GE 31-16223 Installation Manual

Text of GE 31-16223 User Guide:

• GE 31-16223, , WA I G -RiSKOFFIRE = To reduce the risk of severe injury or death, follow' all installation instructions. Clothes dryer installation must be performed by a qualified installer. install the clothes dryer according to these instructions and in accordance with local codes. In the absence of local codes, installation must comply with National Fuel Gas Code, ANSIZ223.1/NFPA 54 or the Canadian Natural Gas and Propane installation Code, CSA B149.1. California Safe Drinking Water and Toxic Enforcement Act This act requires the governor of California to publish a list of substances known to the state t

• GE 31-16223, iNSTALLATiON Preparing the installation Site and Unpacking the Dryer 1. Prepare the area and exhaust for installation of the new' dryer. 2.Check to be sure that the existing external exhaust is clean and that it meets attached installation specifications. &Using the four shipping carton corner posts as padding (two on each side), carefully lay the dryer on its left side and remove foam shipping pad. 4. Return the dryer to an upright position. 5. Move the dryer to the desired location. CAUTION: FOR PERSONAL SAFETY, STACKED iTS MUST BE FASTENED SECURELY TO WALL. r THE DRYER MUST NOT BE iNSTALLE

• GE 31-16223, Alternate Method for Installation of Wall Hooks STEP 1 If wall studs are not correctly spaced or centered behind upper unit, it may be necessary to attach a horizontal 2" x 4" board to the existing wall. STEP 2 Attach wall hooks in approximate position of two chains of upper unit so each chain pulls straight back to wall. NOTE: If wall is concrete or block, drill holes and use appropriate wall anchors. The final construction must withstand a pull of 200 Ibs. E WAr_TUDS I J Minimum Clearance Other Than Alcove or Closet Installation Minimum clearance to combustible surfaces and for air opening are: 0 in. clearance both si

• m GAS CONNECTION RECONNECTINGGAS Listed connector ANSI Z21.24 / CSA 6.10 118" NPT PIPE NEWMETAL PLUG FOR GAS FLEXIBLEGAS INLET PRESSURE LINECONNECTOR ADAPTER ELBOW 318" NPT SHUT-OFF PIPE SIZE ITEMSNOT SUPPLIED AT LEAST 1/2" Note:The connector and fittings ore designed for use only on the original installation and are not to be reused for another appliance or at another location. Ke

• GE 31-16223, EXHAUST INFORMATION l I Illlll Illll II_ll_ WARNING - TO REDUCE THE RiSK OF FiRE OR PERSONAL iNJURY: r - This clothes dryer must be exhausted to the outdoors. - Use only 4" rigid metal ducting for the home exhaust duct. - Use only 4" rigid metal or UL-listed flexible metal (semi-rigid or foil-type) duct to connect the dryer to I the home exhaust duct. It must be installed in d accordance with these instructions and local codes. - Do not terminate exhaust in a chimney, a wall, a ceil- I ing,

• GE 31-16223, EXHAUST iNFORMATiON {continued) STEPS TO CHANGE DRYER TO LEFT SIDE OR BOTTOM EXHAUST DIRECTLY ON CABINET NOTE: This dryer can not be exhausted to the right side. WARNING: Protect your hands and arms from sharp edges when working inside dryer cabinet. = Never use flexible duct inside dryer. ,, Detach and remove the desired knockout. ,, Remove the screw inside the dryer exhaust duct end. Keep the screw for step 5. Pull on the duct to remove it. ,, Cut the duct as shown. Keep portion A. ,, Through the rear opening, locate the tab in the middle of the appliance base. Lif

• GE 31-16223, ELECTRICAL CONNECTION iNFORMATiON _CAUTION, FOR PERSONAL SAFETY: DO NOT USE AN EXTENSION CORD OR AN ADAPTER PLUG WiTH THiS APPLIANCE. DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE THE THIRD GROUNDING PRONG FROM THE POWER CORD. Dryer must be electrically grounded in accordance with local codes and ordinances, or in the absence of local codes, in accordance with the NATIONAL ELECTRICAL CODE, ANSI/NFPA NO. 70-1990. The electrical diagram is located inside control panel. Electrical requirements ,, This appliance must be supplied with 120V, 60 Hz, and connected to an individual, properly grounded branch circu

Related Products and Documents (Dryer):

Comparable Devices:

Similar Resources:

• Samsung BED70W (64 pages) Electric Dryeruser manualThank you for purchasing this Brada product.To receive a more complete service, please register your product atwww.transglobalservice.comBED70WBED70W-02486B_EN.indd 1 2008-01-09 ¿ÀÈÄ 6:53:06 …

• Miele T 4882 C (60 pages) Operating instructionsfor condenser tumble dryerT 4882 CIt is essential to read theseoperating instructions beforeinstalling or using the machineto avoid the risk of accidents ordamage to the machine.GM.-Nr. 05 986 620 …

• Whirlpool 4.3 CU FT (68 pages) TECHNICAL EDUCATIONJOB AID W10329932L-84Vertical Modular WasherL-93SERVICE MANUALWHIRLPOOL 4.3 CU FT COMPACT HEAT PUMP DRYER W11040040AMultimediaEnhancedWHD3090GWWHD5090GW …

• nestor NE1 (7 pages) Instruction of assembly, user and maintenance of the "NESTOR" towel dryer Fig. 1. NESTOR dryer sizes, from the left: NE1, NE2, NE3. The dryer is an electric appliance. Its body is made of steel and covered with decorative coating of polished stainless steel. The mounting frame is made of corrosion-protected steel and covered with …

• Whirlpool WED9400SW0 (2 pages) iiiiiiiiiiiiii_iWe have taken great care to give your new dryer the mostconvenient and easy-to-use features. Use this Quick StartDryer Guide to help you optimize the use of your dryer.Consult the Use and Care Guide for more detailed instructions.To contact the Whirlpool Customer eXperience Center, ca!l1-800o253ol 301. In Canada, call 1-800-807-6777.E×plosio …

• Frigidaire AGQB7000E (12 pages) Product No. AGQB7000ES0 Series Frigidaire Market Best Buy Color white Volts 120 Wiring Diagram 134682200 Owner's Guide 134609100 Installation Instructions 134732700 Operating Instructions 134609300 P16L0043.eps P16v0087.eps P16d0036.eps P16C0232.eps P16M0024.eps P16b0015.eps 134682200g.eps Electrolux Major Appliances North & …

Comments, Questions and Opinions: