (*) Test pattern disa

• Toshiba BG030, 72 / 85 Copyright © 2012 - 2013 TOSHIBA TELI CORPORATION, All rights reserved. http://www.toshiba-teli.co.jp/index.htm D4211908 E ● Setting - Select ColorCorrectionMatrix Select row and column elements of color correction matrix in “ColorCorrectionMatrixSelectorI” and “ColorCorrectionMatrixSelectorJ” register. ColorCorrectionMatrixSelector Value I R / G / B J R / G / B * initial factory setting = R - Set ColorCorrectionMatrix Set a color correction matrix coefficient to the element selected by “SelectorI” and “SelectorJ”. Setting value is Float type. Coefficients of (SelectorI, SelectorJ)=(R,R),

• Toshiba BG030, 52 / 85 Copyright © 2012 - 2013 TOSHIBA TELI CORPORATION, All rights reserved. http://www.toshiba-teli.co.jp/index.htm D4211908 E ExposureControl BG series is able to adjust exposure time by using electric shutter control. This camera series provides two kinds of exposure time control mode. - MANUAL mode : The exposure time is determined by “ExposureTime” register setting value. - AE mode : The exposure time is adjusted automatically by the photometry of the image. By combining AE

• Toshiba BG030, 6 / 85 Copyright © 2012 - 2013 TOSHIBA TELI CORPORATION, All rights reserved. http://www.toshiba-teli.co.jp/index.htm D4211908 E RESTRICTION FOR USE ● Should the equipment be used in the following conditions or environments, give consideration to safety measures and inform us of such usage: 1. Use of the equipment in the conditions or environment contrary to those specified, or use outdoors. 2. Use of the equipment in applications expected to cause potential hazard to people or property, which

More Instructions:

	Toshiba BG030 Thermal design manual 22-11-2022 5	DOWNLOAD
	Toshiba BG030 Instruction manual 06-12-2022 71	DOWNLOAD
	Toshiba BG030 Specification 18-02-2023 31	DOWNLOAD

Related Products and Documents (Security Camera):

Comparable Devices:

Similar Resources:

• Extel WAPP-GO81S (164 pages) O’OUT HDEd. 10/2015 V1Type : WAPP-GO81SO’OGuide d’installation et d’utilisation Manuale d’installazione e usoInstrucciones de uso e instalaciónGuia de instalação e de utilizaçãoInstallation and user guide Installatie en GebruiksaanwijzingInstallation und Bedienungsanleitung …

• Vision Hi-Tech VD101SMi (13 pages) Page 1 / 13 HARDWAREINSTALLATIONGUIDE VD101SMi1.3Megapixel(720P)IndoorDomeIPCameraVD101SMi‐IR1.3Megapixel(720P)IndoorNightVisionDomeIPCameraVD101SM3i3.0Megapixel(1080P)IndoorDomeIPCameraVD101SM3i‐IR� …

• Toa E-7000TB (13 pages) N-8000 Network Intercom Systems Architectural and Engineering Specifications TOA Electronics, Inc. 601 Gateway Blvd., Ste. 300 So. San Francisco, CA 94080 1-650-588-2538 / 1-800-733-7088 www.toaelectronics.com  All Rights Reserved, 2005 …

• Black BLK-CPT235VH (34 pages) High Performance IR Indoor/Outdoor Color CCTV Bullet Camera User ManualProducts: BLK-CPT235VH, BLK-CPT237VH, BLK-CZT242VH, BLK-CZT243VHPlease read this manual before using your camera, and always follow the instructions for safety and proper use. Save this manual for future reference. BLK-BulletCameras_CM 3/18/11 …

• ATV IPFD2TI (72 pages) IR Interior/ Exterior Dome Network Camera - IPFD2TI INSTRUCTION MANUAL Please read this manual thoroughly before use, and keep it handy for future reference. …

• Veilux VP-ATDNC27X (2 pages) SPECIFICATIONS3015 Eagle Drive, Suite 100, Grand Prairie, Texas 75052Local Number: (214) 635-4855 / Fax: (928) [email protected] AUTO-TRACKING DAY/NIGHT CAMERAVP-ATDNC27XFEATURESMODEL NUMBERSVP-ATDNC27XI In-CeillingVP-ATDNC27XO OutdoorVP-ATDNC27XS Surface MountIn-Ceiling OutdoorSurface•1/4” VEILUX Super HAD CCD / High Resolutio …

Comments, Questions and Opinions: