Planet Vip-321 Operation & User’s Manual

Text of Planet Vip-321 User Guide:

• Planet Vip-321, Reset to Default In Default Setting you can restore the DECT VoIP Phone to factory default in this page. You can just click the Restore button, then the DECT VoIP Phone will restore to default and automatically restart again. Save & Reboot In Save & Reboot page you can save the changes you have done. If you want to use new setting in the DECT VoIP Phone, You have to click the Save button. After you click the Save button, the DECT VoIP Phone will automatically restart and the new setting will effect.

• Appendix C VIP- 321 Specifications Product DECT VoIP Phone Model VIP-321 Hardware LAN 1 x 10/100Mbps RJ-45 port WAN 1 x 10/100Mbps RJ-45 port FXO (PSTN connection) 1 x RJ-11 connection DECT 1 x DECT GAP compatible base Protocols and Standard Standard SIP 2.0 (RFC3261) Voice codec G.723.1 (6.3k/5.3k), G.726, G.729A, G.729B, G.711 Voice Standard Voice activit

• Planet Vip-321, Case 3: Voice communication via IP PBX server – IPX-2000 Device configurations on the VIP-321: STEP 1: Log in IPX-2000 and create two testing accounts/password: 100 / 123 (for ATA A ), and 200 / 123 (for VIP-321 B ) for the voice calls. STEP 2: Please log in VIP-321 via web browser, browse to the SIP Settings menu and select the Service Domain Settings menu. In the setting page, please insert the account/password information obtained from your service provider (in this sample, we’re using PLANET IPX-2000 as the PBX server for SIP account, call authentications), and then the sample conf

• Planet Vip-321, STEP 3: Repeat the same configuration steps on VIP-321 B , and check the machine registration status, make sure the registrations are completed. Test the scenario: 1. Pick up the telephone and press the key on VIP-321 A. 2. Press the keypad: 200 shall be able to connect to the VIP-321 B . Then the telephone set in VIP-321 B should ring. Please repeat the same dialing steps on VIP-321 B to establish the first voice communication from VIP-321 A.

• 2 Chapter 2 Preparations & Installation Physical Installation Requirement This chapter illustrates basic installation of VIP-321 • Network cables. Use standard 10/100BaseT network (UTP) cables with RJ45 connectors. • TCP/IP protocol must be installed on all PCs. For Internet Access, an Internet Access account with an ISP, and either of a DSL or Cable modem.

• ÍNote 1. The time setting must be entered in 24H format. 2. In the state of FSK standard, the date and time will be automatically set when you receive a call to this unit. Handset Basic Functions Making a Call ers up to 25 digits which are shown in the display. If the number is longer than 8 You can dial numb digits, the display automatically switches a smaller font in orde

• Planet Vip-321, Rear Panel of VIP-321 Physical Interfaces Description WAN RJ-45 connector, to maintain the existing network structure, connected directly to the xDSL/Cable modem through straight CAT-5 cable. LAN RJ-45 connector, for Internet access, connected directly to Switch/Hub, through straight CAT-5 cable. RESET Reset to the factory default setting. LINE RJ-11 connector, connected directly to the PSTN analog line. Press "＊＊" to switch to PSTN mode. 6V DV 6V DC Power input outlet. • Machine

• Planet Vip-321, Codec ID Setting .........................................................................................................................................30 DTMF Setting .............................................................................................................................................31 RPort Settings..............................................................................................................................................31 Other Settings..............................................................................................................................................31 STUN settings........................................

• Planet Vip-321, Chapter 1 1 Introduction Overview With years of Internet telephony and VoIP manufacturing experience, PLANET now introduces the newest member of the PLANET DECT (Digital Enhanced Cordless Telecommunications) Station VoIP Phone family: the VIP-321. As a direct response to feedback from our customers, PLANET's new DECT VoIP Phone, the VIP-321, not only provides quality voice communications and Internet sharing capabilities with other LAN users but also offers DECT interface for daily cordless

• Planet Vip-321, Parameter Description IP address WAN IP address of the VIP-321 Default: 172.16.0.1 Mask WAN mask of the VIP-321 Default: 255.255.255.0 Default Gateway Gateway of the VIP-321 Default: 172.16.0.254 Connection Type Description Connection Type Data required. Fixed IP The ISP will assign IP address, and related information. DHCP Client In most circumstances, it is no need to configure the DHCP Settings. PPPoE The ISP will assign PPPoE username / password for Internet access. After confirming the modification you’ve done. Please click on the Submit button to apply settings and browse to "Save & Reboot" menu to reboot the machine to make the

• Planet Vip-321, Step4. To select the operation for four calculations, press the Left or Right keys to choose the required arithmetic symbol appears: Step5. Enter the second number (second operand) using the numeric keys Step6. To get the result, press the SELECT key. To insert a decimal point, press key or use the Left or Right key to select the "." symbol. ÍNote Setting Access Code Some telephone systems, such as PABX (Private Automatic Branch of eXchange) or KTS (Key Telephone Systems), require an access code (e.g. 9 or 0) to access an external line and listen for the outside dial tone before dialing the outside

• Planet Vip-321, MAC Clone Settings This page defines the MAC Clone Settings. Some ISP servers check the MAC address for the authentication on the PPPoE interface, so if PC is setup internal in the VIP-321, the MAC Clone Setting must to be enabling, that this VIP-321 will copy the PC’s LAN MAC address to the WAN of VIP-321 for communicating with ISP server properly. When you finished the setting, please click the Submit button. Advanced Settings This page defines the extra Advanced Settings. Allow user to configure the ICMP (Internet Control Message Protocol), Send Anonymous CID (Caller ID), SIP Encryption, PPPo

• Planet Vip-321, Product Features • Feature-rich telephone service over home or public areas with Internet/Intranet connection • Cost effective, field proven compatibility and stability • SIP 2.0 (RFC3261) Compatible • Peer-to-Peer / SIP proxy calls • Up to 5 DECT Handset registering • Voice codec support: G.711, G.723.1, G.729A/G.729B • In-band and out-of-band DTMF support • Call forward, call transfer and call waiting support • Three-way conference calls and caller ID display support • Voice processing: Voice

• Planet Vip-321, services (e.g. call waiting, conference etc.) which can be available in your phone network. For further details please contact your network telephone company. Moreover, if you are connected to an extension of a switchboard (PABX), you can use the R key to locally transfer a call to another extension. To transfer a call, or use the said special services, just press the R key while the line is engaged. Using a Pause A pause is useful when you access an interactive voice response system, such as an automated banking system. A pause provides a delay of 3 seconds. When you are dialing a number i

• Planet Vip-321, VLAN Packets The default setting is OFF. When turn on the “VLAN Packet”, it will enable the VLAN function. VID, CFI One must also set the VID (VLAN ID, supported by VLAN Server) and CFI (Canonical Format Indication) property for the VLAN operation. User Priority One can also set the user priority for 0~7. Virtual Server Settings One can add and deletes virtual server to/from the virtual server list, which up to 24 (no. 0~23 in three pages) virtual servers could be added. User can checking the "Select" fields and click the "Enable Selected" button to enable them, opposite if want to delete the virtual server need t

• Planet Vip-321, Appendix A Voice Communication Samples There are several ways to make calls to desired destination in VIP-321. In this section, we’ll lead you step by step to establish your first voice communication via web browsers operations. Case 1: (Peer-to-Peer mode) VIP-321 to VIP-321 connection via IP address Assume there are two VIP-321 in the network the WAN IP address are 172.16.0.1, 172.16.0.2 DECT VoIP Phone is registering to the base of the VIP-321 respectively. 172.16.0.1 172.16.0.2 1 6 * 0 * 2 *1 7

• Planet Vip-321, press any key. During the conversation, the display shows the elapsed time. To end the call, either press the key or replace the handset on the base. Adjusting Voice Volume During a conversation, press the Up or Down key to adjust the level of the earpiece volume (or the d hands free speakerphone one, if activated). You can adjust the volume in five levels which are showe by the bars of the icon ,the more bars filled blue, the louder the volume. When the last bar is filled red, this means the voice volume reach the maximal level. Muting a Call tion, you can tem

• Planet Vip-321, When you reset the handset you will lose any date stored in it (e.g. ÍNote name and numbers in phonebook). Don’t forget to note them down before resetting the handset. Setting Auto Answer With this feature, you can answer a call by just picking up the handset from the base without pressing any key. Step 1. Entered to the MENU > H/Set Setting item. Step 2. Press the Up or Down key to choose Auto Answer, then press the SELECT key to activate the feature, and the icon will appear at the right of the Auto Answer item. Step

• Planet Vip-321, Step1. Please pick up the handset and press the key to engage the line. Step2. Please press and hold the key until “━” is displayed: your phone is temporarily to the tone dial mode. Step3. Please enter the number of the service you need to access as you do normally. Step4. When you hang up, the phone automatically returns to the pulse mode. Intercom If you connected more than one handset to a base (you can connect up to 5 handsets to the same base), you can have a conversation between two people using two different handsets. 1. Please pick up the handset and

• Planet Vip-321, TFTP Server TFTP Server domain name (or IP address). None Max. length: 128 HTTP Server TFTP Server domain name (or IP address). None Max. length: 128 HTTP Path The file path under HTTP server, for example /aps_cfg/123/ None Max. length: 128 FTP Server FTP Server domain name (or IP address). None Max. length: 128 FTP Username FTP user name for logging in to the FTP Server. None Max. length: 64 FTP Password FTP user password for logging in to the FTP Server. None Max. lengt

• Planet Vip-321, Copyright Copyright (C) 2007 PLANET Technology Corp. All rights reserved. The products and programs described in this User’s Manual are licensed products of PLANET Technology, This User’s Manual contains proprietary information protected by copyright, and this User’s Manual and all accompanying hardware, software, and documentation are copyrighted. No part of this User’s Manual may be copied, photocopied, reproduced, translated, or reduced to any electronic medium or machine-readable form by any means by electronic or mechanical. Including photocopying, recording, or information storage and retrieval systems, for an

• Planet Vip-321, Call forward This page defines Call Forward function. You can setup the phone number you want to forward in this page. There are three type of Forward mode. You can choose All Forward, Busy Forward, and No Answer Forward by click the icon. Parameter Description All Forward All incoming call will forward to the number you chosen. You can input the name and the phone number in URL field. If you select this function, then all the incoming call will direct forward to the speed dial number you choose. Busy Forward If you are on the phone, the new incoming call will forward to the number you choose. You can input

• Planet Vip-321, Phonebook The phonebook built in your cordless phone allows you to store frequently used numbers so that you can easily make a call without having to remember or enter the phone number. Moreover, it reduces the risks of wrong dialing. You can store up 250 entries in your internal phonebook. You can store the phonebook entries in the below stated modes, by using the phonebook menu or in Standby mode. Storing Phonebook Entries By Using the phonebook menu Step1. Press MENU key to display the main menu items. Step2. Please repeatedly the key

• Call Waiting 1. A and B are in the process of conversation. 2. C call to A and A will hear the prompt sounds. 3. A press “R” soft-button to hold the conversation with B, and switch to conversation with C.

Related Products and Documents (IP Phone):

Comparable Devices:

Similar Resources:

• NEC SV-8100 (78 pages) NoticeNote that when converting this document from its original format to a .pdf file, some minor font and format changes may occur. When viewing and printing this document, we cannot guarantee that your specific PC or printer will support all of the fonts or graphics. Therefore, when you view the document, fonts may be substituted and your individual prin …

• Mitel 6920 (4 pages) ECTBetter . ConnectedTMFlip ConnectMitel 6920 IP PhoneQuick User GuideFlip Solutions Ltd t/a Flip ConnectThe Maltings, Bridge Street, HitchinHertfordshire, SG5 2DE 01462 417 999 0870 421 5411 support@flipconnect.co.uk www.flipconnect.co.uk☎✉ …

• VOICE2NET YL41P (2 pages) YL41P User Guide Voice2Net Corp 200 Prescott Street Kemptville, ON K0G 1G0 PH 877-454-0761 Email [email protected] Voicemail Access  If there is an active voice mail on your phone, the Red Lamp on the top right of the phone will be Flashing  Dial *98 or press the Voicemail button on the phone.  Enter your password followed by …

• Linksys SPA932 (2 pages) PRODUCT DATAModel No. SPA932Enrich IP Phone Functionality with the Push of a ButtonThe Linksys SPA932 32 Button Attendant Console for the SPA962 IP Phone is an ideal solution for small businesses wanting to simplify incoming call handling to quickly direct calls to the requested party and also monitor line status from a central location.The SPA932 easily at …

• Cisco 6921 (186 pages) Americas HeadquartersCisco Systems, Inc.170 West Tasman DriveSan Jose, CA 95134-1706 USAhttp://www.cisco.comTel: 408 526-4000800 553-NETS (6387)Fax: 408 527-0883Cisco Unified IP Phone 6921, 6941, and 6961 Administration Guide for Cisco Unified Communications Manager 8.0 (SCCP)Text Part Number: OL-20851-01 …

• Mitel 6869i (2 pages) User Interface (UI) OverviewCall Status Indicators: On Hold Incoming Call Outgoing Call Conference Call Mitel Model 6869i IP Phone Quick Reference GuideFor more information please refer to the 6869i IP Phone User Guide.Getting StartedOptions: Accesses services and options to customize your phone.G …

Comments, Questions and Opinions: