Sanyo DMP-P8 Instruction Manual

Text of Sanyo DMP-P8 User Guide:

• - 1 - Table of Contents IMPORTANT SAFEGUARDS .................................................................. 2-3 PREPARATION FOR USE .......................................................................... 4 LOCATION OF CONTROLS AND INDICATORS .................................... 5-7 REMOTE CONTROL BATTERY ..................................................

• Sanyo DMP-P8, - 2 - Important Safeguards Signal Word Definitions DANGER - Indicates an imminently hazardous situation, which, if not avoided, will result in death or serious injury. This symbol appears only in the most extreme situations. WARNING - Indicates a potentially hazardous situation which could result in death or serious injury. CAUTION - Indicates a potentially hazardous situation, which, if not avoided, may result in minor/moderate injury or product/property damage. It also alerts against unsafe practice

• Sanyo DMP-P8, - 3 - CAUTION - To reduce the risk of personal injury or product/property damage: • This product is intended for indoor, non-industrial, non-commercial use; do not use the product outdoors. • Do not mount this product on a wall or ceiling. Battery Handling and Usage: Warning: Only adults should handle batteries. Do not allow a child to use this product unless the Battery Compartment Cover is securely attached to the Battery Compartment in accordance with all product usage instructions. • Follow the battery manufacturer’s safety and usage instructions. • Keep batteries away from children and pets.

• Sanyo DMP-P8, - 4 - Preparation For Use • Never throw batteries into a fire. Do not expose batteries to fire or other heat sources. UNPACKING AND SET UP • Carefully remove all the accessories from the display carton. Verify that you have all the necessary accessories before you dispose of the display carton. • Remove all packing materials from the individual components. Remove any descriptive labels that may be attached to the front panel of the main unit. Do not remove any labels or stickers on the back

• Sanyo DMP-P8, - 8 - Remote Control Battery The remote control requires one"CR2025 type"3-volt lithium battery (included). To extend the life of the original battery we have inserted a small clear plastic spacer tab between the lithium battery and the battery terminal. You must remove this battery spacer tab before you use the remote control. To remove the tab, pull it in the direction of the arrow in the illustration as shown: When the operation of the remote control becomes unsatisfactory, replace the original battery with a new 3-volt lithium battery. 1. Slide out the battery holder from the remote control case. (Push tab "A" towards the mid

• Sanyo DMP-P8, - 9 - Operating Instructions Make sure the AC power cord from this unit is properly connected to a 240V 50Hz household AC power outlet. Make sure the AC power cord from this unit is properly connected to a 240V 50Hz household AC power outlet. І) Setting the Clock 1) While the unit is at STANDBY mode, press and hold MODE button on the top panel or the remote control for 2 sec. to enter Clock set mode. “12H” will show and flash on the display indicating that the clock is set to 12 hour format. 2) Press TUNE/SKIP button on the top panel or remote control once to change the clock format to 24 hour time. The display will change from �

• - 10 - Operating Instructions ІІ) SETTING 1 or 2 ALARMS You can only set your Alarm mode at Standby mode. A. Set Alarm 1 1) While the unit is at STANDBY mode, press and hold ALARM 1 button on the top panel for 2 sec. and the hour digit will begin flashing. Press TUNE/SKIP button to set the hour. Press “ALARM 1” butt

• Sanyo DMP-P8, - 11 - Operating Instructions C. Snooze Function After alarm is ON, you can press SNOOZE and ALARM1 / ALARM2 buttons on the top panel or remote control to temporarily deactivate the alarm which will activate again after 9 minutes lapse. To switch it off, you can press ALARM1 / ALARM2 button. D. Sleep Function When unit is power on, Press SLEEP button on the top panel or remote control, 2:00 and sleep indication will ON. Press SLEEP button again to change and select from 2:00 to 1:30, 1:00, 0:30, 0:20, 0:10 or 0:05. Select “oFF” means no sleep function. While the sleep function i

• Sanyo DMP-P8, - 12 - Operating Instructions A. LISTEN TO iPod 1) Press STANDBY/SOURCE button on the top panel or remote control to Power on the unit. To select iPod mode, press STANDBY/ SOURCE button again until the “iPod” icon is shown on the top of display. 2) While the “iPod” mode is on, plug the iPod player to the dock and it will switch from play mode to pause mode or from pause mode to play mode. If the unit is not connected to an iPod player, the background light will remain on, plug the iPod player to the dock station and press PLAY to continue playback. 3) Press PLAY/PAUSE button on top panel or remote control to contr

• Sanyo DMP-P8, - 13 - Operating Instructions 1) Press STANDBY/SOURCE button on the top panel or remote control to Power on the unit. To select FM or AM radio, press STANDBY/ SOURCE button until “FM” or “AM” icon is shown on the top of display. 2) FM/AM frequency will show on the display. 3) Tune to the desired frequency as follows: a) Automatic Tuning i) Press and hold TUNE/SKIP button on the top panel or remote control for 2 sec., auto tuning will start. ii) The tuner will search the frequency for the next strong station and stop on that station. Repeat this procedure until the tuner stops on your de

• Sanyo DMP-P8, - 14 - Operating Instructions iii) Press MEMORY UP / DOWN button on the top panel or remote control to select preset channel (CH 01 to CH10). iv) Press MODE button on the top panel or remote control again to confirm. v) Repeat step i) to iv) to until you have memorized up to 10 stations Press MEMORY+/- button on the top panel or remote control to listen to preset FM/AM channel CH01-CH10 at FM/AM mode. Note: The saved preset station will be lost if the AC Power is interrupted and the backup battery is not inserted. C. iPod CHARGING If iPod is connected to the unit, iPod will ch

• Sanyo DMP-P8, - 15 - Operating Instructions During Stand By Mode, Press SNOOZE button on top panel or remote control once to activate the display from Dimmer (Default in Stand By mode) to Brightness mode for 9 sec. Then the display will return to Dimmer mode automatically. RESETTING If the system does not have any respond, you may have experienced a severe electric shock (ESD) or a power surge that triggered the internal computer to shut down automatically. If this occurs, simply disconnect the main power and connect the main power again after one minute. Note: Although discon

• - 16 - Care And Maintenance Troubleshooting Care of the cabinet If the cabinet becomes dusty wipe it with a soft, dry dust cloth. Do not use any wax, polish sprays, or abrasive cleaners on the cabinet. Caution: Never allow any water or other liquids to get inside the unit while cleaning. Please make sure the unit is unplugged from the power source when cleaning. Bef

• Sanyo DMP-P8, - 17 - iPod Won’t play iPod files or will not function as expected. - Make sure the function is set to iPod mode. - Make sure iPod is connected properly. - Make sure the proper cradle for your iPod is fitted to the unit. - Pause mode may be activated; press the Play/Pause button again. - Make sure the iPod is switched on. - Vibrations may have caused the iPod to come loose from the docking station. Radio Poor FM reception. Poor AM (MW) reception. - Make sure the FM antenna is extended. Switch to FM mono mode if signal is weak and this feature is provided. - try rota

• - 18 - Technical Information AC Power : AC 240 ~ 50Hz AM : 522 - 1620kHz FM : 87.5 - 108 MHz DC Backup : 3 V (2 "AA" size batteries) Output Power : 2 x 3.5 W Power Consumption : 13 W

Related Products and Documents (Clock Radio):

Comparable Devices:

Similar Resources:

• Philips 4000 series (22 pages) Register your product and get support atwww.philips.com/welcomeEN User ManualTo obtain a more detailed Electronic Copy of this Manual or to access live chat support, go to www.philips.com/supportES Manual del UsuarioPara obtener una copia electrónica más detallada de este Manual de usuario o para tener acceso al soporte de chat en vivo, vaya a www.philips. …

• Roberts iDream (1 pages) Roberts Radio Limited, P.O. Box 130, Mexborough, South Yorkshire S64 8YT Phone: 01709 571722 Email: [email protected] Fax: 01709 571255 Web: www.robertsradio.co.uk Registered Office: Talbot Road, Swinton, Mexborough, South Yorkshire S64 8AJ Registered in England No. 2978869ROBERTS BY APPOINTMENT TO H.R.H. THE PRINCE OF WALES MANUFACT …

• prologue IP507 (40 pages) T BEnglishSvenskaNorskSuomiDeutschClock Radio with iPhone DockKlockradio med iPhonedockningKlokkeradio med docking for iPhoneKelloradio, jossa iPhone-telakkaRadiowecker mit iPhone-DockingstationArt.no Model36-5833 IP507Ver. 20140623 …

• Hyundai RAC 281 PLL (32 pages) RAC 281 PLL / RAC 281 PLLWNÁVOD K POUŽITÍ / NÁVOD NA POUŽITIEINSTRUKCJA OBSŁUGI / INSTRUCTION MANUALHASZNÁLATI UTASÍTÁSRÁDIO S HODINAMI / RÁDIO S HODINAMIRADIO Z ZEGAREM / CLOCK RADIORÁDIÓ ÓRÁVAL …

• Oregon Scientific RM888PA (8 pages) 1GBTRAVEL RADIO-CONTROLLEDPROJECTION CLOCKMODEL: RM888PAUSER'S MANUALSECTION 1 INTRODUCTIONCongratulations on your purchasing the RM888PA RF TravelProjection Clock.The Travel Clock has a slim, compact design i.e. ideal for travel.The RM888PA is designed to automatically synchronize its currenttime and date when brought within range with the U.S.Atom …

• König Electronic HAV-CR74 (124 pages) HAV-CR74 2CLOCK RADIO 13RADIOWECKER 24RADIO-RÉVEIL 35KLOKRADIO 46RADIOSVEGLIA 57RADIO RELOJ 68RÁDIÓS ÓRA 79KELLORADIO 90KLOCKRADIO 101RÁDIO S BUDÍKEM 112RADIO CU CEAS …

Comments, Questions and Opinions: