Manualios.com

Philips 660 Network Installation Manual

Philips 660 Manual Online:

4.65, 781 votes
Philips 660 User Manual
Philips 660 User Guide
Philips 660 Online Manual

Text of Philips 660 User Guide:

  • Philips 660, 1. Overview is guide is intended to provide the necessary basic knowledge of wireless networking needed to enable the Crys- tal printer to work with wireless LAN (WLAN). e document is based on the assumption that the reader has a Crystal printer at his premises and has read the user manual. It will provide a definition of the typical terms one comes across during the set-up and maintenance of a wireless network. Furthermore the installation of the Crystal printer as a network printer is described and some troubleshooting hints are given. 2. Topologies Wireless LANs (Local Area Networks) can be o

  • Philips 660, 3. Denitions is sections describes the terms a user might come across during the set-up of a wireless network. 3.1 Network Addresses Network adapters and personal computers have to be uniquely identifiable in order to be accessible in a network. erefore each device uses a combination of the MAC address and the IP address to identify itself in a network. 3.1.1 MAC Address e MAC (Media Access Control) address is a six byte long address which is attached to most network adapters. is address is designed to

  • Philips 660, 3.5 DHCP (Dynamic Host Conguration Protocol) DHCP is a protocol that enables network devices to automatically retrieve an IP address from a DHCP server. A DHCP server knows a pool of IP addresses that he can assign to the network devices that request an IP address. 3.6 Subnet Mask e subnet mask is a bit mask which defines how much of an IP address belongs to the private subnetwork and what belongs to the host network. For example the IP address 192.168.1.25 in the subnetwork 255.255.255.0 is split into the host network address 192.168.1 and subnetwork address 25. In

  • Philips 660, 4. Installation of a Crystal Network Printer 4.1 What is needed to install the Crystal Network Printer? To use your Crystal printer as a wireless network printer, you need to have the following items: • PC connected to wireless network either via access point (infrastructure topology) or via WLAN adapter (ad-hoc topology) • USB WLAN adapter for the Crystal printer • Companion Suite installed on your PC 4.2 Basic steps of installation • Install the Wireless drivers on the PC • Setup the network parameters on the PC (IP address, mask) • Setup all parameters on the Crystal Printer • Verify the b

  • Philips 660, Next you have to set the connection mode in Menu 915 to either AUTOMATIC (DHCP) or MANUAL. In an ad-hoc network there will most likely be no DHCP server, therefore normally you will set this parameter to MANUAL. is will prompt you to enter an IP address and a subnet mask. Enter the IP address you want your Crystal printer to have. Make sure that the address is in the subnetwork of your local network i.e. make sure that the parts of the IP address that are covered by the subnet mask (usually the first three bytes) are the same as on all the other computers on the network. Finally set the subnet mask on t

  • Philips 660, 4.5.3 Infrastructure Set-up If you choose INFRASTRUCTURE mode you will be asked to set the authentication mode of the network. e possible choices are NONE, OPEN, SHARED and BOTH. NONE means that there is no encrypted authentication and data is transmitted without encryption. OPEN activates encryption of data and still works with unencrypted authentication. SHARED activates both encrypted data and authentication. BOTH activates both encrypted data and authentication but tries as well to authenticate without encryption if the first try

  • 4.6 Installation of the Crystal Printer as a network printer To add your Crystal printer as a network printer to the system, move to S > P >C S > C S IH > A  R  . In the new dialog choose “I  �

  • is will open the Network Printer Configuration dialog which will show you all the Crystal network printers the application could find on the network. Normally there should only be one but if there are more than one printer in the list you can find the correct one by comparing the MAC address indicated on the screen to the one listed on the USB WLAN adap

  • Philips 660, 5. Troubleshooting 5.1 General Information 5.1.1 Print Network Report A summary of the network settings can be printed out with the help of Menu 95. On this reports the user can find out which networking components are enabled and which networking modes are set. 5.1.2 Restore factory default WLAN settings If it is necessary to restore the default settings of the wireless network configuration, the user can do so by using the Menu 919. 5.2 Changing the printer’s IP address If you change the IP address of your Crystal printer, the device will shutdown the network adapter and rest

  • Philips 660, is will open the Crystal Network Configuration dialog. is dialog will scan for available network printers and show them in a list. Make sure that the network printer with the new IP address is listed. If it is not, press the Refresh button to initiate another network scan. Once your printer is listed in this list it will be found by the printer driver. Close the dialog and print a test page.

  • Philips 660, 5.3 Simultaneous connection of USB and LAN It is possible to have the Crystal printer connected to your PCs via USB and LAN simultaneously. However the same printer will be installed as two printers on your system: once as a USB printer and once as a network printer. If you start print jobs on the network printer and the USB printer simultaneously, there will be a conflict because only one driver can access the printer. e print job that will be started first, will be printed. e other one will show the following dialog as the printer is busy. If you wait until the printer is finished and then cli

Related Products and Documents (Printer):

Comparable Devices:

# Manufacturer Model Document Type File Updated Pages Size
1 LG GD570 Especificaciones lg/gd570-838.pdf 30 Jul 2022 200
2 Bosch DIP-2040-00N Quick installation manual bosch/dip-2040-00n-9P7.pdf 08 Dec 2022 40 1.65 Mb
3 Fisher-Price CATERPILLAR 73260 Owner's manual & assembly instructions fisher-price/caterpillar-73260-72L.pdf 22 Dec 2022 28 1.04 Mb
4 Oneil OC2 Features oneil/oc2-9GZ.pdf 14 Aug 2023 1
5 gfm V07DVDVCR Owner's manual gfm/v07dvdvcr-W6S.pdf 24 Jan 2023 28 7.31 Mb
6 DCS DCS-DRH48N Use and care manual and installation instructions dcs/dcs-drh48n-3P1.pdf 16 Dec 2023 26 1.2 Mb

Similar Resources:

  • Lexmark

    T64x

    (5 pages)
    Lexmark™ T64xClearing Jams GuideAvoiding jamsThe following hints can help you avoid jams:• Use only recommended print media.• Do not overload the print media sources. Make sure the stack height does not exceed the maximum height indicated by the stack line on the labels in the sources.• Do not load wrinkled, creased, damp, or curled print media.• F …
  • Kyocera

    FS-1320MFP

    (87 pages)
    CUA 25307 BUSINESS MACHINES AND BUSINESS MACHINES CONSUMABLES KYOCERA DOCUMENT SOLUTIONS AUSTRALIA PTY LTD ABN: 77 003 852 444 SPECIFICATION GUIDES FOR PANEL 1 PHOTOCOPIER MULTIFUNCTIONAL DEVICES AND ASSOCIATED CONSUMABLES PANEL 3 PRINTERS AND ASSOCIATED CONSUMABLES PANEL 4 FACSIMILE AND ASSOCIATED CONSUMABLES …
  • Xante

    CL 30

    (3 pages)
    __________________________________________ Heavy Stock Enabled CL30 Addendum v3 1 10/19/04 v3Congratulations! With your new, innovative XANTÉ Heavy Stock Enabled CL30, you now can printon heavy weight media up to 330 g/m2.Multi-Purpose TrayThe multi-purpose tray handles from 176 g/m2 (8 point) up to 330 g/m2 (16 point) media. Sheetcapacity varies dep …
  • Epson

    FX-890

    (1 pages)
    Epson America, Inc. October 2001 Epson and Stylus are registered trademarks of Seiko Epson Corporation. Other trademarks are the property of their respective owners. EPSON® Stylus® Photo 890 At-A-Glance Take great shots right to the edge! Product Summary Feature Customer advantage Incredible image quality EPSON core technologies produces prints …
  • HP

    Compaq Presario,Presario CQ5110F

    (2 pages)
    Open unit by side latchesModem CordNOTE:Battery is not fully charged. Please fully charge the battery before using it for the first time. Batterygauge will not be accurate until battery is fully charged and discharged once. Refer to your User’sGuide: “Calibrating the Battery” for further information.Connect AC adapter and power cordPress power button© …
  • Xerox

    Document Centre 240

    (322 pages)
    Document Centre STDocument Centre DCQuick ReferenceSee back coverXerox Document Centre 470 DC/ST460 DC/ST265 DC/ST255 DC/ST240 DC/STReference GuideFebruary 2000 701P34115 …

Comments, Questions and Opinions: