Manualios.com

Datamax PRINTPAD MC70 Operation & User’s Manual

Datamax PRINTPAD MC70 Manual Online:

3.85, 2182 votes
Datamax PRINTPAD MC70 User Manual
Datamax PRINTPAD MC70 User Guide
Datamax PRINTPAD MC70 Online Manual

Text of Datamax PRINTPAD MC70 User Guide:

  • 7 PRINTPAD MC70 USER'S GUIDE Using a Handheld Computer (HHC) 1. Insert the handheld into the cavity by slightly rotating it into the side channels. 2. Press down until the handheld is fully seated (Figure 5). Compatible Handheld Computers Note: The PrintPad MC70 is intended for use with UL Listed Accessory Handheld Computer Symbol Technologies MC70 series. Model 1x Batt

  • Datamax PRINTPAD MC70, 16 PRINTPAD MC70 USER'S GUIDE Using a CardReader General Guidelines  To wake up the CardReader, insert a card into the CardReader slot. One short beep indicates the CardReader/printer is awake.  If you are using a Magnetic CardReader, insert a card with the stripe facing away from the printer.  For information on CardReader LED indicators and audio indicators, see CardReader Indicators on page 16. CardReader Indicators Audio Indicators Note: The following information applies to printers with the CardReader option. Beep Description Action 1 long Bad read. Swipt card agai

  • Datamax PRINTPAD MC70, 14 PRINTPAD MC70 USER'S GUIDE Radio LED Power LED CardReader Audio Indicators Magnetic Radio LED Blue flash - slow RF power is on and printer is asleep. Blue flash - fast RF power is on and printer is awake. Off RF power is off. Power LED Description Off Printer is asleep. Red flash Paper out. Green Unit is awake. Beep(s) Description Action 1 long Bad read. None. 2 short Good read. None.

  • Datamax PRINTPAD MC70, 1 PRINTPAD MC70 USER'S GUIDE PrintPad MC70 Printer Views Open View Closed View Roller Battery/ battery cavity Battery clip Paper/paper cavity Data port Self-test button Charge LED Battery Status LED Radio LED Power LED Battery Status Radio LED Power LED Handheld cavity Latch Paper opening Hand strap LEDs DC power port DEX/UCS port CardReader slot

  • Datamax PRINTPAD MC70, 9 PRINTPAD MC70 USER'S GUIDE moving the paper through the printer. Verify the paper exits straight. 5. Lower the printhead release lever (Figure 10). 6. Feed the end of paper through opening in the printer's cover. 7. Remove any excess paper by grasping the top corner of the paper and pulling it up and away. 8. Close and latch the printer's cover. Printing a Self-Test 1. Open the printer's cover. 2. Press and hold the red self-test button until the printer starts to print (Figure 11). 3. After printing starts, release the red self-test button. Figure 9 Figure 10 Figure 11

  • 17 PRINTPAD MC70 USER'S GUIDE Using External Charging Overview External charge-capable printers have two charging contact points located on the back of the printer's case (Figure 15). External charge-capable printers can be used with various Datamax-O’Neil accessories, such as the truck mount bracket. When an external charge-capable printer is mounted to one

  • Datamax PRINTPAD MC70, 10 PRINTPAD MC70 USER'S GUIDE Configuring the Printer The printer has many configurable settings. To configure or upgrade firmware, download the Windows configuration program at www.datamax-oneil.com. Using the Printer Data Cables 1. Select the appropriate cable for use with the host and/or device you are using. 2. Insert the plug into the printer’s data port (Figure 12. Note: Do not close the lid or damage will occur to the cable. Figure 12

  • Datamax PRINTPAD MC70, 12 PRINTPAD MC70 USER'S GUIDE PrintPad MC70 LEDs and Indicators Power LEDs Battery Status LED Description Action Red (solid): The battery has less than 5% power. • If A/C power is not plugged in, the printer will soon turn off. •Charge the battery. • If A/C power is plugged in, the LED flashes and charging is in progress. •None. Wait for the charge LED to turn green. Orange (solid): The battery has less than 25% power. • If A/C power is not plugged in, indicates the battery charge is low. •Charge the battery. • If A/C power

  • Datamax PRINTPAD MC70, 2 PRINTPAD MC70 USER'S GUIDE Using Batteries: General Guidelines  The printer ships with two batteries installed, but they are not operational. Before operating the printer, remove the two red, battery isolator labels either by gently pulling the labels out, or by lifting the batteries up.  If you are storing your printer for a long period of time or shipping it, reinstall the battery isolator labels.  Both batteries must be installed for your printer to operate properly. Installing and/or Replacing Batteries 1. Open the prin

  • Datamax PRINTPAD MC70, 3 PRINTPAD MC70 USER'S GUIDE 4. Insert the new batteries. Verify the battery contacts are facing down and are facing the outside edge of the printer (Figure 3). 5. Close the battery cover by snapping it into place. Figure 3 Contacts

  • Datamax PRINTPAD MC70, 21 PRINTPAD MC70 USER'S GUIDE Media Supplies Datamax-O’Neil offers seven certified grades of paper for use in the PrintPAD series of printers. Our certified supplies are guaranteed compatible — this important qualification means that rigorous performance and image life testing have been performed. Quality supplies are key to obtaining optimal image quality and print performance. Quality supplies are also the key to extending the life of the printer. Datamax-O’Neil strongly recommends using Datamax-O’Neil Certified Supplies only. For more information, contact Datamax-O’Neil at (949) 458-6400. Maintenance Supplies We

  • 5 PRINTPAD MC70 USER'S GUIDE Caution: Do not plug DC power into the internal and external power ports at the same time. Caution: Do not plug in either DC plug to power if using external charge contacts and they are powered.

  • Datamax PRINTPAD MC70, 19 PRINTPAD MC70 USER'S GUIDE Agency Approvals FCC Notice This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, it may cause harmful interference to radio communications

  • Datamax PRINTPAD MC70, 4 PRINTPAD MC70 USER'S GUIDE Charging the Batteries and Handheld Computer If the battery is low when the printer “wakes up,” the printer sounds three short beeps. 1. Remove the red battery isolator labels, if necessary. 2. Plug the power supply connector into the printer's external DC port. The DC port is located on the side of the printer's case (Figure 4). 3. Plug the adapter in an appropriate power source. The Charge LED flashes red when charging and flashes green when fully charged. The Charge LED is visible when the printer's lid is open o

  • Datamax PRINTPAD MC70, 8 PRINTPAD MC70 USER'S GUIDE Loading Paper 1. Press a new roll of paper into the paper cavity. The end of the roll should exit from the bottom of the paper cavity and face the printer's roller (Figure 6). When properly installed, the roll of paper “latches” into place. 2. Raise the printhead release lever until it is fully open. The lever clicks midway at the partially open position; however, do not stop here, continue to raise the lever until it is fully open (Figure 7). 3. Wake up the printer by momentarily pressing the red self-test button (Figure 8). 4. Feed the end of the paper under the roller until the paper exits from the top o

  • Datamax PRINTPAD MC70, 13 PRINTPAD MC70 USER'S GUIDE Audio Indicators Orange flash - slow Charge has timed out. Restart battery charge (battery may be bad). Orange flash - fast Internal code error. Remove the battery, then re-connect A/C power. Orange, red, or green flash - fast When the AC adapter is plugged into the printer's power port, the battery status LED flashes orange, red, or green (depending on the battery status LED color that is initially displayed) to indicate the AC adapter is plugged in. None. Beep(s) Description Action 1Printer wakes up. None. 2 Out of paper. Install paper. 3 Low battery. Charge battery. 1 s

  • Datamax PRINTPAD MC70, 6 PRINTPAD MC70 USER'S GUIDE Determining Battery Condition You can determine the relative battery status by printing a self-test. For more information, see Printing a Self-Test on page 9 . On the printout, “Battery Volt” varies between 6.8 and 8.4 volts. Caution: There is a risk of explosion if the battery is replaced by an incorrect type. Dispose of used batteries according to the instructions. Caution: The operating temperature of this portable printer is 50° C. However, the operating temperature when used with a Datamax-O’Neil power supply for charging the portable printer is limited to 40° C. Please charge the prin

  • 18 PRINTPAD MC70 USER'S GUIDE Warning: Use of any product not approved by Datamax-O’Neil for use with their printers could cause damage to the batteries and/or printer and will void the warranty. Failure to observe the instructions and/or warnings specified in the documentation may result in damage to your printer. Datamax-O’Neil does not accept liability for resulting da

  • Datamax PRINTPAD MC70, 11 PRINTPAD MC70 USER'S GUIDE Using Bluetooth Radio printers are configured with default factory settings. To determine your printer's radio configuration, print a self-test. (For more information, see Printing a Self-Test on page 9 .) If you have multiple printers, configure them specifically for use in your environment. For proper system operation, set the following parameters on your printer and host computer: Bluetooth Parameters  Device Name  Authentication  Bondable  Discoverable  Connectable  Encryption Contact your network administrator to verify the proper radio settings for your environment. Note: The following information appli

  • Datamax PRINTPAD MC70, TABLE OF CONTENTS PrintPad MC70 Printer Views......................... 1 Open View.................................................... 1 Closed View.................................................. 1 Using Batteries: General Guidelines.............. 2 Installing and/or Replacing Batteries .............. 2 Charging the Batteries and Handheld Comput- er ..................................................................... 4 Determining Battery Condition...................... 6 Using a Handheld Compute

Related Products and Documents (Printer):

Comparable Devices:

# Manufacturer Model Document Type File Updated Pages Size
1 Kambrook COOKIE FACTORY KCP100 Operation & user’s manual kambrook/cookie-factory-kcp100-G58.pdf 28 Feb 2023 6
2 Kenmore 66513206K902 Installation instructions manual kenmore/66513206k902-RD3.pdf 04 Dec 2023 48
3 Palm Pre P100EWW Operation & user’s manual palm/pre-p100eww-23X.pdf 17 Nov 2023 204 4.02 Mb
4 Radio Shack 0904-211-18801 Owner's manual radio-shack/0904-211-18801-5F7.pdf 26 Jan 2023 4 0.48 Mb
5 Motorola QIP7100 - Operation & user’s manual motorola/qip7100-A3P.pdf 17 Sep 2022 43
6 Samsung SHR-1010 Operation & user’s manual samsung/shr-1010-A9C.pdf 09 Feb 2023 38 0.98 Mb

Similar Resources:

  • BIXOLON

    SPP-R410

    (20 pages)
    ◈ Information This installation guide contains quick information required for the product installation. Refer to the User’s Manual in the CD that comes with the product for detailed installation instructions. The CD contains the following information. 1. Manual: User’s Manual, Code Pages, Control Commands, Software manuals 2. Driver: Windows, OPO …
  • Magicard

    Enduro Duo

    (27 pages)
    Enduro QuickStart Guide,Drawing No./Stock No. 3623-0080 Issue 1 (2008)Enduro QSG multi language V3 - 07:Enduro QSG multi language V2- 07 29/1/08 14:10 Page 1 …
  • Konica Minolta

    Copier 2223

    (123 pages)
    Konica 2223 CopierUser’s ManualAs an ENERGY STAR partner, Konica Business Machines U.S.A., Inc. hasdetermined that this product meets the ENERGY STAR guidelines for energyefficiency.Recycled paper is used for the inside pages of this book. …
  • BIXOLON

    SRP-F310

    (16 pages)
    ◈ Information This installation guide contains quick information required for the product installation. Refer to the User’s Manual in the CD that comes with the product for detailed installation instructions. The CD contains the following information. 1. Manual: User’s Manual, Code table, and Control commands 2. Driver: Windows driver and OPOS dri …
  • Rimage

    Amigo II

    (1 pages)
    Rimage Producer™ Family Operator 2000183_B © 2008, Rimage Corporation 1 Replace the Adhesive Back Bumper Use this procedure to replace an adhesive back bumper in an Autostar II™, Protégé II™, Amigo II™, Producer 8100™, Producer 8100N™. Rimage approved parts must be used for this process. The product warranty may become void if parts not …
  • Monarch

    Monarch 9450

    (52 pages)
    TC9450OH Rev. DA 8/99 ©1994 Monarch Marking Systems, Inc. All Rights Reserved.Operator’s HandbookPublished by the Technical Communications Department.Printed in the U.S.A. Monarch® 9450 RASCAL® PrinterFor supplies, service, or assistance call:TOLL FREE:1-800-543-6650 (In the U.S.A.)1-800-263-4650 (In Canada)www.monarch.com …

Comments, Questions and Opinions: