Omega Vehicle Security K9 Classic-EDP2 Operation Manual
|
Complete Programmable Features Matrix Features Ignition on, off, then press Valet Switch 5 times (Status Light turns on steady). # Feature Default Setting Option 2nd Option 3rd Option 1 SecureCode 1 & 0 2 stages, of up to 9 presses each (total of 99 possible combinations) 2 Last Door Arming OFF (L)
Omega Vehicle Security K9 Classic-EDP2, The final 3 Programmable Features are for the installer’s use. Feature #24 Horn Honk Output Functions Factory Default Setting Horn Honk Output ( press “disarm/unlock” button to program ) Options: OEM Alarm Disarm Output (press “arm/lock” button to program) Channel 5 Latch Output (press “II” button to program) Channel 5 On Demand Output (press “III” button to program) The default setting of this feature is to operate the vehicle’s existing horn; either in conjunction with the electronic siren, or in place of the siren.
Omega Vehicle Security K9 Classic-EDP2, Congratulations for your choice of a new vehicle security and convenience system by Omega Research and Development. You will find that your new system will give you years of trouble-free convenience and protection. To enjoy the most from your new system, please take a few moments to learn about the principal user components, and the basic operation of the system. These subjects are found in next several pages, followed by more detailed specifics of complete operations and features. Introduction to the System “disarm/unlock” • Pressi
Omega Vehicle Security K9 Classic-EDP2, Feature #19 Remote Activated Anti-Carjacking Protection Factory Default Setting Off ( press “disarm/unlock” button to program ) Option: On ( press “arm/lock” button to program ) This form of Anti-Carjacking is initiated by a signal from the transmitter. The Anti- Carjacking protection, including the three ways to initiate it are described on page 17. Feature #20 Open Door Warning Upon Arming Factory Default Setting Off (press “disarm/unlock” button to program) Option: On (press “arm/lock” button to program) When this feature is turned on, if one of the vehicle's doors is open at the time that the system is armed via the transmitter
Omega Vehicle Security K9 Classic-EDP2, Feature #15 Steady Siren or Pulsed Horn Factory Default Setting Steady Siren ( press “arm/lock” button to program ) Options: Pulsed Horn Low (press “disarm/unlock” button to program) Pulsed Horn Medium (press “II” button to program) Pulsed Horn High (press “III” button to program) It is important to first understand that the system has a primary audible output, for the electronic siren, and that it also has a programmable output which among its optional applications is being used to sound the vehicle’s existing horn as a second- ary audible output. This feature changes only the primary audible out
Omega Vehicle Security K9 Classic-EDP2, Feature #11 Alarm Duration Factory Default Setting 30 Seconds (press “arm/lock” button to program) Options: 60 Seconds ( press “disarm/unlock” button to program ) 90 Seconds ( press “II” button to program ) 120 Seconds (press “III” button to program) This feature allows four choices of the Alarm Duration, which is the period of time for which the system sounding the siren (and/or horn, optionally) and flashes the parking lights when it is triggered. Caution: Before lengthening the Alarm Duration you should always check and determine if there are any local anti- noise or nuisance ordinances in your area, to avoid the possibility o
Omega Vehicle Security K9 Classic-EDP2, Arming Bypass: Upon arming, if any system sensing circuit is inoperable, that circuit only will automatically be bypassed. When an unsecured sensing circuit is in a bypassed state, all other normally operating circuits will be protected. Should the bypassed circuit become secured, it will automatically be reinstated for protection 5 seconds later. When certain protection circuits are bypassed, such as the hood/trunk and impact sensor, and the system is armed, it will indicate this by chirping
Omega Vehicle Security K9 Classic-EDP2, While the System is Armed, and should it Trigger While the security system is armed, this is indicated by a slowly flashing Status Light. Should any intrusion attempt be detected, the system will instantly activate, or "trigger". Once triggered, the system loudly sounds the siren and flashes the parking and interior lights on and off. When it is first triggered, the Status Light changes its flash pattern, and the doors will automatically relock. Should a door be open when the system triggers, it will wait until the door is closed, and at that time relock the doors.
Omega Vehicle Security K9 Classic-EDP2, Feature #2 Last Door Arming Factory Default Setting Off (press “arm/lock” button to program) Options: On without doors locking ( press “disarm/unlock” button to program ) On with doors locking (press “II” button to program) “Last Door Arming” has the system automatically arm itself every time you exit the vehicle (the complete operation is described on page 8). This feature turns that operation on or off, and with options of having Last Door Arming operate with or without also locking the doors when the system does arm. Feature #3 Automatic Rearming Factory Default Setting Off ( press “arm/lock” button to program ) Options: On without doors locking
Omega Vehicle Security K9 Classic-EDP2, Automatic Rearming Feature: Automatic Rearming is a programmable feature which ensures that your system is never inadvertently disarmed. It is possible to accidentally or unknowingly operate the transmitter from a pocket or purse. You may not even be aware of an accidental disarming due to the enhanced operating distance offered by the system’s extended range, it is not noticed. Automatic Rearming has the alarm rearm itself 90 seconds after it has been disarmed, unless a vehicle door is opened or the ignition key turned on. Automatic Rearming is confirmed by a fast flashing Status Light after the disarming, unless the system was triggered, in w
Should you feel threatened, or the need to attract attention, you can activate your system's remote “Panic” feature at any time by pressing and holding for 3 seconds the transmitter’s “arm/lock”, the “disarm/unlock”, or the “III” button (see programmable feature #21 to enable). Your system will respond by sounding the siren and flashing the pa
Omega Vehicle Security K9 Classic-EDP2, Other Transmitter Operations The 2nd channel output, which is operated by pressing and holding the transmitter “II” button for 1 second, is designed specifically to operate your vehicle’s electric power trunk release. Your vehicle will respond by releasing the trunk lid or rear hatch, chirping the siren twice, turning on your parking and interior lights for 30 seconds, unlocking the doors, and disarming the system if it was armed. The 2nd channel output will not operate when the ignition switch is "on" unless the vehicle's door is open.
Omega Vehicle Security K9 Classic-EDP2, The Valet Switch may be mounted in a special holder with the Status light, or optionally, the installer may have mounted it independently in a hidden, yet accessible location. Please ensure that you and others who use your vehicle are aware of the location of the Valet Switch and its uses. The Valet Switch has several functions: Using the Valet Switch • It is also used in the procedures for programming features and programming transmitters to operate the Excalibur system. See the “Programming” sections of this manual for detail
“SecureCode” allows the user to customize the number of Valet Switch presses which are required to successfully perform an Emergency Override. The basic Emergency Override procedure is described on page 11. Instead of a single “1 press” of the Valet Switch which would be required in order to perform an Emergency Override, two stages of Valet Switch presses m
Omega Vehicle Security K9 Classic-EDP2, this is done to cancel Anti-Carjacking. This is User Programmable Feature #19 The Status Light Security System Status: These are the “normal” operations of the Status Light, indicating the state of the security system. Exceptions to normal operation are the transmitter verification display upon turning on the ignition key, and 1) Off = The security system is disarmed and not performing automatic functions. 2) On Constant = The security system is in the Valet Mode. 3) Flashing Slowly = The security system is fully armed.
Audiovox APS-920 Car Alarm Owner's manual
APS-920 |
Audiovox 1286994 Car Alarm Installation manual
1286994 |
Clifford AvantGuard 5.1 Car Alarm Installation manual
AvantGuard 5.1 |
Clifford 700 Car Alarm Owner's manual
700 |
Audiovox ca 6552 Car Alarm Owner's manual
ca 6552 |
Autopage C3-RS-915 LCD Car Alarm Operation manual
C3-RS-915 LCD |
CrimeStopper HP-8850PR Car Alarm Operator's manual
HP-8850PR |
Silencer 7921P Car Alarm Owner's manual
7921P |
# | Manufacturer | Model | Document Type | File | Updated | Pages | Size |
---|---|---|---|---|---|---|---|
1 | Electro-Voice | EVT 52 Series II | Owner's manual | electro-voice/evt-52-series-ii-4NV.pdf | 29 Jul 2023 | 14 | 2.83 Mb |
2 | LG | DLG5988W | Owner's manual | lg/dlg5988w-19B.pdf | 06 Mar 2023 | 32 | |
3 | Whirlpool | AFG 7080/IX | Service manual | whirlpool/afg-7080ix-24Y.pdf | 07 Mar 2023 | 5 | |
4 | Whirlpool | WFG500M4HS | User instructions | whirlpool/wfg500m4hs-421.pdf | 28 Dec 2022 | 27 | |
5 | Velleman | DVBTR | Operation & user’s manual | velleman/dvbtr-791.pdf | 30 Jan 2023 | 53 | |
6 | Kohler | KDW1603 | Owner's manual | kohler/kdw1603-K44.pdf | 01 Dec 2023 | 148 |
TSS
DS500 CAN DS500 CAN U CANBUS modulárny autoalarm • Užívateľský a montážny manuál CANBUS modulární autoalarm • Uživatelský a montážní manuál CANBUS CAR SECURITY ALARM • User’s & Installer’s manual Ver.1.18 www.eldibg.comcar audio & multimedia system
…
DS600 CAN(23 pages) |
Black Widow Security
1Standard Features:Two 4-Button Remote TransmittersStatus indicator (LED)Valet / override switchMulti-tone siren (120dB)Dual stage impact detectorRemote panicRemote chirp mute Remote sensor bypassActive or passive armingOptional Features:Starter disable Flashing parking lightsKeyless entryRemote trunk or hatch releaseIlluminated entryHood and trunk protectio …
BW2900R2(16 pages) |
Audiovox
128-88071 of 5Model APS-25COwner's Manual3 Button Remote Security SystemCongratulations! Your purchase of this state-of-the-art security systemexpresses a deep concern for the security of your vehicle, its contents,and passengers. To fully appreciate the many functions and safeguardsincorporated in this system, please spend a few minutes reading this …
APS-25C(5 pages) |
Platinum
128-8775b1 of 321Model APS-997CInstallation Manual2 Way LCD Vehicle Security andRemote Start SystemRev B: New Format Add Timing PASD & Light Blue + DBI Lock, Lock, Lock 5/2013If booklet format, pages 26-30, Programming & Wiring Diagram shall be foldout or seperate 5 sheetsfront & back.PATENTED: www.voxxintl.com/company/patentsTable Of Contents:B …
APS-997C(32 pages) |
Audiovox
Model AA-RS20CSOwner's ManualFEATURES:2 Three Button Programmable RF TransmittersFour Channel Code Learning ReceiverAnti Code Grabbing TechnologyRemote Panic In All ModesProtected Valet/OverrideRemote Start Safety Control SwitchSafe Start RF Control (Double Push Of RF Transmitter)Selectable Automatic Timed Start Mode7 Function LED, Arming, Armed, Disarm …
AA-RS20CS(8 pages) |
Autopage
1 RF-420LCD PROFESSIONAL VEHICLE SECURITY SYSTEM INSTALLATION MANUAL (FOR AUTHORIZED DEALERS ONLY) THIS PRODUCT IS DESIGNED FOR PROFESSIONAL INSTALLATION ONLY
…
RF-420LCD(12 pages) |
Magnavox Stereo System MAS-80Magnavox MAS-80 Stereo System Operation & user’s manual MAS-80, 26 |
Mitsubishi Electric Projection TV TM WD-62827Manual: Mitsubishi Electric TM WD-62827 (H9L2WO, Upd.Friday 29-12-2023) TM WD-62827, 129 |
Johnson Controls Unitary Products Controller YCCS TEC2603-4 BACnetController Installation instructions manual (Johnson Controls Unitary Products YCCS TEC2603-4 BACnet) YCCS TEC2603-4 BACnet, 16 |
NetComm Network Router NB5Plus4WNetComm NB5Plus4W Manual (Operation & user’s manual), @3LV16F NB5Plus4W, 112 |
Honeywell Control Unit ADEMCO 4204Honeywell Control Unit Installation instructions (File: honeywell-ademco-4204-installation-instructions-2, Tue 10.2023) ADEMCO 4204, 2 |
Minarik DC Drives MM21036A#448BE5 MM21036A: Minarik DC Drives Owner Documentation MM21036A, 12 |
Xerox Printer DocuPrint N4025Xerox DocuPrint N4025 Guide (Operation & user’s manual), @5LHCAN DocuPrint N4025, 129 |
JVC Camcorder GR-D90#49JHDD GR-D90: JVC Camcorder Owner Documentation GR-D90, 56 |
Stamina Elliptical Trainer EX 30Stamina Elliptical Trainer EX 30 Owner's manual EX 30, 31 |
Tokai Car Receiver LAR-212#T75I4L: LAR-212 Car Receiver Instruction manual LAR-212, 8 |
Weil-McLain Boiler 550 MBHManual: Weil-McLain 550 MBH (2I1ZHQ, Upd.27/11/2023) 550 MBH, 128 |
Extron electronics Stereo System FOX AEX 108Guide: Extron electronics FOX AEX 108 (94ICGS, Upd.02/09/2023) FOX AEX 108, 16 |