Hobart ecomax 402 Installation And Operation Instructions Manual

Text of Hobart ecomax 402 User Guide:

• Hobart ecomax 402, BA-21907-001-GB 23.12.2010 3 GB 2 23.12.2010 BA-21907-001-GB GB CONTENTS PageIMPORTANT NOTES USE IN ACCORDANCE WITH REGULATIONS The machine is technical work equipment for express use in the work place. The machine is exclusively to be used to wash ware such as plates, cups, glasses, cutlery, trays etc. Do not use for electrically heated cooking and heat conservation appliances. SAFETY: Never hose down the machine. The “Attention” symbol is shown beside instructions that are essential for the safe operation of the machine. Please read these passages thoroughly. LIABILITY: Installations and repairs which are carried out by

• Hobart ecomax 402, 4 23.12.2010 BA-21907-001-GB GB BA-21907-001-GB 23.12.2010 5 GB 1. INSTALLATION 1.1. LOCATION – Rear wall clearance not required. – Level machine by turning the feet. – Distribute machine weight equally onto all feet 1.2. ELECTRICAL CONNECTION Must be carried out by an authorized technician according to the local and national codes. – The electrical supply shall comply with the name-plate data. – Line fuses and cable cross section shall comply with the require- ments. NOTE: A cut-off device shall be provided to connect the supply cord (isolat

• Hobart ecomax 402, BA-21907-001-GB 23.12.2010 7 GBGB 6 23.12.2010 BA-21907-001-GB 1 8 354 76 22 70 65 60 55 50 45 85 80 75 70 65 60 2. CONTROLS ➀ Machine ON/STOP button Pushing this button switches the machine on. The LED lights up − ashing = Machine is lling and heating. − permanent = Maschine ist betriebsberei In case of operating error or faults, it is possible to switch-off the machine im- mediately without the drain cycle, by pushing this button. After switch off, the machine is not voltage free! ➁ Program buttons By pushing these buttons,

• Hobart ecomax 402, 8 23.12.2010 BA-21907-001-GB GB BA-21907-001-GB 23.12.2010 9 GB 3.3. PRIMING THE SUCTION HOSES ATTENTION: The machine has to be switched off. – Open the door. – Push Program buttons ➁ simultaneously. • LEDs light up. • In display ➇ , the LEDs 1 and 11−20 illuminate (dependent on basic setting). – Push Program button “1” repeatedly, until the display LED 3 lights up. – Close the door. – Push Program button “1” again. • In display ➇ LED 4 l

• 10 23.12.2010 BA-21907-001-GB GB BA-21907-001-GB 23.12.2010 11 GB 4.1. PREPARATION – Check correct position of wash/rinse arms, strainer and overow pipe. – Open shut-off valve. – Switch on main switch or put the plug in. – Check level of detergent and rinse aid containers. – Close door and push the ON button ➀ • tank will be lled. • Th

• Hobart ecomax 402, 12 23.12.2010 BA-21907-001-GB GB BA-21907-001-GB 23.12.2010 13 GB ATTENTION: The machine has to be switched off. – Open the door. If the door will be closed or if no button is pressed for 30 seconds,the indicator automatically switches off and the new settings will be saved. Therefore the setting procedure can be interrupted at any time. 6.1. ADJUSTMENT OF DETERGENT DOSAGE QUANTITY Only with built in detergent pump. – Push Program buttons ➁ simultaneously. • LEDs light up. • In the left display the bottom LED (1) is illuminated. • The right d

• Hobart ecomax 402, 14 23.12.2010 BA-21907-001-GB GB BA-21907-001-GB 23.12.2010 15 GB 6.3. ADJUSTMENT OF WATER HARDNESS – With optional softener only. – To adjust the softener to the local water hardness (obtain details from local water authorit): – Push Program button “1”. LEDs 1 to 3 illuminate in the left display – Push Program button “2” repeatedly, until the LEDs in display ➇ correspond to the required value. LED "on" Range Water hardness* 11 H01 up to 7°eh 11 and 12 H02 8 to 14°eh 11 to 13 H03 15 to 21°eh 11 to 14 H04 22 to 30�

• Hobart ecomax 402, 16 23.12.2010 BA-21907-001-GB GB BA-21907-001-GB 23.12.2010 17 GB 9.1. POOR WASH RESULT TYPE OF FAILURE POSSIBLE CAUSE REMEDY Washware are not clean. Wash arms stiff (you should be able to turn them easily by hand). Take out wash arms and clean them thoroughly. Check water outlet from machine to wash arms is clear. Wash arm nozzles are clogged (visual check). Take out wash arm, remove cleaning cap and rinse the wash arm thoroughly until soil is removed. Replace correctly. Rinse arm nozzles are clogged (possibly by lime deposit) Remove rinse arms and decalcify them in separate container. D

• Hobart ecomax 402, 18 23.12.2010 BA-21907-001-GB GB BA-21907-001-GB 23.12.2010 19 GB 9.2. OTHER FAULTS TYPE OF FAILURES POSSIBLE CAUSE REMEDY Glasses are totally or partially cloudy Surface of glasses is rough and porous, this is called glass corrosion This is not caused by a malfunction on the machine. Replace with new glasses. Glass breakages. Use of inappropriate dish or glass racks. Use appropriate racks. 9.3. MALFUNCTIONS TYPE OF FAILURES POSSIBLE CAUSE REMEDY Machine suddenly stops dur- ing wash program. Machine is connected to an energy management system which cuts out the energy consumer at a given point, or ma- chine is interlocked with another energy

• Hobart ecomax 402, 20 23.12.2010 BA-21907-001-GB HOBART GmbH Robert-Bosch-Str. 17 77656 Offenburg Tel. +49(0)781.600-0 Fax +49(0)781.600-23 19 E-Mail: [email protected] Internet: www.hobart.de As continued product improvement is a policy of HOBART, specications are subject to change without notice. Printed in Germany

More Instructions:

Hobart ecomax 402 Installation and operation instructions manual 27-10-2022 20

DOWNLOAD

Related Products and Documents (Dishwasher):

Comparable Devices:

Similar Resources:

• Kenwood Slimline KDW45X16/A (36 pages) Slimline DishwasherKDW45X16/Ainstallation / instructions manualKDW45X16/A_IB_RC_191115_grace.indd 1KDW45X16/A_IB_RC_191115_grace.indd 1 15/11/2019 11:40 AM15/11/2019 11:40 AM …

• Whirlpool ADG1900 (2 pages) 5019 396 91700Quick Reference GuideBefore using the dishwasher, readthe user and installation instructions!GBWhirlpool is a registered trademark of Whirlpool USA1)Reference programme for energy label in compliance with EN 50242 regulations.2)Refer to “User Instructions”.NOTE: Wash times can vary depending on the incoming water temperature, ambient condit …

• Zanussi 531310 (4 pages) ZANUSSIP R O F E S S I O N A LRACK TYPE DISHWASHERSSTANDARD NERT10 - HOT AIR BLOWER533315CONNECTION PLATE-HANDLING TOWT90/RT102 2INCLUDED ACCESSORIESSupply voltage 400 V, 3N, 50 400 V, 3N, 50Net weight - kg. 270 270Noise level - dBA 70 70 installed-electric 36 36Power - kW boiler power - kW 16.5 16.5 boiler capacity - lt. 16 16 temperature - °C …

• Samsung DMR78AHB (30 pages) Lavavajillasmanual del usuarioimagina las posibilidadesGracias por haber escogido este producto Samsung.Para que le podamos brindar un servicio más completo, sírvase registrar su producto enwww.samsung.com/global/registerSerie DMT300 DMT300-00062A .indb 1 2010-03-26 �� 1:58:02 …

• Fagor AD-21BDD (10 pages) AD-21BDD Instruction Manual FAGOR GLASSWASHER WITH DRAIN PUMP AND DETERGENT DISPENSER Fagor Australasia Pty Ltd 7 Boola Place Dee Why NSW 2099 Phone: 02 9984 7533 Fax: 02 9984 7544 Email: [email protected] …

• Zanussi DA 6473 (12 pages) LAVAVAJILLASDISHWASHERMÁQUINA DE LAVARLOIÇADA 6473Manual de instrucciones - parte 2 2Instruction book - part 2 12Instruções de utilização - parte 2 22EGBP …

Comments, Questions and Opinions: