Manualios.com

Baxi 910 Installer And Owner Manual

Baxi 910 Manual Online:

3, 814 votes
Baxi 910 User Manual
Baxi 910 User Guide
Baxi 910 Online Manual

Text of Baxi 910 User Guide:

  • Baxi 910, Page 10 Thermal switch. The Thermal Switch should be fitted to the inside of the Diverter Box as in figure 4. Secure using the nut and bolt supplied. Never modify the fixing bracket and always ensure that the switch is fitted correctly. NEVER USE THE STOVE IF THE THERMAL SAFETY SWITCH HAS BEEN REMOVED OR IF IT IS DAMAGED IN ANY WAY. Diverter box. Locate the diverter box to the rear of the stove body and secure in place using the bolts and washers supplied. Burner module.  Offer the burner module into the stove and connect the thermal switch leads to the tags mid way along the thermocouple.  Locate the burner assembly inside the stove body as in figure 5 (The outer front of t

  • Baxi 910,  Avoid upper body/top heavy bending. Do not lean forward or sideways whilst handling the stove.  Always grip with the palm of the hand. Do not use the tips of fingers for support.  Always keep the stove as close to the body as possible. This will minimise the cantilever action.  Use gloves to provide additional grip.  Always use assistance if required. 2. APPLIANCE DATA AND EFFICIENCY General information. *When converted using kit 0591011. The appliance information label is located on a plate at the base of the stove. Efficiency. The efficiency of this appliance has been measured as specified in BS EN 613 and the result is as below : Model Efficiency % (Gross)

  • Baxi 910, Fitting the ceramic fuel effect. The installer and owner guide for the ceramic fuel effect is supplied with the ceramic fuel effect. It is important that the installer guide for the ceramic fuel effect be placed inside or attached to this guide and handed to the customer following completion of the ‘Final review’ section. 6. OPERATING THE STOVE Pre-lighting checks.  Ensure all the building work and flue sealing is complete.  Ensure the down draught deflector plate is fitted correctly.  Ensure all the ceramic fuel effect pieces are correctly placed. 

  • Baxi 910, CLEANING YOUR STOVE Turn the stove off and allow it to cool completely before attempting any cleaning. Note that it will retain heat for some time after it has been turned off. Cast Iron Surfaces. Regular dusting with a dry lint free cloth is all that should normally be necessary. If the paint needs retouching, allow the stove to cool completely. Brush any areas needing attention with a wire brush (Not enamelled surfaces). Clean off any loose matter. Touch up with high temperature stove paint. Apply the paint sparingly. Two light coats are better than one thick coat. Opening the Door. The door is secured with a locking bolt. To open the door use a suitably sized spanner and t

  • © Baxi Heating U.K. Limited 2010. 5122664/02 Firefox 5 Model 910 CAST-IRON GAS STOVE Fitted with a Ceramic Coal fuel effect. (GC No. 32-264-24) INSTALLER AND OWNER GUIDE For further advice please contact the retailer or company from where you purchased your fire INSTALLER: Please leave this guide with the owner

  • Baxi 910, Clearances. Clearances from combustible and non-combustible materials must be at least those shown in figure 6. IMPORTANT: Reducing the clearance distance at the rear of the stove (especially with non-combustible surfaces) can result in the stove switching off. This occurs when the thermal switch operates due to insufficient cool air. Flue / Chimney.  The stove is approved for use with 102mm (4 inch) diameter insulated Selkirk insta - lock gas vent.  The spigot is designed to be compatible with a selkirk 4 SIL - DH draft hood connector.

  • Baxi 910, Do always use a fireguard complying with BS 8423 for the protection of young children, the elderly, the infirm or pet animals. The cast iron top, front, rear and sides of this stove are considered to be working surfaces and so will become very hot when in use. Always take care when using this appliance. Do wait three minutes before attempting to relight if the gas stove is switched off or the flames are extinguished for any reason (Your gas stove is fitted with a safety device that will automatically shut off t

  • Baxi 910, 1. SAFETY This product uses fuel effect pieces containing Refractory Ceramic Fibres (RCF), which are man-made vitreous silicate fibres. Excessive exposure to these materials may cause irritation to eyes, skin and respiratory tract. Consequently, it is important to take care when handling these articles to ensure that the release of dust is kept to a minimum. To ensure that the release of fibres from these RCF articles is kept to a minimum, during installation and servicing we recommend that you use a HEPA filtered vacuum to remove any dust and soot accumulated in and around the stove before and after w

  • Baxi 910, Page 4 © Baxi Heating U.K. Limited 2010. LIST OF CONTENTS Section Heading Page INSTALLER GUIDE 3 - 18 OWNER GUIDE 19 - 25 1. SAFETY 5 2. APPLIANCE DATA AND EFFICIENCY 6 General information. 6 Efficiency. 6 3. UNPACKING 7 4. STOVE SET UP 8 Legs and lower casting cover 8 Flue collar, diverter box, flue spigot and flue restrictor plate. 8 Down draught deflector. 9 Burner module. 10 Thermal switch. 10 Diverter box. 10 5. GENERAL INSTALLATION REQUIREMENTS 11 Regulations, Standards and Law. 11 The Hearth. 11 Clearances. 12 Flue / Chimney. 12 Ventilation. 13 Location. 13 Propane gas. 13 Gas connection. 13 Securing the stove. 13 Fitting the cera

  • Baxi 910,  Light the appliance. Set at the “HIGH” position and leave for one minute.  Turn back to “OFF” to extinguish the pilot. Note the time when the pilot goes out. Listen for a snap sound at the gas tap. Note the time when the sound is heard. This sound is caused by an electromagnetic valve shutting off the gas supply through the tap. The valve is located in the body of the tap. The valve should operate within 60 seconds of the pilot going out. If the valve does not operate within this

  • Baxi 910,  Explain to the customer that when operating the stove for the first time, some vapours may be given off which may cause a slight odour and could possibly set off any smoke alarms in the immediate vicinity. These vapours are quite normal with new appliances. They are totally harmless and will disappear after approximately twelve hours use.  Inform the customer that the Serial number for the appliance is located on the metal plate attached to the burner at the bottom of the appliance underneath the burner module. Servicing.  This product uses fuel effect pieces containing Refractory Ceram

  • Baxi 910, The stove body contains the following: 1 Burner module. 1 Inlet ‘T’ connector with nut and olive. 1 Vent switch and mounting bracket assembly. 1 Diverter box. 1 Down draught deflector. 1 Control knob assembly. 4. STOVE SET UP Legs and lower casting cover (See figure 1).  Locate the four leg securing studs into the four holes in the base of the body.  Locate the four legs to the underside of the casting body. There are two feet with holes in the base. We recommend that these be placed at the rear of the stove. �

  • Down draught deflector.  The down draught deflector is secured in place using the upper front bolt and nut that secure the cast collar to the outside of the cast body. Unscrew and remove the nut and washer from inside the top of the casting body. Position the down draught deflector as in figure 3. It MUST be sealed against the top of the stove casting. It is important that it sits on top

  • Baxi 910, metres (12ft) or higher. The flue must be free of obstruction and any dampers must be fixed in a permanently open position. Ensure that the chimney is not closed and that it has been swept prior to the stove being installed. Make sure that rain, birds or any foreign bodies cannot get into the chimney and cause blockage or damage. This problem can normally be overcome by fitting an approved Gas Cowl. It is essential to the effective running of your stove that the chimney draws properly and allows the products of combustion to escape. Ventilation.  Normal adventitious ventilation

  • Baxi 910, Checking the aeration setting of the burner. (For LPG models refer to the conversion guide).  The aeration shutter is factory set. It is important to ensure that the aeration setting is correct. Check the aeration shutter setting (See figure 10).  To adjust the aeration setting, loosen the two aeration shutter screws, slide the aeration shutter to the position shown in figure 10 and tighten the fixing screws. Page 18 © Baxi Heating U.K. Limited 2010. INSTALLER GUIDE Figure 10. Aeration shutter setting

  • Baxi 910, © Baxi Heating U.K. Limited 2010. All rights reserved. No part of this publication may be reproduced in any material form (including photocopying), stored in any medium by electronic means (including in any retrieval system or database) or transmitted, in any form or by any means, whether electronic, mechanical, recording or otherwise, without the prior written permission of the copyright owner. Applications for the copyright owner's permission to reproduce any part of this publication should be made, giving details of the proposed use, to the following address: The Company Secretary, Baxi Heating UK Limited, The Wyvern Business Park, Stanier Way, Derby, DE21 6BF. Warning: Any

  • The gross calorific value of the fuel has been used for this efficiency calculation. The test data from which it has been calculated has been certified by Advantica Certification services (0087). The efficiency value may be used in the UK Government's Standard Assessment Procedure (SAP) for energy rating of dwellings. The conversion of net efficiency to gross was achieved by multi

  • Baxi 910, MAINTENANCE AND SERVICING Regular maintenance. In order to achieve and maintain high levels of personal safety and performance efficiency, it is essential that the flue is kept clear of any form of obstruction. In the United Kingdom it is the law that a landlord must have any gas appliance, flue and pipework which is situated in a tenant’s premises checked for safety at least every twelve months by a competent person (In the UK a GAS SAFE REGISTER engineer, Outside of the UK a CORGI or GAS SAFE REGISTER engineer). We recommend that all g

Related Products and Documents (Cooktop):

Comparable Devices:

# Manufacturer Model Document Type File Updated Pages Size
1 VMware VSHIELD APP 1.0.0 UPDATE 1 - API Admin manual vmware/vshield-app-1-0-0-update-1-api-BRO.pdf 27 Jun 2022 144 1.46 Mb
2 Ferroli optima 2001 VMF7 Installation instructions manual ferroli/optima-2001-vmf7-2Q5.pdf 12 Mar 2024 44
3 Electro-Voice X-Line XsubF Brochure electro-voice/x-line-xsubf-383.pdf 30 Sep 2023 2 1.34 Mb
4 MTD 132-465-300 Owner's manual mtd/132-465-300-VW9.pdf 15 Feb 2024 35
5 Lifescan INDUO Operation & user’s manual lifescan/induo-74P.pdf 15 Feb 2023 90
6 HP Integral Personal Computer Service manual hp/integral-personal-computer-7GX.pdf 19 Oct 2022 204

Similar Resources:

  • Magic Chef

    WT-TOD

    (44 pages)
    manual with this appli-read and keep this manual for_p sales receipt and/or can-d check as proof of purchase.Model NumberSerial NumberDate of Purchaseuestions, call:!-800-688-1!20 (U.S.A. and Canada)1-800_688:2080 ( U.S. TTY forhearing or speech impaired)(MoniiFrk, 8 am-8 pm Eastern Time)•ce information, see page 13.Form No. B/03/04 Part No, 8113P434-60Gas …
  • GE

    Profile PGB910SEMSS

    (2 pages)
    Dimensions and Installation Information (in inches) For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at geappliances.com or call GE Answer Center® service, 800.626.2000.*Note: Dimension from the wall to the front of the closed door handle is 29". Depth to front edge of cooktop 25-1/4".Electrical Rating: …
  • Kuma Stoves

    K-300

    (12 pages)
    Kuma StovesKuma Stoves Hayden, ID. USA Models: K-300 Fireplace Insert K-400 Free-Standing Wood Stove Installation and Operating Instructions *SAVE THESE INSTRUCTIONS* This manual describes the installation and Operation of the KUMA model K-300/K-400 wood stove/insert. Under specific test conditions, this wood stove has been shown to mee …
  • Kenmore

    790.46992

    (52 pages)
    Electric RangeSlideqn models_:::_ !_ " .3 .......Estufa el_ctricaModelos deslizablesv O _C ,......... yModels/Modelos 790.46992, 790.46991, 790.46994, 790.46999F_y_!318200828(0209)RevD Sears Roebuck and Co., Hoffman Estates, IL 60179 U.S.A. www.sears.com …
  • TP-Link

    TL-WA850RE

    (51 pages)
    Specifications are subject to change without notice. is a registered trademark of TP-Link Technologies Co., Ltd. Other brands and product names are trademarks or registered trademarks of their respecve holders.No part of the specifications may be reproduced in any form or by any means or used to make any derivative such as translation, tran …
  • Coleman

    9422 Series

    (16 pages)
    IMPORTANTRead this manual carefully before assembling, using or servicing these stoves. Keepthis manual for future reference. If you have questions about assembly, operation,servicing or repair of these stoves, please call Coleman at 1-800-835-3278 or TDD:316-832-8707. In Canada call 1-800-387-6161.Propane StoveInstructions for use© 2007 The Coleman Company …

Comments, Questions and Opinions: