Sharp AF-W12CME Operation Manual

Text of Sharp AF-W12CME User Guide:

• Sharp AF-W12CME, INSTALLATION AND OPERATION MANUAL ROOM AIR CONDITIONER Thank you for purchasing a SHARP air conditioner. Please read this manual carefully before installing or operating the product. The manual should be kept in a safe place for handy reference. AF-W12CME PAGE CONTENTS OPERATION INSTRUCTIONS • PRECAUTIONS ........................................ 2 • ADDITIONAL NOTES ON OPERATION .. 3 • CONTROLS .............................................. 4 • USING THE REMOTE CONTROL ........... 5 • BASIC OPERATION ................................. 6 • AIR FLOW AND VENTILATION ............... 7 • TIMER OPERATION................................. 8 • SAV

• Sharp AF-W12CME, 2 OPERATION INSTRUCTIONS WARNINGS FOR USE 1 Do not pull or deform the power supply cord. Pulling and misuse of the power supply cord can result in damage to the unit and cause electrical shock. 2 Be careful not to expose your body directly to the outlet air for a long time. It may affect your physical conditions. 3 When using the air conditioner for infants, children, elderly, bedridden, or disabled people make sure the room temperature is suitable for those in the room. 4 Never insert objects into the unit. Inserting objects can result in injury due to the high speed rotation of internal fans. 5 Ground the air conditioner without fail. Do not connect

• Sharp AF-W12CME, 3 WATER IN THE BOTTOM TRAY Water will be collected at the bottom tray of the unit. This is normal condition. Water condenses on the evaporator coil in the front part of the unit and is channeled to the rear where it is picked up by the condenser fan. The water is blown onto the condensor coil fins, this creates a "splashing" sound which is normal. When the tray is filled up with water, excessive water will be drained outside through a grooved channel in the tray. WAIT 3 MINUTES UNTIL COOLING OPERATION STARTS When you turn the air conditioner

• Sharp AF-W12CME, 4 MODE SYMBOLS :AUTO :DRY :COOL FAN SPEED SYMBOLS :AUTO :Manual setting SAVE SYMBOL CONTROLS UNIT REMOTE CONTROL Control panel Reciever Window Operation Lamp (Red) Timer Lamp (Yellow) AUX. Button Ventilation lever TRANSMITTER DISPLAY (Liquid Crystal Display) ON/OFF Button THERMO. (Thermostat) Button SAVE Button MODE Button TIMER ON Button (for setting the timer) ONE-HOUR OFF TIMER Button TIMER OFF Button (for setting the timer) FAN Button TIMER CANCEL Button SWING Button L.C.D. REMOTE CONTROL DISPLAY TRANSMITTING SYMBOL TIMER ON/TIMER OFF INDICATOR Indicates when timer on or timer off is set. TEMPERATURE AND TIMER COUNT D

• Sharp AF-W12CME, 5 USING THE REMOTE CONTROL Point the remote control towards the unit’s receiver window and press the desired button. A beep sound will be emitted when the unit receives the signal . • Make sure no objects, such as curtains, are between the remote control and the unit. • The remote control operates from up to 7 meters away. • Do not expose the receiver window to strong, direct sunlight, which can adversely affect its operation. In such case, close the curtains to block the sunlight. • Use of a fluorescent lamp with a quick starter in the same room might interfere with transmission of the sig

• 6 BASIC OPERATION Press the MODE button to select the opera- tion mode. AUTO COOL DRY 1 2 Press the ON/OFF button to start operation. • The red OPERATION lamp on the unit will light up. 3 Press the THERMO. button to set the de- sired temperature. 5 • In the AUTO and DRY mode, the temperature can be changed in 1°C increments within the range of 2°C higher t

• 7 AIR FLOW AND VENTILATION Airflow direction can be adjusted by moving the airflow adjustment louvers upward or downward. To avoid condensation on the louvers, please do not adjust these louvers to extremely downward position during COOL and DRY modes. If air in your room is stale, set the VENTILATION lever to the RIGHT (OPEN) position. This will remove stal

• 8 1 Press the TIMER OFF ( ) button and set time as desired. • The time setting will change as you to press the button as follows, TIMER OPERATION The unit will turn off automatically according to your setting. Timer duration can be set from minimum 0.5 hours (30 minutes) to maximum 12 hours. Up to 9.5 hours, you can set by 0.5 hours (30 minutes) increments and from 10 to 12 hours, by

• Sharp AF-W12CME, 9 1 Press the TIMER ON ( ) button. • The time setting will change as you press the button as follows. The unit will turn on automatically according to your setting. Timer duration can be set from minimum 0.5 hours (30 minutes) to maximum 12 hours. Up to 9.5 hours, you can set by 0.5 hours (30 minutes) increments and from 10 to 12 hours, by 1 hour increment. TIMER ON 1 NOTES FOR TIMER SETTING AND OPERATION • The latest time setting will be memorized and will appear on the remote control display the next time you set the TIMER OFF or TIMER ON. • TIMER OFF and TIMER ON can not be set together. The latest set TIMER will be active. • When ONE-HO

• Sharp AF-W12CME, 10 1 Press the SAVE button during operation. • The remote control displays “SAVE”. 1 Press the ONE-HOUR OFF TIMER button. • The remote control displays " ". • The unit will stop operating after one hour. TO CANCEL Press the CANCEL button. Or, turn the unit off by pressing the ON/OFF button. • The red OPERATION lamp on the unit will turn off. NOTES: • The ONE-HOUR OFF TIMER operation has priority over TIMER ON and TIMER OFF operations. • When the ONE-HOUR OFF TIMER is set w

• Sharp AF-W12CME, 11 AUXILIARY MODE Press the AUX. button on the unit's control panel. • The red OPERATION lamp on the unit will light up and the unit will start operating in the AUTO mode. • The fan speed and temperature setting are set to AUTO. • Left/Right air flow adjustment louvers will swing continuously. Use this mode when the remote control is not available. TO TURN ON Press the AUX. button on the control panel again. • The red OPERATION lamp on the unit will go out. TO TURN OFF NOTE: If the AUX. button is pressed during normal operation, the unit will turn off.

• Sharp AF-W12CME, 12 MAINTENANCE Be sure to disconnect the power cord from the wall outlet or turn off the circuit breaker before performing any maintenance. CLEANING THE FILTER If the filter is clogged with dust, the amount of air flow will be reduced, resulting in poor cooling performance. The filter should be cleaned every10 days. At the beginning of every cooling season or if the air conditioner has not been used for a long period, clean the filter before starting to operate the unit. To clean the front panel, grille and cabinet, wipe with a soft, dry cloth or with a cloth moistened with a mild soap. Rinse carefully by wiping with a damp cloth and dr

• 13 IF YOUR AIR CONDITIONER DOES NOT OPERATE PROPERLY, PLEASE CHECK THE FOLLOWING ITEMS BEFORE CALLING FOR SERVICE. AIR CONDITIONER DOES NOT OPERATE AT ALL • Is the power cord loosened or disconnected? • Is the fuse blown or has the circuit breaker been tripped? • Did you restart the unit within 3 minutes after power failure? If the power was off for less than 3 minutes, and you

• Sharp AF-W12CME, 14 BATTERY REMOTE CONTROL DRAIN TRAY GASKET GOLD SCREW (2.5cm/1") GOLD SCREW (1.2cm/0.5") The long GOLD SCREW ( ) is used to secure the cabinet to the mounting frame. The short GOLD SCREW ( ) is used to secure the drain tray to the cabinet. The DRAIN TRAY ( ) is attached to the cabinet, in case drainage is necessary in high humidity district.See page 16 for detail installation instructions. ITEMS PACKED WITH THIS UNIT Q'ty Accessories 9 2 1 1 1 2 1 2 3 4 5 6 1 2 4 1 2 4 3 5 6 PART NAMES AND DIMENSIONS Front panel Grille Air filter

• Sharp AF-W12CME, 15 LOCATION More than 20cm(8") Air outlet More than 40cm(16") Air inlet Air outlet Air inlet More than 40cm (16") About 1cm (3/8") Air inlet More than 20cm(8") Air inlet The appliance shall be installed in accordance with national wiring regulations. Improper connection may cause the power cord, and the electrical outlet to overheat and fire. Install the air conditioner to the opening dimensions shown below. Never install the unit where any of the air inlet is blocked. The air conditioner should be installed with a strong external support to minimize noise and vibration, and for

• Sharp AF-W12CME, 16 WARNING: Turn off and disconnect the unit before working. 1 Unscrew the 3 stopper screws of the cabinet (Fig.4). Keep the front screw and the angle as they will be used later in step 5. Slide the chassis out from the cabi- net by pulling on the hand hold located at the bottom center of the chassis. (Fig.4) 2 (1) (2) (2) Close the grille firmly, and remove the front panel by pulling the front panel at the lower corners towards you for about 3 cm (1" ). Then lift it up and pull it towards you. (Fig.3) Angle Fig.4 Chassis Front panel Fig.3 Air filter Front panel Fig.2 Fig.1

• Sharp AF-W12CME, 17 When drainage is necessary If water drainage is necessary in high humidity district, remove the rubber cap on the bottom of the chassis. Remove the rubber cap from the bottom with a plier. (Fig.6) A hose of an appropriate length have to be attached to the drain tray's drain outlet. (Fig.7) (1) 4 (2) Install the cabinet into the installation opening.(Fig.8) Secure the cabinet to the mounting frame using the 9 long gold screws. (2.5cm/1"). (Fig.8) Chassis Rubber cap Fig.6 Fig.7 Cabinet Drain tray Cabinet Fig.8 Fig.5 Drain tray Cabinet Attach the provided drain tray to the cabinet in case drainage becomes nec- essary. Use the 2 short gold scre

• Sharp AF-W12CME, 18 Fig.13 Front panel back view (3) (1) (2) 5 Slide the chassis back into the cabinet. (Fig. 10) Replace the front panel. (Fig.12) Slide the crank shaft into the open- ing of the louver link at the back of the front panel. (Fig.13) (4) Fig.10 Fig.11 Chassis Angle SlitCabinet Louver link Crank shaft Front panel Fig.12 Grille Fig.14 Front panel Secure the chassis to the cabinet using the screw and angle removed in step 2. Push the angle into the gap between the chassis and the cabinet. Hook the angle to the slit of the cabinet, next screw it on to the chassis. (Fig. 11) Open the grille and secure the front panel with the screw removed in step 1 (Fig.14). Replace the

Related Products and Documents (Air Conditioner):

Comparable Devices:

Similar Resources:

• Clarke Air AC10050 (20 pages) OPERATION & MAINTENANCEINSTRUCTIONSORIGINAL INSTRUCTIONS LS0120 - ISS 1PORTABLE AIR CONDITIONERMODEL NO: AC10050PART NO: 3230575 …

• Carrier 53QPCT18H-708F (54 pages) Hi Wall Split Air Conditioners53QPCT 18C-24C Cool Only 53QPCT 18H-24H Heat PumpRev. (0) - 2013220-240V ~ 50Hz 1PhR22QualityManagement SystemISO 9001 : 2008Certicate No.: QS-5519HHEnviromental Management SystemISO 14001 : 2004Certicate No : 12 104 30334 TMSSafety Management SystemBS OHSAS 18001 : 2007Certicate No : 12 116 30334 TMS03502767Carrier …

• Honeywell ES800 (10 pages) Portable Evaporative Air CoolerUser ManualRead and save these instructions before usewww.honeywellhomecomfort.comE-mail: [email protected]: ES800 …

• Samsung SH18BW6 (26 pages) ENGLISHSplit-type Air Conditioner(Cooling and Heating) ESPAÑOLFRANÇAISITALIANOPORTUGUÊSDEUTSCHE§§HNIKAE S F I P DGDB98-23972A(1)USER’S MANUALSH18BW6 SeriesSH24BW2 Series SH18BW6 IB_E_23972 2/7/06 7:29 PM Page 27 …

• Haier AD092XLERA (42 pages) -1- Commercial Air Conditioning SERVICE MANUAL Models X-MULTI series AD092XLERA AD122XLERA AD142XLERA AD182XLERA  Features  High energy efficiency  New designed structure: adjustable drainage pan, to select water drainage from left or right side  With new designed fan scroll, reduce the noise  Connected wi …

• Furrion Chill FACR13SA-PS (21 pages) FACT11MA-PS/FACT11MA-BL(Sold Separately)TMRooftop Air ConditionerInstruction ManualModel: FACR13SA-PS/FACR13SA-BL FACR14SA-PS/FACR14SA-BLFACR15SA-PS/FACR15SA-BL …

Comments, Questions and Opinions: