Manualios.com

JVC KA-HD250 Instructions Manual

JVC KA-HD250 Manual Online:

3.6, 1694 votes
JVC KA-HD250 User Manual
JVC KA-HD250 User Guide
JVC KA-HD250 Online Manual

Text of JVC KA-HD250 User Guide:

  • JVC KA-HD250, KA-HD250 STUDIO ADAPTER STUDIO ADAPTER INSTRUCTIONS KA-HD250 For Customer Use: Enter below the Serial No. which is located on the body. Retain this information for future reference. Model No. KA-HD250 Serial No. LST0445-001A LST0445-001A© 2006 Victor Company of Japan, Limited e_ka250.book Page 1 Tuesday, September 5, 2006 11:13 AM

  • JVC KA-HD250, 2 INTRODUCTION These are general important Safeguards and certain items may not apply to all appliances. Important Safeguards 1. Read all of these instructions. 2. Save these instructions for later use. 3. All warnings on the product and in the operating instructions should be adhered to. 4. Unplug this appliance system from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning. 5. Do not use attachments not recommended by the appliance manufacturer as they may cause hazards. 6. Do not use this appliance near water – for example, near a bathtub, washbowl, kitchen sink, or laundry tub, in a wet

  • JVC KA-HD250, 3 Safety Precautions (For USA and Canada) CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of suffi- cient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintena

  • INTRODUCTION 4 Safety Precautions (For Europe) This equipment is in conformity with the provisions and protection requirements of the corresponding European Directives. This equip- ment is designed for professional video appliances and can be used in the following environments: z Residential (including both of the location type class 1 and 2 found in IEC 10

  • 5 Thank you for purchasing this product. (These instructions are for: KA-HD250U.) Before operating this unit, read the instruction manual care- fully in order to make sure that the best possible perfor- mance is obtained. Main Features Equipped with Analog 26P Camera Connector Connect the Remote Control Unit RM-P210 (sold separately) to control this unit from

  • JVC KA-HD250, 6 INTRODUCTION Operating Precautions • In order to ensure that this unit serves you longer, avoid storing or using in the following. Extremely hot or cold places Strong vibrations Dusty places High humidity Near loud noise sources • Do not subject this unit to strong vibration or impact when installing or moving it. • Do not plug in or unplug the camera cable connector when this unit is powered on. • Use only the designated power supplies. Use either RM- P210 or IDX IA-60a, VL-2PLUS. • To reduce power consumption, turn off the power when not in-u

  • 7 Controls, Indicators and Connectors Front Section 1Viewfinder Holder Use for mounting the VF-P400 4-inch Viewfinder. 2Lock Lever Fastens the camera to this unit. X See “Mounting the Camera” on page 10. 3[VF OUTPUT] round 20-pin Connect the VF-P400 4-inch Viewfinder (sold separately). X See “Connecting the Viewfinder (VF-P400)” on page 11. 4[PROMPTER OUTPUT]

  • JVC KA-HD250, 8 INTRODUCTION Controls, Indicators and Connec- tors (Cont’d) Rear Section g[TALLY] TALLY Lamp Lights up red when GY-HD250 is in RECORDING mode. Blinks red when preparing RECORDING mode and lights up green when in stand-by. h[INTERCOM] Intercom Input Terminal (XLR 5 Pin) Input terminal for intercom headset. (Dynamic only) Recommended headset: DT109 (Beyerdynamic) i[INTERCOM MIC] Intercom Mic [ON/OFF] Switch [ON/OFF] switch for intercom headset microphone. Set to [ON] to use the headset microphone. j[I

  • JVC KA-HD250, 9 PREPARATIONS Basic System z Power is supplied by the Remote Control Unit RM-P210 via the 26 pin camera cable when in-use. If the Remote Control Unit RM-P210 is not in-use, use AC power adapter. MACRO USER 3USER 2USER 1 STATUS MENU 2 1 ND FILTER REC OFF ON POWER WHT.BAL AUTO AUDIO LEVEL AUTO CH-1 CH-2 VF BRIGHT CALLTALLY INTERCOM LEVEL FULL AUTO F1 SHUTTER GAIN F2 F3 MENU/SHUTTER GAIN PAINT AUTO BR W.BAL AUTO MANU WHITE MASTER BLACK POWER I O IRIS STEP SHUTTER MENU PUSH-ON DOWN UP VARIABLE PUSH-ON HIGH LOW B A

  • JVC KA-HD250, PREPARATIONS 10 Installation Mounting on a Tripod Use the screw holes on the bottom to mount on a tripod. There are multiple screw holes. Use well-balanced holes to mount to a tripod. Mounting the Camera Prepare the camera as follows before mounting. • Attach the lens. • Attach the microphone. • Remove the viewfinder. For details, refer to GY-HD250’s INSTRUCTION MANUAL. 1. Open the side cover. 2. Release the LOCK RELEASE LEVER. Push the safety lever until the front attachment clip clicks, and then pull the lock lever. 3. Position the camera. Position the camera so the rear base mount is ali

  • JVC KA-HD250, 11 Connecting Cables Connect the cables for this device to the camera. Connect the cable for this device to the camera terminal. MEMO • Turn off the device before connecting cables. • Do not touch the plug terminals when connecting. • Insert the DC cable plug all the way in until it locks. Connecting the Viewfinder (VF-P400) 1. Loosen the lock lever. Turn the viewfinder lock lever counterclockwise and loosen the lock lever. 2. Attach the viewfinder. Slide the viewfinder forward along the viewfinder holder guides on the top of this device. 3. Tighten with the lock lever. Turn the viewfinder lock le

  • JVC KA-HD250, PREPARATIONS 12 Connecting to Remote Control Unit RM-P210 Connection Switch off RM-P210 power supply before attempting the con- nection. 1. Connecting the RM-G210 Connect this unit’s RM multi-pin connector and RM-P210 using the 26 pin camera cable. Length of the camera cable should not be longer than 100 m. 2. Connecting the DT-109U Connect the Headset DT-109U plug to the [INTERCOM] terminal to use an intercom headset. MEMO This device supports only DYNAMIC-type headset. CAR- BON-type headphones cannot be connected. 3. Connecting a Monitor Prompter

  • JVC KA-HD250, 13 Operation 1. Turn the RM-P210 on. Turn the [POWER] switch of the camera remote control unit to [ON]. CALL button lights up green when the power is turned on. After the [POWER] switch is turned on, cam- era remote control unit can be operated after about 30 seconds. MEMO After the power is turned on, the camera remote control unit takes about 30 seconds to be ready to communicate with this unit. 2. Press the [CALL] button. Press and hold down the [CALL] to send call signals to the remote control unit operator. The [TALLY]

  • JVC KA-HD250, PREPARATIONS 14 Notes on Operating RM- P210 Some actions are not compatible when setting the GY- HD250 with RM-P210 menu operations. (G: Action available ×: No action) *1 When frame rate is 60p, 60i, 30p, or 24p *2 When frame rate is 50p, 50i, or 25p Level command Function Action BAR OFF G ON G DETAIL OFF G (CONTOUR) ON G IRIS MANU G AUTO G WHITE BAL MANU G PRE G AUTO1 G AUTO2 G FAW G AUTO SET × WHITE G GAIN 0dB G +3dB G +6dB G +9dB G +12dB G +15dB G +18dB G +24dB × –3dB × ALC-EEl G VARIABLE GAIN2 × VARIABLE GAIN × TALLY OFF G ON G PREVIEW G VOLTAGE CHK. (RM r CAM) G G VOLTAGE CHK. (CAM r RM) HIGH G LOW G SHUTTER OFF G 1/100 G*1 1/120 G*2 1/250 G 1/50

  • JVC KA-HD250, 15 OTHERS Specifications RM Multi-pin connector: Composite video signal output (Either Y/PB/PR, RGB or YC separate output signal can be selected) PROMPTER output: PROMPTER video signal output (composite signal) Operating temperature range: • –5°C to 40°C (Humidity below 80%) Allowable storage temperature: • –20°C to 60°C Power supply voltage: DC12 V Power consumption: Max. 40W (GY-HD250, VF-P400) Mass: Approx. 1.8 f Accessories: Instructions ................................................................

Related Products and Documents (Adapter):

Comparable Devices:

# Manufacturer Model Document Type File Updated Pages Size
1 Harvil AH84-B Assembly instructions harvil/ah84-b-683.pdf 26 Aug 2023 4
2 Snapper LW307T Safety instructions & operator's manual snapper/lw307t-5NH.pdf 12 Jun 2023 8 0.73 Mb
3 BMW 5251 Service manual bmw/5251-5SK.pdf 28 Jan 2023 1002
4 Hyundai HYM46SPE Operation & user’s manual hyundai/hym46spe-A6A.pdf 14 Sep 2022 36
5 HP ProLiant SL270s Generation 8 Quickspecs hp/proliant-sl270s-generation-8-759.pdf 19 Sep 2023 48
6 Philips DTRSA200 Specifications philips/dtrsa200-866.pdf 31 Aug 2022 2 0.25 Mb

Similar Resources:

  • Rosewill

    RNWD-N1501UB

    (2 pages)
    Wireless N AdapterQuick Installation Guide1. OverviewThank you for choosing Rosewill’s 802.11n Wireless USB adapter – RWND-N1501UB / RWND-N1502UBE. This chapter is to introduce you more about this Wireless Adapter.1.1 Package Content Before getting started, please verify that your package includes the following items: 1.Rosewill RWND-N15 …
  • National Instruments

    USB-6001

    (8 pages)
    USER GUIDENI USB-6001/6002/6003 OEMThis document provides information about the dimensions, pinouts, connectors, LEDs, and mounting holes of the National Instruments USB-6001/6002/6003 OEM device. For more information about the device, refer to the NI USB-6001/6002/6003 User Guide and NI USB-6001 Specifications, NI USB-6002 Specifications, and NI USB-6003 Sp …
  • Sony

    CCU-TX50

    (194 pages)
    Camera Channel© 2004 Sony CorporationOperating InstructionsBefore operating the unit, please read this manual thoroughly and retain it for futurereference.You can find the operating instructions in Japanese, English, French, German andItalian on the CD-ROM (packed together).For details on the manuals supplied, see “Using the CD-ROM Manual” on page 6.CCU …
  • Avaya

    M12LU

    (2 pages)
    françaisÉtapes d'installationBranchement de Câbles sur le M12LU/CMA. Débrancher de la base du téléphone le cordon du combiné téléphonique.B. Brancher le cordon du combiné téléphonique dans la prise de l'adaptateur de combiné duM12LU/CM, comme indiqué ( ).C. Brancher la base du téléphone M12LU/CM sur la prise de l'adaptateur té …
  • TAO

    TT-BA07

    (49 pages)
    TAOTRONICS WIRELESS 2-IN-1 ADAPTERUser GuideHelloTT-BA07E-mail : [email protected](JP)EUROPEE-mail: [email protected](UK)[email protected](DE)[email protected](FR)[email protected](ES)[email protected](IT)EU Importer: ZBT International Trading GmbH, Lederstr 21a, 22525 Hamburg, DeutschlandNORTH AMERICAE-mail : …
  • Paradyne

    6512

    (28 pages)
    TSTLINEALMPWRETHERNETTMTM98-16014a-01TM 1SuperLine AdapterInstallation InstructionsDocument Number 6512-A2-GN10-20January 1999SuperLineAdapterContents: Important Safety Instructions What Your SuperLine Adapter Does Package Checklist Optional Hardware (Not Supplied) Front Panel Indicators SuperLine Adapter Rear Panel Installing Your …

Comments, Questions and Opinions: