Manualios.com

Galaxy DX 2527 Owner's Manual

Galaxy DX 2527 Manual Online:

4.05, 2557 votes
Galaxy DX 2527 User Manual
Galaxy DX 2527 User Guide
Galaxy DX 2527 Online Manual

Text of Galaxy DX 2527 User Guide:

  • Galaxy DX 2527, DX 2527 AM · FM · SSB · CW · PA Amateur Base Station Transceiver OWNER’S MANUAL N I T L U A O O M 10 0 D 1 RX / TX 1 TALK BACK MAXMIN OFF CALIBRATE RF MICROPHONE VOICE OFF ECHO R2 R4 R3 ROBOT TONE RF POWER ON POWER ECHO 22 WATTS 3 4 2 0 2 6 8 10 12 SET PHONE SHF LOCK MAXMIN OFF MIC RF CHANNEL CLARIFIER NB/ANL TIME DIM +20 dB 80 SIGNAL 9 60 70 5 3 20 30 40 7 50 OVER +40 +60 100 90 9 SWR SCAN R.BEEP SPLIT ENTMEM MANPRG SQUELCH VOLUME LSB AM FM USB MODE CW PA SWR 2527 - 1 - TABLE OF CONTENTS SPECIFICATIONS .........................................................

  • Galaxy DX 2527, - 2 - SPECIFICATION: GENERAL Frequency Range 28.0000 – 29.6999 MHz Emission Types CW, FM, AM, USB, LSB Frequency Control Phase-Lock-Loop Synthesizer Frequency Tolerance 0.005% Frequency Stability 0.003% Temperature Range -30 O C to +55 O C Antenna Impedance 50 Ohms Antenna Connectors Standard SO-239 Type Meter Function Meter #1: RF Output Power / Antenna SWR. Meter #2: Received Signal Strength / MOD% AC Input Voltage AC 120V , 60 Hz TRANSMITTER RF Power Output 25W: USB, LSB. 10W: AM, FM, CW Antenna Connectors UHF Type, 50 Ohms AM Modulation

  • Galaxy DX 2527, - 4 - Antennas Antennas are purchased separately and include installation instructions. Numerous type of antennas are available that range from emphasis on easy of installation to emphasis on performance. Often the difference in performance between many of the antenna is modest. 1. Vertical Ground Plane Antennas: These are omni-directional antennas that provide optimum performance for contacting other fixed stations using vertical type antenna in addition to all mobile stations. For medium to long range communications work. 2. Directio

  • Galaxy DX 2527, - 6 - OPERATION: INTRODUCTION This section explains the basic operating procedures for the DX 2527 amateur band base station transceiver. CONTROL & CONNECTIONS: 1. POWER ON/OFF CONTROL: Push ON to apply power to the unit. 2. MICROPHONE JACK: Used to connect microphone for voice source. 3. RF POWER CONTROL: This control adjusts the RF power output level. 4. CALIBRATE CONTROL: To check your SWR, simply rotate this control while transmitting until the needle on the left meter goes to the small red “

  • - 8 - 10. MIC GAIN CONTROL: This control adjusts the microphone gain in the transmit mode. This feature is designed for use in a high-ambient noise environment or to maximize talk power. 11. SWR SWITCH: This switch is used to check SWR. 12. CHANNEL SELECTOR: This control is used to select a desired frequency. 13. SCAN SWITCH: This switch is used to scan fre

  • Galaxy DX 2527, - 10 - 29. PROGRAM SWITCH: This switch is used to program operating or scanning frequency into memory. 30. FREQUENCY COUNTER: The frequency counter indicates the frequency of operation. 31. MANUAL SWITCH: This is used to return to the manual mode. 32. SHIFT SWITCH: This is used to select 100Hz, 1KHz, 10KHz, 100KHz or 1MHz frequency steps. 22. • UP SWITCH: This switch is used to move frequency upward to select a desired frequency. 23. RX/TX LED: This LED is green during receive and changes to red while transmitting. REAR PANEL CONNECTOR: 1. ANTENNA: This jack accepts 50 O

  • Galaxy DX 2527, - 12 - OPERATION PROCEDURE Frequency Selection Frequency selection for the DX 2527 is simple. Select the desired operating frequency by rotating the Frequency selector or using the UP/DOWN buttons on the top of the microphone. Press the LOCK button to lock the selected frequency. This will disable the frequency selector and the UP/DOWN buttons on the top of the microphone. Repressing the LOCK button unlocks the frequency. Use the SHF button to set the step frequency in 100Hz, 1KHz, 10KHz, 100KHz or 1MHz increments. The frequency step is indicated by a small triangle directly under the corresponding digit on the frequency display. Mode Selection To se

  • Galaxy DX 2527, - 14 - or turn the Squelch control counterclockwise until you hear the receiver noise. The MAN button will disable the Scan function. (See Frequency Scanning for more information.) Split Function This function enables you to split the transmit and receive frequencies for FM repeater operation. To split frequencies, press the MAN button and the SPLIT button to select + split frequency. If you want - split frequency, press the SPLIT button again. If + split is selected, the transmit frequency will be higher than the receiver frequency

  • Galaxy DX 2527, - 16 - 1. Press the PRG (Program) button. 2. Press the SCAN button. ( "PRG SCAN+" should appear in the lower right corner of the display window.) 3. Using the SHF button and UP and DOWN arrows, select the upper scan limit, then press ENT . 4. Press the SCAN button again. ( "SCAN-" should appear in the display window.) 5. Using the SHF button and UP and DOWN arrows, select the lower scan limit, then press ENT . The upper and lower scan limits have now been programmed. To ac

  • - 18 - transmitter frequency either above or below the receive frequency by a user programmable amount. In the following example, programming of a 100 KHz offset will be described. Before attempting to program the offset frequency, ensure that the radio is operating in the manual mode by pressing the MAN button. 1. Press the PRG (Program) butt

Related Products and Documents (Radio):

Comparable Devices:

# Manufacturer Model Document Type File Updated Pages Size
1 Panasonic NI-WT960 Operating instructions manual panasonic/ni-wt960-I2L.pdf 19 Jul 2023 17
2 Sharp YO-P20H Operation manual sharp/yo-p20h-47Q.pdf 07 Oct 2022 32 0.57 Mb
3 Canon PIXMA MP600 Start here canon/pixma-mp600-Y44.pdf 12 Sep 2022 2 6.08 Mb
4 LG 43lh595t Owner's manual lg/43lh595t-97U.pdf 05 Nov 2022 20
5 Dometic miniBar RH 465LD Operating instructions manual dometic/minibar-rh-465ld-D73.pdf 13 Aug 2023 52
6 Berkel 808 Parts manual berkel/808-ZC1.pdf 31 Jul 2022 8 0.58 Mb

Similar Resources:

  • Hamilton

    HAMILTON AM1000

    (22 pages)
    AM1000WR 100’ or 2 pair #22 shielded wire to connect power and audio Select the mount you need for your 1 1/4” mast at Radio Shack or other anten-na store. To Studio Mount Bracket Kit AM1000BR AM1000 Transmitter 1. Getting ready/ Things you may need 2 Page 1.1 Some addition Items 3 2. Starting the Installation 4 2.1 Picking the Grounding for the transm …
  • Philips

    DE-AZ1040

    (53 pages)
    CD Radio Cassette RecorderAZ 1040AZ 1040CD RADIO CASSETTE RECORDERPROGBANDBATTLOWMODESTOPPLAY•PAUSESEARCHDIGITAL TUNER CD SYNCHRO START RECORDINGPRESETPROGAZ 1040CD RADIO CASSETTE RECORDERBANDBATTLOWMODEPRESETSTOPPLAY•PAUSESEARCHDIGITAL TUNERCD SYNCHRO START RECORDINGRECORDPLAYSEARCHSTOP-OPENPAUSESHUFFLEALLSHUFFLEALLDBBDBBPOWERTUNERDYNAMIC BASS BOOSTCDTA …
  • Vertex Standard

    EVX-5300

    (20 pages)
    EVX-5300Operating ManualprOgraMMable FunctiOns/Features 6ProgrammableFunctionKeys 2-ToneEncode/Decodeø 5-ToneEncode/Decodeø MDC-1200®Encode/Decodeø HornAlert PA(PublicAddress) Scan DualWatch FM-Scan(Follow-MeScan) TAScan Privacy Encryptionø� …
  • RCA

    RC142

    (4 pages)
    IMPORTANTES INSTRUCTIONS DE SECURITEBIEN LIRE ET CONSERVER POUR RÉFÉRENCE ULTÉRIEUREFrançaisEN/F/EIt is important to read this user manual prior to using your new product for the fi rst time.Nous vous recommandons de lire ce manuel d’instructions avant d’utiliser votre nouveau produit pour la première fois. Es importante leer este manual antes de u …
  • Icom

    ID-52A

    (263 pages)
    This manual describes instructions for advanced features and instructions.See the BASIC MANUAL that come with the transceiver for precautions and basic operations.ADVANCED MANUALVHF/UHF TRANSCEIVERID-52AID-52E1 ATTACHING ACCESSORIES2 USING a microSD CARD3 BATTERY CHARGING4 FM RADIO OPERATION5 D-STAR OPERATION (ADVANCED)6 GPS OPERATION (ADVANCED)7 VOIC …
  • Milwaukee

    2790-20

    (22 pages)
    OPERATOR'S MANUALMANUEL de L'UTILISATEURMANUAL del OPERADORCat. No.No de Cat.2790-20TO REDUCE THE RISK OF INJURY, USER MUST READ AND UNDERSTAND OPERATOR'S MANUAL.AFIN DE RÉDUIRE LE RISQUE DE BLESSURES, L'UTILISATEUR DOIT LIRE ET BIEN COMPRENDRE LE MANUEL DE L'UTILISATEUR.PARA REDUCIR EL RIESGO DE LESIONES, EL USUARIO DEBE LEER Y ENT …

Comments, Questions and Opinions: