Siemens TPS3 09 Operation & User’s Manual

Text of Siemens TPS3 09 User Guide:

• Siemens TPS3 09, • Only qualified licensed electricians should install or service SPDs • Hazardous voltages exist within SPDs • SPDs should never be installed or serviced when energized • Use appropriate safety precautions including Personal Protection Equipment • Failure to follow these instructions can result in death, serious injury, and/or equipment damage. • This manual shall be read in entirety prior to installing Bonding and Grounding Hazard Verify that the neutral conductor in the service entrance

• Siemens TPS3 09, Introduction Thank you for choosing the Siemens TPS3 09 Surge Protective Device (SPD). TPS3 09 is a high quality, high energy surge suppressor designed to protect sensitive equipment from damaging transient overvoltages. The TPS3 09 is parallel connected such that circuit ampacity is unlimited. Proper installation is important to maximize performance. Please follow steps outlined herein. These instructions are not intended to replace national or local codes. Follow all applicable electrical codes to ensure compliance. Industry Standards Changes - 2009 UL 1449 Third Edition and 2008 NEC® Article 285 generated substantial changes. • The term

• Carefully inspect each item in the package for signs of damage. If damage is found, please contact Siemens TPS Technical Support: 1.888.333.3545. For more information about this product or other Siemens products, visit www.usa.siemens.com. Figure 2: Dimensions and Weight TPS3 03’s have demonstrated 200kA Short Circuit Current Ratings (SCCR) including leads (120/2

• Siemens TPS3 09, TPS3 09 Installation Instructions Pre-Plan your installation. You need to accomplish the following: • Meet all National and Local codes (NEC ® Article 285 and UL 1449 address SPDs) • Confirm System voltage to SPD voltage (120V SPD will fail instantly on 240V, 277V, etc.) • Mount SPD as close to panel or equipment as possible to keep leads short (long leads hurt performance substantially) • Ensure leads are as short and straight as possible, including neutral and ground. If using a breaker, use a breaker position that is close to the SPD and the panel’s neutral & ground • If using a breaker,

• Siemens TPS3 09, Dry Contact Leads Power Leads Blue Grey Red Connecting Optional Form C Dry Contact & Audible Alarm (“D” suffix near end of model number) Three (3) 3’ (~1m) 18 AWG wires are included through the nipple with this option. (These are smaller than the 10 AWG SPD conductors.) Gray is Common, Red is Normally Open and Blue is Normally Closed. (We generally recommend the Normally Closed configuration because it detects disconnected or failed wiring whereas normally open does not.) If the dry contacts are not utilized, insulate lead ends, coil and secure. Audible alarm will still function correctly. The contact is rated 250V, 5A. Higher energy applications

• Maintenance SPDs require minimal maintenance. Periodic inspection of diagnostic indicators is recommended to ensure proper operation. Troubleshooting & Service Please contact us for any service related issues. Quality SPDs withstand severe duty and attempt to protect the load until failure. There are electrical anomalies that SPDs cannot protect against. Th

Related Products and Documents (Surge Protector):

Comparable Devices:

Similar Resources:

• RocketFish RF-HTS205 (2 pages) QUICK SETUP GUIDECongratulations on your purchase of this Rocketsh Power Manager with surge protection and noise ltering.Your power manager: • Reduces energy consumption to save environmental resources and lower your electric bill• Provides surge protection for sensitive electronic devices• Incorporates noise ltering to provide clean power …

• M-system MMA (3 pages) BEFORE USE ....Thank you for choosing M-System. Before use, please check contents of the package you received as outlined below.If you have any problems or questions with the product, please contact M-System’s Sales Office or representatives. ■ PACKAGE INCLUDES:Lightning surge protector ...................................................(1) ■ MODEL N …

• Eaton Crouse-hinds series (12 pages) MTL F860 8 segment redundant fieldbus power system for use with Honeywell Experion “Series C” 4-link FIMSeptember 2016INM F860 rev 4Instruction manualMTL fieldbus networks …

• Tripp Lite ISOTEL8ULTRA (4 pages) Tripp Lite1111 West 35th StreetChicago, IL 60609 USATelephone: +(773) 869 1234E-mail: [email protected] #: ISOTEL8ULTRA8-outlets, 12-ft cord, 3840 joule, RJ11 protection, All metal housing Isobar Surge Suppressor Highlights8 outlets / 12-ft. cord3840 joule ratingAll metal housing with LEDsIsolated filter banksModem/fax surge protection$50,000 Ult …

• Goobay 51270 (4 pages) Betriebsanleitung Netz- und ÜberspannungsschutzschalterDE- 1 -Goobay®by Wentronic GmbH | Pillmannstraße 12 38112 Braunschweig | GermanyREV2017-01-19V2.0512701 Sicherheitshinweise 1.1 Allgemein• Betriebsanleitung vollständig und sorgfältig vor Gebrauch lesen. Sie ist Bestandteil des Produktes und enthält wichtige Hinweise zum korrekten Gebrauch. • …

• RST SURGE Series (11 pages) ELM0100A All efforts have been made to ensure the accuracy and completeness of the information contained in this document. RST Instruments Ltd reserves the right to change the information at any time and assumes no liability for its accuracy. Copyright © 2019. RST Instruments Ltd. All rights reserved. Document Number: ELM0100A Release Date …

Comments, Questions and Opinions: