Fisher FSPI-091B Operating And Installation Instruction Manual

Text of Fisher FSPI-091B User Guide:

• Fisher FSPI-091B, DC Inverter Floor Ceiling Type Air Conditioner Installation and Operation Manual 11 Continued Fig.11 Timer setting under on state of the unit Timer range: 0.5-24hr. Every press of▲ or ▼ button will make setting time increased or decreased by 0.5hr. If press either of them continuously, setting time will automatically increase/ decrease by 0.5hr every 0.5s. Note: ● If both timer on and timer off are set in unit on interface, the wired controller only display time of time off. If both of them are set in unit off-state, only time of timer on is displayed. ● Timer on in unit on-state is timed from the time of unit off

• DC Inverter Floor Ceiling Type Air Conditioner Installation and Operation Manual 28 6.3 COOL mode operation procedure ① According to difference between room temp. and set temp., microcomputer can control cooling on or not. ② If room temp. is higher than set temp., compressor runs at COOL mode. ③ If room temp. is lower than set temp., compressor stops and only indoor

• Fisher FSPI-091B, DC Inverter Floor Ceiling Type Air Conditioner Installation and Operation Manual 6 3. Installation of Wired Controller Fig.4 Sketch for Installation of Wired Controller No. 1 2 3 4 5 Description Socket’s base box installed in the wall Soleplate of controller Screw M4 × 25 Front panel of controller Screw ST2.2 × 6.5 Fig.4: Sketch for Installation of Wired Controller. Pay attention to the following items during installation of wired controller: ① Cut off power supply of heavy-current wire embedded in mounting hole in the wall before installation. It is prohibited to perfo

• Fisher FSPI-091B, DC Inverter Floor Ceiling Type Air Conditioner Installation and Operation Manual 46 ● The rated voltage and the exclusive circuit must be used. ● Leakage circuit-breaker must be installed. ● Please use the specied fuse. ● If the power supply cord of the unit is damaged it must be replaced by the manufacturer or its service agent or a similarly qualied person in order to avoid a hazard. ● An all-pole disconnection air switches which have a contact separation of at least 3mm in all poles is needed 11.3.3 Prole Dimensions of the Outdoor Unit Fig.53 Table.

• DC Inverter Floor Ceiling Type Air Conditioner Installation and Operation Manual 4 1.2 Instruction to LCD Display Table 1 Instruction to LCD Display No. Description Instruction to Displaying Contents 1 Swing Swing function. 2 Air ＊ Air exchange function . 3 Sleep Sleeping states. 4 Running mode Each kind of running mode of in Each kind of running mode of indoor unit (auto mode). 5 Cooling

• Fisher FSPI-091B, DC Inverter Floor Ceiling Type Air Conditioner Installation and Operation Manual 40 11. Checking Before Contact the Service Man Check the followings before contact the service man. You may nd the solution to your problems. After checking, if it still does not operate, please contact your local dealer. Table.3 Problem Solution(s) The unit does not run. ● check if the power supply is in order. ● check if the timer switch is on or not. The air conditioner runs but does not cool enough. ● check if the preset temperature is too h

• DC Inverter Floor Ceiling Type Air Conditioner Installation and Operation Manual 43 Selection of Installation Location ① Such a place where cool air can be distributed throughout the room. ② Such a place where condensation water is easily drained out. ③ Such a place that can handle the weight of indoor unit. ④ Such a place which has easy access for maintenance. ⑤ S

• Fisher FSPI-091B, DC Inverter Floor Ceiling Type Air Conditioner Installation and Operation Manual 52 11.5.2 Refrigerant Piping work The refrigerant is R410A£¬GWP=2020 ODP=0. The standard pipe length is 5m. When the length (L) of the connecting pipe is less than or equals 7m, there is no need to add refrigerant. If the connecting pipe is longer than 7m, it is required to add refrigerant. In the below table, the amounts of refrigerant to be added for different models are listed for each additional meter of pipe length. Select copper pipes for gas and liquid as informed in specic table (see the pipe table below).For dust and moistur

• Fisher FSPI-091B, DC Inverter Floor Ceiling Type Air Conditioner Installation and Operation Manual 50 Rated Parameters and Outline Dimensions of the Fuse Table.9 Unit Code Rated parameter Dimensions 46010408/ 46010029 250V/15A 250V/3.15A 46010014 250V/3.15A 46010014 250V/3.15A 46010014 250V/3.15A 46010014 250V/3.15A 46010014 250V/3.15A 46010014 250V/3.15A 46010014 250V/3.15A 46010014 250V/3.15A 46010013 250V/5A 46010013 250V/5A All the indoor units 46010013 250V/5A FSOI-091B FSOI-121B FSO

• Fisher FSPI-091B, DC Inverter Floor Ceiling Type Air Conditioner Installation and Operation Manual 24 The LED Indicator Display on the Main Board of Outdoor Unit (09K/12K). This table is applicable to the electric control box of the 09K and 12K C Series DC inverter air conditioners. Some of the items are not malfunction; they mean the normal running status. Running Status Outdoor unit Yellow Lamp Outdoor unit Red Lamp Outdoor unit Green Lamp wired controller Display Compressor started Flash once Defrosting Flash twice Displayed Anti-freezing protection Flash 3 times E2 IPM protection Flash 4 times E5 Over-current protection Flash 5 times E5 Heat exchanger overload protection Fla

• Fisher FSPI-091B, DC Inverter Floor Ceiling Type Air Conditioner Installation and Operation Manual 7 4. Instruction to Operation 4.1 On/Off Press On/Off button to turn on the unit. Repress this button to turn off the unit. Note: The state shown in Fig.5 indicates off-state of the unit after energization. The state shown in Fig.6 indicates on-state of the unit after energization. Fig.5 Off state of the unit Fig.6 On state of the unit 4.2 Mode Setting Under on-state of the unit, press Mode button to switch the operation modes as th

• Fisher FSPI-091B, DC Inverter Floor Ceiling Type Air Conditioner Installation and Operation Manual 41 Table.5 Accessories List for Installation (Indoor Unit) Number Name Shape Quantity Type Remark 1 Nut (with gasket) 8 M10 2 Tie Line 4 200mm 3 Installation Paperboard 1 used for ceiling drilling 4 Thermal Insulation Layer of Discharge Pipe 1 5 Thermal Insulation Layer of Inlet Liquid Pipe 1 6 Sealing Plaster* 2 7 Remote Controller 1 8 Battery 2 9 Power Cord * 1 (H05VV- F)3×1.0mm 2 10 Communication Cable* 1 AWG#24 11 Drain Hose* 1 Φ17×1.75 12 Pipe Clamp* 1 13 Operation 1 Notes: See the packing list to check the delivered accessories. The accessory with * in

• DC Inverter Floor Ceiling Type Air Conditioner Installation and Operation Manual 21 (continued) Fig.18 Quiet function setting Note: ● During quiet function, fan speed is un-adjustable. ● When turning on auto quiet function, the unit will enter quiet running state according to temperature difference between room temperature and setting temperature. In thi

• Fisher FSPI-091B, DC Inverter Floor Ceiling Type Air Conditioner Installation and Operation Manual 1 Safety Considerations Please read this manual carefully before use and operate correctly as instructed in the manual. You are specially warned to note the two symbols below: A symbol indicating that improper operation might cause human death or severe injury; A symbol indicating that improper operation might cause human property damage. This unit shall be used in ofces, restaurants, residences or similar places. WARNING! ● Please seek an authorized repair station for installation work. Improper installation might cause water leakage, electric shock or re. ● Please install at a p

• Fisher FSPI-091B, DC Inverter Floor Ceiling Type Air Conditioner Installation and Operation Manual 54 11.5.4 Liquid Pipe and Drain Pipe If the outdoor unit is installed lower than the indoor unit (See Fig.63). ♦ A drain pipe should be above ground and the end of the pipe does not dip into water. All pipes must be restrained to the wall by saddles. ♦ Taping pipes must be done from bottom to top. ♦ All pipes are bound together by tape and restrained to wall by saddles. If the outdoor unit is installed higher than the indoor unit (See Fig.64). ♦ Taping should be done from lower to the upper part. ♦ All p

Related Products and Documents (Air Conditioner):

Comparable Devices:

Similar Resources:

• Unitary products group DNH018 (32 pages) CONTENTSGENERAL. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3INSPECTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3RENEWAL PARTS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3APPROVALS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3INSTALLATION . . . . . . . . . . . . . . . . …

• Mitsubishi Electric Mr.Slim MSY-GN18VF (28 pages) SPLIT-TYPE AIR CONDITIONERSINDOOR UNITMSY-GN18VF MSY-GN24VF MSY-GN30VFEnglishOPERATING INSTRUCTIONS For user• To use this unit correctly and safely, be sure to readtheseoperating instructionsbeforeuse.JG79Y212H01_Cover.indd 1 2016/09/30 15:46:56 …

• Gree GWHD(18)NK3FO (112 pages) GREE ELECTRIC APPLIANCES,INC.OF ZHUHAIChange for LifeService ManualModel: GWHD(18)NK3FOGWHD(24)NK3FO GWHD(24)NK3GOGWHD(28)NK3FOGWHD(36)NK3BOGWHD(42)NK3AO(Refrigerant:R410A) …

• LG ARNH963K2A2 (55 pages) P/NO : MFL67086705INSTALLATION MANUALAIR CONDITIONER • Please read this installation manual completely before installing the product.• Installation work must be performed in accordance with the national wiring standards by authorized personnel only.• Please retain this installation manual for future reference after reading it thoroughly.TYPE : (For …

• Toshiba RAS-18SKCV Series (8 pages) BAHASA MELAYUBAHASA INDONESIAùċĂċęðûTIìNG VIóTESPAÑOLFRANÇAISENGLISHAIR CONDITIONER (SPLIT TYPE)For general public useIndoor unitRAS-18SKCV SeriesRAS-22SKCV SeriesOutdoor unitRAS-18SACV SeriesRAS-22SACV SeriesOWNER’S MANUAL11106501311110650131_CoverFB_B5.indd 11110650131_CoverFB_B5.indd 19/28/09 2:51:12 PM9/28/09 2:51:12 PM …

• TemperZone OPA 161RKTY (4 pages) OPA 161RKTY (c/w EC motor & UC7 Controller)Packaged Reverse Cycle R410AAir Cooled Air ConditionerInstallation &Maintenanceshown returns the fan control voltage down to the minimum value for 'High' fan speed (3.0V).v. When the desired setting for high fan speed is selected then wait for 30 seconds. The controller will save the selected valu …

Comments, Questions and Opinions: