Manualios.com

GMC 40L Instruction Manual

GMC 40L Manual Online:

4.9, 2213 votes
GMC 40L User Manual
GMC 40L User Guide
GMC 40L Online Manual

Text of GMC 40L User Guide:

  • GMC 40L, 1 40L & 50L VERTICAL DIRECT DRIVE AIR COMPRESSORS EVAC40 & EVAC50 INSTRUCTION MANUAL Black Cyan Magenta Yellow Code: EVAC40/50 IM Date: 070912 Edition: 6 Op: DCR Do not switch on for the first time without first filling with oil.   Air discharged from this unit is not suitable for human consumption.  Test the safety relief valve daily. Refer the instruction manual.  Keep oil level as shown: Use only oil grade specified in instruction manual.  To prevent build-up of condensation, open drain cock daily When filter

  • GMC 40L, 2 Contents Warranty Power Tools Whilst every effort is made to ensure your complete satisfaction with this tool, occasionally, due to the mass manufacturing techniques, a tool may not live up to our required level of performance and you may need the assistance of our service department. This product is warranted for a 2-year period for home domestic use from the date of the original purchase. If found to be defective in materials or workmanship, the tool or the offending faulty component will be repaired or replaced free of charge with another of the same item. A small freight charge may apply. Proof of purchase is essent

  • GMC 40L, 3  Air discharged from this unit is not suitable for human consumption.  Test the safety relief valve daily. Refer the instruction manual. When filter becomes dirty or oily, clean or replace filter. Refer to instruction manual.   High voltage used on this equipment. Prior to servicing or removing the cover, switch off the power supply & remove plug from mains. Ensure mains outlet is adequately rated for this unit. 

  • GMC 40L, 4 Description of symbols The rating plate on your tool may show symbols. These represent important information about the product or instructions on its use. Wear hearing protection. Wear eye protection. Wear breathing protection. Conforms to relevant standards for electromagnetic compatibility. Specifications EVAC40 EVAC50 Power: 2.4HP/1800W Voltage: 230–240V ~ 50Hz No load speed: 2850 min -1 2850 min -1 Discharge pressure: 0.8 MPa(115 psi) 0.8 MPa(115 psi) Tank capacity: 40 litres 50 litres

  • GMC 40L, 5 General safety instructions To use this tool properly, you must observe the safety regulations, the assembly instructions and the operating instructions to be found in this Manual. All persons who use and service the machine have to be acquainted with this Manual and must be informed about its potential hazards. Children and infirm people must not use this tool. Children should be supervised at all times if they are in the area in which the tool is being used. It is also imperative that you observe

  • GMC 40L, 6 affect the operation of the tool. A part that is damaged should be properly repaired or replaced by an authorised service facility, unless otherwise indicated in this Instruction Manual. Defective switches must be replaced by an authorised service facility. Do not use a tool if the switch does not turn the tool on and off correctly. 18. Guard against electric shock. Prevent body contact with grounded objects such as water pipes, radiators, cookers and refrigerator enclosures. 19. Use only approved parts. When servicing, use only identical replacement parts. Use an authorised service facility to fit replacement p

  • GMC 40L, 7 • Prior to transporting the compressor make sure that the pressurised air is bled from the tank and that the compressor is firmly secured. Note. Never transport pressurised tanks. Prior to transporting the air compressor make sure the tank has been completely drained of air. • Protect the air hose and cordset from damage. Inspect for weak or worn spots regularly and replace if necessary. • Do not use an extension cord with this product. Use additional air hose instead of an extension cord to prevent power loss and possible damage to the motor. Use of an extension cord

  • GMC 40L, 8 Know your product 1. Handle 2. Pressure switch cover 3. On/off switch 4. Tank pressure gauge 5. Regulating knob 6. Regulated air outlet 7. Regulated outlet pressure gauge 8. Safety valve 9. Non-return valve 10. Drain cock 11. Air tank 12. Wheel (x 2) 13. Safety cover 14. Oil filling plug 15. Air filter assembly 16. Oil level glass 17. Air tap 18. Oil drain plug 19. Allen key for handle assembly 10 6 13 11 7 4 5 2 8 9 10 12 15 17 1 3 14 16 18 19

  • 9 Unpacking Due to modern mass production techniques, it is unlikely that your GMC Power Tool is faulty or that a part is missing. If you find anything wrong, do not operate the tool until the parts have been replaced or the fault has been rectified. Failure to do so could result in serious personal injury. Assembly Wheels Fitting the wheels Note. In order to fit

  • GMC 40L, 10 Oil WARNING. The air compressor must be filled with oil before first use. To prevent possible spillage of oil during transport, the compressor oil is supplied in a separate container. It must be added to the compressor before turning the compressor on. Failure to add the oil will cause non-repairable damage to the compressor and will void the warranty. 1. Remove the plastic oil filling plug (14) located on the top of the crank case of the compressor housing. 2. Use the oil supplied to fill the crank case until the oil level as seen in the oil level glass (16) is up to the mid point of the red circle. 3. Replace the oil filling plug (14). Ensure the plug is fully fitte

  • GMC 40L, 11 4. To stop the compressor, lift the On/Off lever (3) to the vertical position. Operation 1. The pressure in the tank is controlled by the action of the pressure switch located under the pressure switch cover (2). When the set maximum pressure is reached the pressure switch activates and the motor is switched off. The pressure then decreases as the air is used by the connected tool until the set minimum pressure is reached after which the pressure switch causes the motor to switch on again. The operator of the compressor sho

  • GMC 40L, 12 Troubleshooting Problem Possible Cause Suggested Remedy Motor will not run, running too slow or becoming excessively hot Power fault or supply voltage too low Check the power supply. Do not use an extension cord with an air compressor. Make sure that the compressor is plugged directly into a 240V household power point and not an extension cord or power board. Faulty pressure switch Use authorised service centre to repair or replace the switch Faulty motor Use authorised service centre to repair or replace the motor Main compressor sticking/tight

  • GMC 40L, 13 Troubleshooting continued Problem Possible Cause Suggested Remedy Insufficient pressure or decreased outlet capacity Motor running too slow Use authorised service centre to check and repair if necessary Dirty air filter cartridge Clean or replace the filter cartridge Leaking safety valve Use authorised service centre to repair or replace the switch Leaking pipe Use authorised service centre to check and repair if necessary Damaged gasket Use authorised service centre to check and repair if necessary Damaged or carbon coated valve seat Use authorised service centre to check and repair if necessary Damaged piston ring or cylinder Use

  • 14 Troubleshooting continued Problem Possible Cause Suggested Remedy Insufficient pressure or decreased outlet capacity Air line hose leaking Examine the air hose for any holes and tears. If the hose is found to be defective replace it. Safety valve leaking Examine the condition of the safety valve. If the valve is leaking immediately shut off the compressor

  • 15 Do not have your face close to the safety valve when performing this test as air will discharge from the valve at a high force. If the safety valve does not operate correctly in any way as described above, turn off the compressor immediately and have the compressor and safety valve checked and tested at an authorised service centre. DO NOT CONTINUE TO USE THE COMPRES

  • GMC 40L, GMC customer assist If your product needs repairing, replacing, technical service or you simply need help or advice, please contact us on our Customer Assist Line 1300 880 001 (Australia) or 0800 445 721 (New Zealand). For prompt service we suggest you log your service request online at www.gmcservice.com.au. Should you not have access to the Internet, please contact our service department on 1300 880 001 (Australia) or 0800 445 721 (New Zealand). 7am –7pm, 7days a week (AEST). Please note that if repair or replacement is required, you must provide a valid original purchase receipt. You will need the following details at hand to lo

Related Products and Documents (Air Compressor):

Comparable Devices:

# Manufacturer Model Document Type File Updated Pages Size
1 Pioneer HTZ-7 VisionPlus Service manual pioneer/htz-7-visionplus-1H4.pdf 29 Nov 2023 130
2 Samsung TXM2792F Owner's instructions manual samsung/txm2792f-C54.pdf 03 Dec 2022 58
3 Aiwa CA-DW330 Operating instructions manual aiwa/ca-dw330-397.pdf 05 Jul 2022 20 2.75 Mb
4 Kramer VS-88A Operation & user’s manual kramer/vs-88a-ML6.pdf 09 Jul 2022 37
5 Yamaha CVP-50 Owner's manual yamaha/cvp-50-6OK.pdf 25 Nov 2023 40 5.94 Mb
6 Ultra Products ULT31922 Specifications ultra-products/ult31922-51Z.pdf 16 Oct 2023 1 0.06 Mb

Similar Resources:

  • Silvercrest

    SGP 230 A1

    (84 pages)
    ES1Traducción del manual de instrucciones originalBomba eléctrica de tobera SGP 230 A1AplicaciónEste aparato está destinado para inar y desairear colchonetas, lanchas de goma, pisci-nas hinchables y demás artículos hinchables de gran volumen y de uso doméstico, no siendo adecuado para inar neumáticos de bicicletas ni de coches. Cualquier otro …
  • Powerbuilt

    240039

    (32 pages)
    THIS MANUAL CONTAINS IMPORTANT INFORMATION REGARDING SAFETY, OPERATION, MAINTENANCE AND STORAGE OF THIS PRODUCT. BEFORE USE, READ CAREFULLY AND UNDERSTAND ALL CAUTIONS, WARNINGS, INSTRUCTIONS AND PRODUCT LABELS. FAILURE TO DO SO COULD RESULT IN SERIOUS PERSONAL INJURY AND/OR PROPERTY DAMAGE.IF YOU SHOULD HAVE ANY QUESTIONS OR EXPERIENCE A PROBLEM WITH YOUR S …
  • EINHELL

    TE-CD 12/1 3X-Li

    (102 pages)
    TE-CD 12/1 3X-LiArt.-Nr.: 45.135.95 I.-Nr.: 210109D Originalbetriebsanleitung Akku-BohrschrauberGB Original operating instructions Cordless drill/screwdriverF Instructions d’originePerceuse sans fi lI Istruzioni per l’uso originaliTrapano avvitatore a batteriaS Original-bruksanvisningBatteridriven borrmaskin/skruvdragareNL Originele handleidi …
  • KTC

    COMPACK 2 ECO

    (63 pages)
    CONFIDENTIAL - This document is the property of K.T.C. S.r.l. and cannot be reproduced or issued to third parties without written authorization. K.T.C. S.r.l. shall safeguard its rights to the full extent of the law. OPERATION AND INSTALLATION MANUAL COD. 091114 – COMPACK 2 ECO / SPECIAL - REV. 08 - DATE 10/2020 page 1 of 63 OPERATION …
  • Porter-Cable

    C3151

    (72 pages)
    OilfreePortable Air CompressorInstruction manualIMPORTANTPlease make certain that the person who is to use this equipment carefully reads and understands these instructions before starting operations.Part No. A08192-0410-0ESPAÑOL: PÁGINA 25 FRANÇAIS: PAGE 49To learn more about Porter-Cable visit our website at: http://www.porter-cable.com …
  • L&W Compressors

    LW 100 E

    (154 pages)
    C H A P T E R O V E R V I E W Operating Instructions .............................................................................................................. Spare Parts Lists .......................................................................................................................... Options (if equipped) ................... …

Comments, Questions and Opinions: