Philips PDIUSBD12 Operation & User’s Manual

Text of Philips PDIUSBD12 User Guide:

• Philips PDIUSBD12, Philips Semiconductors Interconnectivity _______________________________________________________________________________________________ Philips Semiconductors - Asia Product Innovation Centre Visit http://www.flexiusb.com 1 September 1998 PDIUSBD12 Evaluation Board (PC Kit) User’s Manual Rev. 2.1

• Interconnectivity Page 2 of 14 PDIUSBD12 Evaluation Board (PC Kit) User’s Manual Rev. 2.1 _______________________________________________________________________________________________ Philips Semiconductors - Asia Product Innovation Centre Visit http://www.flexiusb.com This is a legal agreement between you (either an individual or an entity) and Philips Semico

• Philips PDIUSBD12, Interconnectivity Page 3 of 14 PDIUSBD12 Evaluation Board (PC Kit) User’s Manual REV. 2.1 _______________________________________________________________________________________________ Philips Semiconductors - Asia Product Innovation Centre Visit http://www.flexiusb.com TABLE OF CONTENTS DISCLAIMER .............................................................................................................2 TABLE OF CONTENTS.............................................................................................3 INSTALLATION OF PDIUSBD12 EVALUATION BOARD........................................4 Introduction..........

• Philips PDIUSBD12, Interconnectivity Page 4 of 14 PDIUSBD12 Evaluation Board (PC Kit) User’s Manual REV. 2.1 _______________________________________________________________________________________________ Philips Semiconductors - Asia Product Innovation Centre Visit http://www.flexiusb.com INSTALLATION OF PDIUSBD12 EVALUATION BOARD Introduction The PDIUSBD12 evaluation kit uses 2 PC as a complete USB development environment, a host PC with USB host capability and a device PC running PDIUSBD12’s firmware. The PDIUSBD12 ISA bridging board is plugged inside the device PC and connects to the evaluation board using a 25-wire cable. So the device PC behaves as a big USB device. Features evaluation of P

• Philips PDIUSBD12, Interconnectivity Page 5 of 14 PDIUSBD12 Evaluation Board (PC Kit) User’s Manual REV. 2.1 _______________________________________________________________________________________________ Philips Semiconductors - Asia Product Innovation Centre Visit http://www.flexiusb.com Installation Jumper’s setting on PDIUSBD12 ISA bridging board The PDIUSBD12 ISA bridging board is plugged inside the device PC. It will occupy I/O, IRQ and DMA resources of the device PC. To avoid possible conflicts in settings, we sugges

• Philips PDIUSBD12, Interconnectivity Page 6 of 14 PDIUSBD12 Evaluation Board (PC Kit) User’s Manual REV. 2.1 _______________________________________________________________________________________________ Philips Semiconductors - Asia Product Innovation Centre Visit http://www.flexiusb.com Possible conflict table: IRQ or DMA Number Possible Conflict IRQ5 Creative SoundBlaster™ and compatible sound cards always occupy this IRQ by default. If this kind of sound card is installed, you should check its settings or remove it. Some network cards may also use this IRQ. IRQ7 Used by

• Philips PDIUSBD12, Interconnectivity Page 7 of 14 PDIUSBD12 Evaluation Board (PC Kit) User’s Manual REV. 2.1 _______________________________________________________________________________________________ Philips Semiconductors - Asia Product Innovation Centre Visit http://www.flexiusb.com Installation of firmware, INF and driver The firmware, D12FW.EXE, runs on the device PC under DOS mode. When D12FW starts, it lights up test LEDs on the evaluation board for 1 second. This means that the I/O address setting is correct. And the evaluation board is disconnected and re-connected to USB by SoftConnect TM . If this is the first time that the evaluation board is connect

• Philips PDIUSBD12, Interconnectivity Page 8 of 14 PDIUSBD12 Evaluation Board (PC Kit) User’s Manual REV. 2.1 _______________________________________________________________________________________________ Philips Semiconductors - Asia Product Innovation Centre Visit http://www.flexiusb.com See the table below for the description of endpoints operations on PDIUSBD12 evaluation board. Endpoint Number Endpoint Type Operations 1 Generic In This pipe is defined as Interrupt In pipe. The PDIUSBD12 evaluation board sends key press/release data packet to the host when test keys are pressed or released. The firmware uses I/O accesses on this endpoint. 1 Generic Out This pipe is defined as Interrupt Ou

• Interconnectivity Page 9 of 14 PDIUSBD12 Evaluation Board (PC Kit) User’s Manual REV. 2.1 _______________________________________________________________________________________________ Philips Semiconductors - Asia Product Innovation Centre Visit http://www.flexiusb.com HARDWARE DESCRIPTION Block Diagram Above block diagram shows 5 main components on the PD

• Philips PDIUSBD12, Interconnectivity Page 10 of 14 PDIUSBD12 Evaluation Board (PC Kit) User’s Manual REV. 2.1 _______________________________________________________________________________________________ Philips Semiconductors - Asia Product Innovation Centre Visit http://www.flexiusb.com Bit description for general input port: Bit Usage 0 Key S1, ‘0’ for pressed 1 Key S2, ‘0’ for pressed 2 Key S3, ‘0’ for pressed 3 Key S4, ‘0’ for pressed 4 D12 GoodLink TM pin state 5 USB bus power state, ‘1’ for USB VBUS p

• Philips PDIUSBD12, Interconnectivity Page 11 of 14 PDIUSBD12 Evaluation Board (PC Kit) User’s Manual REV. 2.1 _______________________________________________________________________________________________ Philips Semiconductors - Asia Product Innovation Centre Visit http://www.flexiusb.com 17 I/O DATA0 18 I T/C, Terminal Count: This line provides a pulse when terminal count for any DMA channel is reached. This signal is active high. 19 I ADDR2 20 I -DACK: This line is used to acknowledge DMA request and is active low. 21 I ADDR1 22 O DRQ: This line is asynchronous channel request used by peripheral devices to gain DMA service. A DMA request is generated by bringing DRQ line to an active

• Philips PDIUSBD12, Interconnectivity Page 12 of 14 PDIUSBD12 Evaluation Board (PC Kit) User’s Manual REV. 2.1 _______________________________________________________________________________________________ Philips Semiconductors - Asia Product Innovation Centre Visit http://www.flexiusb.com Schematics Schematics for PDIUSBD12 evaluation board D12-EVAL-200 2.00 D12 EVALUATION BOARD A 1 1Thursday, April 23, 1998 Title Size Document Number Rev Date: Sheet of VCC VCC VCC VCC VCC V_BUS VCC V_BUS VCC V_BUS VCC Shell to GND

• Interconnectivity Page 13 of 14 PDIUSBD12 Evaluation Board (PC Kit) User’s Manual REV. 2.1 _______________________________________________________________________________________________ Philips Semiconductors - Asia Product Innovation Centre Visit http://www.flexiusb.com Schematic for PDIUSBD12 ISA bridging board D12-ISA-200 2.00 D12 ISA BRIDGING BOARD A 1 1Tuesday, February 24, 1998 T

• Philips PDIUSBD12, Interconnectivity Page 14 of 14 PDIUSBD12 Evaluation Board (PC Kit) User’s Manual REV. 2.1 _______________________________________________________________________________________________ Philips Semiconductors - Asia Product Innovation Centre Visit http://www.flexiusb.com Bill of Materials Bill of materials of the PDIUSBD12 evaluation board Item Quantity Reference Part 1 2 C2,C1 4.7 TANT 2 8 C3,C8,C9,C10,C11,C12,C14,C16 0.1 3 1 C5 47P 4 1 C6 22P 5 1 C7 10 TANT 6 1 C13 470P, Ceramic 7 1 C15 1000P 8 1 D1 GREEN 9 4 D2,D3,D4,D5 RED 10 1 J1 UP_CONN 11 1 J2 DB25 12 1 J

More Instructions:

Philips PDIUSBD12 Firmware programming manual 22-11-2022 22

DOWNLOAD

Related Products and Documents (Motherboard):

Comparable Devices:

Similar Resources:

• AOpen AX4SG MAX (152 pages) 1 AAXX44SSGG MMaaxx OOnnlliinnee MMaannuuaall AX4SG Max DOC. NO.: AX4SGMAX-OL-E0307D …

• MSI P67A-GD65 (13 pages) P67A-GD80 (B3) Overclocking Guide 1Following the footsteps of P67A-GD65 and P67A-GD55, MSI releases its newest iteration of Sandy Bridge mainboards. With richer features and more sophisticated designs, introducing the new P67A-GD80 (B3).OverviewRecognize the P67 PlatformEasy OC for Sandy Bridge ~ OC Genie IIMilitary Class MaterialsP …

• MSI MS-6367 (30 pages) Introduction1-1Chapter 1. IntroductionChapter 1. Getting StartedThank you for purchasing the MS-6367 v1.X M-ATX mainboard. TheMS-6367 mainboard is a superior computer mainboard based on nVIDIA Crush11 & MCP-D chipsets for optimal system efficiency. Designed to fit the ad-vanced AMD® Duron/Athlon processors in the 462 pin package, the MS-6367mainboard …

• Texas Instruments TIC12400 (52 pages) 1SCPU036–October 2017Submit Documentation FeedbackCopyright © 2017, Texas Instruments IncorporatedTIC12400 Evaluation ModuleUser's GuideSCPU036–October 2017TIC12400 Evaluation ModuleThis user's guide describes the characteristics, operation, and use of the TIC12400 Evaluation Module(EVM).Contents1 Introduction ................................. …

• Artesyn MVME3100 (2 pages) MVME3100Quick Start GuideP/N:6806800M29B (May 2014)Observe ESD-safe measuresWhat’s in the box?Configure the hardwareWhen installing or servicing the module or accessories, strictly observe the safety precautions in the Safety Notes. Otherwise, per-sonal injury or property damage may occur.• Use either a properly grounded ESD wrist strap or make sure that …

• Biostar J1800NH3 (28 pages) FCC Informaon and CopyrightThis equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protecon against harmful interference in a residenal installaon. This equipment generates, uses, and can radiate radio frequency energy and …

Comments, Questions and Opinions: