Smeg TLS10 User Manual Manual

Text of Smeg TLS10 User Guide:

• GB 5019 612 10178 Programme Care Labels Max. Load kg Type of wash / Notes - for temperature selection, respect the manufacturer's recommendations on the care label Detergents and Additives Special options Max. Spin Speed rpm Pre- wash Main Wash Softener Start delay Avvio ritardato Eco Eco Pre- wash Pre- lavaggio Easy ironing Stiro facile Intensive rinse Risciacquo intensivo Rinse hold Ant

• Smeg TLS10, 5019 612 10178 Programme Temperature (°C) Load (kg) Water (l) Energy (kWh) Approx. Programme Duration*** (hours : minutes) Cotton/Antibacterial 95 5.0 49* 1.70 1:55 Cotton + Eco** 60 5.0 42 0.85 2:20 Cotton 60 5.0 42 0.95 2:10 Cotton 40 5.0 49 0.55 2:00 Synthetics 60 2.5 53* 0.85 1:30 Synthetics 40 2.5 47 0.50 1:15 Delicates 40 1.5 51 0.50 0:45 Daily load 40 3.0 43 0.48 1:00 Quick wash 30 3.0 36 0.30 0:30 Wool 40 1.0 53 0.50 0:45 Handwash 40 1.0 43 0.50 0:35 Handwash 30 1.0 42 0.30 0:31 1. Load the machine, close the drum doors and check that they are p

• Smeg TLS10, DEFINITION OF USE • Keep these Instructions for Use and the Programme Chart; if you pass on the washing machine to another person, also give him/her Instructions for Use and Programme Chart. This washing machine is exclusively destined to wash and spin machine washable laundry in quantities which are usual for private households. • Observe the instructions given in these Instructions for Use and the Programme Chart when using the washing machine. BEFORE USING THE WASHING MACHINE 1. Remove the packaging and check a. Cut and remove the shrink-wrap. b. Remove the top protection and the protective corners.

• Smeg TLS10, PRECAUTIONS AND GENERAL RECOMMENDATIONS 1. Safety instructions • The washing machine is appropriate for indoor use only. • Do not store flammable fluids near the appliance. • Do not place electrical appliances on the lid of your washing machine. • Children must be supervised to ensure that they do not play with the appliance. • This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for t

• Smeg TLS10, Removal of transport bracket The washing machine is fitted with a transport bracket to avoid any possible damage during transport. IMPORTANT: Before using the washing machine, the transport bracket at the back MUST be removed. 1. Unscrew the two screws “A” and the four screws “B” with a flat screwdriver or a No. 8 hex nut box spanner. 2. Remove the transport bracket. 3. Replace the four outer screws “B” on the machine and tighten them. 4. Clip the two seals “C” supplied into the openings “D” of the washing machine. Note: do not forget to replace and tighten the four outer screws. GB 3 INSTALLATION Adjust the feet Install

• GB 4 Connect the water inlet hose 1. Carefully screw the water inlet hose to the valve on the rear side of the washing machine (“A”); screw the other end of the hose to the tap by hand. 2. Make sure there are no kinks in the hose. 3. Check water-tightness of tap and washing machine connections by turning the tap completely on. If the hose is too short, replace it

• Smeg TLS10, GB 5 Do not use extension leads or multi sockets. Electrical connections must be made in accordance with local regulations. 1) Warning - this washing machine must be earthed This washing machine is normally supplied with a mains lead having a plug fitted in the factory which has been checked for correct earth continuity. If the fitted plug is not suitable for your socket outlet, or if the machine’s mains lead is not fitted with a plug, you should fit a suitable new, good quality plug by following the instructions in (2) below. Any unsuitable plug should be cut off and disposed of in order to avoid a possible shock

• Smeg TLS10, GB 6 To remove any residual water used in testing by the manufacturer, we recommend that you carry out a short wash cycle without laundry. 1. Open the tap. 2. Close the drum flaps. 3. Add a small amount of detergent (maximum 1/3 of the quantity the detergent manufacturer recommends for lightly soiled laundry) to the main wash chamber of the detergent dispenser. 4. Close the lid. 5. Select and start programme “Synthetics” at 60°C (see separate the programme chart). BEFORE THE FIRST WASH CYCLE PREPARATION OF THE

• Smeg TLS10, Loading the laundry 1. Open the machine lid by pulling it upwards. 2. Open the drum - by pushing the drum flap release (for “1a” and “1b”; models as shown on “1a” have a fixed drum flap release which will not compress when pushed). - by holding the rear drum flap, sliding back the slider into arrow direction and pushing the front flap towards the inside of the drum until the closing mechanism releases (for “1c”). 3. Place the items of laundry into the drum one by one. Do not exceed the maximum load of the programmes indicated in the separate programme chart. - Overloading the machine will result in unsatisfactory washing r

• Smeg TLS10, GB 8 DETERGENTS AND ADDITIVES Choice of the right detergents and additives: The type of detergent depends on: - Type of fabric (cottons, easy care/synthetics, delicate items, wool). - Colour. - Washing temperature. - Degree and type of soiling. • Use only specific detergents for wool and garments made of microfibres (like sports or swimwear). • Do not use liquid detergents when activating the “Start delay” function (if available on your machine). • Do not use liquid detergent for the main wash when activating the “Prewash” option or selecting a programme with “

• Smeg TLS10, GB 9 Using chlorine bleach • Wash your laundry in the desired programme (Cotton, Synthetics), adding an appropriate amount of chlorine bleach to the SOFTENER chamber (close the lid carefully). • Immediately after end of programme, start the “Rinse and Spin” programme to eliminate any residual bleach smell; if you want, you can add softener. • Never put both chlorine bleach and softener into the softener chamber at the same time. The washing machine is provided with a self-cleaning pump. The filter keeps objects like buttons, coi

• Smeg TLS10, GB 10 Detergent dispenser Clean the detergent dispenser regularly, at least three or four times a year, to prevent detergent build-up: 1. Push in the buttons on each side of the dispenser. 2. Pull the dispenser towards you and remove it. A small quantity of water can remain in the dispenser. It is advisable to carry the dispenser in an upright position. 3. Wash the dispenser using running water. You can also remove the siphon caps in the dispenser for cleaning. 4. Replace the siphon caps in the dispenser (if removed). Make sure that they lock in place. 5. Replace the dispenser by locating the b

• Smeg TLS10, GB 11 Appliance exterior and control panel • Clean with a soft damp cloth. • If necessary, a neutral household cleaner can be applied (do not use aggressive or abrasive products). Appliance interior • After each washing, leave the lid open for some time to allow the inside of the appliance to dry. • If you never or seldom wash your laundry at 95°C, we recommend to occasionally run a 95°C programme without laundry, adding a small amount of detergent, to keep the interior of the appliance clean. Recovering an object that falls between the drum and the tub If an

• GB 12 TROUBLESHOOTING GUIDE Your washing machine is equipped with automatic safety functions which detect and diagnose faults at an early stage and allow you to react appropriately. These faults are frequently so minor that they can be removed within a few minutes. Problem Causes - Solutions - Tips Appliance does not start, no indicator lamps are on • Pl

• Smeg TLS10, GB 13 Failure indication lights up Description - Causes - Solutions “Water tap closed” Appliance has no or insufficient water supply. The “Start(Pause) ” light flashes. Check whether: • Water tap is fully open and water supply pressure is sufficient. • Kinks are present in water inlet hose. • Mesh filter of water supply hose is blocked (see “Care and Maintenance”). • Water hose is frozen up. • Safety valve inspection window of your water supply hose is red (provided yo

• Smeg TLS10, Failure indication lights up Indication on display (if fitted on your machine) Description - Causes - Solutions “Service” “bdd” (in case your washing machine has no display: all lamps of the programme sequence indicator light up) from “F02” to “F35” (except “F09”) “F09” “FA” “Fod” Appliance stops during the programme. “Drum flaps open” (the drum flaps have not been closed properly). Push the “Reset” button for at least 3 seconds and wait until the “Door open” lights up. Open lid and close drum flaps, then select and start desired programme again. If fault persists, no

• Smeg TLS10, AFTER-SALES SERVICE 1. Unplug the washing machine. 2. Turn off the tap. 3. Remove the water supply and drain hose. 4. Eliminate all water from the hoses and the washing machine (see “Cleaning the Filter/ Draining Residual Water”). Wait for the water to cool so as to avoid any accidents. 5. To facilitate moving the machine, pull the handle situated at the bottom front (if available on your model) out a little by hand and pull it out to the stop with the foot. Afterwards push the handle back into the original stable position. 6. Fix the tran

Related Products and Documents (Door):

Comparable Devices:

Similar Resources:

• American Standard Acrylux Framed By-Pass Shower (1 pages) H176© 2008 AS America Inc.ACRYLUX™ FRAMED BY-PASS SHOWER DOORACRYLUX FRAMED BY-PASS SHOWER DOORProduct Features:• Tempered safety glass• Reversible header• Adjustable roller carriage for out-of-square installations• Easy clean tackless sill plate• Heavy duty metal frame• Jamb bumpers❑ 6000Y1.STE5 Rain Glass 57-1/2" to 59-1/2& …

• NuTone LA14WH (4 pages) INSTALLATION INSTRUCTIONSREAD & SAVE THESE INSTRUCTIONS!TO REGISTER THIS PRODUCT, VISIT WWW.NUTONE.COMRecess-MountedDoor Chime• Your NuTone Door Chime is designed for two-door operation. For best results, use NuTone Model C905 Transformer.• Handle the door chime carefully as you would any precision instrument.• Comply with local wiring codes w …

• Schlage B-Series (2 pages) *P513-611*P513-611B662/B762/B862B-Series Double Cylinder DeadboltCerrojo Cilíndrico Doble Serie BPêne Dormant à Double Cylindre de Série BInstallation InstructionsInstrucciones de InstalaciónInstructions d’installation1 Mark door with template.Marque la puerta con la plantilla.Tracez la gabarit sur la porte.Door Puerta PorteA B2 Drill 2 holes.Tala …

• Viking SR-1 (4 pages) PRODUCT MANUALDesigned, Manufactured and Supported in the USACOMMUNICATION & SECURITY SOLUTIONSAdd Loud Ringing to Any Analog PhoneFeaturesThe SR-1 will generate loud ringing from an analogringing line or from a dry contact closure. Thereare 4 different ringing sounds to choose from.Loudness is easily adjusted with a volume controland test button.The SR …

• BMW X6 - BROCHURE 2010 (2 pages) Entertainment, communication and information X6 xDrive35i X6 xDrive50i X6 xDrive30d X6 xDrive40d ActiveHybrid X6– DAB tuner     – DVD changer in the glove compartment, with multi-channel audio system     – DVD system in the rear     – HiFi loudspeaker system     – HiFi system Professi …

• Therma-Tru Double-door (5 pages) SPECDoor SystemSpecificationsDOOR PANELSOPTIONALFACTORY-GLAZEDGLASS OR GLASSINSERTSGASKETING,WEATHERSTRIPPINGHINGES, STRIKESFRAMESSILL, SWING-IN, SWINGOUT, SIDELITE OPTIONSTRANSOM OPTIONS⎠Classic-Craft Door System SpecificationsOPTIONALDECORATIVE PANELSFaces: 3/32-inch minimum thickness, molded from proprietary thermoset composite,wood-grained to duplicate …

Comments, Questions and Opinions: