Pyle PWD103 System Manual

Text of Pyle PWD103 User Guide:

• Pyle PWD103, 1 SYSTEM MANUAL Full Featured Keyless Entry System with Optional Starter Defeat and Passive Immobilize Feature STANDARD FEATURES Some of the system’s standard features include: • Two 4-button remote transmitters • Remote keyless entry • LED Status indicator • Valet switch OPTIONAL FEATURES This system has many optional features that may not be compatible with some vehicles, and may require additional parts and/or labor. Please contact your dealer for more details. • Flashing Parking Lights • Starter Defeat • Illuminated Entry • Trunk/hatch Release • Passive Immobilze feature • Horn Honk out

• Pyle PWD103, 2 PASSIVE STARTER DEFEAT If the optional starter defeat is installed, the system can be programmed to automatically disable the starter 45 seconds after turning off the ignition as an extra measure of security in the event the vehicle is accidentally left unlocked. During the 45 second countdown,the LED will flash rapidly to indicate the passive starter defeat sequence has begun. After 45 seconds, the LED will flash slowly and the vehicle’s starter will be disabled. IGNITION TRIGGER After the system is remotely locked, turning on the ignition before remotely unlocking the system activates the optional ignition trigg

• Pyle PWD103, 3 Before you begin the installation: • This product must be installed by qualified personnel according to these instructions. • Verify with the customer the desired location for the program switch and LED. • Always use a multimeter when verifying vehicle wiring. Installation Notes: • Do not install the main unit in the engine compartment. • Make all wiring connections to the vehicle before connecting the main 15-pin connector harness to the main unit. • Mount the main unit in a secure area,away from vehicle computers and heating/air

• 4 • BLUE/WHITE WIRE - Passenger unlock output (-) 500mA. The BLUE/WHITE wire provides a ground to unlock the passenger doors when the unlock button on the transmitter is pressed two times. To install the two-step unlock feature, the BLUE/BLACK and BROWN/BLACK wires must be run directly to the driver’s door actuator unlock wire and the BLUE/WHITE wire must be connected to a relay to unlo

• Pyle PWD103, 5 DEFAULT RESET To reset all programmable features to their factory default settings: 1. Turn on ignition. 2. Within 5 seconds, press valet switch 5 times. • The horn will provide a long chirp, to indicate entering program mode. 3. Press transmitter button 3.The LED will flash 3 times, pause then continue flashing. All programmable features will be reset to the default position. ADDING / DELETING REMOTE TRANSMITTERS Adding new transmitters to the system will automatically delete all other remotes that were previously operating the system. NOTE: You must code all desired remotes at this time.The unit can learn

• Pyle PWD103, 6 FACTORY DOOR LOCK RELAYS NOT USED NOT USED FACTORY DOOR LOCK SWITCH VIOLET BLUE/BLACK BROWN/BLACK VIOLET/BLACK GREEN/BLACK WHITE/BLACK (-) DOOR LOCK (-) DOOR UNLOCK HARNESS FACTORY DOOR LOCK RELAYS NOT USED NOT USED FACTORY DOOR LOCK SWITCH VIOLET BLUE/BLACK BROWN/BLACK VIOLET/BLACK GREEN/BLACK WHITE/BLACK (+) DOOR LOCK (+) DOOR UNLOCK HARNESS CONNECT TO +12V VIOLET BLUE/BLACK BROWN/BLACK VIOLET/BLACK GREEN/BLACK WHITE/BLACK CONNECT TO +12V AFTER-MARKET ACTUATORS HARNESS VACUUM PUMP LOCK/UNLOCK SWITCH VIOLET BLUE/BLACK BROWN/BLACK VIOLET/BLACK GREEN/BLACK WHITE/BLACK

• 7 BLUE/WHITE VIOLET BLUE/BLACK BROWN/BLACK VIOLET/BLACK GREEN/BLACK WHITE/BLACK LOCK/UNLOCK SWITCH CUT DRIVER'S DOOR MOTOR PASSENGER DOOR MOTORS X (-) DOOR LOCK (-) DOOR UNLOCK L UL HARNESS FACTORY DOOR LOCK MODULE CONNECT TO +12V CONNECT TO +12V BLUE/WHITE 86 30 87 87a 85 VIOLET BLUE/BLACK BROWN/BLACK VIOLET/BLACK GREEN/BLACK WHITE/BLACK LOCK/UNLOCK SWITCH CUT DRIVER'S DOOR MOTOR

• Pyle PWD103, 8 © 2004 64-853 Rev 1 2/04 Black Ground (-) Valet Switch LED Violet Unlock #87 Normally Open input [10A fuse] Blue/Black Unlock #30 Common output Brown/Black Unlock #87a Normally Closed output Violet/Black Lock #87 Normally Open input [10A fuse] Green/Black Lock #30 Common output White/Black Lock #87a Normally Closed output Orange Starter Defeat output (-) 500mA Black/Yellow Dome Light output (-) 500mA Gray Auxiliary output (-) 500mA Brown/White Horn Honk output (-) 500mA Blue/White Passenger Unlock Output (-) 500mA Red +12V Battery input (+) [15A fuse] W

Related Products and Documents (Car Alarm):

Comparable Devices:

Similar Resources:

• Ultra Start 3295Series (32 pages) REV.2009.09.19TMINSTALLATION GUIDETMwww.ultrastarters.comTHIS MANUAL COVERS THE OPERATIONS OF THE 3295, 4295 SERIES REMOTE STARTERS AND ALARMSWARNING: NEVER USE AN AUTOMATIC TRANSMISSION STARTER IN A MANUAL TRANSMISSION VEHICLE!95 SERIES Advanced Remote Starters & Vehicle Security Systems …

• PUTHON 460HP (28 pages) 460HPInstallation Guide© 2002 Directed Electronics, Inc. Vista, CA N429P 4-02NOTE: This product is intended for installation by a professional installer only!Any attempt to install this product by any person other than a trained professionalmay result in severe damage to a vehicle’s electrical system and components. …

• Omega RS-7K (10 pages) 1OPERATING & INSTALLATIONINSTRUCTIONSCOPYRIGHT: OMEGA RESEARCH & DEVELOPMENT 1999RS-7KDELUXE KEYLESS ENTRY/REMOTE CAR STARTERFOR AUTOMATIC TRANSMISSION VEHICLES ONLY2Operating Instructions:Introduction & Warnings ......................................................................... 3Transmitter Functions ...................................... …

• Clifford 4806X (17 pages) OWNER’S GUIDEMODEL4806X© 2013 Directed, All rights reserved. The company behind Clifford® Auto Security Systems is Directed.Since its inception, Directed has had one purpose, to provide consumers with the finest vehicle security and accessories available. The recipient of nearly 100 pat-ents and Innovations Awards in the field of advanced electronic …

• Audiovox 5BCR07 (8 pages) 128-6799C1 of 81Your Alarm and or Remote Start unit has a configurable receiver that allowsthe transmitter to be programmed to operate the Lock Unlock functions withone transmitter button or with two transmitter buttons (separate Lock/Unlock). In addition, the receiver also allows driver priority function. Thisdriver priority function takes place when eve …

• CrimeStopper CS-2011RS.II (12 pages) CS-2011RS Series II Super Rage™ Remote Control Alarm & Remote Engine Starting System OPERATION INSTRUCTIONS INTRODUCTION CONGRATULATIONS on your choice of a Super Rage™ Alarm & Remote Engine Starter by Crimestopper Security Products Inc. This booklet contains the information necessary for operating your system. If any questions arise …

Comments, Questions and Opinions: